Santa Fe (CM - 2007-12) :: 2010 - Driver Side Lights Are Not Working
The driver side rear marker light, stop & tail lights as well as the front park light have stopped working...its not any of the bulbs..just wondering if it is a fuse or a grounding issue? i cant seem to locate a fuse for the driver side lights... Where to begin looking for a ground problem (assumed to be the issue)
View 2 RepliesSanta Fe (CM - 2007-12) :: Reverse Gear Not Working For 5 Minutes In The Morning
I have Hyundai Santa Fe, 2009 (automatic). when I start engine in the morning everything is fine except the reverse gear. the reverse gear moves to position easily but the car does not move. After 5 minutes of starting engine, the reverse gear works again.
View 1 RepliesAvalon 2005-12 :: 2007 LE - Outer Reverse Lights On Both Sides Not Working
I (or rather my dad) have a 2007 avalon limited. I'm trying to install a backup camera for him. I don't know if it's something I did now but I see the outer reverse lights (on the car body, rather than trunk lid) don't come on as they should. Also any tips to install the video interface and/or camera are extremely welcome - it can never be too basic!
View 11 RepliesSanta Fe (CM - 2007-12) :: 2010 - Slipping Transmission / Grinding Sound And Could Not Go Forward Or Reverse
I was driving out of a parking lot and as I accelerated onto the main road my vehicle stopped. I heard a grinding sound and could not go forward or reverse. While the car is in drive, park or reverse my car will roll any which way. It pushed it across the street. I tried to locate my tranny dipstick via visual inspection and manual. I could not find it. Could the stick have never been put back at some point in service and caused this issue. That seems unlikely but the thought occurred. Could it be the velocity joint? Whatever it is it certainly sounds like a transmission issue.
View 1 RepliesSanta Fe (CM - 2007-12) :: 2010 V6 Can't Start / Clicking Noise With Dimming Lights
Our 2010 Santa Fe SE V6 just developed a problem where when we turned the key, the car wouldn't start, and there was a loud clicking sound during start attempt. Battery tested 100% OK.
This often points to a starter problem, but a telling symptom was than the headlights would dim, almost going out, along with the dash lights and most any other lamp. If it was just the starter, unless dead short, this associated dimming would not happen. I also put a volt meter on the battery and watched battery voltage during cranking attempt, and the voltage showed minimal drop, so once again the battery was not the problem.
Traced the problem to the ground strap from the battery which terminates to the driver side front wheel well. Two bolts hold the strap to the wheel well, and they are oxide coated and the contact point on the wheel well is painted. This means all the current returning to the battery is essentially passing through the bolt threads and cap where the oxide has been scratched enough to be conductive.
I sanded underside of the bolt heads to remove oxide, sanded the ground strap itself which seemed to have some sort of clear coating, and sanded the paint away from the wheel well where the strap makes contact. I didn't have star washers, but if I did they would have been a good addition.
Car now starts with no problem.
I am concerned with the possibility of corrosion under the strap where I sanded away the paint, but will monitor this. I think the contact between the strap and fender wall is tight enough with the two screws to seal out moisture and oxygen.
I am also going to locate and check any other chassis to engine ground straps so I don't have any new problems in the future.
Santa FE SM (2001-06) :: 2003 - Blinkers Not Working But Hazard Lights Working Fine
I have a 2003 santa fe and the blinkers are not functioning but the hazard lights are working fine. I checked the fuse and that is fine. Is there someway I can take apart the handle assembly where the switch for the blinkers are? Also, sometimes they would work and other times they wouldn't so that seems like a loose connection somewhere. The indicators for the blinkers on the dash do not work either so there has to be a problem giving power to the switch.
View 8 RepliesGolf/GTI VI :: Reverse Lights Are Not Working
My 2010 gti reverse lights are not working when my buddy told me they didn't work i didn't believe him. Now i see they are not working...
View 9 RepliesPhaeton :: Reverse Lights Not Working
My reverse lights aren't working. I assume the trunk cable assembly is fine, as all my trunk opening and latching works and there is no viable damage to the cable. I figured the bulbs were burned out but I pulled the trunk liner today and at least one of the bulbs looks intact. I don't see any fuse listed for reverse lights.
View 2 RepliesGolf IV R32 :: Reverse Lights Not Working
Checked the bulbs, checked the connection....What is going on here. Is there a switch in the transmission or some crap that must have gone bad?
In good news. I have my rear fogs wired so that both sides work. ...the reverse lights stopped working like a week ago. So a crap rear fog install is not to blame.
Santa Fe (CM - 2007-12) :: Noise While In Reverse
Recently, my 2007 Santa Fe GLS (not AWD) has been experiencing a grinding noise coming from the rear of the vehicle while in reverse. What may be causing this?
View 9 RepliesMontana :: PRND123 Not Working - Reverse Lights Come On
My PRND123 isn't working on my 03 Montana. I replaced the neutral safety switch still no go. The reverse lights come on. When shifted out of park the doors lock and when put back in park they unlock. I checked some fuse the are for the nss and there good. Any wiring diagram for it?
View 4 RepliesSanta Fe (CM - 2007-12) :: Jumping When Turning In Reverse
I have a 2008 HYUNDAI SANTA FE 2.2 CRTD CDX MANUAL. It jumps when reversing, especially when turning in reverse. Is this normal or is there a fault?
View 4 RepliesSanta Fe (CM - 2007-12) :: Stops With A Bang In Reverse
This is the 4th time this has happened.While in reverse it will suddenly lock up as if I hit a large object,and the anti skid light will come on and also the all wheel drive light will come on.I will then shut off the engine and start the vehicle were the lights on dash will reset and go off.
View 7 RepliesPrius (Gen 2) :: 2004 - Brake And Reverse Lights Not Working
I have a 2004 Prius, with both the brake and reverse lights not working (right & left). Already replaced all bulbs and checked fuse...No luck.
View 3 RepliesCamry :: 2008 - Reverse Lights Have Stopped Working
I have a 2008 Camry 4 LE. My turn blinkers and reverse lights have stopped working and i'm 90% its a bad relay. I have checked all fuses and they are good. I just have a problem locating the relay. I think i saw it right above the fuse box under the dash in the driver side but i'm not 100% sure.
View 11 RepliesFord F-150 (2004-2008) :: Reverse Lights Not Working
My reverse lights do not work and it is not due to the bulbs. Guy at autozone said it is the neutral safety switch. Does this sound correct? And I have done work on my truck myself, is this a difficult fix?
View 6 RepliesFord Excursion :: Reverse Lights Quit Working
I have checked the fuse number 38 and it's fine, and I've also checked the bulbs and they look good. Where else do I look to check for problems with my reverse lights not working? I just had my transmission rebuilt, and wondering if a sensor or something went bad?
View 1 RepliesFord F-150 - 1997-2003 :: Reverse Lights Not Working
I have an automatic 5.4L (L code) 2000 Ford F-150 and I am having problems with the reverse lights not working when I place the transmission in reverse. Fuse #5 in the passenger compartment fuse panel is good and both reverse lamps are good as well. I have also metered the LB/PK input wire at DTR sensor and it is reading 12 volts when the ignition is in the on position. I have also the metered the BK/PK wire output wire at the DTR and this wire also reads 12 volts when I place the transmission in reverse. I have checked continuity from the BK/PK wire at DTR to the BK/PK wire at the reverse lamp socket and I do not have continuity. I then ran a fused jumper wire from the BK/PK wire directly to the BK/PK wire at the reverse lamp socket and the lamps will light up when I place the transmission in reverse and will also turn off when the transmission is placed back in park. So it seems that the DTR is not defective. I'm not sure what else to check. Obviously the BK/PK circuit is open at some point between the DTR and the reverse lamp socket, but I'm wondering if there is something else that I need to check. The vehicle is also equipped with a factory trailer tow package
View 3 RepliesToyota - Corolla :: 1999 - Brake And Reverse Lights Not Working
Brake and Revers lights not working on 1999 Toyota Corolla? I have checked fuses and wire connections with no results. My brake and reverse lights just stopped working yesterday and I don't know what else to check.
View 1 Replies