Golf IV / Jetta IV :: 2004 - Have To Hold The Shifter Until Clutch Is Engaged For 3rd Gear Position
I picked up a 2004 GTI not long ago for pretty cheap because it had a few issues. I am working my way through them. However, having 3rd gear issue.
All other gears are perfectly fine but there is way less play in the shifter in the 3rd gear position and I have to hold the shifter in position until the clutch is engaged (pedal up) to avoid the gear grinding. Once the clutch is engaged it stays in 3rd gear fine. It doesn't matter if I am moving from 2nd to 3rd or 4th to 3rd. Same deal. I have aligned the shifter several times using to proper procedures with no effect.
It never grinds 3rd with the clutch disengaged (so the synchro is fine?) and it will bang shift no problem. Oh and the clutch is less than a year old. It was installed by a shop before I bought the car. It's not really a big deal, but I would like to fix it. If I have to swap the trans that's fine, but need to figure out if it is a trans or linkage issue first.
Ford F-150 (2009-2014) :: 2010 F150 Cam Shaft Position Sensor
I have a 2010 F150 with the 5.4 V8. How many cam shaft position sensor do I have ??? I replaced one but I swear I see one one the passenger side...
View 1 RepliesFord F-150 (2009-2014) :: 2013 - Got Codes For All Banks - Fuse Position?
I have a 2013 F150 SC 2wd with a 5.0 180k mileage. I have codes for all 4 banks coming up. P141 P135. I'm trying to find out which fuse works this circuit and the OM does not have it listed. What is the fuse position for thin?
View 4 RepliesFord F-150 (2009-2014) :: 2012 - Airbag Light Flashes On Once Ignition Is At On Position Then Turns Off
I've got a bit of a weird problem with my 2012 F150 XLT Supercab w/ 5.0 and 4x4. My airbag light flashes on once ignition is in the "ON" position then turns off and back on making it code 1-1 I believe but, I cannot for the life of me, find anything about this. Also, for some reason it only happens when it's above 66 degrees outside, the temperature barely gets above that until this time of year and as soon as I take it anywhere they pull it into their shop, which is cooler than outside, and the code disappears. I would like to see if I can solve this first without doing taking it to a dealer and have a huge bill. I checked all of the cables under the seats, the fuses, the battery and the airbag module under the center console and I cannot find anything that seems loose.
View 5 RepliesFord F-150 (2009-2014) :: Codes P0345 And P0349 - Camshaft Position Sensor Bank 2 Circulation Error / Interim
For 2009 and 2010 f150's with the 5.4L engine, this may apply to you.
About a month back I got some odd vibrations at start-up and while driving and the following codes:
P0345 - Camshaft Position Sensor, Bank 2 (drivers side), circulation error
P0349 - Camshaft position Sensor, Bank 2 (drivers side), circulation Interim.
These codes are common in the previous generation truck for various reasons. In my case, I started trying to troubleshoot with the easiest solutions first.
Checked the battery - fully charged.
Checked/played with the alternator connection and related wiring - looked good.
Checked the oil - it was down at the half mark on the dipstick, so toped it off with synthetic oil.
Cleared the codes, and now have been driving for a month, no issues, no codes!
If these codes come up for other folks, try the easiest on the list first, before bringing to the dealer... these codes can be really hard to solve, but sometimes we can get lucky.
Ford F-150 (2009-2014) :: Buttons On Center Console Gear Shifter?
Ive noticed while looking at online photos of the 2011 F150s, that on the FX4 and above trim levels, there are 2 sets of buttons on the center gear shifter. On mine, there is only one for tow/haul mode. I can make out in the pictures that its still there, but what is the other button?
View 10 RepliesFord F-150 (2004-2008) :: Shifter Stuck - Cannot Get The Truck To Shift Out Of Park Position
My son who is away at college, has a 04 F150 that has a center console and he can't get the truck to shift out of the 'Park' position. I told him to try and rock the truck back and forth and then try again...no luck.
View 1 RepliesPrius (Gen 2) :: Shifter Stays In D Position When Selected
Problem I am having with my '04, my shifter stays in the "D" position when selected. The previous owner said it did not use to do that when new, it does not do it when "R" or "B" are selected, so perhaps something inside is awry or something was spilled on it. I thought I may take it apart and clean/lube it.
View 6 RepliesGolf IV R32 :: Shifter Moves Depending On Throttle Position?
When I am in 6th gear (this only happens in 6th) the shifter kicks forward (towards the front of the car) about a quarter inch when I let off of the gas. When I press the gas again the shifter kicks back (towards the back of the car) a quarter inch.
I believe that this is caused by the haldex disengaging, because no matter how slowly I let off of the throttle, the kick is the same strength (or force? dont really know how to describe it). I was wondering if this is normal, or if I should get it checked out?
When I searched the only thing that came up was checking the mounts. I'm not sure this is the solution to my problem since this ONLY happens when I am in 6th gear, all other gears feel solid.
Ford Excursion :: Ignition Switch Stuck In Off Position
None of my 4 keys will operate my ignition switch.
It's stuck in off position. Steering wheel is not locked and I have pulled pretty hard on it to see if I could get the ignition switch to turn.
I have a new switch on the way but I have to get the old one out and don't know how to get old one out if I cannot turn the switch to on position.
Honda - Cr-v :: 2003 - Dome Light Works In On Position But Not In Auto Position With The Doors
In hooking up a overhead DVD player it shorted out the Controlled Ground (Delay)(DOOR) Wire, now the dome light works still in the ON position but not in the AUTO position with the doors. It is very frustrating of a night when getting out and can't see. I'm not sure if it is a relay or a module that has gone bad and where it would be located. I know it's not a fuse because I have already check for that and I've checked the Controlled Ground Wire before it went bad and after with a meter.
View 2 RepliesFord - F250 :: 1981 - Three Position Switch (off / Slow / Fast) Not Working
Three position switch (off/slow/fast) not working. Bought a new switch and have same problem. The SWITCH OFF position gives very slow wiper movement. The SWITCH SLOW and SWITCH FAST position work OK. The only way I can turn off wipers is to high-center the switch between positions. But it won't stay high-centered very long. Is this a wiper motor problem?
View 5 RepliesFord F-150 - 1997-2003 :: 2002 - Fan Selector Switch Actually Blow Any Air Only On High Position
2002 F150 XL... My heat & AC work fine, but the only position the fan selector switch will actually blow any air is on high. Bought an OEM replacement switch and installed it but the issue still exists.
View 4 RepliesFord Excursion :: 2001 - Door Ajar Switch Stuck In Open Position?
2001 excursion 4'4 V10 XLT.
One or more of my door switches is stuck in open position. Door ajar light on and interior lights on.
Interior lights stay on for about 15 min than go off.
I have sprayed all 4 doors and both rear hatch lock assemblies several times with WD40 and electrical cleaner with no improvement.
When I open drivers door there is no key chime with key in cylinder. Could the hood switch cause this issue? How do I determine which door/doors is/are the offending crimimals?
Ford F-150 (2004-2008) :: Switch 4 Wheel Drive To 4 Low Position - Not Shifting Into 4 High Or Low?
I made a big mistake, I was cleaning out my truck and accidentally switched my 4 wheel drive to the 4 low position. Not knowing this I started the truck and just drove it all day. Then I noticed my mistake and now the truck will not shift into either 4 high or 4 low!
The truck drives just fine, I feel no pull when I turn to the left or right so it seems that it never did any shifting into 4 high or 4 low, so I'm looking for recommendations on maybe how to fix?
Nissan - Rogue :: 2008 - Shifter Will Not Go From Park To Drive Position After Car Started And Foot On Brake
I have a 2008 Nissan Rogue that is experiencing a shifter problem. The problem is that periodically the shifter will not go from the "park" position to the "drive" position after the car is started and your foot is on the brake. I have been able to drive the car by inserting a small screwdriver into the slot on the gear shift assembly to depress the switch that allows you to override the mechanism but as you can imagine that is tedious and what do you do if suddenly the screwdriver is lost - you go nowhere and you can't even get to store to buy another one because the car won't move!
I have had the car into the dealer twice now and they have been unable to correctly diagnose the shifter problem. They have said that it could be a failed solenoid that senses the brake pedal being depressed but so far that has checked out fine. They also thought that it may be a brake sensor and they asked me to keep an eye on the brake lights to see if they come on when the brake pedal is depressed and the lights do come on so they believe that is not an issue. They "repositioned" the shift assembly in the car center console thinking that it may be an improper position and they tightened it down into place but that has not corrected the problem either. They now tell me that the entire shift assembly needs to be replaced at a cost of $670.00 and I find that hard to believe let alone pay for!
The car has about 70,000 mile on it and it was recently in an accident that did deploy some side airbags and I am wondering too if the accident may have damaged the assembly in some way that caused the malfunction where the repairs may be covered by my insurance company. This has only started after the accident repairs were made and we never had a problem like this prior to that event.
Ford Excursion :: Keeping Front Hubs Locked And Switch In 2wd Position For Everyday Driving?
Is it ok to keep my front hubs locked in and the switch in the 2wd position for everyday driving? Only reason I do it is because in auto it doesn't always go into 4wd.
View 11 RepliesFord Super Duty (1999-2016) :: 2003 - Second Position Of Blower Switch Does Not Work
I have an '03 F250 and the second position of the blower switch doesn't work. The first, third, and fourth are all fine.
I bought a Motorcraft YH-1670 blower switch, but can't figure out where it's located?
I looked behind the glove box, but didn't see it there. I did not remove the screws to the cover behind the glove box because I wanted to first confirm where the switch is located.
Ford Super Duty (1999-2016) :: 1993 F350 - Clutch Position Switch Fault?
I'm getting a random 'no start' fault which I think is related to a clutch position switch. The dealer tells me the clutch pivot bushing and master cylinder push rod are worn out, which is causing the switch not to close when the clutch pedal is depressed.
1993 F-350 7.3L Diesel 5 Spd 4x4, Std Cab, 8 Box.