Chevrolet - Corsica :: 1994 - Cannot Get High Beams To Come On
I recently purchased a 1994 Chevy Corsica that is in excellent shape for the year with one exception. I can't get the high beams to come on. When I pull back on the turn signal lever, nothing happens. I know that most of them make a "click" noise when you pull on them, but this one doesn't. Is the high beam switch a part of the turn signal switch that is in the steering column? I am not sure what else to try.
View 4 RepliesChevrolet - Corsica :: Surge When Driving Around 30 MPH / Idles Rough And Stumbles When Starting From A Dead Stop
1989 Chevy Corsica has lower than spec fuel pressure, but exhibits no problems under heavy acceleration at highway speeds (passing), so I'm not sure it's a problem (yet). When cold, seems fine. As warms up, starts to surge somewhat when driving around 30MPH and idles rough and stumbles when starting from a dead stop. No blink codes (except code 12) and no check engine light. I suspect a sensor, but which one(s)? Low fuel pressure or bad sensor?
View 2 RepliesHonda - Accord :: 1993 - No Power / Act As Either Running Out Of Gas Or Has No Spark
I have a 1993 Honda Accord(4cyl) w/ 257,000 miles and I have a problem. When driving, it will intermittently act as if it is either running out of gas or has no spark and sputter and putt and have no power. This will go on for a bit and at times when the engine is at lower RPM's or load it will run a bit longer; however, in the end it will die and I'll find myself on the side of the road. It will not start again. I can crank it until the battery dies. The really confusing thing is that after it sits for anywhere from 2 hrs to a day, it will start up and run again for a week or two or a couple hundred miles. I have replaced the fuel pump, fuel filter, ignitor, distributor cap and rotor(not the whole distributor), coil and wires, checked and replaced all fuses.
View 4 RepliesJeep - Grandcherokee :: 1993 Won't Start / No Spark To Injectors
I have a jeep grand cherokee 1993 that wont start. I have no spark to injectors. I have change the coil, pcm, rotor, cap, pick up coil, starter, alternator, fly wheel sensor, relayes, wires, fuel pump. I don't know what else to do i need to get it running so I can get rid of it.
View 9 RepliesMetro :: 1993 - Engine Cranks With Spark But Won't Start
This Geo Metro 3 cyl engine cranks with spark, but won't start. I replaced the fuel pump, fuel filter and fuel pump relay. The fuel pump does not make a noise. What could it be?
View 12 RepliesDodge - Dakota :: 1993 - Cranking Strong / Getting Spark But Won't Start After Cold Snap
I've got a '93 Dakota that wouldn't start this morning after a cold snap, it used to fit just fine in any temp. It's cranking strong, can smell gas, and it's getting spark (used an inline tester). Battery had a full charge. Lay night the windchill got down to -40 Fahrenheit.
View 4 RepliesFord Ranger / B-Series :: 1993 - No Spark / Rotor Button Broke While Driving?
Checked icm and is good, replaced coil and still no spark. Issues be gan when about 700 miles ago rotor button broke while driving??? Replaced button cap wires and plugs. Engine fired right up. Ran 700 miles and rotor button broke for 2nd time. This time replaced and will turn over but not crank. That's when I checked icm and changed coil. what should i check now?? 1993 Ranger 3.0 ... Truck has 199,800 miles. Top end was redone at 140,000.
View 10 RepliesCamry :: 2002 XLE - No Spark On Cylinder 2 And 4
I recently changed my timing chain on my 2002 Camry XLE and now it won't start. I have done this twice before on different camrys but it is the first time this happens. I don't have spark on cyl 2 and 4. I checked all connections from the ignition coils to the ECM, no opens or shorts. All ignition grounds are good also. I check the continuity from the Crank and Cam sensors to the ECM and they are good. The timing chain was put in like the repair manual says. There is fuel pressure and good battery voltage so I am now stuck.
View 11 RepliesDodge - Ram :: 1993 Van Misfire On 6th Cylinder When Warmed Up
I have a 1993 dodge ram 15 passenger van. When it is cold, it runs fine, but after it warms up it starts to miss on the 6th cylinder. We have checked the plug and wires. Did not get anywhere. We replaced the injector. No dice.
View 8 RepliesCelica :: 1996 GT Won't Start - No Spark On Any Cylinder
This has the 2.2 engine with the ignition coil mounted on the firewall, not inside the distributor.
Original not start condition seemed to be fuel related because it tried to sputter on time after it died in the middle of the intersection.
Changed fuel filter, primed and no start.
Checked for spark at the plug wire using a solid wire and touching a ground - no spark on any cylinder.
Tested for voltage at the center distributor cap - have 12 volts - replaced distributor - no spark
Replace ignition coil and ignitor - no spark
The wires all test with the right ohms so I'm not sure what is left to replace.
Grand Prix :: 08 - Misfire And No Spark On Cylinder 6
Driving last night and my 08 died after searching I found the ICM fuse was blown. I replaced the fuse and now it has a misfire on cylinder 6. I have changed the coil with no luck. I replaced the plugs and wires about 2 weeks ago and I don't find any problem with the plug or wire. I checked at the coil and there is no spark at all on cylinder 6. I was thinking the ICM is bad but was wanting some opinions.
View 11 RepliesSanta FE SM (2001-06) :: Cranks But No Spark In Cylinder 1 And 4
I have a 2001 Hyundai Sante Fe that died on me while driving down my street. The engine sounded like it was loading up for about 1-2 seconds, then it died. It turns over but does not fire.
After a little troubleshooting, I have no spark in cylinders 1 and 4. I swapped the two coils thinking that I had a bad coil, but then the suspected bad coil created spark on the 2-3 cylinder side. So both coils work.
I towed the car to the shop and the mechanic after about 2 hours of billed labor, he is leaning toward a bad ecu. He said there also is no fuel metering from two of the fuel injectors. He checked the resistance on the injectors and said they are fine. He is thinking it is a control/command issue. The car has many other unrelated problems and I am not sure I want to spend too much more money on it.
I am skeptical about a bad ecu. Or sensors that may be causing my two cylinder no spark and alleged fuel problem?
SC/SL/SW :: 1999 Saturn Cylinder 1 Will Not Fire / It Has Spark To The End Of Plug
I have a 99 Saturn SL2/auto. Cylinder 1 will not fire. It has spark to the end of the plug. But the cylinder will not fire. No oil is getting on the plug it isn't fouling out. A brand new plug doesn't work at all. The cylinder is DEAD!
View 8 RepliesDodge :: Ram 2001 - Cylinder 4 Spark Plug Keeps Blowing
I have a 2001 Dodge Ram 1500 that I bought used a couple of years ago. About every 20k miles (120k miles on it now) I get a check engine light and upon diagnosis it's the 4th cylinder spark plug fouled out, every time. I change the spark plug, but the old ones are always identical in damage. The porcelain has cracked on the spark plug.
View 17 RepliesFord - Ranger :: Cylinder Misfire - Spark Plugs Keep Going Bad
I purchased a 2000 Ford Ranger last year. Within the first two months of ownership, the vehicle was having a cylinder 4 misfire. To fix it, I replaced the fuel filter, plugs, wires and cap - replacing the wires, plugs and cap fixed the issue. The issue went away for four months when cylinder 4 misfired again. I brought it to a repair shop and they again replaced the wires and plugs. The vehicle now has a cylinder 6 misfire.
There has to be something causing these plugs to continually go bad. Rather than just replacing the plugs again, I'd like to attempt to be proactive and fix the root of the issue. I've googled the issue and some of the forums seem to indicate a bad EGR valve.
Ford F-150 - 1997-2003 :: No Spark To Any Cylinder And Won't Start
I recently took a 4.6 from a 98 e-150 van and put in a 1997 f 150. put new oil pump, bearings, and rings. Got everything hooked up and ready to roll. turn over but no spark to any cyl. What it might be?
View 14 RepliesFord Ranger / B-Series :: 1993 - How To Replace Key Lock Cylinder
I am trying to replace the key lock cylinder (where you insert your key to start the truck) in my 93 Ranger. Using the Haynes manual, I have removed the steering wheel cover (I don't have airbags), pulled the steering wheel, removed the 3 plastic decorative shrouds and looked at a naked steering column assembly. The manual says there is a 1/8" hole on the bottom of the steering assembly where you can push up the actuator pin to release the lock cylinder assembly.
I looked and looked (even with a flashlight) and could not find a hole. I looked at the new key lock cylinder assembly and found the little actuator pin so I sorta know where the pin would be in the installed assembly. The entire key lock assembly is enshrouded (is that a word?) in the cast aluminum steering assembly.
There was a small metal plate - but that plate is just for access of the release of the steering wheel lock actuator (so I carefully bent it back!!). I know all this is for theft protection, but the truck is co safe I can't even replace the lock assembly.
Corolla :: Spark Plugs In Left Hand Cylinder Burning Up
I have been burning up spark plugs in the left hand cylinder (when facing the engine from the front). I have burnt up two plugs in a month in that cylinder. I have low compression in that cylinder and my oil consumption is high as well (1QT every 300 miles). My question is, is the oil fouling plugs and the oil consumption connected or is there other things I should look into?
View 2 RepliesPontiac - Grandprix :: 2004 - Cylinder 3 Misfire And Gas On Spark Plugs
Ok , i have a 2004 Pontiac Grand Prix GT V6 GM 3.8, my car didnt have any misfires until after i changed my Lower Intake Manifold Gaskets. After changing the gaskets and putting everything back together. The car ran fine. The next day i took it an hour and 30 min away, while driving there it started misfiring and shaking,rough idle at an hour into the trip. The check engine light went to blinking. The Next day i drove it all the way back home in the condition. Put code scanner to it, and received P0303 "Cylinder 3 Misfire":
So i automatically assumed it was the coil pack because i just installed new wires and plugs a week before changing Lower Intake manifold Gasket. Bought new coil pack. Still getting rough idle and P0303 code. So i decided to take a look at Cylinder 3 Spark plug and it was dry black, carbon fouled:
So went and bought new spark plug, installed it, started car and still rough idle and misfiring. Took the new spark plug out and it had been FOULED also ( DRY BLACK AGAIN). So i was told to switch a coil pack around. I did it and the started car, took away some of the rough idle, car actually wasn't misfring or shaking, would run smooth for about 5-8 seconds then start misfiring (Didn't that until i switch coil packs around).
Next Decided to pull out the rest of the plugs from the back and all of them were WET with GAS!! and 2 Spark plugs are just dry fouled!! (Cylinder 3, Cylinder 1). If I can figure this out i will fully have my car back to running correctly.