Passat :: 1997 Volkswagen - Engine Compartment Sounds Like Vacuum Cleaner
Recently my car has been doing some weird things. After driving it for about an hour, I get a sound from the engine compartment that sounds like a vacuum cleaner. It's fairly loud, but it's mostly just noticeable from the outside. The car continues to run, but if I turn it off, it doesn't restart (does not even crank). Last night I was driving at about 55 MPH and all the electronics went off and then came back on. In other words, the radio restarted and all the lights turned off and back on. The headlights turned off, but they did not come back on no matter what.
View 2 RepliesPassat (B5) :: How To Replace Passenger Side Turn Light Assembly
I was driving the other day and the lens on the turnlight assembly apparently fell off. I've ordered a replacement assembly and I'm planning on trying to replace it tonight. How to get the assembly out and how to install the new one.
1998 Passat GLS 1.8T ....
Ford Ranger / B-Series :: Top End Engine Cleaner
Does running a can of top end cleaner through your engine like Seafoam foul your oxygen sensors? should they be removed beforehand?
View 3 RepliesGolf IV / Jetta IV :: CEL, TC Light Never Went Off / Sprayed MAF Cleaner On Sensor
.About a week ago NC got some really bad rain and in about 5 minutes the roads were under water. I had to end up driving through about a foot of water to get home, then parked the car. On my way home from work the next morning my car barely made it home, would cut out over 2k rpms and die if i didn't push the clutch in.
I sprayed some MAF cleaner on the sensor and tried that, it now will not idle when slowing down and will shut off every-time while rolling. (Also, while it is running it idles HORRIBLY and doesn't seem like it wants to pull boost efficiently)
I unplugged the maf and it does run a little better but when i pull the full 21lbs of boost then let off of the gas it dies.
Also i scanned the CEL and it says something about the MAF, i cleared it but the TC light never went off. and the CEL came back on in minutes.
Golf V R32 :: 2008 - Vacuum Cleaner Sound Coming From The Engine At Start Up
I recently started to notice what sounds like a vacuum cleaner coming from the engine at start up, usually in the morning. The sound continues for about a minute or less then goes away. Haven't noticed it after repeated starts during the course of the day. Car runs fine, no CEL's.
View 4 RepliesPrius (Gen 2) :: 2005 Brake Light Dim - Light Assembly Or Electrical?
my 70K mile 2005 passenger side brake light is sporadically dim (5 or 6 of the LEDs light up dim) and occasionally (but rarely) is fully bright. The driver side brake light and all of the other lights work fine.
Does this sound like I need to replace the whole assembly or have the electrical connections and voltage checked?
Also, I assume that the tail light assembly removal instructions that are posted for the 2007 are the same as for the 2005.
Passat (B6) :: Oil Leak From Cam Cover Assembly
I noticed my '08 TSI wagon has been marking it's territory, couldn't figure out where the leak was coming from so I ran it into the dealer. Turns out the oil is leaking from the cam cover assembly & they said it's a seven hour job to fix it. And while they have it torn apart, anything else I should replace?
View 6 RepliesPassat (B5) :: 2000 - How To Remove The Viscous Fan Assembly
I'm doing an install on my son's 2000 passat V6 30 valve.
I have the front rad pulled out and there is plenty of room to work. How do I get off the viscous fan assembly. I removed the fan's 3-4 allen bolts, I now need to get the assembly out. I also removed one of the long allen bolts in the actual assembly. I have the fan ribbed pulley secured with an old serp belt and grip wrench. I am trying to losen the large nut behind he fan assembly. I have attached a photo to point of reference. I may have a manual next week yhat may explain all this.
Passat (B6) :: Side Mirror Assembly Removal?
Looking for a DIY for removing the side mirror assembly? I have to replace the whole thing.
View 12 RepliesPassat (B5) :: 2000 - How To Get Inside Of Headlight Assembly
New owner of a 2000 Passat. The headlights are dingy on the inside and I would like to be able to clean them. How I can get to the inside of the headlight assembly? Can't stand the look of them like this!
View 13 RepliesPassat (B6) :: Bolt Failure On Oil Pump Assembly?
Bolt failure on oil pump assembly in 2.0t FSI engine
View 9 RepliesPassat (B5) :: Moisture In Taillight - Removing Assembly Part
I need to replace my passenger side tailight assembly due to moisture inside of it. Is it hard to take the assembly apart? If it is not hard than how do i do it. I already know that i have to go into the compartment in the back of my 02 1.8 wagon, but from there what do i need to do?
View 4 RepliesPassat (B5) :: Center Dash Vent Assembly Removal?
How to remove the center (upper, right above the radio) dash vent assembly on an '04 Passat (I assume many other years would be similar). I have a rattle/squeek in there that I'd like to address. Sliding a credit card in between the vent/dash provides some improvement, so I'm thinking if I could get the assembly out and shim and/or lube it I might be able to resolve the problem.
View 2 RepliesPassat (B7) :: Passenger Side Headlight Assembly Replacement
I am in need of replacing the passenger side Front Headlight assembly. I was wondering, how to assemble it outside of a repair shop. I was also looking to possibly get the part number so I can make sure I am purchasing the correct product for my 2012 VW Passat SE.
View 8 RepliesPassat (B5) :: Exhaust Broke Between The Turbo And Cat
So about 30 minutes ago my exhaust broke between the turbo and cat. I guess I could weld it back but the pipe is a little rusty. Should I just get a turbo back and call it good and if so what brand and where do I get one for a 01 passat 1.8t
View 1 RepliesPassat (B6) :: Oil Cap Plastic Cylinder Broke / CEL Lit Up
I got a CEL this morning and the car was driving rough, tach bouncing at idle so I popped the hood and the plastic funnel that the oil cap screws into was completely broken off from the top of the engine. I was picking little slivers of plastic from it out of the hole in the pic. Fortunately the oil cap actually screwed into the spot where the plastic cylinder had broken out of. Not sure if that's by design but it worked and the car drove ok after.
View 6 RepliesPassat (B6) :: How To Remove / Replace Left Outer Taillight Assembly
2008 Wagin .... Specifically, how do I remove the reflector plate that hides the bolt?
View 3 RepliesPassat (B5) :: Shift Linkage Bracket Broke
Iv got a 2000 passat 1.8t and the shift linkage bracket broke, so i got a new one but my problem is how do i get the linkage cable off the old one, and onto my new one. Is the cable supposed to be able to break into two parts.
View 2 RepliesPassat (B5) :: Oil Dipstick Tube Broke In Half
I was checking the oil this morning before getting ready to drive (for an hour) to the in-laws for Christmas, and the Effing orange plastic dipstick tube broke about halfway down. Now I'm afraid to drive for an hour at highway speeds, for fear that a lot of oil might come out of that compromised Effing orange plastic dipstick tube part -- would you all agree that I should not drive the car? Figures this would happen on Christmas Eve when nothing is open.
View 6 Replies