Corolla / Matrix 2009-13 :: Installing A Power Cord In Front Of Dash Near Windshield?
I would like to install a usb power cord that would somehow run out from the front of my dash (near the windshield). How difficult is this and have others on this site done it (links)? I would like to route the wire to either my GPS or cell phone mount and not take up a cigarette lighter plug.
View 1 RepliesCorolla / Matrix 2009-13 :: Installing A TRD Exhaust?
Owner of a 2011 Corolla S and wanting to install a TRD exhaust.
View 1 RepliesCorolla / Matrix 2009-13 :: Dimming Headlights If Roll Up More Than One Window At A Time
I've got a 2013 Corolla S with an upgraded sound system. Well when the vehicle is running and its in park or stopped and I turn the wheel, the headlights dim. My headlights also dim if I roll up more than one window at a time. I've been slowly trying to narrow down the issue but with no such luck. I have a 1600 watt amplifier and two, 800 peak watt subwoofers.
View 4 RepliesCorolla / Matrix 2009-13 :: Installing New Stereo With JBL Speakers?
I have a 2009 corolla XRS with the JBL speaker package and recently received a new stereo GPS unit from eonon, the GM5169.[URL] Their website says its suppose to work with the model car and year, but did not say anything about not working with the JBL speakers.
When I went to install it yesterday the wiring harness did not match up with the set up that was already in the original stereo. The only one that did connect was the controls for the steering wheel.
Corolla / Matrix 2009-13 :: Car Is Bouncy After Installing Coilover
I just installed BC BR type coilovers on my 2010 Toyota Corolla S and now even driving at 55 on a smooth highway my car is a bit bouncy. Its really bouncy if I hit a dip or hole. The dampening setting is still at factory setting which is 8 clicks from full hard. I haven't lowered the car anymore than just putting the coilovers on so its about .5-1 inch lower than stock I would say.
View 11 RepliesCorolla / Matrix 2009-13 :: Idle Rough And Throttle Body Will Shut The Car Down
Having problems with a ECM and throttle body for 2010 Corolla S? My corolla will idle rough and the throttle body will shut the car down to where it is inoperable. It throws codes and shuts the VVT down. The car currently has 56k miles on it and has been to Toyota 3 times in 3 months.
The first time they say they replaced the ECM, I really don't think so. 24 hours after we picked the car up it shut down again. The second time we brought it back in they said the brake light bulb caused the throttle body to shut down.
It had to go back again this week after it shut down again in traffic when it was idling. Toyota said the throttle body had to re-learn the idle again from when the ECM was supposedly replaced.
Corolla / Matrix 2009-13 :: Installing LEDs On MAP And License Plate
Combo of interior and internal LED bulbs. What particular bulb type to get for my MAP lights and license plate lights.
This was suggested by V-Leds for my license plate... [URL] ..... What do you think?
They did not suggest any for the MAP light, I'm thinking these are the ones... [URL] ......
Corolla / Matrix 2009-13 :: TPMS Light Did Not Show Up After Installing New Tires?
Yeah, like what I said on other thread (what did you do....) I installed new set of tires. I know most of guys here prefer not to have light on their dash, but I was worried because after I installed it the light did now show up even my new tires doesn't have TPMS sensor.
View 4 RepliesCorolla / Matrix 2009-13 :: 2011 - Installing Amp And Subs - How To Do Radio Wiring
I am trying to install the amp and subs that I have. The radio doesn't have a rca jack on the back and I don't know which wires I am suppose to splice into.
by the way I just purchased my 2011 Corolla S 2 weeks ago n loving it!
Corolla / Matrix 2009-13 :: 2012 - Power Windows Not Working After Installing New Audio System
After installing a new audio system to my corolla (front/rear speakers, amp) all of my power windows stopped working. None of the controls from any of the doors will work. What could be the problem? A blown fuse perhaps?
View 4 RepliesCorolla / Matrix 2009-13 :: Installing 2008 Toyota Tundra Head Unit On 2013 L?
A friend of mine is giving away its head unit (it has video) from a toyota tundra 2008, can it be installed without too much trouble on my corolla 2013 L?
View 1 RepliesCorolla / Matrix 2009-13 :: Installing A Rear View Mirror Gps System With Built-in Backup Camera On 2011?
I am looking to install a rear view mirror gps system with built in backup camera on my 2011 Corolla S. I have been searching for various different types and so far I have found these two links which look to be suitable.
will the wireless camera work good or is it better to get a wired one? Sounds like the gps system included maps for Canada & US. I am not sure if the camera will fit properly on this car or will it stick out. Also whether running a wire from the mirror to the camera will be challenging.
[URL]
Corolla / Matrix 2009-13 :: After Installing Cruise Control Horn Won't Work - Cruise Lights Up On Dash Borad?
I'm at my wit's end trying to install cruise control in my 2009 Corolla. I thought it was a relatively easy install, but then after putting the airbag in place, I find that the horn no longer works. I test out the cruise control, and the green "Cruise" lights up on the dashboard..but it doesn't actually work.
View 9 RepliesPassat (B6) :: Installing Springs - Can't Get The Front Strut Tower Out Of The Lower Clamp
We have spread it as much as we can and it's come up about 2 inches - then stops,
View 8 RepliesCorolla / Matrix 2009-13 :: Front End Rumbling / Vibration Around 20 - 25 Mph
Recently purchased my first Toyota, a 2012 Corolla S with 76,000 miles on the ODO. I have a concern about a front end rumbling.
First, the problem...
This "rumble" (the best way I can describe it) starts becoming noticeable around 20-25 mph, depending on the condition of the road I'm on (it could be lower, but I'm in Michigan, all the roads are bad here). This rumble isn't a noise, but more of a low frequency sensation that can be felt in the car and through the steering wheel, and vibrates the rear view mirror. The rumble comes and goes, it isn't constant. Sort of like driving over a rumble strips put on roads before stop signs/intersections, it seems to have an oscillation to it. The rumble intensifies very little with speed. It doesn't seem to oscillate any faster or rumble much harder, it's just there.
Things I've ruled out...
Brakes. When I bought the car, the first thing I noticed was that the front brake rotors were slightly warped, so I installed new rotors and good pads. That didn't get rid of the problem, though I didn't really expect it to.
Tires. The previous owner had seriously over-inflated these tires. Once taken down to their proper pressure, they were noticeably cupped down the middle. These tires were also horribly noisy would not balance, so brand new tires went on (Michelins). The new tires greatly improved the ride, reduced noise, and got rid of a lot of other shakes and vibrations, but the "rumble" remains.
Wheel Bearings. I'm not 100% on this one, but as far as I can tell, it's not the wheel bearings. I've taken the car out on twisty roads and there is no change in the rumble through hard turns, nor any additional vibrations of any kind. Usually bad wheel bearings will exhibit some noise or vibration when being loaded in a turn, but not in this case, so I've ruled them out.
Things I'm not sure about...
CV Joints. I've never had a CV joint go bad or fail on me, so I am unfamiliar with the common signs and symptoms. I have inspected the boots, and they appear to be in good condition and crack free, though that doesn't mean a joint isn't failing. There's no clicking during slow sharp turns, but I think that would only present itself if an outer joint was failing. I'm going to get the car in the air this weekend to do a drain and fill on the tranny (the fluid is getting pretty dark, so I want to get some new in there).
I drove a Ford Focus for the past 10 years and a Ford Contour for 10 years before that, putting over 200,000 miles on both, and never experienced any sort of problem like this.
Corolla / Matrix 2009-13 :: Replacing Both Front CV Axles
My Axles started to make noises couple months ago While making Sharp turns. I bought some new axles for the front, but this will be my first time replacing CV Axles.
Any tips and or recommendations on what to do and not do, and tools to use? I watched a couple Youtube videos already. I plan on changing them out this weekend.
Corolla / Matrix 2009-13 :: Click In Front Wheel?
There Is a click in my front wheels that is audible as I slow down. What is going on. nothing else is wrong with the car. I have a 2013 corolla le....
View 3 RepliesCorolla / Matrix 2009-13 :: How To Change Front Door Speaker
Speaker brackets and bracket preparation.
View 2 RepliesCorolla / Matrix 2009-13 :: End Link Tab On Front Right Coilover Bent
So last week I bought and installed a set of Megan EZ street coilovers for my 2011 corolla s. Everything was installed correctly and I lowered them as far as they would go without messing with the spring preload. They don't rub and I don't bottom out and everything was going fine until I pulled the wheels off to re plasti-dip them. At this point I noticed that the end link tab on my front right coil-over was bent. After doing some research I have found that this is a common problem when you lower a car and don't adjust the sway bar preload with adjustable end links. However I have looked high and low on the internet and cant find adjustable end links for a 2011 corolla. I can try and bend the tab back before it breaks or if it does break I can re-weld it back on but I don't want the problem to persist.
View 10 Replies