Santa FE SM (2001-06) :: Fuel Pump Hums When Turn The Key To On / Cranks But Won't Spark
My Santa Fe quit running one day as I was driving. The fuel pump hums when I turn the key to on. The spark plugs look ok. One coil is not getting a spark. We replaced that coil and it still isn't sparking. The timing belt appears to be fine. I bought an OBD II reader, and it gave me the code for the camshaft position sensor. We replaced that today, but there is still no spark. I cleared the code and tried to start the car. There are no codes present so I am assuming I fixed the camshaft sensor issue. Next up on the list is to replace the wiring leading up to the ignition coil. I gave it a quick look over. It appears to be ok, but I might replace it anyway. The outer housing is cracked a little, but the car is 13 years old so I expect that. Before it died there was an awful sound coming from the engine. It sounded like a piston was rubbing/scraping. I am throwing that out there just in case it is related to my electrical issues. I have noticed other weird electrical issues as well. The middle brake light usually works, but sometimes it doesn't work and sometimes only part of it works.
View 4 RepliesDodge :: Ram 2001 - Cylinder 4 Spark Plug Keeps Blowing
I have a 2001 Dodge Ram 1500 that I bought used a couple of years ago. About every 20k miles (120k miles on it now) I get a check engine light and upon diagnosis it's the 4th cylinder spark plug fouled out, every time. I change the spark plug, but the old ones are always identical in damage. The porcelain has cracked on the spark plug.
View 17 RepliesFord F-150 - 1997-2003 :: 2001 4.6L V8 - Spark Plug Blown From Cylinder 3
My son has a 2001 F150 with a 4.6L V8 that's blown a sparkplug from # 3 cylinder. The plug looks as if struck by lightning and has a burn groove as deep as a kitchen match stem the full length of the threads.
How difficult is an engine swap/change using another 4.6L? Neither of us have extensive mechanical backgrounds but plenty of aptitude.
Santa FE SM (2001-06) :: 2.4L Doesn't Start And No Spark
2.4L. Starter cranks but engine doesn't start. Per other forums I have changed the crank sensor and cam sensor, spark plugs. No change. I went back and did Volt meter test on the new sensors: Crank sensor showed 13 volt on red wire, 0 and 5 volt while cranking on blue wire. Cam sensor had 13 volt on red wire and 13 volt on signal wire while cranking. Was expecting alternating 0-5 volt. Could I have a bad ECM?
View 2 RepliesSanta FE SM (2001-06) :: 2002 - No Spark At The Coils
I did a valve job on a 2002 Santa re 2.7 after I got it done and all back together I don't have and spark at the coils all of them are dead I'm sure the coils did go bad form sitting.
View 2 RepliesSanta FE SM (2001-06) :: AWD Cranks But Won't Start - No Codes
I have a 2006 Santa Fe with the 3.5l, AWD, 5 speed auto, and 65,000 miles. Its a daily drive. Out of the blue it won't start. It cranks, but it won't start. The battery is strong and it has 1/2 tank of gas. I figured my code reader would solve the mystery, but it's doesn't produce any error codes. With no codes I don't even know where to begin.
View 4 RepliesSanta FE SM (2001-06) :: Won't Start After Spark Plug Change
I somehow managed to kill my 04 Santa Fe 3.5 while doing the dreaded spark plug change and looking for pinpointing and rectifying the problem.
A quick rundown of the car... My mom bought her new in late 03, decided to get a BMW X3 a couple of years ago. I bought her with 65k miles. I just recently had the timing belt replaced by a reputable shop at 79k (yes I know I let it go too long.) I just hit 80k and decided it was also time to do the plugs as I had noticed a decrease in performance and gas mileage of late. Other than the recent dip in performance the car has been extremely reliable and has had no previous issues.
I researched as much as I could knowing that the 3.5 isn't the easiest engine to work on. I bought the recommended Champion plugs that came in the car from the factory as well as the oem Hyundai wires. I also replaced the plenum gasket.
I took my time replacing everything but despite my best efforts, I accidentally cracked the plastic on the radiator reaching over to the back bolts on the plenum. Other than that mishap, the only other issues was the #5 plug sticking which finally came loose after some begging and pleading to the car Gods. Unfortunately, my begging and pleading was enough for them to allow the car to start.
After reading a thread on here, I believe the problem is that I removed the TPS sensor to get to the bolts on the EGR valve, I know now that this was a big mistake. I checked and double checked every connector and can not find one that was missed or disconnected. The car would try to start but would not crank over. I was unable to get any OBD2 codes from my code scanner.
I decided to try a TB from a junkyard and swap it on to see if that was the issue. After swapping it on, the car started and ran like crap for about 15 seconds and stalled out. I was however able to pull some codes in this short time.
The codes I received are:
P0102: Mass Airflow Circuit Low Input.
P110 & P1172: ETS Improper Motor Current.
P1192: ETS Limp home - Target Follow Malfunction.
P2127: Throttle Pedal Position Sensor "E" Circuit. Accelerator Position Sensor 2 Voltage Too Low.
I'm not sure if these codes are left over from before I swapped out the TB or not. I reset the codes after I wrote them down and researched them to see if they reappeared but the car will not start again so I can't get the codes to reappear.
Santa FE SM (2001-06) :: 2004 - Hyundai Cranks Over But Won't Start
I have a 2004 Hyundai Santa Fe 2.4 L. Front wheel drive. Cranks over won't start, replaced crankshaft sensor & camshaft sensor, no spark. Where do I go from here?
View 1 RepliesSanta FE SM (2001-06) :: 2004 - No Spark / Strong Smell After Cranking
I bought a 2004 Santa fe with the 2.4 engine not running. It will not get spark, it is getting fuel I can smell it strong after cranking...It has a new crank position sensor, I took the timing cover off to verify. Whoever put the sensor on cut the wires and soldered/ heat shrink them back together obviously because they didn't want to remove the timing belt. It Also it has a new ignition failure sensor, all fuses are good, there was a spare computer in the vehicle which I tried still no luck. I took loom off and looked at the harness and can't find anything.
View 8 RepliesSanta FE SM (2001-06) :: 2002 2.4 Model Cuts Out And Won't Start - No Spark
I am new here just bought a santa fe 2002 2.4 model and its playing up it will start run for a few mins then die and wont start again for a while. the crank sensor has been renewed as has the cam position sensor the fuel pump makes the normal noise so fuel is getting threw the only other symptom is when it cuts out and wont start i check both ignition coils and neither are sparking yet there is power to both, all fuses are fine .
View 21 RepliesSanta FE SM (2001-06) :: No Power When Pulled Into Gas Station / Cranks But No Fire
Here is what happened. Pulled into gas station and car just died. Tried to restart and no fire. Cranks but no fire. Flat bed trip home and started to diagnose. Thought it was a bad fuel pump so I pulled and tested with a direct power and functions fine. Checked all fuses and relays, all seemed fine. checked for power at pump and nothing. Reset cut off switch and still nothing. Thought maybe ECM relay in the under hood fuse box was bad I borrowed the one out of a friends car. Nothing. Thinking ECM was bad put theirs in my car and got power to pump. So I put their car back together thinking mine was the ECM, then theirs won't start. The ECM relay i took from there car and put in mine blew when i tried to start my car. Got another ECM for my car and put in. Still no power at the pump. Here is the info about the car. 2001 Santa fe 2.4L auto. 80,000 miles. Timing belt, tensioner and all Idler wheels changed along with water pump at 71,000 miles. This car has been very reliable up till this point. No check engine light came on at any time..
View 8 RepliesSanta FE SM (2001-06) :: 2004 2.4L - Stalled / Engine Cranks But Will Not Turn Over
2004 2.4L Sante Fe Base model. Car stalled out the other night, engine cranks but wont turn over. I have it towed to mechanic who tells me that the ECU is fried and they cant get any diagnostic done, that only a hyundai service can do this. I have it towed to service. Service tells me that they cant get a diagnostic done without a working ECU and that for the ECU alone. Then they could figure out what was going on with the car. The service also told me that the ECU isn't something that you can just go get at a scrapyard because it is specific to the VIN on my car. It just didn't sound right to me but I might be wrong.
View 7 RepliesSanta FE SM (2001-06) :: Slow Acceleration And Rough Idle After Spark Plugs Changed
Here's the run down:
-bought 6 months ago for cheap because it wouldn't pass smog test
-changed Purge Control Valve (PCV) and it passed
-filled with gas, heard popping noises like a backfire, and coded it read the same "Bank 1 and Bank 2 running lean, like it did before the PCV and then also "Cylinder 3 Misfire" appeared.
-At this point the car started running rough, at idle, and through acceleration...sputtering uphill, and when climbing through the gears.
-Changed the plugs & wires
-NOW, it's cylinder 5 misfiring, and not nearly as bad. It's idling and running rough, acceleration has somewhat come back, but it's definitely not 100%.
Should I start with the PCV again, since it's not starting after I fill the tank, and climbing gears slow? Is there anything else I should be checking?
Santa FE SM (2001-06) :: 2005 - P0113 Code After Spark Plugs And Coils Replacement
Just replaced the spark plugs and coils yesterday, today it gives P0113 code, Intake air temperature (IAT) sensor - high input Wiring open circuit/short to positive, ground wire defective, IAT sensor, ECM...
View 3 RepliesSanta FE SM (2001-06) :: Misfire In Cylinder 3 And 6
I am trying to fix my friend's 03 Santa Fe 2.7L with 325K miles on it. Pulled the codes and he has misfire in #3, 6 and a random one. It doesn't do it all the time, and when it does do it he can sometimes shut it off and restart it and it will be fine.
What is the likely culprit causing the misfires and how to test it? He can't just throw parts at it.
Santa FE SM (2001-06) :: Strange Spark Noise Coming From Power Steering Belt Region
I have a 2003 Santa Fe, 2.4L.
Last night, I added some power steering stop leak to my PS system, but I accidentally spilled some below the reservoir. Soon after, that area of the engine starting making a consistent "spark"-type noise. I think it has something to do with the belt, because when I turn on AC, the noise gets a little faster in rhythm.
I say "spark" noise because it sounds like an electrical spark, rather than clicking or whining.
Santa FE SM (2001-06) :: Engine Misfire In Cylinder 1 And 4
2002 Hyundai Santa Fe 2wd 2.7L 175,000 miles
Having misfire in #1 &4, new plugs, new wires, new coils, new cam and crank sensors, cleaned and tested fuel injectors, checked injector signal, checked timing belt.
Swapped around plugs, wires and injectors(keeping same firing order) and the # 1 & 4 will not fire. There is spark to the wires and plugs and gas thru injectors but no detonation.
With plenum and exhaust manifold removed (front only) visually checked valves. Installed new oxygen sensors while exhaust was out. Tested ecu fuses in black relay box in engine compartment.
Engine stars first time ,every time but only runs on 4 cylinders. Check engine light code reads no 4 cylinder misfire.
Santa FE SM (2001-06) :: 2004 / 3.5L - Cylinder 1 Location
Where cylinder 1 is located on my 3.5l v6 santa fe. I am replacing the heads and need to know.
View 2 RepliesSanta FE SM (2001-06) :: 2005 - Ticking Noise / Blue Spark Occurring At Random Intervals On The Balancer
2005, 2.7l. FWD automatic, with 180,000+ miles.
A week ago it started making a random ticking noise I've never heard before. Today was the first chance I got to try and find it and I'm stumped on what could cause this.
The sound is a static or low voltage electrical discharge coming off the harmonic balancer. I can actually see the blue spark occurring at random intervals and locations on the balancer as the car is running.
Do i need to be looking for a bad engine ground? I'm having no other electrical problems. The car runs like a champ other than a minor oil and power steering fluid leak.