Chevrolet - Corsica :: 1993 - Cylinder 4 Has No Spark?
A friend of mine has a 93 Corsica with the 2.2 liter engine. His #4 cylinder has no spark. #1 and #4 share a coil and #1 has spark. Also #2 and #3 are ok. He has replaced the coil for 1&4 and also the ignition control module but still only has spark on #1. The wires are new and test ok. How you can have spark on one side of a waste spark system?
View 1 RepliesHeadlights - Chevrolet - Blazer :: 1997 Chevy - No High Beams
I have a 97 chevy blazer, that has no headlights. the daytime running lights, dash and marker lights all work but not the headlights or high beams?
View 4 RepliesChevrolet - Silverado :: 1983 - Dash Cluster Lights Go Off When High Beams Are Turned Off
Vehicle: 1983 chevy c10
Here's the problem, when the high beams are on the dash cluster lights work fine,but when I turn the high beams off the dash cluster lights go off.Im going to buy a new high beam switch but what else might cause this problem?The truck has one of those metal button high beam switches that is mounted on the floor.
Chevrolet - Corsica :: Surge When Driving Around 30 MPH / Idles Rough And Stumbles When Starting From A Dead Stop
1989 Chevy Corsica has lower than spec fuel pressure, but exhibits no problems under heavy acceleration at highway speeds (passing), so I'm not sure it's a problem (yet). When cold, seems fine. As warms up, starts to surge somewhat when driving around 30MPH and idles rough and stumbles when starting from a dead stop. No blink codes (except code 12) and no check engine light. I suspect a sensor, but which one(s)? Low fuel pressure or bad sensor?
View 2 RepliesFord Super Duty (1999-2016) :: Truck Only Has Low Beams / No High Beams
My truck only has low beams. When you move the stalk on the colum backwords it changes nothing, when you move it forwards the low beams go out but the high beams do not come on.
View 14 RepliesChevrolet - Suburban :: 1994 - High Idle All The Time
I have a 94 C2500 suburban with a TBI 454BB. Obviously, I'm not concerned with fuel mileage, but I am currently getting about 4 miles to the gallon because the idle is stuck at 1800RPM. Normal idle for my model according to the index book is 750RPM. it's usually pretty close to that when operating normally (+/-25RPM). 3 days ago I did my biannual throttle body cleaning. Took it completely off replaced the gasket cleaned the throttle body and put it all back together. This is when the problem started... It now idles at 2300 RPM, it threw the code for bad idle air control valve, and I figured I probably got the plug wet when cleaning the throttle body, so I went ahead and ate the 60 bucks and replaced it.
Went through the reset process for the ECM to learn the new one and it the idle has come down to 1800RPM, it also literally DUMPING fuel through the injectors into the top of the throttle body. While I don't believe it is actually running rich, it seems more like the idle is trying to compensate for the excess fuel that is being dumped into the top end. Now, Before I go any further I want someone else's input. "I" think it is a also a bad throttle position sensor that probably got wet when cleaning the TB. But I am worried it could also be the PCM has finally gone out, although this is probably not likely because the entire ignition is run by this and if it was bad, it would stand to reason that it wouldn't run at all. Or it could be a bad vacuums control module. I have checked all my vacuum lines and do not have any leaks, so I know that isn't the problem. So that's where I am. I am hoping to check the leads on the TPS today with a ohm meter. I know my resistance levels.
Ford 7.3L Power Stroke (1999-2003) :: High Beams Only And No Low Beams After Installing New Headlight Bulbs
I have checked fuse 46 and 47, and installed new headlight bulbs. I have high beams, but no low beams. I have searched this topic but no one has the same prob it seems. My headlight switch has broken. Could it be the headlight switch?
In my manual, it says the 2002 has a fuse panel behind the glove box. I took glove box out but it doesn't look like a fuse panel.
Ford F-150 - 1997-2003 :: Low Beams Don't Work But High Beams Do
I recently installed new halo HID headlights in my 2003 f150 with HID bulbs and ballast the passenger side worked and the drivers side didn't nth lights wired exactly the same. I switched everything from the passenger to the drivers side still nothing I switched everything back to passenger side and they don't work now. I tired regular bulbs in the passenger side an it worked then on the drivers side and it worked for a split second and went out and then I retried t on the passenger side and it worked for a split second and went out a now neither are working. I checked all the fuses and their good. What the problem could be?
View 5 RepliesPrius (Gen 3) :: 2010 - Only High Beams Works / Low Beams Out
I have a 2010 prius the basic model I turned the lights and both headlights went out they only worked on high beams.
I changed the bulbs no luck they still only work on high beams checked fuses they looked good is there anything else I can check?
Golf IV / Jetta IV :: Low Beams Went Out / High Beams Functional
After spending weeks ordering parts and doing research on this issue all my attempts have not solved the issue. To reiterate the issue, the high beams work, and the low beams do not. Thus far I have attempted the following without the desired result-
1. Changed the headlights out just in case both bulbs burnt at once.
2. Changed the blinker stalk in hopes of a faulty switch.
3. Changed the headlight switch to a brand new OEM Euro style switch.
4. Checked all fuses (did this first actually).
Accent RB (2012+) :: Low Beams Stay On With High Beams
The other night on my way home, I flipped on the high beams and the low beams didn't shut off. Flash to pass still works, and pushing in on the end of the stem turns the low beams off as well.
Having the column switch apart, is it possible this could be fixed without having to pull the steering wheel? Or, am I better off just spending the hundred dollars of so and putting in a new part?
Ford Wiring/Electrical :: HID Low Beams But No High Beams
It ford related but I just bought a used car that has hid low beams and when you turn on high beams there is no light at all. The blue light on dash comes on and head lights go off. I just got this car 2 days ago and haven't really looked into it.
View 5 RepliesChevrolet - Beretta :: 1994 - Stalls In Hot Weather Due To High Heat And Humidity
I continue to have problems with my Chevy Beretta. The original problem was that -- after my neice's husband ran the car out of gas -- we had to replace the fuel filter. That was last spring. Afterward the car seemed to run fine until the weather got hot. Now it seems to stall generally in high heat and humidity.
I only paid $800 for the car, and my idea was to get everything fixed on it and drive it a while to get my money out of it. I don't want to go into debt for a car, and I don't want to buy another one (unless I have to). I travel a lot, but I don't need my car for work -- just for personal travel.
A local mechanic has changed the crankshaft position sensor and now the ignition module. I got the car out of the shop again yesterday, but the problem remains. I could barely drive it around the block this evening. The temperature is 73F, humidity is 84%, and dewpoint is 68.
Is this problem definitely weather related? What could be the cause? Vapor lock? An intermittent problem with the fuel pump, filters, or fuel injector? Is it possible to get this fixed for good?
Cavalier - Chevrolet :: 1994 Braking System - High Pitched Squeak Sound Comes From The Wheel
I have had this issue with the braking system for about a year now. Most of the time when using the brakes, everything works fine, but once in awhile, it seems like the brakes on one (I think one) wheel seem to just let go, apply full braking power, or both one after the other. When this happens, you hear loud clunking sounds (which I guess it the caliper going from on to full off and back again) and the rear of the car will raise and lower with the instances. There are also times when a high pitched squeak sound comes from the wheel (like when a bus uses their brakes) which will normally happen a second before coming to a full stop. It does not happen at the same time, but I think is related. Going off the sounds and rear of the car moving I tend to think this is focusing around the driver's rear tire. The brake fluid has been changed, the brakes have been changed on all 4 wheels, and so have the all brake lines to the cylinders. There are no leaks anywhere in the system. The car does have ABS.
View 13 RepliesGolf/GTI VII :: Fog Lights On With High Beams?
Didn't find anything on this, but I've noticed that on my GTI the Fog Lights stay on when the High Beams are turned on. Which I find unusual since no other car I've ever owned did this (Including my '12 TDI), and as far as I understood, in the US (At least here in NY), it was actually illegal to have them both on at the same time. ?
View 12 RepliesPassat (B6) :: No High Beams After HID Coding
I just had my car coded for aftermarket HIDs and i have no high beams and a bulb out indicator on. did i miss a step in the VAG coding or will the high beams work when i put the HIDs in?
View 6 RepliesPassat (B6) :: High Beams Are Not Working
I have a b6 Passat and the high beams are not working. I am going to be installing HIDS in the next week or so so I located a vag com disabled the drls and enabled Xenon without the shutter. now no high beams. they will only work with the car off and pull back the switch instead of pushing it forward.. I'm sure there are ppl on here with HIDs and there high beams working on a b6.
View 9 RepliesGolf/GTI VI :: Fogs Don't Go Off When High Beams On
I did some VAG COM work today. (Comfort Blinker, fogs as DRL, Needle Sweep, Auto Lock/Unlock, Remote Windows, Fogs as Corner lights, Fogs don't go off when high beams on). I am using a Hex- Can cable that is approx. 1 year old. These are the malfunctions I am getting with the VAG Com
01-Engine -- Status: Malfunction 0010
02-Auto Trans -- Status: OK 0000
03-ABS Brakes -- Status: OK 0000
04-Steering Angle -- Status: OK 0000
08-Auto HVAC -- Status: OK 0000
[Code] ....
Passat (B6) :: High Beams Don't Stay On
My regular beam light stopped working today. If i pull back on the high beams, both come on and work, however, if i push the lever forward to leave them on permanently, they don't come on at all. Is this because the regular bulb is out, or is something else wrong?
View 6 Replies