Ford 6.0L Power Stroke Diesel :: Solenoid Stuck / Transmission Not Shifting Out Of Second Gear
Transmission was not shifting out of second gear set a code stuck solenoid cleared code seems to be working now....
View 4 RepliesFord F-150 - 1997-2003 :: 2000 - Bad Starter Solenoid Relay?
My truck has started fine every time I've turned the key except for last night after work. I got in had all the lights on the dash and dome lights. I turned the key and nothing. Not even a click. Hooked it up to a company truck and it fired right up and ran fine. Drove home shut off and then started it a little later and it started fine. Then this morning it wouldn't start. I hooked up the jump pack and still nothing. I drove my fusion to work and when I got home I went out and it fired right up like nothing happened. Does the work sometimes not work other times sound like the solenoid on the firewall? 2000 4x4 4.6 auto 253k miles
View 4 RepliesVolvo - 240 :: 1989 - Changed Battery And Cleaned All Terminals Still Not Charging?
Installed new alternator cleaned terminals car started charging one week later battery died changed battery cleaned all grounds going to battery checked all connections coming from battery to alternator car is still not charging what should i look at next?
View 1 RepliesVolvo - S80 :: 1999 Turbo 2.8L - Cooling Fan Relay Bad
My 1999 Volvo has been diagnosed by a Volvo dealer to have a bad "cooling fan relay". Another shop analysis states the "cooling motor fan assembly module" is the problem. Are these one in the same? Can I replace it with one from the salvage yard? Are there any bad omens with messing up other electronic components If I make the repair myself?
View 9 RepliesVolvo :: 1986 740 - Brake Lamp Failure Relay
After fixing no brake lights on my 86' 740 I still can't get the inner ones to work. To fix the problem I changed the brake lamp failure relay. The bulbs are good. The relay was used.
View 1 RepliesSonata NF (2006-10) :: Shifting Rough Intermittently - Changed Fluid
I drive an 06 Sonata with the 2.4L. I have put about 25,000 miles on the car and since then I have changed the tranny fluid 3 times due to it shifting rough. I will change the fluid and it will shift smooth for about 2 or 3 months then it will start to shift roughly again. What I could do or what the problem could be?
View 3 RepliesVolvo :: Fuse Panel Removal To Change The Socket In Relay
I have access to the fuse panel but I need to remove the panel to reach the relays. I need to change the socket in the relay panel because one is burnt out. I change the K(headlight)relay and when my car is off and key out of the ignition my lights are still on.
View 10 RepliesVolvo :: Electric Fuel Pump Relay Quit Intermittently?
i have had this problem before where the relay for the electric fuel pump would quit intermittently, and had it fixed. but, i suspect this is acting up again. so, i was gonna do it myself. there are 2 relays strapped to the radiator overflow can. is one of them the relay i am seeking?
What started all this, motor was running really rough at idle, but ran ok once moving. So, I replaced the spark plugs, and cleaned the contact areas in/on the cap and bug. motor started right up, and actually sounded good... for about 10 or so seconds, then it died, like the gas was shut off. I do have spark.
How to check/test the fuel pump relay and could pass this info on to me would be good. i do have test light, and DMM.
Montana :: 1997 Venture - No 3rd Gear After Shift Solenoid Replacement
97 Venture, 4T60e trans, 197,000 mi. No shift or performance problems ever, solid as a rock. Well taken care of. Then a few months back it throws a P0758 code for Shift Solenoid B, and intermittently seems stuck in 3rd or 4th gear when starting from a stop. Wife drives w/ kids so immediately I park it to investigate and drive it myself and observe. Problem would happen usually after warming up and driving a couple miles, but would sometimes go away after shutting it off for a bit and going again.
After lots of research I decided it was probably a stuck solenoid and tried Sea Foam Trans Tune to see if it would clean it up, and it WORKED! For about 4 weeks that is, then came back. So I took the proper time and steps to replace both shift solenoids myself, and of course the fluid & filter (since you have to drain it to open the side cover anyway). My work is meticulous and clean, so I know nothing was done shoddy.
When removing shift solenoid A, however, a spring-loaded spool came partway out of that port in the valve body, didn't fall out, and I pushed it back in with the new solenoid. Everything else went back together flawlessly. On the first drive, it shifted to 1st as expected so all seemed well. Then after a several miles of driving I noticed something felt wrong - it was skipping 3rd gear altogether (1-2-4), and it would NOT downshift from 4th to 3rd. However if shifter was in "3" it would shift from 2nd to 3rd just fine, then I could put it in "D" and would hit 4th, but could only downshift to 3rd manually.
I am stumped, and it's been parked for months because something in the solenoid change has caused a major problem. I don't believe it could be mechanical gear/clutch failure as it shifts to 3rd w/ shifter in "3", and there was never a mechanical problem before. And it also still intermittently starts out in a high gear though quite seldom (3rd or 4th, not sure which but it barely moves) but putting shifter in "2" or "1" makes it start in 2nd. And never a SES light. Checked solenoid resistance at trans connector and they're perfect.
Tranny shop checked computer and said it's good, and also said "it's shifting just fine" which is absolutely not true. So much for a "free" diagnostic check... Could I have just gotten a bad solenoid? Could the spring-loaded spool that came part way out gotten hung up or the spring not reseated properly? Could it be the vacuum modulator (it got slightly bent upward when lowering engine)?
Lexus GS 2006-11 :: Gear Won't Shift Past Third - Code P0751 Stuck Solenoid
I bought the car with 117k and never since my possession bothered to service it. Why? I kept putting it off well at 165k I said heck ill do it. Currently at 170k my gear wont shift past third and its reoccurring almost daily. When I first bought it it was intermittent. I think the late service messed it up. Here's the thing, aamco will open up my pan and look at my solenoids which is 250ish.
View 14 RepliesElantra XD (2001-06) :: Stuck In 3rd Gear - Code P0760 And P0755 / Malfunction Shift Solenoid B And C
I have two codes P0760 and P0755, malfunction shift solenoid B and C, today I took it to Hyundai here in queens ny, I was told that It would cost e 2684.00 to fix my issue, I can't believe that if those two codes are the problem why would it cost 2684.00 ? Where are these solenoids located?
The car feels like your one of the flintstones, it's stuck in 3rd gear and cant get out, then it jerks when it tries to shift, tranny oil is fine not burnt like if the clutches are gone.
Elantra XD (2001-06) :: Transmission Is Shifting Into Higher Gear Without Releasing The Lower Gear
My 2006 Elantra (54,000 miles) shifts really, really hard when it's not cold and passes through the 35 mph range -- hard enough to make you glad you've got your seatbelt on. I've taken it to my regular mechanic and now it's in an automatic transmission shop.
My mechanic changed the fluid (twice), and took it through a "learning sequence". The fluid didn't look that bad and he reported that there were no codes to work with. He thinks I'm going to have to get a new transmission.
The AT shop has confirmed that there are no codes to work with and that the problem begins at 143 degrees. They tell me that the transmission is shifting into a higher gear without releasing the lower gear. They tried replacing a couple of solenoids, but that yielded no change in behavior. Now, they're telling me they "think" I need a new computer. I'm just afraid the trial & error approach is going to cost me a boat-load.
Golf IV R32 :: Shifting Noise Too Loud From Gear To Gear?
Shifter seem like it is way too loud going from gear to gear? Just holding in the clutch and rowing from gear to gear...seems way too loud, Seriously sounds like shifting gears in my old 5.0 mustang.
View 1 RepliesVolvo - 240 :: 1991 - Transmission Suddenly Stopped Shifting Out Of First
My 1991 Volvo 240 with automatic transmission suddenly stopped shifting out of first. No warning. Fluid level is good.
View 4 RepliesFord Excursion :: Nail In Tire - Idling High - Gear Hard When Changed
Took the wife to work today, she has a big nail in her tire. The X started idling high at red lights, right before I dropped her off, It didn't want to change gears until about 3200 rpms. And change gears hard. About a Mile from home, X started driving normal again...
View 6 RepliesCorolla / Matrix 2009-13 :: Changed Rotors And Pads - Car In Limp Mode And Won't Shift Out Of 3rd Gear
Today I decided to change my rotors and pads out.. Got everything back together and i believe car is in limp mode.. It wont shift out of 3rd.. Abs light on ,check engine light, traction control and stability control light on.. Also my speedometer doesn't work but my rpm"s do...hooked up scan tool and comes back as wheel speed sensors.. I never touched them or removed them....
View 3 RepliesVolvo - Xc70 :: Jerks Significantly When Shifting / Clunking Sound From Transmission
Transmission Problems in 2001 Volvo XC70 with 123k... A year ago, I had the input and output speed sensors replaced after the service light came on indicating a transmission problem. The transmission has always made a clunking sound and now it is having a hard time shifting from 1st to 2nd and 2nd to 3rd when doing city driving for a while. It jerks significantly when it finally shifts. It is usually fine in the morning on my 3 mile commute but if I am running around town or after coming off of the highway, it has a hard time shifting. The book states only to have the transmission fluid changed every 52,500 if you use the car to tow which I do not. Should I just give it up and get a new car as everyone I know is recommending? I love this car and otherwise it is in beautiful shape.
View 3 RepliesGti - Volkswagen :: 2003 - Shudder While Shifting To 3rd Gear - Smaller Shudder Shifting To 4th
I had recently purchased a 2003 golf gti AUTOMATIC (with optional shifter) with a 1.8 turbo 4 cylinder engine. The vehicle has 139,000 miles on it. Before purchasing, I had a mechanic come out and look at the vehicle for a pre-purchase inspection, and ran the code P0303 (cylinder 3 misfire) which without test driving, told me that is what caused the shift shudder I noticed when I had test driven it a previous day. He told me the coil packs were in good condition by looking at the top of them, and told me if I replace the spark plugs, the issue should go away.
I feel it is important to mention that he had also run codes on the transmission and nothing came up. Taking it home, this morning I had replaced the spark plugs and driven it for about an hour both regularly and aggressively to test it. The problem is still there, and I was really hoping that there is a solution to this problem, because everything else on the car is beautiful, while being my dream car, I just want it to work as well as I know it can. To be more descriptive, when shifting to 3rd the whole car feels basically like it is tripping over itself before successfully shifting.
Volvo :: 92 940 GL - Gear Doesn't Want To Shift Into The Next
I have an automatic 1992 940 GL and it has been almost a year since the head gasket blew in the car. The gaskets and everything have been replaced as well as the fuel filter, transmission pulley, and timing belt. The car seems to run fine except for a small problem with the gears. When driving it's like it doesn't want to shift into the next gear unless you let off the gas a little bit which then it shifts over fine and it does this for all for gears. It has also recently started back to stalling out at a stop light or stop sign but very rarely.
View 1 Replies