Subaru - Outback :: 2005 - Big Boost Upon Acceleration At Stoplights / Limp Mode
I have been battling a big boost upon acceleration at stoplights for approximately 6 months. Now twice I have gone into limp mode and the tech reads: PO700 (Transmission) and PO731 (Gear 1). I just turned over 190,000 miles but only purchased it a year ago. What is the problem(s)?
View 1 RepliesSubaru - Legacy :: 2.5 Gt - Automatic Transmission Going Into Limp Mode
I have been having trouble with the shift solenoid and the trans going into limp mode. I recently replaced the shift solenoid and I now have the same problem but just when the temp outside is above 90 F or when I sit in traffic or idle for more than 3 or 4 minutes. The same code p0758 comes back up. I was thinking maybe the temp sensor?
View 2 RepliesSubaru - Outback :: 1999 - Front End Grinding After Replacing Struts
I recently replaced the struts and strut mounts (front and back) on my 1999 Subaru Outback (all wheel drive). Immediately after this was done, the car began making a grinding noise that comes from the front end when I either am coming to a stop (grinding begins happening at 5mph or so) or turning left (happens at any speed). However, if I am traveling along and, upon approaching a stop sign or left corner in the road, shift the car into neutral (it is an automatic transmission) the grinding does not occur. When I replaced the passenger-side strut I did not mark the position of the bolt that is responsible for adjusting the caliber. I did, however, do this for the drivers side.
I really have no clue what is going on here. I replaced the struts because the rear tires were wearing badly on the inside and I was told by a mechanic that the struts were bad (which they were). However, in an effort to save money I am unsure of how to proceed. If I go ahead and have the tires replaced and get a four-wheel alignment and it doesn't solve the issue, I will likely have to mess with the front end (or someone will anyway) which will then require another alignment.
Chevrolet - Equinox :: 2005 - Replacing Hold Ups / Carrier Bearings On Drive Shaft?
My mechanic tells me that the hold up or carrier bearings on the drive shaft of my 2005 Equinox need to be replaced. He says that about half the time this cannot be accomplished and that I might have to replace the entire drive shaft. From the research I have done, it seems that a press (?) and blow torches are needed to replace the bearings. I can't afford the new drive shaft, but I could afford to replace the bearings if I could find someone who was sure they could accomplish this.
View 8 RepliesPrius (Gen 2) :: 2006 Car Went Into Limp Mode - Unable To Shift Into Drive Or Reverse
I was once the proud owner of a 2006 Prius with 106,716 miles on it. Never missed a regularly scheduled service. Now, I am no longer proud, but just another owner of a Prius with a failed transaxle.
Last week, I parked my car on my way to work and, while the car was idling in park, the Triangle of Death (red with exlamation mark within) came up on the dashboard. The car went into limp mode -- it was unable to shift into drive or reverse -- so I had it towed to Darcars in Silver Spring, MD. They thought the original 12v battery was dead, so they replaced it.
P0AA6 -- 526 and 613 codes 600 miles after Transaxle Fluid Replacement...
Subaru - Outback :: 2011 - Intermittent Rattle - Replacing Catalytic Converter
Heard a funny intermittent rattle and my mechanic told me that my check engine light should be going on any time now as my cat converter is bad. The part is about a thousand bucks! Looked on line and see some aftermarket ones from walker and some other retailers. My car has 103K miles on it,.
View 17 RepliesSubaru - Outback :: 2000 - Replacing Ball Joint And Steering Rack Boots
Our 2000 Subaru Outback has just over 200k. We want a vehicle that is safe, but do not want to put a lot of money into this. At the last service the dealership said the left ball joint boot and power steering rack boots need to be replaced and the rear differential bushings are broken or loose. All of this would be > $1000 to repair. They said that the ball joint could get dirty and fail catastrophically and be a safety issue. Is that right or will the steering start to feel rough beforehand? Can we drive it safely?
View 11 RepliesNissan - Xterra :: 2005 - Code P1757 / When Change From Park To Drive It Goes Out Of Gear And Go Into Limp Mode
Nissan XTerra 2005 transmission RE5R05A. Trouble code is p1757 When I go from park to drive it goes out of gear and puts my car in limp mode. I took it to the dealer and they told me that I have to replace a transmission another place told that it could be brake solenoid or oil filter. In third place they told me it could be the TCM problems.
View 7 RepliesSubaru - Outback :: 2001 H6 Overheats Only When Drive For A While On Hot Day
My 2001 Subaru Outback H6-3.0 is at 215k miles (I bought it for $4k at 201k miles). It overheats only when I drive for a while on a hot day. I was trying to get to Yosemite with my whole family in the car, and rather than do the intelligent thing and go back home and get it repaired, I kept going, stopping when the gauge started going past the middle to let it cool down and replace any water it was missing (after the engine cooled, of course). Amazingly, we managed to use the car almost normally during the trip, as long as we did short-ish trips and kept some water in the car. Having to pull over randomly isn't so bad when you are in Yosemite anyway.
There was a mechanic shop in the little town we stayed in, but they weren't equipped to to do a head gasket job in the little time we were going to be up there, and we needed the car to get around anyway. So I tried putting some of that coolant leak repair gunk in there and it seemed to work. We made it the hundreds of miles home, no problem (but it was downhill, where the trip up there was uphill). Problem solved, right?
Well, about a year later of only driving the thing about 50 miles in any given run, and not terribly hot weather, we decide to go a few hundred miles south. Sure enough, it was a hot day and after about 60 miles I saw the temp gauge go past mid and immediately pulled over. After it cooled a bit, I drove it (in two hops, because it started heating up again quickly) to a shop. They tested it and sure enough it's a head gasket leak. They said it'd be $2500 to fix it.
So far this car has been pretty good to me otherwise. Numerous times, I've taken it up 300+ miles into the snow and ice covered roads to go skiing and LOVE not having to put chains on. I am guessing that all the cold air up there kept it from overheating while I was pushing it pretty hard up some steep inclines without issue. It seems like there is a temperature threshold beyond which it starts to quickly overheat, and below witch, the gasket is holding fine, or something along those lines.
So, given that I like this car, is it worth another $2500 to get her back on the road? Should I just try the leak stopping junk again? Should I have been using "SUBARU cooling system conditioner" this whole time, even though it's not one of the supposed head-gasket-problem engines? Should I just drive it until it finally overheats to death? It's probably still fine to drive in moderate to cool temperatures (winter is coming), but I haven't driven it since the leaking head gasket diagnosis. I don't know if I did permanent damage to it that day, or if it's just its usual self still. It didn't get into the red, heat-wise.
Subaru - Outback :: 2000 - Slips Into Neutral While Still In Drive
Sometimes my car, a 2000 Subaru Outback Wagon with 115k miles, when stopped in drive will slip into neutral. It is an automatic and is still in drive when this happens. It does not happen on a consistent basis. It seems to happen more often when it is either wet outside or after it has rained. However, it does happen when the sun is shining brightly too. Sometimes when I am driving, there does feel as though there is a delay when I press on the gas almost as though it needed to kick itself into gear. Any thoughts on what this might be and why this is happening? It has been happening since last fall.
View 5 RepliesSubaru - Outback - Transmissions :: Car Won't Move In Drive, Reverse Or Neutral
When I started my car and put it in reverse, it didn't move. It felt like my front, right wheel was in a divet or was being blocked somehow (intuitively it seemed like if I accelerated enough, it would eventually move, but since there was nothing physically stopping it - that I could see - I didn't want to break something by doing that). I tried putting it in drive and neutral and the same issue was still there. I put the car up on a jack and checked one wheel at a time - I could move each wheel completely around in both directions.
I could move the steering wheel all the way to the right and to the left. I tried turning off the 4-wheel drive and that didn't do anything. At this point I'm concerned it could be the transmission or the drive shaft, but I'm not sure what to look for in order to know if I need to get it towed to a shop (hoping I can avoid this) or if there's a simple test I can do, or a way to "reset" something if it may be locked. I haven't had anything happen to the car that would have been of concern.
Ford Super Duty (1999-2016) :: Transmission Would Not Work In Tow Mode And Caused Engine To Go Into Limp Mode
I have a 2008 F350 with a 6.4 Powerstroke diesel engine that just experienced total engine failure. It has around 65K miles.
There is a heavy burn star pattern on all 8 pistons, a few pistons are cracked, a few cylinder walls are scored, glow plugs are melted, both heads are cracked with multiple stress fractures in each head.
About 1 month previously, the transmission would not work in tow mode and caused the engine to go into limp home mode. The dealership just replaced the entire tranny as a warranty item. About 1 week before the engine failure, I put in a 5.25 oz bottle of Lucas injector cleaner with a full tank of gas.
The Ford dealership is saying that the star pattern on all 8 pistons is due to high pressure fuel overspray and is evidence that I had a tuner on this engine and that the warranty is invalid. I did not have a tuner. What might have caused this engine failure?
Also, they only ripped down the top half of the motor, not the bottom half. I heard this might have been caused by a cracked crank shaft, but Ford refuses to investigate this possibility.
Ford Super Duty (1999-2016) :: Front Drive Shaft Spinning While In 2 Wheel Drive
I have a 1999 Ford F250 super duty 4wheel drive, lifted (really a leveling kit but had to lift rear to compensate), 5.4l. Im having a problem with my front shaft turning while in 2 wheel drive. Hubs aren't locked and its in 2 wheel not 4. I've taken hubs off and the bearing spins free soo I know its in auto. Why is the drive shaft still turning???????
View 5 Replies06 Charger Won't Start Sometimes - Going Into Limp Mode
I have a 2006 Charger R/T. My car used to not start (even thought the battery, starter, and alternator was good). I had it fixed, and the problem seemed to be electrical. However after that, it would always start, but would go into "limp mode". I let it sit for two days, and the limp mode disappeared. However, it will only start on occasion. It won't start after about 30 mins after use. It won't start for a few hours. All electrics work fine, it just won't even attempt to crank. Try to start it later, it will work fine. Even though the check engine light was NOT on, I was able to pull three codes out of it: U0100, U0103, P0700. I did have to replace the notorious "pink thingy", but everything (should be) connected fine.
View 1 RepliesPhaeton :: 2004 V8 - Going Into Limp Mode
Happened once or twice where I tried to back up a hill and the car went into limp mode. Neither the dealer nor my mechanic could replicate it.
View 5 RepliesGolf VI R :: Limp Mode With APR Flash?
So I was driving kinda hard yesterday on the highway, and it was about 80 degrees outside. At some point in the drive, I got no boost from the turbo at all (my gauge also was showing no boost). I pulled over, stopped the car, and restarted it, and the car was back to normal. Is this something I should be worried about? I am running 93 program APR Stage 1+ with VWR intake and HPFP.
View 24 RepliesSanta Fe (CM - 2007-12) :: MIL Comes On And Goes To Limp Mode
My 2007 Santa Fe was acting up at one time, then stopped doing it, and recently started again. My wife is the primary driver so I'm not always in the vehicle when it happens. When the vehicle is started cold, it will run a short distance then the MIL comes on and it goes to a 5 mph limp mode. After pulling over and shutting the vehicle completely down for a couple of minutes, it will run normally with the MIL still on. However, by the time I get back home to pull the codes, the MIL goes off. I don't remember the exact codes, but when it acted up last time I believe the codes had something to do with the TPS, Pedal Pos Sensor, and one other I can't remember.
View 3 RepliesSanta FE SM (2001-06) :: 3.5L - CEL Came On And Car Will Go Into Limp Mode
I have been having a problem where the Santa Fe will drive great for a week, sometimes only a day and the engine light will come on and the car will go into limp mode. It will drop you from 65MPH to 10 MPH, if you put it in park the RPM's will race and stomping on the pedal will not affect the RPM's. After you turn it off for a couple of minutes it will drive ok again. I have replaced the Throttle Position Sensor and the Accelerator Pedal Sensor, cleaned all connections and checked wires in them. I have also cleaned the Throttle Body. The Dealer wants to replace the Throttle Body.
Had Engine Codes:
P0123 - Throttle Position Sensor 1 Signal Circuit High Imput
P1110 - Throttle Actuator Control System Malfuntion
P0222 - Throttle Position Sensor 2 Signal Circuit Low Imput
P1175 - Electric Throttle Valve Control System (ETS) Valve #
P1196 - Throttle Actuator Control System Limp Home-Stuck
Golf IV R32 :: EPC Light Came On And Car Gone Into Limp Mode
So on cold mornings my r has been kicking on the epc light and gone to limp mode. The only codes are for the coolant temp sensor and an intermittent accelerator position sensor. Would the temp sensor really cause this? After awhile I can start it up and it runs fine.
View 7 Replies