Ford - F150 :: 1977 - Clunk Sound When Put It In Reverse Or When Shifts To A Lower Gear
I have been fixing up my 77 F150 since I got it in January and it's really starting to look nice! I love this truck, but I have noticed a clunk sound when I put it in reverse and also a same if not similar sound when I'm driving and slow down. It makes a clunk sound when it shifts to a lower gear, (automatic). Now, I was thinking it was a U joint at some point and crawled under there and started to grab them and see if there was any play in any of the spots but found no play. I checked it a few times, thinking well it could be just the point the U joint stopped and that would explain no play but after a few times of crawling under I still never found any.
View 8 RepliesAccent LC (2000-05) :: 2004 - No Reverse / Shifts Hard Into Drive
2004 accent had a drink spill on lower console, and think this is why it quit shifting? Disassembled, cleaned switches, unhooked battery, and car still has no reverse, shifts HARD into drive, will not move further.
View 5 RepliesChevrolet - Malibu :: 1999 - Hard Clunk When Put Car Into Reverse
I have a 1999 chevy malibu with a 2005 chevy impala motor in it. Recently I put my car into reverse and it made a hard clunk and went into reverse. Later on that day I tried to go into reverse and it will not reverse. I had to have 3 people push my car back in neutral. However, in neutral I am able to press on the gas and drive forward... This is an automatic transmission. Am I just screwed and need a brand new transmission?
View 12 RepliesFord Transmission :: Hard Shift And Clunk When Shifting To Reverse
I just recently bought a 95 F150 with a 351. The truck has high mileage, about 190k, and I am not sure how long the transmission has left. It rides smooth down the road, but when I put the truck into reverse it hesitates for a moment then makes a loud clunking sound(as if a door is being slammed) and then jerks into gear. The reverse works great at the moment though. Should I be worried, is there anything I can do to fix this?
View 11 RepliesSaturn :: 2001 - Shifts Hard Intermittently?
i have a 2001 saturn l200 2.2 about 160000 miles..sometimes when i drive the car it shifts hard and sometimes it shifts smoothly..i did have new transmission fluid and new filter put in..i did have transmission scan for codes and there was no codes..i do have a engine code came up it was Crankshaft Position Sensor..cud a Crankshaft Position Sensor cause a car to shifts hard sometimes...
View 4 RepliesElantra XD (2001-06) :: Trans Shifts Hard And Slips A Little From Third To Fourth
I have a 2002 Elantra GLS with the 4 speed auto and in the mornings or after sitting in lot at work for 9 hours, the trans shifts hard from second to third (almost as if it has a shift kit) and slips a little from third to fourth. The TPS was changed once and that seemed to eliminate problems at the 26K mark. I have 109K on it now and at around 80k took it in to the dealer with the receipt for the same complaint and what was done the first time. Dealer kept overnight and said there were no problems. I do know from having a performance TH350 built that the harder a trans shifts (up to a point) the longer it will last due to less friction on clutches and bands.
View 6 RepliesSanta FE SM (2001-06) :: Hard Jolt When Transmission Up-shifts From 2nd To 3rd Gear
I have a 2003 Santa Fe 3.5l FWD 155k miles. Car has been incredibly trouble free until now. When the transmission up-shifts from 2nd to 3rd there is a hard jolt. All other up-shift and down-shift points work smooth. Occasionally will shift smooth just after I start the car or if I am accelerating hard. The rough shift happens whether I am in D or use the "manual" shift control. This coincidentally(?) started just about the time I had a battery die hard and an O2 sensor fail. Both have been replaced. Changed the AT fluid and no difference. No engine codes, but I think the AT codes don't show there? What might be going on? Any chance the battery failure had anything to do with this? Seems odd that battery, O2 sensor and transmission all start acting up at the same time.
View 5 RepliesPassat (B5) :: Clunk When First Pressing Gas Or Sometimes Going Into Reverse
V6 A/T ... So to start ball joints, control arms, tire rods are all good as are suspension bushings.
So when driving, if I stop at a light and go to leave theres a slight clunk front the front when first pressing gas or if I am on a hill and pul it in reverse theres often a clunk. Definitely when the cars cold and go from reverse to drive.
Motor mounts?
Torque converter?
There are no shifting issues, tranny works just fine.
Ford 7.3L Power Stroke (1999-2003) :: 2001 - Trans Shifts Hard Sometimes
2001 7.3 auto, 2wdr, 291,000, Transmission sometimes shifts hard from 1st-2nd, 2nd-3rd. Problem started after I found trans dip stick tube broken and loss of fluid. Anything I can do without going to a shop. I've replaced the Broken Tube.
View 2 RepliesFord Super Duty (1999-2016) :: F350 - Trans Shifts Great Under Light RPMs But 2 - 3 Shifts Very Hard
I have 99 f350 v10 4x4 and trans shifts great under light rpms but 2-3 shifts very hard. At wide open from about 35 mph it will shift down and take off like a bullet but wont shift until I lift my foot and then it bangs hard from 2-3. All other gears are smooth. I did some searching and have found some threads saying it could be an accumulator spring that is broken? Truck has 115,000 miles on it. love the truck but want to fix this before it does some damage.
View 1 RepliesPassat (B5) :: Clunk When Going Into Reverse - Transmission Maintenance?
I have a 2000 Passat 1.8T with the 5 speed automatic. Bought it four months ago; it now has 188,000 miles on it. According to the service records, (The car has full records and was always serviced by one dealer) the transmission fluid has never been changed. This makes me a little crazy, as the manual recommends a 60k interval.
BUT, the dealer says this is no longer recommended, the transmission shouldn't be touched except to check the level. Two other dealers agree. I've also asked a few independent shops, and everyone says if it's gone this long, changing it would probably cause the transmission to malfunction. They say leave it alone as long as it lasts.
The transmission seems to work fine, with two possible exceptions: The first couple of shifts when cold are slightly harsher than when warm; and twice (in 6,000 miles) I got a noticeable "clunk" when going into reverse.
Elantra XD (2001-06) :: 2004 - Hard Jolt When Putting Into Reverse
My 04 elantra starting acting up yesterday. It has started jumping/ rocking entire car when putting in to reverse. What might cause this problem. It is hard to describe what it is doing being I know nothing about cars. It is a large jolt when going into reverse.
View 4 RepliesElantra XD (2001-06) :: Hard Shift When Put It In Reverse / Hesitates Quite A Bit To Accelerate
I have an 01 Elantra Gls with perplexing issues. The car starts at 3000 rpms, and continues to bounce between 2k and 3.5k in both park and neutral. when I put it in reverse i get a very hard shift. It actually jerks the whole car. in drive and reverse, it idles around 1.5k it hesitates quite a bit to accelerate. All fluid levels are right and don't smell burnt. it takes me 10 mins to put 4 gallons of gas in. if i pump too fast it shoots back at me. i randomly smell gas while driving. Im hoping these problems are a couple of issue I can handle at home. i just wanted some input before i buy the manual. thinking vacuum lines maf sensor.
View 7 RepliesGolf/GTI VI :: Shifts Are Really Rough With A Clunk Sound
I am finding that my GTI's downshifts with the DSG are extremely jerky. Its a 2012 with close to 15,000 miles and whenever I come to a stop, light at a red light or something, the shifts are really rough and sometimes I even get a "clunk" sound. Now, this being said, if the car is in D and while slowing down to stop I tap the paddle to downshift once, suddenly the stops are smooth as butter.
View 3 RepliesSanta FE SM (2001-06) :: 2004 - Hard Thump When Shifting From Reverse Into Drive
Recently my 2004 Santa Fe 2.7 AWD (~86k miles) has started to give a sort of hard thump when shifting from reverse into drive. It's fine going into any other gears and it shifts up and down normally. If I shift from reverse to neutral and then to drive it's fine.
I changed the transmission fluid when we first got the car at 40K miles with Hyundai Liquid Unobtanium SPiii fluid and again at 80k miles with Valvoline's SPiii offering. I just checked the transmission fluid level and it's within the normal range.
I can't tell if this is just drive-line slop or something else inside the tranny.
Golf IV / Jetta IV :: 2001 - Transmission Has Hard Time Going Into 1st And Reverse / Rough Idle
2001 VW Jetta 1.8t automatic.
Transmission has a hard time going into 1st and reverse. Also some times hits hard going into third. I have a CEL for a vehicle speed sensor? Was wondering if it's not the VSS but maybe one of the other tranny sensors?
Separate question. Same car has a rough idle issue. Occasionally stalls but intermittently runs normal always has a low idle around 600 rpm. I have a code for an injector on cylinder three.
VSS code : P0725 - engine speed sensor circuit malfunction
Injector code : P0203 - injector circuit open cyl 3
Subaru - Impreza :: 2001 - Hard To Get Into Gear And It Would Not Move In Reverse / Neutral Or Drive
I had a problem with the CV Axle and the Wheel Bearings. I replaced them already and I ran into another issue with the Wheel Studs and the Ball Joint, so I ended up replacing them as well. Yesterday I put everything back together after replacing all the parts mentioned before and I made sure everything was bolted down and tightened, and then the tire back on and lowered the jack. I started up my car expecting it to drive just fine and it was harder to get into gear than before and it wouldn't move in reverse, neutral, or drive. I called a Monroe Muffler around here and they told me that the CV Joint is probably not seated all the way inside the Transfer Case.
So later the same day I took everything back apart and made sure that I put the CV Joint back into the Transfer Case and I put the pin back in and made sure that both CV Axles would turn at the same time, which they did. I figured it was good so I put it all back together again and went through the same process as before, making sure everything was tightened down, all the bolts and nuts and pins were where they needed to be. Everything seemed to be good. I put the tire back on again, lowered the jack, started the car and attempted to drive it again. It still won't move. Why this is happening.
Honda - Accord :: Noticeable Clunk When Trans Shifts Down Into Low Gear And Shudders
1998 accord 4 cyl auto, mostly on start up and when coming to a stop at a light it sounds like someone is under the floorpan hitting it with a hammer. maybe 5 or 6 hits. I've looked into the exhaust being loose and hitting but it's tight and has good clearance. could it be a broken motor mount letting the engine rock too much? next, SOMETIMES when the trans shifts down into low gear you get a very noticeable clunk and the car kind of shudders. planning on doing a trans drain and fill today. lastly the instrument cluster is a little strange. tach doesn't work at all, speedo is fine as is the gas guage but the temp is erratic. when the temp is acting up you can thump it with your finger and it will jump around.
View 9 RepliesSonata NF (2006-10) :: 2.4 Transmission - Clunk / Shake When Shifts And Downshift For No Apparent Reason
Well, After reading about the weird transmission issues these cars have...mine finally started to do it. It will clunk, shake the car when it shifts and downshift for no apparent reason. All of this does NOT happen all the time. The noises that come from my transmission do though.
I can have the car in Drive and have my foot on the brake and I can hear a grinding/low power steering fluid like sound that comes and goes. Its worse when I shift from Park to Reverse though. It sounds like air being released followed by a bunch of faint grinding noises.