Golf IV R32 :: Clunking Sound From Right Front Suspension When Going Over Bumps
I have a clunking noise from the right front suspension when going over bumps. I've replaced the Strut bushings that were collapsed, the control arm bushings that had play and the noise is still there. There is no play in the links. There is a slight noise in the sway bar bushings when struck with a rubber mallet. I hate to keep replacing parts chasing down this noise.
View 9 RepliesHonda - Accord - Suspension :: Clunking Sound From Front When Go Over Wavy Pavement Or Dips
I have a 2002 accord 4-cyl with a 5-speed with 89,xxx miles. Just a few months ago, I noticed a clunking sound coming from the front suspension when I go over certain bumps. "Certain" bumps are usually wavy pavement or dips (not wide dips, but short/concise ones), and sometimes certain speed bumps. Sometimes the sound happens regardless of the types of bumps though, but the aforementioned ones usually bring the noise quite consistently. The sound hasn't really gotten worse, but it hasn't been getting better either.
A while back when I had my timing belt done, the mechanic stated that one (or more) of my engine mounts were worn. Is it possible one or more of my engine mounts is the source of this issue (from the engine "rattling" around in the compartment. I'm not sure if that's even possible, just a hypothesis) or is it purely suspension. PS. The sound isn't quite a sharp metal on metal sound. Its more of a "thump" or "clunk" coming from the front end (left or right) as if its bottoming out or a bushing or spacer has worn off. Its just loud enough to drive me crazy, and sometimes I can feel it through the floor.
Passat (B5) :: Clunk Sound From Front Left Suspension When Making Turns
I'm getting a clunk sound from my Passat's front left suspension when making turns. I've found info on how to diagnose control arms and I plan to jack the car up tomorrow and check it out. But how would I diagnose a tie rod end problem?
My Passat has 53,000 miles on it.
Saab - 9-3x :: 2008 - Front End Clunking Slightly In Steering
I've got a 2008 Saab 93 TurboX AWD, 6sp manual. It's got about 40k miles and I just had my front right wheel bearing replaced in November. The clunking sound started probably 2 months ago and it started off very subtle but has now progressed to being audible even over the radio. It occurs typically at any speed and is independent of RPM and/or braking. I can feel it slightly in the steering wheel but nothing significant. It sounds like a low clunking/flapping and occurs during deceleration as well. I hear it particularly in the front center to front right of the car. It kind of sounds like a golf ball rolling around in a cardboard box if you can imagine that.
I've had a Saab specialist look at it and they've tightened the suspension and inspected for loose parts in the engine compartment as well as the wheel wells and springs were all in good condition.
Suspension - Nissan - Sentra :: 2012 - Making Clunking Noise While Turning Wheels Or Parking?
I have 2012 sentra with CVT transmission & 60,000 miles. I just got 60,000 miles service done. Service adviser called me to let me know that I need to have replaced upper strut bearing on the front (left & right) replaced because they are making clunking noise when turn wheels or parking. When I asked for the reason why they should go bed he told me that it's normal, some sand other debris could clog there or water could have damaged it.
View 4 RepliesPassat (B7) :: 2013 - Making Clunking Sound?
I purchased back in January my 2013 Passat and today for the first time, I noticed that when I turn my steering when the car is not moving, I hear a clunking sound and I can actually feel the clunk too.
When I'm driving I don't feel or hear anything. It's really when the car is on but not moving.
This is getting annoying because this is the 3rd time something is going wrong with my car.
Going back to the clunking, I was reading that it's a common problem with most VW vehicles.
What it could be. I don't wanna look like an idiot that's been going to the dealer so often for these types of issues.
Golf IV R32 :: FSB Making Clunking Sound At Low Speeds
My FSB is making some clunking noises. Literally sounds like metal on metal banging. Im thinking its the FSB bushings. I just put the bar in about 4-5 months ago, not sure how the bushings could be shot already. The car only makes these noises at low speeds. On the highway i dont hear a thing. I installed the bar myself, so i know there is very little room for play.
View 5 RepliesGolf VI R :: Front Suspension Clunking Over Bumps?
Aside from the clutch and gear changing noise, recently I've been noticing something that sounds almost like a rattle when going over bumps, say a series of filled potholes on a highway where they just slightly bump to move your wheel around, it's not that deep thumping you would expect to hear but it sounds like something is loose in terms of the suspension.
Happens on the front and seems like its coming from both sides. To me it sort of sounds like they forgot to tighten something up when they removed the shipping "blocks"/spacers, but I am not exactly sure what to check. I really do not want to visit the dealership at only 600 miles on the clock ...
Ford - Ranger :: 2002 - Making Clunking Sound
My 2002 Ranger XLT Supercab Edge makes a clunking sound, but not every time, when I start going from a stopped position. It's coming from underneath right behind the cab. The Ford dealership could find nothing wrong. What this could be?
View 15 RepliesSaab - 9-3 :: Thumping Sound At Very Slow Speeds From Bottom Front End
I just started getting this thumping sound, at very slow speeds from the bottom front end. What this could be. It sounds like it might be coming from the suspension or steering.
View 2 RepliesPassat (B5) :: Front Suspension Clunking Vibration At Low Speeds
This just started happening on the driver side. Going over bumps and slight road wobble type imperfections make a medium pitched clunk sound. The sound stops as soon as I press the brakes ( which I just replaced last week). I do have a worn out bushing on the curved lower control arm. Could that be it? Do I need to replace all control arms or can I do just the curved set? If thats the issue.
View 13 RepliesSedan :: Clunking Noise In Front Suspension Only Sometimes When Turning
So I got a steering problem and it's got me going crazy. I have a 06 g35 sedan lowered about an 1.5 inches. It's been about 5 months since I lowered it, lately I've been herring clunking noise in front suspension, not all the time but only sometimes when I turn. The other day my steering got really stiff and when I turn the steering won't return to the center. My Power steering isn't making any noise and I'm good on fluid. A lot of people say my ball joints but don't they usually make a lot of noise when they go bad ?
View 18 RepliesGolf IV / Jetta IV :: Clunking Noise From Front Suspension
I am trying to find origin of clunking noise, but it is difficult to do as there is no visual signs and no excessive movements in any components.
Little bit of details and video. Noise occurs when moving rapidly steering wheel on stationary car with running engine. Not noticeable when at speed. Wheel is not vibrating and cv joints not clicking. Very tiny free movement in steering wheel about 1mm, but I am not sure if that is related maybe a completely different issue there. Mot tester make an advisory note that steering system slightly rough, but its not that useful to find an issue.
[URL] ....
Passat (B5) :: Clunking Noise In Front Right Suspension At 67,000 Miles
My 2002 Passat Wagon (2.8L, FWD) has started developing a clunking noise at 67,000 miles in the front right suspension. Based on forum search here, it sounds like a common problem with the control rods, tie rod ends, ...
I looked at the control arm kits available at ECS Tuning. Is this a DIY job for someone with only moderate mechanical skills? I have never performed front end suspension work before. How difficult is it? Special tools needed?
If I had it done (both sides, upper and lower) at an independent repair shop, how much might I expect to pay?
Lastly, is it best to replace all the parts (as provided in these kits), rather than isolating the part that is currently causing the clunk and just replacing what needs to be replaced?
Ford Brakes/Suspension :: Clunking And Rattling In Front End
I have had a clunk in the front end that started out as a light clunk that was sometimes noticeable. It has now turned into a clunk that can be heard very often. It sounds like a hollow clunk. I'll try to explain it so it makes sense...If I'm going over a bump or speed bump or something like that it doesn't really do it noticeably. If I'm driving a get to a place where the road is uneven or there is a hole or pothole and the front end seems to "fall into the hole", then the sound is very audible, and I can feel it slightly in the steering wheel and under my feet in the drivers floorboard. So, I've had the front end checked out 4 times and between what they said to do and what I've read on here...here is what I've done so far......
Changed end links with moog end links
Changed sway bar bushings with moog bushings
Undid the bushing mounts from the front frame and wired the sway bar up to keep from flopping around. No change in sounds
Didn't get rid of the clunk....
Had front end shop check out truck... They said ball joints were ok, no play in them. They did say that they could feel some "clicking in the pitman arm pivot" when turning the wheel. Like something was loose in box.
I've changed shocks and bearings.
I can grab a hold of the passenger outer tie rod at the adjustment sleeve and rotate the tir rod and it will rotate around in the socket and hitting on the insertion point and make a metal thud sound.
Again, took into shop and they said that would be normal b/c the tie rods have to have that to keep from binding up in front end.
My thinking is that if the tie rod rotates that much, then it is rotating the drag link which in turn puts stress on the pitman arm which in turn has either broken or sheared the pinion shaft inside the box and then when I go over a hole, it moves and all of the above is put into motion.
Shop (Ford) basically called me an idiot and that wouldn't be the cause.
So, now onto my thoughts and questions....
Radius arm bushings
Axle bushings (????? how many and where are they all located)
tie rods and drag links..
Lexus LS 2007+ :: Suspension Rattling Clunking Sound On LS460
Why my suspension is so loud and clunky are doing a swaybar link and upper control arm replacement? I did remove the air suspension unit in order to access and remove the bolts that hold the upper control arm bracket mount onto the frame.
I did not think that would do any harm. Now my suspension is way louder than it ever was to begin with.. I just did a visual inspection and saw that my original parts were cracked and worn in the bushings and links. So I did a swap.
Suspension LS460 - YouTube
Honda - Pilot :: 2005 - Clunking Sound From Rear Suspension
My 2005 Honda Pilot has 125k miles and has developed an occasional clunking sound from the rear suspension. It seems to happen around sharp turns or when the rear suspension is unloaded, like hopping over railroad tracks, or when going over short/sharp bumps. It is inconsistent, in that it does not happen all the time. I was checking and checking for loose parts for months and tugging on suspension parts like arms, links, sway bar, etc. I find nothing loose or clunking or showing signs of loose connections.
Today, I was checking with the car on jack stands and found the "hubs" or sheetmetal covers that the CV boots are clamped to are loose at the differential. I believe this is the sound of the noise. They rotate with the rear wheels and kind of clunk around with some manual pressure applied.
Are they a typical source of trouble? Are they easy to replace? Are they nothing to worry about or is this a precursor to the axles falling out?
Elantra MD (2010-15) :: 2011 - Clunking Noise In Front Suspension
I have been frustrated with my Elantra's handling from the time I purchased. I feel that the car is setup poorly and has design/OEM part issues.
I have improved the rear-end "hop" issue by replacing the OEM rear shocks with the KYB Gas-A-Just's -- a big improvement in handling the bumps. But the rear-end solid axle on such a light car is just crap...
I have developed quite a bit of 'clunking' noise in the front suspension.
I am considering replacing the front-end shock-strut assemblies with KYBs -- I'd love to hear if it made a big difference. Also wondering if I should change-out the 'sway bar link' while replacing the shock/struts.
I'm just so frustrated with the way this car handles (I've driven Subaru's, Honda's, and VW's) compared to other cars. I feel it's a combination of low-quality OEM suspension parts, rear solid axle, light weight, crappy electric steering settings, and tires that are too wide and too low-profile for such a light car. (I have the limited with 17 wheels).
Santa Fe (CM - 2007-12) :: Clunking Coming From Front Suspension When Go Over Bumps
I can't find the obd port on my new 2007 SF. Also there is a clunking coming from the front suspension when i go over bumps, what is the most common cause of this?
View 13 Replies