Santa Fe (CM - 2007-12) :: Stuck In Drive While In Operation - Faulty Stop Lamp Switch
I have 2008 Hyundai Santa Fe......approx 10K miles......no major issues to date
Drove my son to school this morning and pulled into a parking spot.....the shifter would not move into PARK......it was stuck....would only go into NEUTRAL and DRIVE....the vehicle was idling
I was a little panicked, but put on the parking brake and called the dealership on the cell.....they told me to pop the cover on the switch near the shifter and and depress the reset button (needed a flat head screw driver).......it took about four tries and then finally worked.....
I shut the vehicle off, restarted it and tried to put the car into REVERSE...to back out of the parking spot......shifter was stuck again.....had to depress the reset button......
Immediately took the car to the dealership where it was DIAGNOSED with a faulty "stop lamp switch".......causing the shifter to stick and the brake lights not to work... this was a recall item for the 2007 Santa Fe, but not the 2008 (that I'm aware of)
Dealership replaced the stop lamp switch and had me in and out in a hour.......but they did not initially give me a write up......i told them this was a very dangerous situation that had just occurred and I wanted a write up.....they happily complied....
So keep a flat head screw driver (glove compartment) in the car and have your dealership take a look at the stop lamp switch, on your next visit, even though it was only recalled on the 2007.......I will also be contacting HYUNDAI directly...
ETA: ESC light was illuminated when I was trying to get the vehicle into PARK from DRIVE......also contacted HYUNDAI and gave them a description of the incident and now have a case number.
Santa Fe (CM - 2007-12) :: 2008 - Whine When Trans Warms Up And Is In Drive Or Reverse / Not In Neutral
The car has about 53k miles. The problem has persisted since probably 20k miles. The whine is only after the trans warms up and is in drive or reverse, not in neutral. Whine is while the car is stationary or moving at low speed. The whine doesn't seem to change due to gear it is in. It does not change frequency with engine RPM. It does seem to diminish the more load the transmission is under.
Whine is probably not an accurate description, it sounds like a noisy pressure relief valve. Had Hyundai service look at it and all they said was all pressures in the transmission are normal. They could not find any cause.
It sounds like a bunch of small ball bearings running in a loop and can hear each one impact. Sharp raspy impact type sound.
You cannot hear it from the interior but it is quite pronounced while in the garage or if you hear the car coming down the driveway.
Santa Fe (CM - 2007-12) :: Engine Lost Power / Shut Down
I was headed down the highway in my 2007 Santa Fe last night. All of the sudden, I lost engine power. I pushed the gas peddle and nothing. We coasted down to a stop on the side of the road. I attempted to restart, all it did was turn over. I noticed the OIL light was on, so I got out and double checked my oil level. Right up to the full mark. Probably about a year ago, I had a check - engine light. I have a code that indicates that my gas level sender has failed, so my gas gauge does not work. I am sure you are saying.....he just ran out of gas. Well, not the case. I filled up the day before, and figured I had another 100 miles left on this tank.
Over 171000 miles on it and I have no intention of giving it up soon.
Ford - Explorer :: 1997 - Trans Won't Engage While In Drive - Reverse Lost?
I got myself a 1997 explorer Australian model when I got it (here's the problem) if you put it in drive it will not engage but if put in first will drive normal then shift into second all good now u have push O.D then shift into drive all good (unless u slow down to almost a stop) ? New problem is, it has gone and lost reverse, put it in reverse and it engages with a small clank (normal) but just slips with any revs. I have read posts here talking about upper and lower valve body gaskets and transgo shiftkit which I have ordered but do there maybe more parts needed? Cause it's going to cost me lot just to put transmission fluid back in.
View 4 RepliesSanta FE SM (2001-06) :: Lost Ability To Shift Gear - Stuck In 2nd
My 2001 Santa Fe 2,4l - Have suddenly lost the abillity to shift gear. Its stuck in 2 and the shift stick is very loose in the "front to back and back to front" motion.. in other words there are resistance sideways.
I suspect it to be a broken shift cable. So my question is : changing shift cable on a santa fe easy? Is the best approach to start from inside the vehicle or from transmission side?
Suzuki - Forenza :: Stuck Between Reverse / Neutral - Check Engine Light Goes On
I have a 2006 suzuki forenza (automatic) with about 90,000 miles on it. Five times this summer, it seems to get "stuck" between reverse/ neutral (both letters are displayed on dashboard) and the check engine light goes on. I turn the car off/on and the the problem seems to resolve. The check engine light stays on for about 24 hours. The car drives "fine" (its a relative term, has some other quirks) for another 2-4 weeks until it happens again. My question is: is this a serious problem or can I just ignore it?
View 1 RepliesPrius V :: Stuck On Neutral When Try To Shift The Car Into Reverse Or Drive
I have recently been having problems with my 2013 Prius v (lowercase v for the Prius v wagon). When I press power, all the dashboard lights turn on. And when I try to shift the car into reverse or drive the car stays on neutral. What is going on?
View 7 RepliesFord Transmission :: Truck Stuck In Drive No Reverse
My truck does not go into reverse but thinks all positions of shifter are drive. I had some slippage and changed the filter and oil great for awhile then blame no reverse just forward I was told my torque converter was out I just don't know....
View 1 RepliesSanta Fe (CM - 2007-12) :: 2011 - V6 Idles Rough At Red Light / Stop Sign While In Drive
I have really taken care of this 2011 SF Limited with the 3.5 V6 but it has always seemed to idle rough at a red light/stop sign while in drive. Is this common for all the 3.5 V6 engines? I run a fuel cleaner through it before every syn oil change and also use top tier gas. It drives nice but like I said, at a stop in drive it seems to run rough at around 500-550 rpm's.
View 10 RepliesSanta Fe (CM - 2007-12) :: 2009 - Engine Wouldn't Start / Shift Lever Was Stuck In Park
I have a 2009 Santa Fe and last night, out of the blue, the engine wouldn't start. The shift lever was stuck in park and the brake pedal was very stiff and wouldn't move much. I popped the cap off the shift lock and moved it to neutral at which time the car started without a problem. I could drive but shifting was difficult and the lever didn't really click into a gear. I noticed that when shifting gears. the indicator on the dash would change from N to D and to R in reverse but when I moved up to park, the indicator went blank and the lever locked up again and had be released manually. I also noticed when I got home, since my driveway is a slope, that when the car seemed to be in park is rolled down the driveway, so I had to engage the emergency brake.
View 13 RepliesCavalier - Chevrolet :: 2003 Won't Shift To Park And Reverse / Stuck On Neutral And Drive
I have been driving a 2003 Chevrolet cavalier and the automatic shift is stuck and can only shift to neutral and drive since Thursday morning. It wont go up to reverse and parking and down to the other 3 shifts.
This first happened last April but somehow with the right grip or pressure was able to get back to all the other shifts. Since then it happened 2-3 times as I can remember and now could be getting worse.
Santa FE SM (2001-06) :: Auto Transmission Will Not Move In Reverse Or Drive
I just did a motor swap on a 2003 with 3.5 auto tranny and awd. engine runs great and every thing is running fine. Only problem is that the trans will not create any power. With no drive shafts on it still wont move the splines. With that said the trans was driving/running great b4 the swap.
View 2 RepliesSanta FE SM (2001-06) :: Grumbling Noise When First Started And Put Into Drive Or Reverse
My 2003 Santa Fe makes a grumbling noise when first started, and put into drive or reverse. The noise seems to be coming from the passenger side of the engine compartment. The noise disappears when the drive train has warmed up.
View 4 RepliesSanta FE SM (2001-06) :: 2004 - Clunking Noise In Drive Or Reverse
2004 Santa Fe, clunking noise in drive or reverse. checked brakes and cv joints, replaced drivers front and still making the noise. Transfer case was a little low on fluid but not much. Put up on stands and turn wheels with no noise. Put in drive or reverse while in the air and rear wheels sit still. It is a 4wd so I would think that all 4 tires would be turning. While in the air the front both turn and no noise is made.
View 18 RepliesSanta Fe (CM - 2007-12) :: Warning Lights Came On And Acceleration Lost
My company has a fleet of about 20 2007 GL AWD Santa Fe's. A few of them have had a strange problem....AWD, ESC, and check engine lights will turn on and they will lose acceleration of the vehicle. The dealership has said that it is a problem with the electronic throttle. Apparently it has been quite dangerous for some who have been driving at highway speeds and lost acceleration.
View 15 RepliesSanta FE SM (2001-06) :: 2004 - Hard Thump When Shifting From Reverse Into Drive
Recently my 2004 Santa Fe 2.7 AWD (~86k miles) has started to give a sort of hard thump when shifting from reverse into drive. It's fine going into any other gears and it shifts up and down normally. If I shift from reverse to neutral and then to drive it's fine.
I changed the transmission fluid when we first got the car at 40K miles with Hyundai Liquid Unobtanium SPiii fluid and again at 80k miles with Valvoline's SPiii offering. I just checked the transmission fluid level and it's within the normal range.
I can't tell if this is just drive-line slop or something else inside the tranny.
Santa FE SM (2001-06) :: Rear End Clunking When Going From Reverse To Drive At Slow Speed
2001 Santa Fe 2.7L 4wd ... In December I bought this vehicle it only has 95K on it. When I drove the car home I noticed it needed brakes so I put brand new pads and rotors on the whole way around. I changed the oil, air filter, wiper blades, and made sure all fluids were good. I had the front spring recall done and also put some new sway bar end links on the front. The car runs fine and I am rather impressed with it. It does have some rust but I'm not to worried about that. This isn't my everyday car just a winter/extra car. Recently I have been getting some clunking only when going from reverse to drive and going slow. You get a clunk..clunk pause clunk..clunk almost like you have a flat but once I get the car up to speed it is fine and you never hear it again until the car sits a day or so and then it will do it again. I don't know if I have a differential problem or a u joint or maybe something with the e brake or rear brakes? but it is -3 right now outside and I would rather know where to start so that when I can take a look at it I know some things to check or what it might be.
View 3 RepliesSanta FE SM (2001-06) :: Clunking Sound When Shift Into Drive Or Reverse - Bad Motor Mounts?
I have a 2002 santa fe 2.7. I just had the transmission rebuilt and since then have noticed a clunking sound when I shift into drive or reverse. It seems to be the lower motor mount is making noise from the motor moving the mount. I look at the mount and it appears to look good, but was wondering how I can really tell if a motor mount needs replacing or not.
View 3 RepliesFord F-150 (2009-2014) :: Lost Speedometer / Odometer / Stuck In 5th - No Power And Airbag Light
Just hasn't been my luck lately guys. Last night was around 4 F out, taking a left at an intersection and lost power. Though it might be the TC kicking in as it was a bit icy out, but no indication of that on the dash. Then the "service engine" wrench showed up for a second on the display.
This was followed by the airbag light turning on, and the truck going into some kind of limp mode. The speedo indicated "0 MPH" though I was running about 2k RPMs in 5th.
My display showed this:
I couldn't force a downshift with the throttle, or get one from manual mode. I slowed down and pulled over at a safe place, shut the truck off and restarted. Hasn't happened since then.