Subaru - Outback :: 2004 - Cruise Control Flashing - Replaced Both Banks - Catalytic Converter?
engine light and flashing cruise control switch--computer says replace bank one---so I replace with factory catalytic converter----six months later light comes back on with flashing cruise control switch and computer asking me to replace bank one---So I use computer to shut light off----four weeks later light comes back on----called dealer they said "we usually replace both banks"---I found it most painful paying for dealer supplied catalytic converter even when I was under the impression that it would keep light off.---This is my wife's car and she is not really buying the piece of black electrical tape I placed on dash over check engine light.---Am I dealing with a bad oxygen sensor ?
View 5 RepliesToyota - Sienna :: 2003 - Replacing CA Catalytic Converter
Chk engine light is on. Checked it at Advance Auto and indicated either cat or the O2 sensor (rear). So, I went to replace the O2 sensor and learned the hard way that you can't just unscrew the nut. I torqued off the stud to which the O2 sensor attaches. Muffler shop told me you need to heat up the stud/nut first to remove it. Oh well, lesson learned. So, I'm looking at replacing the pipe with the catalytic converter attached since I can't seem to fix the broken stud (or actually get the one I didn't break off). The problem is, my car is apparently a CA model and has the special cat on it. I live in VA. What sort of problems might I run into if I replaced the cat with a non-CA version? They are significantly less expensive. This is for a 2003 Toyota Siienna
View 1 RepliesHonda - Accord :: 1997 - Still CEL Comes On After Replacing New Catalytic Converter
My wife and I have a 1997 Honda Accord, roughly 260k miles. A few months back the Check Engine light came on, diagnostic came back with P0420, typically indicating the catalytic converter is shot. Who am I to argue, it was an factory part. So we replaced that with an inexpensive Magnaflow converter. (don't have the part number on me); this was 5 days ago. Today my wife takes the car in for inspection. Check Engine is still on with the same code. The guy at the testing station begins laughing at my wife when she says we only spent about 200 in parts and labour on the new converter. I'm inclined to think that since we already replaced the converter that I should be looking somewhere else (O2 sensor maybe). But I also don't want to just start throwing parts at it. Do I have a case here? I would really prefer not to spend $1000 on a car that old with that many miles on it just to pass inspection.
View 4 RepliesCamry :: 2006 SE Lost Electrical Power After Replacing Catalytic Converter
06 Camry SE I4
I had to replace my catalytic converter because of the code I was getting. It wasn't difficult to do, but took me a while because I had to transfer the thread rods to the new CAT. Once the new CAT was installed, I went to test her out, but noticed that the car all of a sudden, has no electrical power. Nothing at all. I checked all fuses and nothing is blown. The only electrical I messed with on the car was the O2 sensor.
Car has a brand new battery from yesterday. The only thing I didn't do is install a support bracket on one side, because it was missing a bolt and one thread rod was stuck in the old CAT, i couldn't remove it.
A friend suggested that the missing bracket may be causing a ground issue. Is this true?
Passat (B5) :: Replacing Catalytic Converter, Valve Cover, Cam Seals And Timing Belt?
I have some serious work that needs to be done on my car. The catalytic converter needs replacing, and the valve cover gasket and cam adjuster seals need to be replaced. This work falls under their respective warranties. However, I'm wondering if I should have the water pump and timing belt done at the same time as I have 77000+ miles on my car. Is there anything else that would be good to do at the same time as this work. I would be going back to the VW service center for these repairs. Would it save me any money to do this all together?
View 4 RepliesSubaru - Oil - Forester :: 2002 - CEL Came On - Bad Catalytic Converter?
On my 2002 Subaru Forester (137,000 m), the check engine light came on. They diagnosed and repaired O2 sensor. About 300 miles later it came on again, this time they said the catalytic converter was cooked, and they blamed whatever caused the O2 sensor to fail (or the O2 sensor failure itself). After the repair (about $1300 and 30 miles later), I discovered that the engine oil was so low that it was not showing up on the dipstick (tho the oil light was not yet on). The shop (after admitting that they did not check the oil while it was in there) said it was related to catalytic converter failure. Does this make sense? I have only gone another 60 miles since the oil was refilled, but so far it looks OK. Should I be on the look-out for anything else?
View 16 RepliesSubaru - Impreza :: 2006 - Catalytic Converter Is Going Out?
We have a 2006 impreza, that we've been told the Catalytic converter is going out. We cannot seem to determine if there are one or two converters on this car, and want to know if this is something that we could do ourselves once we find out where everything is at?
View 18 RepliesGolf IV R32 :: Catalytic Converter - Heat Shield Rattle
The catalytic converter shield is tack welded on the front end but free on the rear end. There was originally some braided wire packing at the rear to keep the shield from rattling against the pipes. Mine was deteriorated and had been damaged, I think, when I sustained some oil pan damage last summer -- big jolt to the system when running over a muffler on the highway.
The fix is simple. Bought a foot of 3/16" braided stainless steel cable. I used about 8 inches and layed in the lower bead line on the catalytic converter shield (see picture below). You can see a bit of the cable thru the gap in the upper/lower shield on the left side. (1/4" cable would be a better fit, but this will work for a long time.) Cost: $1.84
The local VW parts man dug out an exploded drawing of the system but it showed NO parts or packing for this problem.
Golf V R32 :: Rattle Coming From Underneath The Car - Catalytic Converter?
I have this rattle coming from underneath the car that's been going on for a while.
The car has 110k miles and the rattle is most prominent when I start the car or accelerate hard or just cruising downhill without gas.
I went to one of the well known shops in the area and they said it's coming from the cat and it needs to be replace and quoted me like $1300 for parts and labor which seemed quite steep to me.
They said it's coming from the inside the cat so it needs to be replaced.
Is this a common issue with our cars? I though maybe something is loose and can be just welded together or something.
Subaru - Forester :: 2001 - Smoking From Catalytic Converter Area
I'm getting smoke from the catalytic converter area on my 2001 Subaru Forester. The smoke smells of rubber or oil. I've only noticed it after the car has been driven up a long, steep incline of at least a couple of miles. I've never seen it happen after normal highway driving. The car runs fine, gas mileage is good, CE light is not on, 85K miles, regularly serviced.
View 2 RepliesSubaru - Forester :: Intermittently Stuttering / Bad Catalytic Converter Cause O2 Sensor?
2001 sub forrester. In 2009 it was intermittently stuttering: tuneup, new coil, finally O2 sensor (both) replaced which fixed it. In Oct started to do the same thing. First the back then the front sensor replaced but they commented the flow was low on the catalytic converter but wouldn't say it could be the cause of the sensor issue. Now the O2 sensors are on either end of the converter and the car is starting with early signs already. Is is reasonable that it is the catalytic converter? I am wrestling with just having them do the full tuneup and replace the converter or am I crazy?
View 7 RepliesPrius (2010-12) :: Tinny Clunking Sounding Rattle - Catalytic Converter Failing
Took my car to a shop today after I'd been experiencing a "tinny clunking" sounding rattle. I was worried it might be my catalytic converter and after couple of bumps on the exhaust system while on the lift, the tech thought this was indeed the case. Replacing the catalytic converter could be a $1500+ job from what I hear if replaced by toyota.
View 17 RepliesSubaru - Forester :: 2000 - CEL / Code Is P0133 Came On Randomly - Replace The Catalytic Converter
My 2000 Forester has 96,000 miles on it. A few months ago, the CEL came on. At first it would turn off every couple of days but would eventually pop back on. I first thought it was tied to putting gas in the car, now I think it was just a coincidence.
Over the past two months, I have replaced the catalytic converter with a aftermarket piece (done by a mom and pop muffler shop) and replaced the front o2 sensor three times. The first two times, I used Bosch sensors from an auto parts store and had the code cleared. After about 50 miles the CEL came back on. Just yesterday, I picked my car up from the dealership where they installed a Subaru fron o2. After about 30 miles, the light is back on again. Code is P0133 - heated oxygen sensor, bank 1 sensor 1, circuit slow response.
Now, the dealership is suggesting I need to replace the catalytic converter with a Subaru converter before they can source the issue.
Subaru - Outback :: 1999 - Front End Grinding After Replacing Struts
I recently replaced the struts and strut mounts (front and back) on my 1999 Subaru Outback (all wheel drive). Immediately after this was done, the car began making a grinding noise that comes from the front end when I either am coming to a stop (grinding begins happening at 5mph or so) or turning left (happens at any speed). However, if I am traveling along and, upon approaching a stop sign or left corner in the road, shift the car into neutral (it is an automatic transmission) the grinding does not occur. When I replaced the passenger-side strut I did not mark the position of the bolt that is responsible for adjusting the caliber. I did, however, do this for the drivers side.
I really have no clue what is going on here. I replaced the struts because the rear tires were wearing badly on the inside and I was told by a mechanic that the struts were bad (which they were). However, in an effort to save money I am unsure of how to proceed. If I go ahead and have the tires replaced and get a four-wheel alignment and it doesn't solve the issue, I will likely have to mess with the front end (or someone will anyway) which will then require another alignment.
Subaru - Outback :: Limp Mode After Replacing Drive Shaft
I have a 2005 Subaru Outback 2.5 and a while back I had to replace a drive shaft. After replacing it my car goes into limp mode and I get a different random code every time. The car seems to run fine when it is cold but after it warms up it will go into limp mode randomly. If I cost to a stop and shut down the car and wait a while to restart it runs fine. I've tried and researched just about everything thing.
View 6 RepliesSubaru - Outback :: 2000 - Replacing Ball Joint And Steering Rack Boots
Our 2000 Subaru Outback has just over 200k. We want a vehicle that is safe, but do not want to put a lot of money into this. At the last service the dealership said the left ball joint boot and power steering rack boots need to be replaced and the rear differential bushings are broken or loose. All of this would be > $1000 to repair. They said that the ball joint could get dirty and fail catastrophically and be a safety issue. Is that right or will the steering start to feel rough beforehand? Can we drive it safely?
View 11 RepliesSubaru - Outback :: Intermittent Strong Gas Odor From Under Hood - No Leaks
Strong Gas Odor from under the Hood. Mechanic found no leaks. Contacted Subaru only reply I got was "how many miles are on the Car" and take it to a Subaru Dealer. Odor is intermittently.
View 5 RepliesSubaru - Outback :: Intermittent Loss Of Power Steering Ability
I bought my outback a few months ago from a dealer/mechanic who had fixed the car after it was totaled. So it has a reconstructed title, but it was hit in the back, so all the engine parts were unaffected by the crash. Since I have had the car I have experienced intermittent loss of power steering ability. Sometimes it's nearly impossible to parallel park or turn a corner gracefully, and other times, within the same short trip, the steering will be completely fine and smooth. I have had the issue looked at about three times now by different mechanics. Each time they have either replaced or tightened the belt, which temporarily fixes the problem. But within a few weeks it always comes back. Is there something not keeping the belt tight, or could the issue actually be in the power steering pump?
View 3 RepliesSubaru - Outback :: 2005 - Rattle Noise In Right Front Suspension
I just replaced both front strut mounts on my 2005 Outback 3.0L. I was 100% sure that it would resolve an ongoing noise/rattle in the front end when driving over bumps and generally rough roads. It worked with some of the noise because the strut mount bearings were shot. But much to my disappointment after putting everything back together I still have a rattle (more like the sound when you shake a shoe box with a tennis ball inside it) in the right front suspension somewhere. When lifted the right front wheel is solid with no wobble left to right or top to bottom so I"m thinking it is not a tie rod but I am not a professional mechanic. Should I take the right front strut back off and check the new mount or is there an easier answer.
View 3 Replies