Golf IV / Jetta IV :: Shifter Got Stuck And Won't Budge Out Of 5th Gear?

I'm having an issue with my clutch and I'm really in a hole. Two days ago I was driving my car and everything was fine. Later in the day the shifter got stuck and would not budge out of 5th gear. Eventually it popped out. Driving like normal again and then yesterday I was on my way home from work and all hell broke loose. I was a mile away from my house and the car would not shift into any gear without a fight.

I also at this time lost my clutch pedal. It went really soft but did come back up.. it would not engage however. Limped it the rest of the way home and took a look at it. What I came across was a full brake/clutch reservoir, no leaks around the slave, and I didn't see any leaks around the master. I will say that after the car sat for about 10 mins the pedal felt normal again but quickly went soft after a few pumps.

2.0 AEG 5spd. Trans code DZQ if any of that would be relevant..

View 3 Replies

Ford Ranger / B-Series :: When Go From 4th To 5th Shifter Wouldn't Budge While Upshifting From A Stop

I have an 89 Ranger, 5 speed, 2wd, M50D transmission. On the way home tonight I was upshifting from a stop and when I went to go from 4th to 5th the shifter wouldn't budge. Luckily I was on a back road so I pulled off the road and tried all sorts of things (rolling truck while stopped, etc) and the shifter just will not budge.

Now here is the thing. I had my fiancé with me and no tools so I really couldn't do any diagnosing. However, 6 months ago I replaced the clutch, pressure plate, throwout bearing, slave cylinder, and pilot bearing. While I had the transmission out of the truck I changed the fluid, siliconed around the rubber plugs, and put a shift bushing kit in. The bushing kit is the bushings around the shift ball with new wave washers and new pins that insert into the ball.

It is obviously not related to the clutch as it engages/disengages properly. When this happened, there were no noises of any kind when I shifted from 3rd to 4th. It just will not come out of 4th. I am going to pull the shifter out tomorrow and have a look. Do you think one of the new pins that I drove in to hold the shift ball broke or fell out or something and if so would it cause this problem?

View 4 Replies

Ford 6.0L Power Stroke Diesel :: 2003 Excursion - Trans Would Not Budge In Any Gear

After doing some hunting/wheeling with my son, got back to town and 2003 Excursion w/ ~145K miles would not budge in any gear. No codes with Scangage. After 30 minutes I finally thought to rev it up and it shifted hard into gear, and drove normal home. What do do now?

View 4 Replies

Santa Fe (CM - 2007-12) :: Gear Shifter Very Difficult To Move When Put Car In Reverse

Here is what I have:

2009 Santa Fe 3.3L AWD
70k KMs / 43k Miles
Temp has been very cold, -20C / -4 F

Car starts up without any problems. Try to put car in Reverse and the shifter is very hard to move, if it moves at all. When I am able to get it into Reverse, I then try to put it in Drive and it does not "engage" the "D" and the car behaves like its in Neutral. Moving the shifter back to Park, Neutral, Drive is very difficult and sometimes it will not go into Park. The dash lights do not illuminate the selected P, R, N, D.

However, once the car is warmed up (no longer on C on the temperature gauge) I can with a little effort move the shifter freely (but more effort than it should take) and the car behaves normally. Gear shifts are smooth and in general it is operating normally.

The dash lights do illuminate the selected P, R, N, D. I've checked the Trans fluid level and it appears to be normal and was planning to change it this w-e but I'm no longer sure it will work. Even if it has never been changed.

Also note that I have recently changed a wheel/hub bearing due to a noise that sounds a lot like loud tires on a highway. The bearing change did not eliminate the noise and I assumed that I've changed the wrong one. The noise does not appear to be coming from the Trans, but I cant be 100% sure. The noise is speed related and occurs only after about 20KM/h 16MPH. Unsure if they are related..

View 3 Replies

Santa Fe (CM - 2007-12) :: Shifter / Gear Select Hard To Move

Got in to go to work this am, and the gear shifter was difficult to move. What to check?

I drove 70 miles to work and didn't seem like any issues with the transmission shifting.

Got in to go to lunch and it seems even more difficult to move...

Shifting back and forth in the selector seems to loosen things up a little.

A friend move the selector while I looked at the linkage and the bracket that support the cable is flexing while shifting between gears....More likely a transmission issue or something with the linkage?

View 24 Replies

Ford Ranger / B-Series :: Gear Shifter Does Not Go Into 1st Gear But Changes To Other Ones

I bought a 96 Ford Ranger XLT Supercab 4.0 on the 21st and the gear shifter doesn't go into 1st gear but changes to the other ones(see pic below) and was wondering if it's a easy fix.

Also I have a oil drip(at least it looks like oil to me) and I can't figure out where it's coming from because it's a small drip and the oil dipstick and tranny dipstick both show full and I can't figure out where the drip is coming from and I only noticed a dip on a metallic tank but don't know what that is either but check out the pic below to see the drip I circled.

View 3 Replies

Golf IV R32 :: Shifter Moving Slightly Side-to-side While In Gear - Shifter Cables Need Adjustment?

I recently changed the bushings and installed SS kit. I don't know if this was the case before, but now while in any gear, i can still move it approx half inch to the right and half inch to the left.

I checked everything and all screws are tight. Could it be that the shifter cables need adjustment?

View 24 Replies

Ford - Windstar :: Gear Shifter Does Not Engage Properly

Our cars shifter does not engage properly to Drive position. It comes down to D but the car just revs up or does not pick speed when we hit gas. we have to adjust/move it up and down to engage it. other position seems to be working fine. what could be the problem?

View 6 Replies

Ford F-150 - 1997-2003 :: Shifter Very Loose In Gear?

Okay, so I am not really sure where to post this. I have one of the weird 1999 F-250s that aren't a SD. The shifter is pretty loose, about 4-5 inches of play while in gear. Shifting isn't a problem, just the play in the shifter that I worry about. I have been trying to find rebuild kits, but can only find stuff for Rangers/Mazdas.

View 7 Replies

Ford Aerostar :: 1993 - Gear Shifter Broke?

I went to put the van in park, and the gear shifter just went all floppy in my hand. I was able to wiggle/jostle it around and get it into neutral or drive, but nothing else. Tow truck driver crawled under the van, and put it into drive for me, and told me it was probably just going to need a new cable or link shaft (tube shaped thing)... My hubby usually fixes these things, but is now living 1700 miles away.

Anyway, the shop called me and said I needed a new steering column, and said something about the 'lower' cap or half??? He quoted me $340 for the job. I am not getting the connection between the gear shifter being loose/floppy and the steering column needing to be replaced? Is this right?

It is a 1993 Aerostar, 3.0 by the way...

View 14 Replies

Ford F-150 - 1997-2003 :: 2002 - Unable To Put The Shifter Into Gear

It started with not being able to pull the shifter into gear...when started and no wipers, interior light, found a blown fuse, repaced it, all ok, blew fuse again, bigger fuse. It still works, now I have no high beams and cruise. 170,00kms....

View 1 Replies

Ford F-150 - 1997-2003 :: Overdrive Light Comes On When Put Shifter In Gear

I got a 1999 f150 if you put shifter in gear the overdrive light comes on. When you put it back in park the light goes out.

View 1 Replies

Ford F-150 (2009-2014) :: Buttons On Center Console Gear Shifter?

Ive noticed while looking at online photos of the 2011 F150s, that on the FX4 and above trim levels, there are 2 sets of buttons on the center gear shifter. On mine, there is only one for tow/haul mode. I can make out in the pictures that its still there, but what is the other button?

View 10 Replies

Ford Wiring/Electrical :: 2004 Truck Won't Go Into Any Gear / Shifter Will Not Move

My 2004 expedition wont go into any gear the shifter will not move I changed the stop light brake switch and a 30 amp buss fuse I found blown and also the check engine light is on now too this was after I parked it I also changed a 30 amp buss fuse I found blown out but it still don't work the only way I can get it into gear is to push the little button under steering wheel...

View 2 Replies

Ford Excursion :: Gauges Fuse Keep Blowing When Move Gear Shifter To Drive

My 2000 ford excursion gauges fuse keeps popping. It started earlier this year and I couldn't pin point when it would pop. Now I'm sure after 30.00 worth of fuses that it happens when I change the gear shifter from park or rev to drive.

View 5 Replies

Ford Excursion :: Reverse Lights And Back Up Alarm Will Not Engage - Gear Shifter Adjustment?

My reverse lights and back up alarm will not engage unless i hold up on the shifter while in reverse the only thing i found was a adjuster for the indicator....

View 14 Replies

Ford Super Duty (1999-2016) :: Gear Shifter Jammed In Park After Startup

I've been having an ongoing problem with the gear shifter jammed in park after startup. I changed the brake switch and installed a new ignition switch to try fix the problem. Later, I noticed the battery indicator gauge was flat lined even though the truck was running. Out of sheer frustration, I banged the bottom of the steering wheel and suddenly the battery indicator jumped to life and the truck went into gear again.

I took off the panel beneath the steering wheel off to look for any obvious loose wires but found none. This sounds strange but at first, the problem occurred more in the mornings when the weather was cold outside. No, it seems that the battery indicator will flat line while I'm driving in all weather conditions but jumps back up when I tap the steering wheel. I've included a video on youtube to illustrate the problem.

Youtube Video .....

2001 F250 Lariat Superduty 7.3Lm

View 2 Replies

Ford Super Duty (1999-2016) :: Hard To Start - Shifter On The Column Seemed To Have Some Play When In Gear

I started having a issue with getting my 00 f250 power stroke to start. It started out I could move around the gear shifter in park and get it start and today I had several times I had to put it in neutral to get it to crank. I did notice that my shifter on the column seemed to have some play when in gear but then again my 99 F250 V10 also has some free movement when in gear. Is there a neutral safety switch I could replace or any way to adjust the shifter?

View 14 Replies

Golf IV R32 :: Could Not Get The Shifter To Get Over To 1st Or 2nd Gear

So i was driving home from work yesterday and out of no where i couldnt get the shifter to get over to 1st or 2nd gear. i had to wiggle it around and push down on the shift knob and it eventually went over. Happened a few more times yesterday and like twice on my way to work today. It feels kind of sticky or something, not really moving as freely as it used to. What could be causing this?

View 6 Replies