Ford Super Duty (1999-2016) :: 2011 F250 Won't Shift Out Of Park / Brake Lights Do Not Work
My 2011 f250 is stuck in park and the brake lights do not work. I have changed the brake switch but still wont shift out of park.
View 4 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Tail / Brake / Back Up Lights Won't Work?
The flashers and blinkers work, the taillights, brake lights and back up lamps do not.
The truck is a 2004 F250 4x4... Checked all fuses. What am I missing?
Ford Super Duty (1999-2016) :: 2007 F250 - Third Brake Light Does Not Work - No Power To Socket
Checking out my 2007 gasser this weekend an found that my third brake light does not work....no power to the socket. The cargo lights on either side of it in the same assembly work fine so I believe the ground to be intact. My question is does this light have it's own fuse? if not where should I start looking for the solution to my problem?
View 1 RepliesFord Super Duty (1999-2016) :: 2002 F250 Brake Pedal Goes All The Way To The Floor
The other day I got in my truck and started down the driveway when I realized I had no brakes, I slowly backed up and parked it. I haven't driven the truck for approx. 2 weeks and it seemed fine then. The master cylinder is full, there are no signs of leakage from wheel cylinders or lines. Today I unscrewed the left front zert and no fluid came out. My pedal goes all the way to the floor.... Whats going on, and if its a easy fix?
View 14 RepliesFord Super Duty (1999-2016) :: 2004 F250 - No Brake Pedal Sinking
I don't know whats up with my new truck, its a 04 f250 scsb, 4x4, 5.4l with 61k orig miles on it. Truck will stop on a dime, has NO pedal sinking, but it takes about 3/4 of the pedals travel to apply pressure to the pads and have the truck stop, sometimes if I push the pedal down then let up and push it again the pedal wont travel as far, I just flushed the system today, no air in the lines, is there a bleeder on the abs? truck has 4 wheel abs...
View 14 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Brake Pedal Seems More Spongy Than Usual
I noticed last week that my brake pedal seemed more spongy than usual. The next day the pedal would go down about half way to the floor before I had pressure. And then the next day the pedal would go straight to the floor. Pedal comes back up once released. I still have brakes pressure about an inch before the pedal bottoms out. Its been like this a couple days now. The vaccum pump works fine. I'm gunna try bleeding the brakes on it tomorrow.
View 5 RepliesFord Super Duty (1999-2016) :: Brake Lights Would Come On When Slightly Touch Pedal
So, before I noticed a problem, all I had to do was a slight touch to the brake pedal, and the brake lights would come on. Now, they MAY just quickly flash and won't come on unless I really push hard on the pedal, such as at a complete stop.
I've noticed some issues with trying to lock-in 4W-LOW now too, and I know the brake pedal has to be pushed to engage 4W-LOW. Never had problems before now. 1999 F250 Superduty ...
Ford Super Duty (1999-2016) :: 2001 F250 - Dome Lights Work On Occasion
I have a 2001 f-250 that has dome lights that work on occasion. Mostly don't work. The inside dash dimmer won't turn them on. And they will sometimes work with the rear doors opening. Not the front(4 doors). The cargo light comes on all the time. So I don't know where to start chasing.
View 9 RepliesAccent MC (2006-11) :: Brake Lights Does Not Work When Pedal Pressed
Noticed when I press brake pedal brake lights does not work even the center one. Checked all fused in the car and the small ones under the hood. All fine. I have a long trip tomorrow. Where else i can look. Everything seems working. Reverse light is fine. Is that related to latest brake light switch recall? Cant think of anything else.
View 4 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Parking Lights Not Working After Electrical Work
2000 F-250 Super Duty
I was replacing my headlights, which required me to splice in their lights to my parking lights, and I seem to have shutdown ALL my parking lights. I did a test after twisting my wires together and everything worked fine. Then I soldered and heat shrunk them and somewhere during that process I lost all the parking lights.
I checked the 8th fuse as per the manual (for Parking Lamps) with a multimeter and it checked out just fine.
Figured it was the time to ask the experts on here where I should go from here. Are there some other fuses I could be missing, or maybe some else I could do?
Solved: Bad fuse in the #8 slot in the Power Distribution Box (under the hood, near Cab, driver's side)...
Ford Super Duty (1999-2016) :: 2003 F250 - Pedal Slowly Go To The Floor When Hold Down Brake For Long
I don't know what's going on maybe some body can shed a little light on this. If you hold the brake pedal down for a long period of time you can feel the pedal slowly go to the floor. So no problem I'll change the master cylinder bleed everything brand new fluid. Don't drive it much we let the sister in law drive it we'll I jump back into it the other day to go to Home Depot and once again I notice it still does it. Could the hydra brake booster be bleeding by or what's else could be causing this it's driving me insane. I really can't imagine the hydra booster causing a problem but it's new to me. I was thinking about bleeding the brakes again thinking there maybe there's air but I have run 2 bottles of brake fluid through how much more??
View 8 RepliesFord Super Duty (1999-2016) :: 2004 F250 - No Brake Lights?
I have an 04 F250 with no brake lights. However the third brake light works. I've also noticed that my trailer brake lights don't work either. I do have all my turn signals and running lights. Another issue that could be connected is I have one out of four hazard lights. When I push in the hazards my front passenger blinker works but none of the others. Could this all be due to a relay switch?
View 14 RepliesFord Super Duty (1999-2016) :: 2004 F250 - No Brake Lights
Bought an 04' F250, looked good but definitely not well maintained. Have replaced tranny temp sensor, thermostat, fuel filters, air filter.... Etc. heads have been redone and new studs installed , Egr delete, new oil cooler, flushed cooling system. Now tonight coming home noticed the brake lights aren't working, all 3 are out... fuses are good. I've heard multifunction switch or brake switch.....
View 12 RepliesFord Super Duty (1999-2016) :: 2012 F250 - Three LED Running Board Lights Does Not Work On Passenger Side
I just purchased a '12 f250 Lariat w/ 39k miles. When I got home I noticed one of the three LED running board lights does not work on the passenger side. Can I replace this myself?
View 6 RepliesFord Super Duty (1999-2016) :: 3rd Brake Light And Pedal Adjustment Switch Does Not Work - ABS Light On
Was checking fuses for why my 3rd brake light and pedal adjustment switch does not work. Was also looking for a fuse to tie into so that a light in the cab floorboard will stay on when the headlights or marker lights are on... After trying several spots to no avail (finally putting it into the bright headlight fuse). I got the light to work.... But now my ABS light stays on!!! Also 3rd brake still not working...
View 1 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Brake Lights Not Working?
I have a 2005 F250 that the brake lights are not working when brakes are applied. The rear blinkers and flashers are working. what could be my problem.
View 2 RepliesFord Super Duty (1999-2016) :: 2006 F350 - Brake Lights And Rear Turn Signals Don't Work
My sons 2006 F350 brake lights and rear turn signals quit working. When the headlights are on, all the lights operate but the rear turn signals and brake lights do not nor do the emergency flashers. The front signals work but flash very rapidly. Although I'm not an auto electrician, I'm fairly mechanically inclined but the fact that the front signals work, the rear don't and all lights work as lights, just not as turn signals or brake lights.
View 4 RepliesFord Super Duty (1999-2016) :: Fuse 13 Keeps Blowing - Brake Lights / Turn Signals And Hazards Don't Work
Every time I step on the brakes, there is a bright spark in fuse #13. My brake lights, turn signals and hazards don't work. At this point my truck isn't drivable.
According to the owner's manual in my truck, says circuit #13 is for "stop lamps, CHMSL/hazard, trailer tow stop lamp, and speed control."
I'm assuming that the hazard part covers the turn signals as well, but I know the cruise control works even when the fuse is blown. I used it last night on the way home (this was before I realized I didn't have brake lights).
So I know I have a short somewhere. The only mods I've done to the lights are aftermarket headlights, but if the fuse only gets blown when I step on the brakes, I don't see what that would have to do with it. Also, the lights have been installed and working for about a month before this started. The only thing that I did around the same time was install the gauges. I ran the power to them from #5, the customer access circuit.
Are there any other "common" areas for this to happen? I already removed the rear brake lights and it didn't work. I am quickly running out of 20A mini fuses.
Ford Super Duty (1999-2016) :: Jet Sound When Pressed The Pedal And Got Louder As Speed Increased
I have a 2004 Ford f-250 super duty 6.0 turbo diesel. I noticed yesterday that it was making a jet sound when i pressed the pedal and got louder as i increased the speed. When you let go of the pedal it goes away. I have asked around and some say it could be the turbo...the diesel mechanic THINKS it could be the fan clutch. The truck doesn't overheat and if i punch it i don't think i sense any loss of performance. All I know is that it makes this sound like a plane taking off.
View 14 Replies