Accent LC (2000-05) :: 2001 1.6L Manual Tranny Just Went Out
I have also owned a 2001 hyundai accent for almost 6 years now. This is the vehicle I drive to and from work. Today I was pulling off the on ramp onto the interstate and when I shifted to fifth-year it took for a few seconds and then all of a sudden I had absolutely no pull in 5th gear. There was a small pop sound but I can't be too sure exactly what it sounded like. And there is a really bad rattle from the tranny whenever the car is running 2000 RPM in fifth gear any higher than that then there's no noise at all and no pull. The RPMs just go up as if you're revving the car in neutral. I just wanted to know if that pretty much tells me that fifth gear is gone and I need to replace the transmission or have it rebuilt.
My other question is I've been looking up on the Internet to find a replacement transmission and so far I found out that for the 1.6 L if my car was made after March 8, 2001 that it requires a different transmission. But my car was built in September 2000 and I was wondering if the manual transmission was the same on the 1.5 L and the 1.6 L.
Santa FE SM (2001-06) :: Tranny Is Losing The Clutches
We have a 2003 Sante Fe 2.7l that looks like the tranny is losing the clutches. Not ready to give up on it as the engine is still strong even with 176000 miles.
View 9 RepliesSanta FE SM (2001-06) :: Occasional Surging / Bucking In 2.4L Manual Trans
I've got a 2006 2.4L manual trans - runs great, except every once in a while, at low r.p.m., it surges or bucks. Sometimes, I press the gas and not much happens for a second then it takes off.
Other - much more rare - times it bucks like a jackrabbit a few times until I let off the gas, start over, and it accelerates fine. And most randomly of all, the idle seems erratic - not rough or jumping all over the place, but not always at the exact same r.p.m. Or if I come to a stop, the idle will drop really low for a second, then "wake back up" and idle normally.
But then most often of all, it drives normally. Anyway, step one was to run a tank of premium gas with a good injector cleaner. Which I'm doing now. Wondering if it's spark plug wires?
No "check engine light" at any point during this. All maintenance up to date; recent spark plugs; 187,000 km.
Santa FE SM (2001-06) :: Hard To Shift Gears (Manual Transmission)
I have a 2004 manual transmission Santa Fe. I've maintained it very well since new.
About 6 months ago I noticed it was getting difficult to manually shift gears. It wasn't grinding or anything, just "hard" to get it to go into the various gears while driving. Before, I could shift into any gear with just 2 fingers on the gearshift and it was smooth as silk.
I went in and had the gear oil changed. This was something I didn't even know needed to be changed and the guy said most people never do. They showed me the oil they took out and it looked more like black water than oil and smelled kinda funky. They changed the gear oil out, but still no difference, and in fact it's getting worse.
The best way to describe it is the only way I can really shift gears now is to find that "sweet spot speed" where the gears will change on their own (so to speak). I find it particularly difficult going from 1st to 2nd, such as when starting from a stop light. People almost rear-end me now as it takes me longer to get it into 2nd gear.
Once in gear it runs perfectly, no problems. The clutch seems to be working normally, except perhaps while stopped in 1st gear, it sometime seems to jerk a bit, and I find this most noticeable if I'm stuck in very slow moving heavy traffic with the constant stopping and then moving forward slightly and such.
It is almost impossible to "gear down" into a lower gear unless I'm at the speed where it would normally go into that lower gear on it's own. The best way to describe it is how it is possible to drive a standard transmission car WITHOUT a clutch if you shift at just the right time/speed. But I DO use my clutch, but if I'm not close to "that speed" it's really, really difficult to force it into another gear, and the few times I do try and force it, I'll often get a bit of grinding.
Santa FE SM (2001-06) :: Tranny Slipping - Power Loss When Going Uphill And Has To Downshift
I just recently bought an 06 Santa Fe with a 2.7l v6. It was a rebuild. It had been hit in the left wheel. The lot put a new fender, suspension parts, axle, etc. It only has 25k actual miles.
We took it on a 100 mile trip today. I noticed if I am going up hill and it has to downshift, it feels like it looses power. The car continues to slow... Like the tranny is slipping. I stopped at Walmart and found the tranny fluid wouldn't even register on the dipstick. I bought Valvoline max life tranny fluid that matches the sp3 specs in the manual. I had to add almost 3 quarts before it was full. I think they may have forgot to add fluid back to replace what leaked out after they replaced the axle It didn't seem to work though when I continued to drive. After I stopped and let it cool about 30 minutes, it did seem a little better.
I guess my question is should I replace the tranny fluid? If so, what should I replace it with? Is there anything else what could be causing this now?
Santa FE SM (2001-06) :: Noise While Turning Sharp In Both Directions - Tranny Fluid Leaking
Noise started a day earlier, drove slow and listened to the noise while turning sharp in both directions. Was noisy at full turns and mostly quiet going straight. At higher speeds a slight wine could be heard.
It was a clunking, grinding noise with a little steering bind and pulling. I assumed it was cv joints but but after jacking up the front end to inspect, I have tranny fluid leaking from between transfer case and tranny.
Last thing I expected was tranny, It shifts fine and just started leaking, NOW what am I facing.
Geo :: Manual Tranny Won't Shift Into Gear From Neutral
1993 Geo Prizm with some odd 275,000 miles on it. Was at a stop sign, in first gear, and gave the car some gas. Very quickly it jumped out of first gear and stopped moving abruptly. Tried to get it back in first gear and it just stayed in neutral. Had to push it to the side of the road. Tried putting it in any gear and it wouldn't go. Then tried to have the car running in neutral and let up on the clutch and as soon as I started letting up on the clutch, something (like metal) started grinding. Pushing the clutch it (in neutral) stops the grinding. So, do I need a new clutch? New transmission?
View 11 RepliesElantra MD (2010-15) :: 2013 - Turn Off Manual Tranny Shift Indicator
Is there a way to shut this feature off. I don't need to be told when I have to shift or down shift. I thought the manual tranny E's had the ECO button which would turn this feature off, but there's no button.
View 5 RepliesFord Ranger / B-Series :: 1991 4WD Manual Tranny Locks Up After Going Forward A Few Feet
My 4x4 4WD Ranger has a 5 speed manual tranny that locks up after going forward a few feet. It can back up all day long but locks up going forward. some god awful noises (grinding, clunking, etc) come out of that gearbox. the 4wd is electrically operated. the ? is , can this tranny be rebuilt with a kit? I'm having great difficulty finding a replacement. Are bronco II's compatible? Engine is 2.9L V6. On disassembly I found 2 meshing gears with broken teeth.
View 5 RepliesSonata NF (2006-10) :: 2009 - How To Detach Interior Rear Door Handle
I'm having trouble figuring out how to remove the interior rear door handle from my 2009 Sonata. My wife scrapped the back door along a concrete parking post. I was able to find a replacement door in the same color, but the interior doesn't match. I'm able to get both door cards off but cannot for the life of me figure out how to remove the inside door handle.
I have: removed the screw and slid the handle over to get it off the side of the door. Popped the two cables off the door housing and was able to remove the cable from the door handle connection. But for the lock switch mechanism, that appears to be encircled by plastic and I can't see a way to remove it without breaking the locking mechanism.
Ford Super Duty (1999-2016) :: Headliner Fabric Starting To Detach?
The headliner by the front windshield is starting to come off the foam headliner. It's a small portion now but can get worse over time. It's not enough to warrant replacing the whole headliner, so I was wondering what can be a temp solution for now. Hot glue, thumb tacks, tape? I only noticed it because I had the windows down and the wind must have caught the fabric and made it flap around.
View 3 RepliesSanta Fe (DM - 2013+) :: Tranny Lagging In Particular When Shifting From 1st To 2nd Gear
I have a 2014 2.0T AWD Limited, now it's about 9000 kms so far with regular maintenance at dealer. Recently I have found the tranny is shifting a bit lagging, in particular shifting from 1st to 2nd gear. I didn't think it was like this when it was new, not sure if it's something wrong, or now I'm getting more used to the shifting and start complaining.
View 3 RepliesSanta Fe (DM - 2013+) :: Tranny Slipping In 1st Gear At Around 3k RPMs
So dont know whats going on, but after my santa fe sat for a day, I went to go for a drive and when I left the house, the tranny slipped in 1st gear at around 3k rpms. The rpms just shot up, hammered into 2nd, then drove off as normal.
I couldn't get it to repeat it after that.
Facts:
-Car in eco mode
-Car sat for at least 24 hours
-Outside temp 70F
-slippage happened on takeoff at 3k rpm
-No CEL's
-around 11500 miles
What it could be? Should i take it in to hyundai? OR wait and see how it drives the next couple days.
Santa Fe (CM - 2007-12) :: Doors Not Unlocking (using Fob And Manual Key)
I just came back from a 3 day trip and went to get into my car with my regular FOB and it won't work. I tried to open the door using the actual key in the front driver side door (the only door with a key hole) and it would turn but not unlock.
What could be wrong? I've had the battery die on me before and I was able to get into the car to boost it, so I don't think its the battery.
Just find it strange that the FOB AND actual key won't open the door (even though the key turns).
Santa FE SM (2001-06) :: 2.4L Engine Running So Hot
This little engine runs very hot. To make matters worst the radiator fan comes on high on the gauge temperature reading unlike other cars I have had in the past. What else to do to run the engine cooler without affecting fuel economy? I wish there was a way to make the radiator fan come on at a lower temperature.
View 5 RepliesSanta FE SM (2001-06) :: Engine Misfire In Cylinder 1 And 4
2002 Hyundai Santa Fe 2wd 2.7L 175,000 miles
Having misfire in #1 &4, new plugs, new wires, new coils, new cam and crank sensors, cleaned and tested fuel injectors, checked injector signal, checked timing belt.
Swapped around plugs, wires and injectors(keeping same firing order) and the # 1 & 4 will not fire. There is spark to the wires and plugs and gas thru injectors but no detonation.
With plenum and exhaust manifold removed (front only) visually checked valves. Installed new oxygen sensors while exhaust was out. Tested ecu fuses in black relay box in engine compartment.
Engine stars first time ,every time but only runs on 4 cylinders. Check engine light code reads no 4 cylinder misfire.
Santa FE SM (2001-06) :: 2004 3.5 Engine Will Die Randomly
Engine will die randomly. After sitting for half hour it will restart. It has been to the dealer, it sets no codes but when it dies all lights on dash come on just like when you first start car. It has 75k on it timing belt replaced new plugs and wires. Dealer kept it 2 days and could not replicate the problem.
View 2 RepliesSanta FE SM (2001-06) :: Smoking Engine When The Defrost Is On
When I turn on the defrost in my 02 santa fe, the engine smokes. when i'm parked and turn on the defrost, the car stalls out.
What I think is the timing belt seems to be making a funny noise, and my wife thinks she saw the smoke coming from there. it looks to be in good shape, though.
Santa FE SM (2001-06) :: 3.5L V6 Engine Shuts Down While Driving
3.5L v6 173k. Engine shut down twice while driving. Started right up each time. From what I have seen in the forum it could be the Crankshaft Position Sensor. If it is the CPS, should I have the timing belt done at the same time?
View 4 Replies