Ford Ranger / B-Series :: 2000 - Turn Over But Won't Start Till Gas Pedal Pressed?
This has happened 4 times now over 2 weeks. The engine will turn over but will not start till I press the gas pedal. I have to keep the engine running for a few seconds by hold the gas pedal steady.After it's running you can cut the engine off and it will start right back up.
View 9 RepliesFord Ranger / B-Series :: Brake Light Quit Working / No Power To Switch At Pedal
What is the likely culprit? No other electrical issues, brake light quit working when brake is depressed, all other lights work including blinkers/running/head. Was going to break out a wiring diagram....
View 7 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 - No Voltage At Plug When Brake Pedal Pressed?
Installed Tekonsha P3 on my 2000 F350 I used the recommend pig tail easy hookup when I press brake pedal no voltage at plug but when I move the manual lever I get voltage. I believe the stop light switch activates it. The fuses all check out. I did have a Banks engine brake installed by their people I don't know if makes a difference
View 8 RepliesYaris/Scion & Vitz :: 2000 Echo Squealing While Driving Or In 2nd Gear And When Brake Pedal Pressed
The front end of my Toyota Echo has been squealing but only when it's either in drive or in 2nd gear and only when the brake pedal is pressed, once I release the brake pedal it only squeals for a few seconds then once the car moves faster than 5 miles an hour it goes away.. I completely replaced the suspension late last year. I just replaced the belt a few minutes ago and it still does this. I noticed that when the car is off and in park, when I shake the car forward and backward I hear a slight squeal coming from the front. I think it might be the engine mounts and or the transmission mount. What could it be?
View 12 RepliesFord - Ranger :: ABS Light Came On / Speedometer Quit Working And Trans Not Shifting Right
Recently the ABS light came on (truck does not have ABS), also speedometer quit working and trans was not shifting right. After a few minutes the problem went away.
View 4 RepliesFord Super Duty (1999-2016) :: 2001 - Speedometer Jump To 12 MPH While Stopped With Foot On The Brake?
2001 PSD ... Had speedometer jump 20 km's (12mph) while stopped with foot on the brake? This has been happening on my 2001 PSD intermittently for the last couple months.
View 1 RepliesHonda - Accord :: 1999 - Engine Dies When Pedal Pressed Down / Revs And Then Quits When Pedal Is Pressed Slowly
Ok, did an intake manifold cleaning on my 99 Accord the other day, and now I have problems...
Long story short, some time ago my car started to have a very rough idle. Took me awhile to find the problem. Turned out the air hose, between the filter and throttle body, had developed a big hole on the underside. So I replaced it and while I was at it used some throttle body cleaner, spraying into the intake manifold chamber. Lot of junk blew out the tailpipe. The car ran much better, but the idle could still be a little rough. I ran it that way for awhile, and finally the other day decided there was probably still some junk in there and it was time to really clean it out. So I took ff the throttle body and intake manifold housing. There was a lot of junk in there! The small intake on the passenger side was completely clogged shut. (I understand this isn't surprising on these cars.) I used a bunch of rags and 2 cans of Valvoline throttle body cleaner and a lot of elbow grease and cleaned it out. I was thinking to myself that whatever I didn't get with the rags flushed through OK, but I didn't want to take the whole intake manifold out.
So I put it all back together. (I took a video before I started, so I'm pretty sure it's all back together right.) But now I have problems. The car starts. It idles fine mostly, but can be a bit rough. But the trouble starts when I put the pedal down. If I do it in Park, well, if I push it quick the engine just dies. If I push it slow, the engine revs then quits, revs and quits, over and over. Similar if it's in gear. If I push it hard, the engine stalls. If I push it gentle, it revs up, but chugs along a bit.
I've run some seafoam through it, thinking it was clogged up with all that junk, and sure enough, lots of smoke comes out, but nothing is improving so far. What have I done wrong?
Ford - Explorer :: Brake Pedal Vibrates When Pressed Down
When I press the pedal down the pedal vibrates and make an odd sound like errrrrrrrrrrrr best way I can explain it...
View 5 RepliesCherokee :: Passenger Side Brake Light Won't Engage When Brake Pedal Pressed
I own a 04 Grand Cherokee and have recently had problems with my passenger side brake light. Now the light itself does work under normal running light conditions, but when I go to press the brake pedal it doesn't engage the bright brake light. Drivers side works fine and so do all my other lights, I replaced the bulb to no avail, and am now currently looking into replacing the bulb socket.
View 1 RepliesFord Ranger / B-Series :: 2003 V6 - Squeal Sound Coming From Engine Compartment When Gas Pedal Pressed
Ok, my question is, when gas pedal is pressed half or more down-ward, a squeal sounding is coming from engine compartment. 2003 ranger v-6 3.0 flex....
View 1 RepliesFord - Escape :: Grinding Noise While Backing Out Of Driveway (downhill) And Pressed Brake Pedal
I have a 2008 Ford Escape, and today I noticed that while backing out of my driveway (downhill) as I pressed the brake pedal it made this grinding noise, but when I got out of the car I looked through the tires and the rotors and pads were fine. I did not get a chance to check the inner side of the rotor or pad yet. What else could this noise be if it's not the brakes? It only makes this noise when I press the brake pedal which is why I thought it was the brakes.
View 3 RepliesFord Excursion :: 2000 - Hard Start - Clunking Noise When Pedal Pressed?
The vehicle is a 2000 Excursion 7.3 Diesel. I have never owned a diesel before....
First issue is that I have developed a hard start. It started last Saturday, and went from sporadically starting hard, to starting hard every time. I have 146,000 miles on her. She cranks strong, but will not turn over the first time, sometimes takes 2, 3, or 4 times. (Foot on gas pedal) I don't know if it's an issue of not getting enough fuel or what. Occasionally, even after she starts, it's very rough (shaking the whole vehicle, and acting like she wants to die) until I rev the engine and she smoothes out. After she smoothes out, there is no problem with wanting to drive, she's strong. If I kill the ignition, and start up immediately, she starts the first time, it's only after 10 minutes or so of being off.
My next issue is a clunking noise when I press the gas pedal. I don't know if it's the tranny, because she shifts pretty smooth for the most part, doesn't miss gears, etc. I could be travelling say 50MPH, press the gas pedal very little, and I can hear the clunking, and actually feel it every time I press it. (Don't have to be mashing the pedal, happens on very light presses as well).
I have the TS Performance 6 position chip, otherwise she's stock. I tow roughly a 7000 travel trailer every couple of weeks, never any problems before this.
Ford Super Duty (1999-2016) :: F250 - Brake Lights Don't Work / Power Going Out When Pedal Is Pressed
I'm having issue with my brake lights. Checked for voltage and nothing. Checked the fuses under the dash. Checked the brake pedal switch and have power going out when the pedal is pressed. Is there a relay or something somewhere else? 1999 f250 7.3 superduty....
View 2 RepliesPrius (Gen 3) :: Chirping Noise When Brake Pedal Pressed
I was wondering if this problem is the "Barking" noise that keeps coming up the search or is it another problem. I will include a link to the video down below.
To start off, the Prius is 2010 Prius II and has 120k miles on it. Great Car. Only other problem was AC compressor dying at 90k.
The chirping noise happens when the brake pedal is pressed and does not go away until the release the pedal. It makes the noise regardless of whether the car is on or off.
It makes the noise when the car is stopped and or when the mechanical brake engage at between 0 and 6 mph.
Noise does not occur when the brake switch is removed. Not valid solution since the brake lights will stay on. It does not affect the performance of braking.
Here is the link to the video .... .... ....
Prius C :: Brake Pedal Stuck / Not Going To The Bottom When Pressed
Today I faced another problem i just try to start my car but, due the dead 12v battery it didn't start so i pressed the BRAKE PEDAL until it reach the bottom, again i tried to press but its not going to the bottom why was that, is it due to dead battery? And last time i called an automobile expertise to jump start my car. They check the voltage with a digital multi-meter and he said me if you jump start even you will get this problem again until u replace the new battery. but i said him it doesn't matter do a jump start and finally it was ok . Now again I faced the same problem and this time i am going to change the battery.
View 1 RepliesAccent LC (2000-05) :: Speedometer Quit Working And Transmission Does Not Shift Out Of 1st While Driving
I have an 02 GS with automatic transmission. The speedometer quit working and now the transmission does not shift out of 1st while driving. CEL is on but I'm waiting for a friend to come over and get the codes. It shifts into drive and reverse fine but I'm wondering if there is a speed sensor in the speedometer that signals the tranny when to shift?
View 4 RepliesLexus LS 2007+ :: Starting Engine Without Brake Pedal Having To Be Pressed
Requiring that the brake pedal be depressed in order to start the engine can be a nuisance, say if the driver is out of the vehicle and the passenger wants to start the engine to run the A/C, etc.
There is a workaround though. Press the engine start switch once to go into ACC mode, then press and hold it for 15 seconds and the engine will start without the brake pedal having to be pressed.
Passat (B6) :: Brake Pedal Vibrates When Fully Pressed In Drive
When brake pedal is fully pressed and my car is in drive the pedal vibrates. The only thing I thought of is that my intake is touching something, but I don't see anything.
View 8 RepliesSubaru - Legacy :: 1996 Sometimes Will Not Start Unless Brake Pedal Is Pressed
Sometimes my 96 Subaru Legacy will not turnover unless the brake pedal is pressed. Other times starts without my foot on the pedal. It seems to need the brake pedal addition more often if it has sat a couple hours or more without being started.
View 5 Replies