Impala - Chevrolet :: 2007 - Hard To Shift Out Of Park On Cold Engine
2007 Chevrolet Impala 1LT3.5L Flex Fuel EngineAuto Transmission with shift lever on the steering column29,980 miles
Bought new Nov 2006 so is now four and a half years oldThe drive train is still under warranty (6 years or 60,000 miles). All recommended service per the manufacturers manual has been done. Book calls for first transmission service at 50,000 miles
NOTE: Previously at 19,600 miles the transmission cooler line fittings were replaced due to a small leak. Currently no evidence of a leak; no fluid on garage floor and the transmission fluid level on the stick shows right on the mark. Fluid still clean pale red and has no odor.
Majority of my driving is short hops with multiple stops, so the car gets heavy use shifted into and out of park gear. I do use the "parking brake" applying it after shifted into park and released before shifting out of park. I always have my foot on the brake pedal when shifting out of park.
PROBLEM: Having trouble shifting out of park on a cold engine or if the car has been sitting for an hour or more since turned off and put into park gear. Oddly enough, if I'm running a series of errands where the car has been in park for only 5 to 30 minutes, there is no problem shifting out of park gear. But if the car sits long enough for the engine to cool then it becomes hard to shift. The longer the time it sits in park the harder it is to shift out of park when the car is started.
Santa Fe (CM - 2007-12) :: 2011 3.5 V6 Hard Start From Cold
The vehicle has 80,000kms, and from a cold start it is having this problem more and more frequently. I must crank the engine 3+ times, and then she starts. A prolonged cranking period doesn't seem to work, and this only occurs when cold. The car starts fine when warmed up. I have scanned the car with a generic OBD2 reader and there are no codes. Once the car is running, it runs great with no misfires.
View 1 RepliesSanta Fe (CM - 2007-12) :: Knocking At Cold Startup / Noise With Vibration In Reverse Gear
I have santafe 3.5 2012 4WD , it's 51K on odometer, the problem when cold startup , Noise and small vibrate form front side , its look like from gears
When put to reverse (R) sound is louder and strong vibration from front side, all this problem gone when drive about 15 minutes.
I have visit 3 local shop they check the engine, gear box, everything normal, no check indicator appears.
Santa Fe (CM - 2007-12) :: 2009 - Engine Wouldn't Start / Shift Lever Was Stuck In Park
I have a 2009 Santa Fe and last night, out of the blue, the engine wouldn't start. The shift lever was stuck in park and the brake pedal was very stiff and wouldn't move much. I popped the cap off the shift lock and moved it to neutral at which time the car started without a problem. I could drive but shifting was difficult and the lever didn't really click into a gear. I noticed that when shifting gears. the indicator on the dash would change from N to D and to R in reverse but when I moved up to park, the indicator went blank and the lever locked up again and had be released manually. I also noticed when I got home, since my driveway is a slope, that when the car seemed to be in park is rolled down the driveway, so I had to engage the emergency brake.
View 13 RepliesSanta Fe (CM - 2007-12) :: 2009 Spongy Brakes In Cold Weather
In cold weather (10-15 deg.) the brakes in my 2009 Santa Fe are very soft/spongy. I had to depress the brake pedal nearly to the floor before it would stop on dry pavement. Once it's warmed up, the brakes seem fine. Pumping them seems to work but they are not back to their normal condition.
View 14 RepliesSanta Fe (CM - 2007-12) :: 2009 - Automatic Transmission Won't Engage D When Cold
I have a 2009 Santa Fe (Automatic 3.3 v6 AWD). I have found the last few days (-20 C) where my gear shift will move into all gears (R, P, N and D) but the car wont move in Drive. R, N and P all work fine. It does seem as the car warms up everything's fine.
The light in the dash for D does not light up either when not working. What this might be?
Golf IV / Jetta IV :: Hard To Shift Into 1st And Reverse When Car Is Hot
Over the past few weeks, my car (2002 Golf 2.0L) has gotten really hard to shift into 1st and reverse (has crunched once or twice), but only when the car is hot, after driving it for a little while. When this happens, and I try to shift into reverse, the shifter feels really "sticky" and can get kind of stuck in the depressed position near reverse.
I bled the hydraulic system and replaced the slave cylinder, but no dice. I haven't noticed any clutch slipping. Shop wants to replace the whole clutch. Is this the right answer?
Camry 2012+ :: Hard To Shift Car From Park To Reverse
I am planning to buy this 2012 Camry LE (38k), automatic, I am on the test run and realized that the car's shifting from park to reverse is harder than shifting from reverse to drive. What I mean is, it is really hard to move the selector from Park to Reverse.
View 6 RepliesElantra XD (2001-06) :: Hard Shift When Put It In Reverse / Hesitates Quite A Bit To Accelerate
I have an 01 Elantra Gls with perplexing issues. The car starts at 3000 rpms, and continues to bounce between 2k and 3.5k in both park and neutral. when I put it in reverse i get a very hard shift. It actually jerks the whole car. in drive and reverse, it idles around 1.5k it hesitates quite a bit to accelerate. All fluid levels are right and don't smell burnt. it takes me 10 mins to put 4 gallons of gas in. if i pump too fast it shoots back at me. i randomly smell gas while driving. Im hoping these problems are a couple of issue I can handle at home. i just wanted some input before i buy the manual. thinking vacuum lines maf sensor.
View 7 RepliesFord - Focus :: 2005 - Hard To Shift Into First Gear And Reverse
I have a 2005 Ford Focus Man Trans, and am having issues getting it into first gear and into reverse. This happens most often when the car is cold. I am kind of wondering what it may mean before I take it in to have the issue fixed. It has 65 thou miles on it and I would think that I don't need a new trans already?
View 8 RepliesFord Transmission :: Hard Shift And Clunk When Shifting To Reverse
I just recently bought a 95 F150 with a 351. The truck has high mileage, about 190k, and I am not sure how long the transmission has left. It rides smooth down the road, but when I put the truck into reverse it hesitates for a moment then makes a loud clunking sound(as if a door is being slammed) and then jerks into gear. The reverse works great at the moment though. Should I be worried, is there anything I can do to fix this?
View 11 RepliesVolkswagen :: Transmission - Grinding Noises From Transfer / No Reverse And Hard To Shift
I have a 97 jetta trek that is having problems. Grinding noises from transfer , no reverse, hard to shift, loud winding noise. I think it's may be the trough out baring thing from what I'm reading.
View 6 RepliesCamry 2012+ :: Toyota SE V6 / Occasional Hard Shift From Park To Reverse?
My 2012 Toyota Camry SE V6. 37,500 miles. Occasionally when I'm parked shifting down to reverse it's so tight/put effort to shift & it literally thumps the entire car.. I heard to put the E-BRAKE/PARKING BRAKE down BEFORE shifting it to park & it worked but occasionally even with the E-BRAKE/PARKING BRAKE it still jerks the entire car going from PARK to REVERSE.
Also going from REVERSE to NEUTRAL it gives off a little vibration underneath me ALL THE TIME going from REVERSE to NEUTRAL.. I know these are so many questions that are probably a no-brainer answer but I'm looking to see if any one here had/has or heard of a similar or exact problem. Is the trans fluid low or dirty? I saw the CARFAX I didn't see the services he's done it's only been 1 owner on this car I'm the second. Previous owner leased it brand new.
Civic - Honda :: 2005 - Drops Out Of 5th Gear / Hard To Shift Into Reverse
05 Honda Civic 5spd... 157k original miles, and I bought it new. 1-4th gear no issues. Reverse has always been hard to shift into and sometimes misses getting into gear, but the car has had that quirk since i bought it new in 05. Last month driving home I was cruising in 5th gear and the car just dropped out of gear into neutral. No gear grinding, no noticeable noises at all. just suddenly slowed down and when i went to grab the stick its was neutral.
Since then it did it a lot the following week, but now has stopped. I've talked to a few different mechanics and gotten a few different diagnosis. First the clutch. Another said the transmission, but "we might as well do the clutch since we have it in the shop". Now another mechanic says its just the clutch linkage bushing.Obviously I want the cheapest way to go, but at the same time I need to fix it right since its my only car.
Ford Ranger / B-Series :: New Clutch - Hard To Shift Going Into 1st / 2nd And Reverse Intermittently
1997 Ranger extended cab, 222k mi., 4 cyl, standard transmission. Shifting got worse until it finally died and the mechanic replaced the clutch "kit" and slave cylinder.
It still fights back going into 1st, 2nd, and reverse. But it is intermittent. If I put it in neutral, depress the clutch, and start the vehicle, then, after a few seconds wait, when I try to go into 1st (or reverse), it fights me back, forcing me to pause and apply about twice the pressure I should need to go into gear. When I go forward in 1st, and am ready to shift to 2nd, it fights back so that I have to pause just a bit and apply more pressure than I should for it to go into 2nd gear. 3rd, 4th, and overdrive are FINE. Also, the clutch seems to disengage about halfway down, where I was expecting it to disengage after only 10 -20% depression.
The mechanic doesn't see the problem (or won't admit it). Is there an adjustment to make the clutch disengage with only 10-20% depression instead of the 50%? Is that something I should be worrying about?
Is there some other problem? Like maybe the synchromesh mechanism in the transmission itself not bringing the transmission rotor to engine speed soon enough (wear on the synchromesh)?
When it was new, it went into ALL gears with ease, no fighting back, and it starrted doing this after about 150k miles. Now, at 222k mi., even with a new clutch, plate, throughout bearing, and slave cylinder, it still seems partially stuck going into 1st, 2nd, and reverse.
I just don't want to start replacing things until I can get a correct diagnosis as to what is causing the problem.
Ford Aerostar :: Loose Shift Selector - Hard To Find Reverse
Catfish is a '96 4wd extended doggie RV, with 175k. It has developed transmission selector problems in the last few weeks.
The shift selector stops seem to be going soft. It's not to bad going from P to OD, but I have to fiddle with the lever almost every time I put it into reverse.
Particularly harrowing when trying to do a quick turn around in traffic. What's going on here and what I need to do to fix it.
Pontiac - Metro :: 1990 - No Reverse And Will Shift From 1st To 3rd When Car Is Cold
I have a 1990 Pontiac firefly with a 3 cyl automatic. It will not go into reverse and will shift 1st to 3rd when the car is cold. once it is warm it shifts fine. it is puzzling. When it is warm shifts are crisp solid. I am thinking it is not worn disks or band. I would like to get this fixed before winter sets in. I have a little more info now. If I shift into low it will shift into second, So I now have all three gears but still no reverse until it warms up. I don't seem to be getting any takers, and this is so odd.
View 1 RepliesHyundai - Elantra :: 2005 - Rally Hard To Move Gear Shift When Put Car Into Reverse
I have a 2005 Hyundai Elantra with approx 155,000 miles on it(I don't know if that matters). The car started ok at first. When I put it into reverse, I noticed that it was really hard to move the gear shift(which it's normally really easy). I put it back in park and let it sit for a minute thinking it just had to warm up a bit more.
When I tried it again, it was still hard to shift, but this time when it got into gear I heard a loud clunk. This scared me, so I put it back in park and turned off the car. Now it won't start. All of my lights(headlights, dashboard lights, radio) come on, but the engine won't turn over.
I don't know if any of the following is relevant but I'm putting it out here anyway just in case it is: The battery is only a year old(and since all my lights came on, I don't think it's dead)I had an oil change on Saturday. The belts were replaced a few months ago. My check engine light is on because of an O2 sensor.
Golf/GTI VI :: Hard To Shift In 2nd Gear When Cold
2011 TDi 6 Speed (Sportwagon) with problems shifting into 2nd? Mine is currently in the shop under investigation for a balky shift when cold. The tech says it's not right, but then they find another vehicle in inventory with the same issue...currently waiting on a VW engineer.
View 16 Replies