Toyota - Electrical-wiring - Corolla :: Dies For Few Seconds When Turn On High-beams After Driving For A While
I have a 2003 Toyota Corolla CE manual transmission with 431,000 (not a typo) miles on it. About 7 weeks ago I noticed that when I turn on my high-beams after driving for awhile, the car dies for a few seconds. All lights go out, radio stops, engine stops and then it starts up again as if nothing happened. It will just do it once in about a half-hour time frame. I can switch the high-beams on and off repeatedly afterwards and it doesn't do it again. I have to drive for about a half-hour before it will do it again. I usually hear a slight pop sound when it does it.
A month later I noticed that if I parked it after driving for awhile, like at a gas pump, and get back in it, it acts as if the battery is dead for a few seconds. If I step on the clutch or open and close the driver door, the car comes back on. It appears that the battery was disconnected. The CD pops out of the player and all the radio station settings are gone. One morning last week I got in, and it had happened during the night. The CD was out, station settings gone, and the clock was 6.5 hours off.
I have had the car to a Toyota repair center 3 times. They have checked fuses, battery, battery cables, grounds, alternator, tensioner, looked for rodent nests, squirrels and I don't know what-all, etc. They can't find what is wrong. I am scared to drive it, but I depend on it. I commute 200 miles/day. I won't leave anything important in the car because I am afraid it will catch fire. I am scared I am going to have a wreck, too, with no lights and no power steering suddenly.
Ford Wiring/Electrical :: Flashers Don't Work / High And Low Beams Work
2004. Hazards and brake lights work.
View 6 RepliesFord Super Duty (1999-2016) :: Truck Only Has Low Beams / No High Beams
My truck only has low beams. When you move the stalk on the colum backwords it changes nothing, when you move it forwards the low beams go out but the high beams do not come on.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: High Beams Only And No Low Beams After Installing New Headlight Bulbs
I have checked fuse 46 and 47, and installed new headlight bulbs. I have high beams, but no low beams. I have searched this topic but no one has the same prob it seems. My headlight switch has broken. Could it be the headlight switch?
In my manual, it says the 2002 has a fuse panel behind the glove box. I took glove box out but it doesn't look like a fuse panel.
Ford F-150 - 1997-2003 :: Low Beams Don't Work But High Beams Do
I recently installed new halo HID headlights in my 2003 f150 with HID bulbs and ballast the passenger side worked and the drivers side didn't nth lights wired exactly the same. I switched everything from the passenger to the drivers side still nothing I switched everything back to passenger side and they don't work now. I tired regular bulbs in the passenger side an it worked then on the drivers side and it worked for a split second and went out and then I retried t on the passenger side and it worked for a split second and went out a now neither are working. I checked all the fuses and their good. What the problem could be?
View 5 RepliesPrius (Gen 3) :: 2010 - Only High Beams Works / Low Beams Out
I have a 2010 prius the basic model I turned the lights and both headlights went out they only worked on high beams.
I changed the bulbs no luck they still only work on high beams checked fuses they looked good is there anything else I can check?
Golf IV / Jetta IV :: Low Beams Went Out / High Beams Functional
After spending weeks ordering parts and doing research on this issue all my attempts have not solved the issue. To reiterate the issue, the high beams work, and the low beams do not. Thus far I have attempted the following without the desired result-
1. Changed the headlights out just in case both bulbs burnt at once.
2. Changed the blinker stalk in hopes of a faulty switch.
3. Changed the headlight switch to a brand new OEM Euro style switch.
4. Checked all fuses (did this first actually).
Accent RB (2012+) :: Low Beams Stay On With High Beams
The other night on my way home, I flipped on the high beams and the low beams didn't shut off. Flash to pass still works, and pushing in on the end of the stem turns the low beams off as well.
Having the column switch apart, is it possible this could be fixed without having to pull the steering wheel? Or, am I better off just spending the hundred dollars of so and putting in a new part?
Ford F-150 (2009-2014) :: Interior Wiring - High Beams And Reverse Lights
For my 2013 with HID lights, I'm adding a light bar, and trying to find a good wire to tap into so I can wire in a relay to turn the light bar on with my high beams. As it's going to a relay, I originally thought to use a fuse tap, but the high beam fuse is always powered. Any other wire I can use in the cab?
I'm also looking for an in cab wire for the reverse lights I'm adding. I've been trying to make sense of the wiring diagrams online, but I am not having any success.
Ford 6.7L Power Stroke Diesel :: Wiring Some Light To Activate High Beams?
Just wiring up some light on the front and want to activate the relay off my high beams.. Where the best place to hook into... I'm running it off number 1 upfitter switch. But also want it connected to the high beam switch as well.
View 12 RepliesCamry :: Headlight Bulbs - 8000K In Low Beams And 3000K In Hi Beams
I want to replace my headlight bulbs; I want to install 8000K in my low beams, and maybe 3000K in my hi beams. But all of the bulbs that I ever installed either; A the burnt out within few weeks (lost color), or B they stopped working.
Now, regular WHITE bulbs seem to work forever; but the color ones, burn out/break. Low quality?? I need a pair of very good 9006 8000K, and 9005 3000K. Again, but I don't want to change them in a week or two. I want them to last!!
P.S. 2005 Toyota Camry
Ford Excursion :: 2000 - High Beams Not Working
Low beams work fine. When I push the Multi-Function lever on the column forward to activate the high beams, I have no lights at all. When it is in low beam (middle) position, low beams work fine. When I pull back for click to pass, only the low beams are active. No high beam indicator in instrument cluster. I have:
1. Replaced both headlight bulbs
2. Replaced the multi-function switch on the column. Checked test pins on switch (MF) they are hot when in either high beam position or click to pass position
3. checked fuses (interior)
#8 - power on both sides of fuse
#16 (15a) High beam headlamps, instrument cluster. ***NO POWER ON EITHER SIDE***
4. checked fuses (engine compartment)
#10 - power on both sides
#21 - Power on both sides
#23 - power on both sides of fuse
Ford - Explorer :: 1997 - High Beams Shut Down
97 Exp xlt 6 cyl --- While driving at night w/high beams on, all lights will go completely out. Turn light switch off and back on, then they will come on again. Where to start.
View 14 RepliesFord F-150 (2004-2008) :: Way To Run Fog Lights And High Beams Simultaneously?
Any way to run fogs and high beams same time?
View 9 RepliesFord F-150 (2004-2008) :: Flashers Don't Work But High And Low Beams Does?
I'm talking about the flash to pass feature, not turn signals.
View 2 RepliesFord Ranger / B-Series :: 2000 - No High Beams And Indicator?
I have no High Beams and the little blue light does not come on in the dash. I also do not have flash to pass. I searched through the older posts and found other similar problems but their dash indicator came on. I changed both bulbs this morning and checked the 2 fuses in the panel (#4 & 8 I believe.)
What to check next? I don't see how you would get the headlight switch out of the dash to change it, the fuse panel is directly behind it. Does it get moved to access the switch? Should I be looking at the dash on/off switch first or the column lo/hi/flash to pass switch?
Ford Ranger / B-Series :: 1998 - High Beams And Turn Signals Not Working
The turn signals and high beams do not work on my 1998 ford ranger xlt 4x4. I have replaced the multi function switch, the yellow flasher relay checked all fusses and all are good. What could be the problem?
View 7 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 - High Beams Won't Stay On
First time driving my 'new' 2000 7.3 Ex and the high beams won't stay on for more than a minute or two. Playing with the switch in the driveway, they came on after a minute of not being run, but after throwing the switch a few more times, they wouldn't come on again. The indicator light corresponds with the high beam function. I'm thinking a relay is going bad? The switch is brand new and the bulbs are definitely working. Also, I did not get an owners manual with the truck, and the fuse diagram I found online did not match the box at my left knee.
View 11 RepliesFord Super Duty (1999-2016) :: High And Low Beams At Same Time And Fog Lights
A good while back I seen a thread to do this , but can't locate it now. I have a 2012 F250 and looking to make my night time driving better ....... I want to run both low and high beams at the same time and getting the fog lamps to stay on when going from low to high beam.
View 14 Replies