Ford Wiring/Electrical :: Analog MLPS Neutral Safety Switch Shows Continuity In Neutral But Not In Park
I have a '94 E4OD trans in my '53 F100. It uses an analog MLPS for the gear selection indicator, Neutral Safety Switch, and Backup light.
My MLPS Neutral Safety Switch shows continuity in Neutral, but not in Park, I need to be able to energize the starter solenoid in both Park & Neutral.
Shouldn't the MLPS show continuity in both Park & Neutral?
Elantra MD (2010-15) :: 2012 GL Jerking Whenever Switch The Gear From Park To Drive Or Reverse / Neutral
I have an Elantra 2012 sedan GL and last year i tried installing HID's. It worked for a whole but then it stopped after. I learned that it wasn't getting enough power so then yesterday I bought a wiring kit to be able to wire my HID to tap to the battery to get more power. Everything was fine till I got to work but when I had to leave work., there was an issue. Whenever i switch the gear from park to drive or reverse or neutral. My car seems to jerk. And when I'm driving and it changes gears, it also jerks. Kind of the same thing how if your driving a manual car and you change gears wrong. This happens when my lights are off. But when i turn them on it then stops. And when i turn it back of it doesn't do it anymore.
View 5 RepliesFord Escape / Hybrid :: 2002 - Stumble At 1k RPM In Park And Neutral
So my buddy has a 2001 escape. It has a shudder at 1k rpm in park and neutral. It's not nearly as noticeable in drive. I scanned it for codes and there isn't one. Ran a power balance on ids and it's straight. Doesn't miss during the shudder either. Has all new coils and plugs. I cleaned IAC. MAF. Ran sea foam through the engine. And there is Lucas oil conditioner in the oil and Lucan fuel injector cleaner in the gas. It runs amazing other than that shudder. What could it be ?
View 1 RepliesFord - F150 :: Transmission Stuck In 4th Gear - How To Get Back Into Neutral
My manual transmission got stuck in 4th because of a melted oil trough sticking between the gears. I got all the plastic out, and the dog clutches/collars are "free." But, I don't know how to put the gears back into neutral. When it's reassembled, the stick doesn't work to change the gears. How can I get the gearbox back into neutral?
View 19 RepliesFord Transmission :: 2007 F150 Acts Like Gear Is In Neutral When Goes From 2nd Into 3rd
I have a 2007 F150 FX4 with 105K on it. When it goes from 2nd into 3rd, it acts like it's in neutral. There's nothing there. This is in "D" with "OD" on. If i turn OD off, it will wind up and grab 2nd again and will coast if I let off the gas. Also, if I manually shift into 2nd, it will engage 2nd and I'll have engine braking if I let off the gas.
The trans fluid was full and bright red as is should be with no burnt smell to it.
I dropped the pan and the magnet was a little fuzzy with some metal filings but there was no metal laying in the pan. I also dropped the valve body and there were no broken snap rings and the e-clip on the OD servo was intact. The valve body was also clear of anything that shouldn't be there. I'm hoping that I can replace the shift solenoid and that will solve my issues.
Ford - F150 :: 1989 - Idle Dies When Put In Neutral Or Gets Stuck At 2500 RPMs
I got an old 1989 F-150, manual, in-line 6 engine, with an 8-foot bed. I use it for hauling landscaping equipment, as i am starting a business. i will likely start hauling trailers with it this summer, but I also just want the engine to give me more power.
What are some things I could do to up the HP, or a better truck in general. I'm not looking to make it into a 350Hp monster, just get a little more out of it. What can I replace or add that would do this?
First, the idle dies on me when i put it in neutral, or gets stuck at 2500rpms. is this a vacuum leak, or the idle-air control valve?
Ford Transmission :: Extreme Grinding Noise In Neutral And Park
My Dad has a 01 f150 xtended cab 5.4 auto. Some of this info is second hand. He had driven it on a trip about 50 miles,when he started it to return he said it did not want to engage, put it in gear and nothing happened. Messed with it a bit and got it to go. was fine for about 30 miles or so. Then it started to make noise. I trailered it home and drove it a couple hundred yards to the shop. It sounds like a very large, very dry bearing, also seemed to catch/lock up then clunk.
With the wheels off the ground you can kick it into neutral and while the wheels are still rolling it quiets down. Also it does it sometimes while in neutral. When it is in park it sounds like stuff is still turning. At fist I thought wheel bearing or rear end until it made noise in neutral and park. The noise in park is not loud, just sounds like things are turning. It is full of fluid. The tranny has always worked flawlessly and still does even with the noise. Where to start looking? Transfer case?
Ford Excursion :: 2000 - High Idle In Park And Neutral
I'm trying to find out what I need to check or replace to get my 2000 Excursion to idle at normal rpm's in park and neutral.
View 11 RepliesFord Transmission :: 4r100 - Rattle Noise In Park And Neutral
I've got a 2001 E350 van with the 5.4 triton and 4R100 transmission in it. Has about 130,000 miles on it. I was doing some work under it a couple of days ago and noticed a rattling noise coming from the front of the bell housing. I can't hear it sitting in the vehicle or standing next to it but it's pretty scary sounding with my face under the inspection cover.
Shifting is smooth no noticeable problems there. Tranny fluid looks good, not burnt. After further investigation the noise is only present in park or neutral. In drive it goes away. In park it takes a few minutes of warm up for it to begin starting as a light tap tap, eventually working its way up to a clatter once warm. I know the 99 4r100 had some TC issues that sounded like this. It sounds like it's in front of the TC so I'm thinking the flex plate maybe?
Ford Transmission :: 1997 F150 4.2L V6 Stuck In Park
1997 Ford F150 4.2 liter V6 with Eod transmission. I have replaced the shift actuator, the brake switch, the ignition switch and tumbler, tightened all nuts and bolts on and around the steering column shifter, and had a mechanic replace the shift cable and go through the wiring from front to back. He couldn't figure out the problem.
I recently noticed while coming to a stop on a gravel road I touched the brakes and the front brakes locked up. I have anti-lock on this truck so is this normal and could this maybe be the problem with no brake lights and not coming out of park? Just for giggles I also had to come to a sudden stop in town on pavement a couple times and the tires locked up so hard I could smell rubber burning where the tires slid.
Ford :: 1998 - While Shifting Into Reverse From Park Or Neutral Engine Dies
My 1998 Ford Explorer XLT v6 with about 233,000 miles on it has a bit of a problem. Infrequently, when I shift into reverse from park or neutral the engine dies. It restarts without issue. There are no strange noises or smells when this happens.
The transmission was rebuilt 10,000 miles ago by a reputable mechanic. Almost all of the 230k+ miles are highway miles. Each trip around 40 miles.
Ford F-150 - 1997-2003 :: High Idle In Park / Neutral And Shifting
I have a '98 F150 4.2l with 230k miles on it. A couple of days ago when starting, I noticed that the engine kept racing instead of idling down like it normally does and the weather here in Arkansas has approached the 80 degree mark. The engine also doesn't idle down when shifting (I have a manual tranny). Where to start? I don't have any codes stored other than two for bank 1 and bank 2 running lean but they popped up many miles ago. I'm thinking either a vacuum leak or throttle control. I checked the operation of the cable and the throttle valve and they appear to be fine. Maybe the idle air control?
View 4 RepliesFord 6.0L Power Stroke Diesel :: Shaking When In Park / Neutral And At Idle
OK I know it's not a 6.0 or even a diesel. I had my Ford Expedition(2005) in to have rear main bearing seal, transfer case input shaft seal, etc, which included dropping the transmission. When we picked it up I noticed that it now shakes when in Park and Neutral when at idle. The shake cycles every 2 seconds or so, shakes for 2 seconds, smooths out for 2 seconds, shakes for 2 seconds, etc. There are no codes thrown, it runs smooth in gear running at interstate speeds and in town driving. They put the scanner on it, unbolted the transmission and re torqued them, and a bunch of other stuff. They are lost. I though maybe the torque converter wasn't in balance or something but they ruled that out.
View 1 RepliesFord - Explorer :: After Neutral Safety Switch Replacement Shift Alignment?
Daughters explorer sport trac, needed a neutral safety switch and a fuse ( no reverse lights),, I have replaced both but now the shifter doesn't line up right.
P is now reverse, and cant get all the way over to 1 with out holding it...
the two marks in the switch line up for neutral.... and switch is keyed to shaft...
how do i now re align this so shift indicator and transmission are on the same page again??
I am guessing move tranny arm all the way to the rear of the truck position and put shifter in P....then put cable back on arm.... but doesn't seem to work ....
Ford - F150 :: Rolls When In Park / Clicking Noise From Underneath
The other day I put my truck in park and it started to slowly roll, and while it did made a clicking noise from underneath, till it finally caught and stopped. About the same time, it would only start if I put the selector on N. This problem is not every time I start it maybe 30% of the time. It had been a few days since the rolling in park incident, but today I put the truck in part, it started rolling, again making a grinding noise, but it never stopped rolling. Had to use the E brake to get it to stay in place. On my drive home I turned the radio off and everything sounds good when shifting gears. If I have to start the truck with the selector in N no big deal, if I have to start using the E brake no big deal. But is this the start of some bigger transmission problem? My knowledge of vehicles only allows me to check the transmission fluid, and it was within the cross hatched lines.Truck is a 98 F-150, 6 cylinder, 60K miles. Not sure if I want to start putting large sums of money in this thing or consider an upgrade.
View 19 RepliesFord - Focus :: Engine Shuts Off When Shift To Neutral Or Park And Take Foot Off Of The Brake
I have a 2003 Ford Focus with the Zetec 2L, 16 valve. When the car is warm and I put it in neutral or park and take my foot off of the brake it will occasionally shut off. Not stall, but shut off - as though I turned the key. This doesn't happen every time; it usually doesn't. I have no other drivability problems and there are no warning lights or engine codes. The ideas I have are:
- Vacuum/ brake booster leak
- MAF problem or dirty throttle body
- Something weird going on with the transmission shift interlock mechanism.
Ford Transmission :: 1994 - Barely Engage - Grinding Noise In Park And Neutral?
I have a 1994 F-150 extended cab electronically activated 4x4, with the 302 V8 and an e4od transmission.
When the truck is running and it is in park or neutral it makes a grinding/whining noise and when it is in gear it doesn't engage, or occasionally will barely engage, but only enough to move it a little ways.
I've read a couple of post that suggested bad connections to the transmission could cause the transfer case to be in neutral which could cause a similar problem to this. I checked all the connection the best I could and the only thing I found that gave me any concern was one of the wires connected to the transfer case shift motor had some of the insulation melted or rubbed of and the wire was a bit corroded.
Is there any chance that this could be causing my overall problem with the truck not driving? Or what might be going on with it? Or any way I might be able to fix it without having to hand over a significant chunk of change for the full rebuild.
Ford Transmission :: 2007 E350 - Shudder When Accelerating In OD - Whine In Park / Neutral
Looking for your collective expertise
2007 E350 with 5.4L and 4R70W trans. 107K miles and the fluid has probably never been changed ( my mistake - thought it was 100K interval - finding out from my reading that is def not true ). Anyway, following is recent development (last couple days):
Symptom #1: In Park/Neutral there is a whine. As soon as you put it in P or N, the whine 'spins up', stabilizes, and does increase with engine RPM.
Symptom #2: Hesitation (albeit minor) when starting from stop in D and R, with _very_ minor shudder. Sometimes feels like it's struggling a bit to move its own weight just until it's rolling.
Symptom #3: Shudder when accelerating in OD. No shudder when I turn off OD. It does not stop when applying brakes (a test suggested elsewhere). Also, the shudder does not happen when applying gas while braked in D at standstill. Only at highway speeds (enough to be in OD).
This all started at the end of a trip (90 miles or so in 85-90 degrees) when I was pulling a utility trailer (maybe 2000 lbs loaded). Not sure if related, but traction control warning went off a couple times. I think I have a axle seal leak that may be triggering that.
Otherwise shifts fine (no change in shift behavior or smoothness). Things seem to be worse when it has heated up. Should I start with a fluid change? Wasn't sure because there are comments out there saying don't do it or the tranny will just fail faster (I am skeptical).
Ford Transmission :: 2006 F250 5R110W - No Reverse Drive In Park And Neutral?
I've got a 2006 F250 6.0 5R110W 4wd 220,000 miles It started getting a slight delay going into reverse and tow light flashing last week. all else functioning perfect Got a pending code P0700 and P0741 I stopped at NAPA when I was leaving no reverse checked every thing all was normal no leaks and fluid good color drove perfect in drive I got back to the shop [10 miles] put truck in park it was like its still in drive same with neutral, in reverse it wants to creep forward.
View 1 Replies