Santa Fe (CM - 2007-12) :: Knocking At Cold Startup / Noise With Vibration In Reverse Gear
I have santafe 3.5 2012 4WD , it's 51K on odometer, the problem when cold startup , Noise and small vibrate form front side , its look like from gears
When put to reverse (R) sound is louder and strong vibration from front side, all this problem gone when drive about 15 minutes.
I have visit 3 local shop they check the engine, gear box, everything normal, no check indicator appears.
Santa Fe (CM - 2007-12) :: Jumping When Turning In Reverse
I have a 2008 HYUNDAI SANTA FE 2.2 CRTD CDX MANUAL. It jumps when reversing, especially when turning in reverse. Is this normal or is there a fault?
View 4 RepliesSanta Fe (CM - 2007-12) :: Stops With A Bang In Reverse
This is the 4th time this has happened.While in reverse it will suddenly lock up as if I hit a large object,and the anti skid light will come on and also the all wheel drive light will come on.I will then shut off the engine and start the vehicle were the lights on dash will reset and go off.
View 7 RepliesSanta Fe (CM - 2007-12) :: 2010 - Reverse Lights Are Not Working
I recently noticed that both reverse lights on my wife's 2010 Santa Fe are dead.
It's odd that both bulbs would burn out at the same time. So I checked them and they're both good. The bulbs are not burnt out.
What should I check next?
I looked up the fuses in the owner manual, checked those, and everything looks good there. There is a relay as well. I swapped that with a similar relay in the fuse box, but that made no difference either.
I suspect it's the reverse switch on the transmission. Ours is a manual transmission. How to locate and access that reverse switch?
Santa Fe (CM - 2007-12) :: Reverse Gear Not Working For 5 Minutes In The Morning
I have Hyundai Santa Fe, 2009 (automatic). when I start engine in the morning everything is fine except the reverse gear. the reverse gear moves to position easily but the car does not move. After 5 minutes of starting engine, the reverse gear works again.
View 1 RepliesSanta Fe (CM - 2007-12) :: Gear Shifter Very Difficult To Move When Put Car In Reverse
Here is what I have:
2009 Santa Fe 3.3L AWD
70k KMs / 43k Miles
Temp has been very cold, -20C / -4 F
Car starts up without any problems. Try to put car in Reverse and the shifter is very hard to move, if it moves at all. When I am able to get it into Reverse, I then try to put it in Drive and it does not "engage" the "D" and the car behaves like its in Neutral. Moving the shifter back to Park, Neutral, Drive is very difficult and sometimes it will not go into Park. The dash lights do not illuminate the selected P, R, N, D.
However, once the car is warmed up (no longer on C on the temperature gauge) I can with a little effort move the shifter freely (but more effort than it should take) and the car behaves normally. Gear shifts are smooth and in general it is operating normally.
The dash lights do illuminate the selected P, R, N, D. I've checked the Trans fluid level and it appears to be normal and was planning to change it this w-e but I'm no longer sure it will work. Even if it has never been changed.
Also note that I have recently changed a wheel/hub bearing due to a noise that sounds a lot like loud tires on a highway. The bearing change did not eliminate the noise and I assumed that I've changed the wrong one. The noise does not appear to be coming from the Trans, but I cant be 100% sure. The noise is speed related and occurs only after about 20KM/h 16MPH. Unsure if they are related..
Santa Fe (CM - 2007-12) :: 2009 - Hard Shift Into Reverse When Cold
Our 2009 Santa Fe AWD Limited shifts hard first thing in the morning when my wife shifts into reverse to back out of our parking space. This is a real hard THUD kind of shift, where the car jerks. After that, all shifting is normal. We don't have any other problems with the transmission when driving.
View 6 RepliesSanta Fe (CM - 2007-12) :: Repeated Door Lock Sound When Shifting Into Reverse
I started noticing that when I shift the car into reverse to back out of the driveway, the car door locks sound like they are trying to lock/unlock repeatedly for a couple of seconds. I know the car automatically locks the door when I shift out of park, but the multiple retries is a new behavior. All doors do lock. I do have the child locks enabled for the rear doors and that hasn't changed in 3-4 years. I also disabled them and the retries persist.
I have also noticed that around the same time (past month?) I must push the unlock button on the keyless entry remote twice to unlock all the doors--including the driver side door. In the past I only had to push the button once to just unlock the driver's door and the side lamps would flash, but one push doesn't do anything anymore. I've never changed the battery in the remote, but does the car care that the remote battery may be running low to exhibit this behavior? It's a 2010 SF with 52K miles.
Santa Fe (CM - 2007-12) :: Engine Light Stuck On / Lost Drive And Reverse
I was driving my santa fe at 80 k's per hour when the revs started to climb towards 3500 thousand revs. I pulled of the road and stopped, I had noticed the engine light stuck on. then i lost drive and reverse, let it idle for 4 min and they come back. What's gone wrong with the car?
View 3 RepliesSanta Fe (CM - 2007-12) :: 2010 - Slipping Transmission / Grinding Sound And Could Not Go Forward Or Reverse
I was driving out of a parking lot and as I accelerated onto the main road my vehicle stopped. I heard a grinding sound and could not go forward or reverse. While the car is in drive, park or reverse my car will roll any which way. It pushed it across the street. I tried to locate my tranny dipstick via visual inspection and manual. I could not find it. Could the stick have never been put back at some point in service and caused this issue. That seems unlikely but the thought occurred. Could it be the velocity joint? Whatever it is it certainly sounds like a transmission issue.
View 1 RepliesSanta Fe (CM - 2007-12) :: 2008 - Whine When Trans Warms Up And Is In Drive Or Reverse / Not In Neutral
The car has about 53k miles. The problem has persisted since probably 20k miles. The whine is only after the trans warms up and is in drive or reverse, not in neutral. Whine is while the car is stationary or moving at low speed. The whine doesn't seem to change due to gear it is in. It does not change frequency with engine RPM. It does seem to diminish the more load the transmission is under.
Whine is probably not an accurate description, it sounds like a noisy pressure relief valve. Had Hyundai service look at it and all they said was all pressures in the transmission are normal. They could not find any cause.
It sounds like a bunch of small ball bearings running in a loop and can hear each one impact. Sharp raspy impact type sound.
You cannot hear it from the interior but it is quite pronounced while in the garage or if you hear the car coming down the driveway.
Santa FE SM (2001-06) :: Grumbling Noise When First Started And Put Into Drive Or Reverse
My 2003 Santa Fe makes a grumbling noise when first started, and put into drive or reverse. The noise seems to be coming from the passenger side of the engine compartment. The noise disappears when the drive train has warmed up.
View 4 RepliesSanta FE SM (2001-06) :: 2004 - Clunking Noise In Drive Or Reverse
2004 Santa Fe, clunking noise in drive or reverse. checked brakes and cv joints, replaced drivers front and still making the noise. Transfer case was a little low on fluid but not much. Put up on stands and turn wheels with no noise. Put in drive or reverse while in the air and rear wheels sit still. It is a 4wd so I would think that all 4 tires would be turning. While in the air the front both turn and no noise is made.
View 18 RepliesSanta Fe (CM - 2007-12) :: Faint Metal-on-metal Sound When Put Car In Reverse
I have a 2011 Santa Fe AWD Limited. 90,000 miles. I have a strange sound I need identifying. At first I thought the sound was my AC depressurizing, but it's not that. It sounds similar, but has a faint metal-on-metal jingle sound to it, like something is rubbing or something is rotating and intermittently hitting something just slightly. The mechanic went in to change the water pump because it was leaking, and he thought that the water pump when rotating was rubbing because the rubber ring/gasket was failing, therefore making that sound. Not it. Tired rotated and new brake pads put on. Still there. To be clear, the mechanic never said he heard the sound. I just told him about it.
I can hear the sound when I turn the car on and put it in reverse start backing up. I can hear it when I let off the brake (driving and in park), which lead me to believe that it could have been the pressure in the Master Cylinder or ABS. I don't know now because it does it intermittently when I am driving down the road with no brake applied. When I park, I put the car in Park, get off the brake and just listen. And I can hear it. When it is in park it is more rhythmic, with two or three second breaks in between. kshhh kshhh kshhh kshhh. (I hope you like my poor attempts at sound effects.)
Is it the ABS system? Don't tell me it's transmission related. I just bought this car (used at 87,000 miles) and already had the struts done, the water pump and drive belt done. For what it's worth, this car's passenger and back seats vibrate at 60+. Not sure if that has anything to do with this sound, but thought I would mention it. New struts and tire rotation did nothing.
Lexus ES 2007-12 :: Whining Noise From Rear When In Reverse
So I am a hearing a whining noise in the rear end area sounds like its coming from passenger rear wheel well. It sometimes happens when driving forward. What it could possibly be ?
View 2 RepliesLexus LS 2007+ :: Brakes Making Clicking Noise While In Reverse
The other day I had my windows open while backing up and noticed that the brakes make a clicking noise when I initially apply them while in reverse.
This happens every time I'm in reverse and I apply the brakes.
The clicking is only when I first step on the brake, but it happens every time I first step on the brake in reverse.
Maybe this is unique to the LS600hL (2008)? Are brakes on my LS different from brakes on LS460 / LS460L?
Lexus LS 2007+ :: Clicking Noise From Rear When Tapping Brakes In Reverse
I had my window down as I was backing the car into the garage today and heard a metallic clicking noise from the rear as I tapped on the brakes. The noise only happens when I am in reverse. When I put it in drive and move forward there is no clicking noise. As an AZ resident its rare for us to have the windows down so to be honest I cant really say how long this has been going on for. My car was just in for service for oil , tire balance, and alignment this saturday
View 7 RepliesLexus ES 2007-12 :: 2008 ES350 - Vibration / Noise When Reverse Out Of Driveway
When I reverse out of my driveway, my car makes a noise. It only happens when it is in reverse and sounds like something may be rubbing against each other. It's not a high pitched squeaking noise but more so just vibrations and a light rubbing noise.
View 8 RepliesLexus ES 2007-12 :: Loud Chirping Noise Under Hood When Put Car In Drive / Reverse
Have mechanical issues with my Lexus, I own an 07- es350. Everytime i put the Lexus in reverse/drive sounds like i have a huge bird under my hood chirping very loud. I replaced the serpentine belt but same issues. The Lexus is quiet when in park, but as soon as i put it in gear it starts screeching.. 2007 Lexus es350...
View 1 Replies