Santa Fe (CM - 2007-12) :: Code C1209 - Faulty Right Rear Wheel Speed Sensor
My mother in laws 2012 Santa Fe had a number of dash lights on (ABS, hill decent, stability control). I put my scanner on it and came up with fault code C1209 which showed up as a faulty right rear wheel speed sensor. I have replaced this module and then cleared the codes.
However, the dash lights still light up and the vehicle continues to throw the same code. I don't work on Hyundai's very often so I am at a bit of a loss.
Touareg :: 2004 - Premature Tire Wear And Faulty Wheel Alignment On V8
Premature tire wear and faulty wheel alignment issues on 2004 Touareg V8 with 10,000 miles. My dealer informed me that my original tires, Continental 4X4 Contact 255/55R18s were about to need replacement and that there were known issues with the tire compound and alignment specifications. I have had the vehicle about 14 months. He said it was over twelve months but he would bring it up with the district representative. I told him that I thought this came under concealed defects and I expected VW to replace the tires and align all four wheels to whatever the current spec. Are there VW bulletins covering this I can obtain copies of?
View 1 RepliesFord Super Duty (1999-2016) :: 2008 F250 V10 - Bank 2 Sensor 2 Oxygen Sensor Is Faulty
My Bank 2 Sensor 2 oxygen sensor is faulty and I need to replace it. The guys at the parts store were pretty certain it is downstream driver's side, but I just want to make sure before I PB Blasted and removed it. 2008 F250 SD v10 ....
View 1 RepliesPrius (2004-09) :: Faulty Oxygen Sensor Caused CEL To Came On
We took our 2008 Prius in for a check engine light. The dealership said oxygen sensor was faulty. Changed that and had them change the serpentine belt while there due to cracks in the belt. My wife filled up the car the next day ( it took 13 gallons) but gas gauge was not registering a full tank. We drove 67 miles and I decided to pull into a gas station and see how much it would take since the gas gauge was not working properly. It took over 7 gallons.
View 8 RepliesLexus SC430 :: Faulty 02 Sensor Could Damage Motor?
I was wondering whether a faulty 02 sensor (in my case bank 1 sensor 1) is bad for the motor or not?
It is clear to me that a worn out 02 sensor can cause the following problems:
Wastes fuel
Can cause engine performance problems, such as surging and hesitating
Is the number one cause of excessive harmful exhaust emissions
Accelerates catalytic converter damage
BUT are there any other risks in case of damage on the long term?
What the ECU will do in case of a faulty 02 sensor? Will our Lexus order a rich fuel mixture to prevent heating problems or are we also running the risk of a poor mixture?
Santa FE SM (2001-06) :: P1192 Code - Faulty TPS Sensor
My 2003 Santa Fe 3.5 is in limp mode, you can't change the gears and showing signs of faulty tps sensor, but my mechanic is telling me to change whole electronic throttle system , May be its only the sensor.
View 1 RepliesAccent LC (2000-05) :: Faulty Engine Coolant Sensor?
I went to emissions test my 2002 Accent, 1.5L 5spd, and failed because of a faulty engine coolant sensor. Problem is, I can't find it anywhere! Worse, I can't find anything online either. I have my second child on the way and need to sell the car and this is the only thing preventing me to sell. Is it worth it to replace myself or to take to a shop and have them do it.
View 6 RepliesHyundai - Sonata :: 2006 - Faulty Oxygen Sensor
I have a hyndai Sonata v6. It is 2006 model and has done 86K miles. It recently failed the inspection and I was told it has faulty oxygen sensors. I have replaced the sensors. But now I am advised by the mechanic that I need to drive abut 200 miles before I can take it for the inspection again because it takes some time for the sensors to get adjusted. Is that true ?
View 7 RepliesMazda - Protege :: Faulty Upstream Sensor Cause Error CEL?
If the upstream pre-cat sensor is bad could it cause a P0421 CEL error? 2001 Mazda Protege L4 2L 116,800....
View 5 RepliesCamry :: 2003 - Faulty Air Fuel Oxygen Sensor
I thought this strange occurrence I am about to describe was maybe happening because of a faulty air-fuel oxygen sensor, that I knew was bad do to a code test that was done, when my check engine light came on. However, after changing the air-fuel oxygen sensor, doing a reset on my check engine light over the weekend, this same occurrence is happening, to spite the check engine light remaining off. Here is what is happening.
When I start and drive it to normal driving temperature then put the car in "Park" with nothing turned on, the car will shake the idle speed will move up and down until it will eventually kill.
Special Note: It does not always have a idle drop and kill the engine every time. If I turn the A/C on in "Park" it idles up higher and does not ever kill. Could it be a bad Idle Air Control Motor?
Prius (Gen 2) :: Faulty Battery Temp Sensor - Code POA9B
My first Prius, an 05 has 249K and performs pretty much flawlessly. My second, an 04 which I purchased in May, has 75K. While driving the 04 yesterday, all the lights came on the dash and really scared me. I immediately pulled off the road and checked belt, fluids and anything else I could. I then called the dealer and they thought since the car was running normal, to bring it in. For a hundred dollars I was told the HV battery, though working and not a problem, would have to be replaced due to a faulty "battery temp sensor" and that this part is not repairable....I need a new battery! Code POA9B ... Tomorrow I am taking the rear panel out and check the HV battery fan, etc. Can I drive the car with these lights on? Everything seems to work but the CC.
View 9 RepliesSanta FE SM (2001-06) :: Faulty MAF Sensor - Getting Codes P0171 And P0172
Still having problems with my 2.4l 2002 santa fe. At stand still the MAF readings are within range. At 2000rpm it reads 9.3 gm/s. the info I have says it should be between 7.89-9.83.
When driving along at 50mph, 5th gear, engine speed 2000rpm it reads approx. 25.0 gm/s. at 3000rpm it reads 48 gm/s. Is the MAF sensor faulty?
It is now not running very well with fault codes P0171(fuel system to lean) That code comes up whilst driving at speed. I also get P0172(fuel system to rich). I got that one whilst driving slowly in a car park.
Accent RB (2012+) :: Code PO326 - Faulty Knock Sensor
2012 Hyundai Accent. I am getting a po326 code. Wondering if it may be a faulty knock sensor. And po463 fuel level sensor code when I fill up with gas.
View 2 RepliesFord - Mountaineer :: 2000 - Faulty DPFE Sensor - How To Replace
I have a 2000 Mountaineer AWD 5.0 with a faulty DPFE sensor. (as diagnosed by dealership) I'm relatively handy with tools and I was wondering if this is an easy fix.
View 13 RepliesGTI 337/20th Anniversary :: Faulty Reverse Lights - Switch / Sensor Broken
(6 speed)... I have faulty reverse lights, my speed sensor is working so I am sure it isn't the fuse, I am guessing this means the switch/sensor is broken. Where it is located, and what the correct part number is?
View 3 RepliesToyota - Corolla :: 2004 - Check Engine Light On / Oxygen Sensor Faulty
I have a 2004 Corolla with a Check Engine light on. The Toyota dealer diagnosed this as: "Oxygen Sensor Bank 1 Sensor 1 - slow to respond".
The diagnostic code is PO133. Elsewhere, I find that this code indicates:
The oxygen sensor is faulty.
The wiring to the sensor is broken / frayed.
There is an exhaust leak
Haven't noticed exhaust leakage, and I doubt the wiring is faulty.
1) Where is sensor 1?
2) Do I really need a new sensor, or can I clean the old one?
Jetta - Volkswagen :: 2006 - CEL Code P0332 / Knock Sensor 2 In Bank 2 Faulty
I have a 2006 VW Jetta with 92K miles and just a couple of days ago my check engine late came on and when i took to an auto store to check the code, it came as P0332, Knock sensor 2 in bank 2 is faulty. Three things have happened all around the same time and I am not sure if they are related and are just coincidence.1.Check engine light came on.2. I have noticed after that, my car RPM has dropped, idles at about 600-700RPM and when trying to accelerate, it tops at 3000 RPM and feels like the motor cuts off at that point and I have to step off the gas and the car runs ok again, but cant go over 3000.
Had trouble getting on the interstate due to this and thought the car was going to stall, but it didn't. just had to back off the gas and let it run, It did go up to the speed that I wanted, but seems like it wont go past the 3000 RPM point.3. My fuel gauge, drops to empty when it reaches the half way mark on the meter. It stays at the correct level when I start and keep the car in idle, but when I start moving, it drops to empty. When I fill up the tank, it goes all the way to F, and after the car goes the usually of about 190-210 miles, when It reaches the half full level, the meter drops to zero, so have been using my trip odometer to drive after that.
Ford Ranger / B-Series :: MIL P1444 Code - Faulty Purge Flow Sensor
So I had a post up saying "is MIL P1444 a urgent fix" and I got "no". On an other website though it said that it was an urgent fix. They said it was "similar to running a bad catalytic converter. You don't want to do it."
P1444:
Possible causes
- Faulty Purge Flow Sensor
- Purge Flow Sensor harness is open or shorted
- Purge Flow Sensor circuit poor electrical connection
So I located the purge flow sensor and look at the tube that connects to that,the canp solenoid, and the carbon canister. Nothing looks bad, but I did notice that the tube that connects to the carbon canister to the solenoid is not connected. The part that connects to the carbon canister dry rotted off. So I turned on my car to see if anything was coming out of that tube or air and there was nothing (not sure if that's good or bad). Also a week ago when I filled up my gas tank (before the check engine light was on) a lot of fumes were coming out of the tank while pumping.
The scanner i use also lists the secondary air system, the EVAP system, Heated catalyst, and the AC refrigenant has red X's, but they weren't continuous.
Yaris/Scion & Vitz :: 2001 Echo Faulty ECT Sensor - Error Code P0125
I'm getting error P0125 on my 2001 Echo, which points to possibly a faulty ECT sensor.
Where is this sensor located? Seems like under the air box? Is replacing this part as annoying as it looks? And, are there any other possible causes for code P0125?
In case it's related, I will mention that code P0171 (mixture too lean, I believe) is present as well, and the car does hesitate upon initial acceleration when standing still. Once it's moving, it works fine.
Maybe it's time to start thinking about replacing this car... it has 216,000 miles...