Prius (Gen 3) :: Plastic Piece Under The Car Broke After Scraping
I heard some scraping under my car and pulled over to check it out and the plastic piece under the car was hanging down. I took it off all the way so it wouldn't get damaged any more, and took it to the dealer. The piece was torn off in almost a perfect straight line, which they told me was from the piece being bent for oil changes. They didn't have the part in stock and I was going on a long trip the next day, so they put the piece back in place with new clips and zip ties. The dealer said it should be replaced at the next oil change which will be 60k for me.
View 11 RepliesPrius (Gen 3) :: Black Plastic Underneath Front Area Broke
I live in Michigan and we recently had a 8 inch snowfall. While parking my 2010 Prius it bottomed on the snow pile which took two pieces of black plastic off of the underneath front area of my car. I assume the plastic is for aerodynamics.
View 9 RepliesFord F-150 - 1997-2003 :: Sensor Broke In Cylinder Head?
I have a 1999 Ford E150 4.2l. My cylinder head temp sensor was dangling but still connected to the sensor... the connector was loosed from the filament but was still connected by exposed metal pins.
I figured I would replace it like i did to my ECT by the Water Pump. So I pulled the connector out and it started to leak...a little. and when I put the socket on it I instantly broke the sensor flush with the Cylinder Head.
I researched on here and found many people believe the CHT gives info to the Dashboard Gauge and the ECT is used by the ECU. I thought that was correct because I had ECT readings from my scantool...and my Dash Gauge never worked. When I found the dangling CHT I figured it was never working.
So I JB welded CHT hole. figuring i would fix it properly later. I replaced the ECT and expected everything to go back to normal.. No gauge reading on dash and a scan reading with no codes.
I want to replace the CHT sensor properly. Do I HAVE to remove the manifolds. Or do you think its safe to drain the coolant and drill it out. Its easy access. Im worried about all the tiny pieces getting into narrow passage ways.
I am almost 100% going to drill out. Manifold sounds like hell and its getting cold. What sensor controls what? Can I drill it out safely?
Ford Super Duty (1999-2016) :: 2000 - Master Cylinder Reservoir Plastic Cracked?
my 2000 f550 master cylinder reservoir plastic is cracked from vibration and it would be good to know if it can be replaced separately than having to purchase a new complete unit.
View 2 RepliesPassat (B5) :: Exhaust Broke Between The Turbo And Cat
So about 30 minutes ago my exhaust broke between the turbo and cat. I guess I could weld it back but the pipe is a little rusty. Should I just get a turbo back and call it good and if so what brand and where do I get one for a 01 passat 1.8t
View 1 RepliesPassat (B5) :: Shift Linkage Bracket Broke
Iv got a 2000 passat 1.8t and the shift linkage bracket broke, so i got a new one but my problem is how do i get the linkage cable off the old one, and onto my new one. Is the cable supposed to be able to break into two parts.
View 2 RepliesPassat (B5) :: Oil Dipstick Tube Broke In Half
I was checking the oil this morning before getting ready to drive (for an hour) to the in-laws for Christmas, and the Effing orange plastic dipstick tube broke about halfway down. Now I'm afraid to drive for an hour at highway speeds, for fear that a lot of oil might come out of that compromised Effing orange plastic dipstick tube part -- would you all agree that I should not drive the car? Figures this would happen on Christmas Eve when nothing is open.
View 6 RepliesPassat (B5) :: 2001 - Handle Above Handbrake Broke?
In my 2001 Passat, the handle / compartment above the handbrake has a problem - it can be rotated (as to reveal the compartment), but when I want to put it back to horizontal position, I can't, it always leaves a distance of 4-5 cm. I took out the black compartment to see what's inside, and I found out that it gets stuck because when I push the handle down, it doesn't rotate the shaft that holds the teeth (which are in charge of the several "steps" in the handle position) down so that the handle will be able to be put to a full horizontal position. Also, I found a orange-yellow-semi transparent plastic thingy near the teeth of the compartment part, and it was loose, it appears to be broken. Looking for a detailed (exploded) view of the part assembly (like in a Haynes manual)?
View 2 RepliesPassat (B5) :: 2001 - Timing Belt Broke?
Looks like my timing belt broke. I was taking my car out of the parking lot, and heard the warning chime. I tried to look at the warning light, I think it was the malfunction one. I heard a belt/ fan snap. The engine stalled and I dint try to resart the engine. I had it towed to the dealership and am waiting to hear from them. The engine dint make mucg of a noise but sorta just died. Does this sound like a timing belt? I am worried abt the damage. how much would it cost if it was a timing belt? my car only had 73k miles on it. It is a 2001.5 1.8t.
View 5 RepliesPassat (B7) :: Connector On HP Fuel Pump Regulator Broke Off
Hit a bump in the road, car hiccuped then EPC and MIL illuminated. Scanned it with Carista and showed low fuel pressure. Looked under engine cover... Lo and behold! Connector is plugged in but male portion on regulator is snapped off!!! Needs whole fuel pump assembly at 25,000 miles!
View 3 RepliesPassat (B7) :: 2015 - Turn Signal Socket Broke Off
So I had to replace a front ten signal bulb the other day and with almost no pressure, one of the small plastic tabs on the bulb socket broke off when I was trying to seat the new bulb into the headlight housing. The plastic socket looks like it's own piece that's removable from the wiring harness, but my dealer tells me it comes as a kit with the whole headlight housing and I'd have to replace the whole thing.
View 1 RepliesPassat (B6) :: Engine Light On - Air Cleaner Assembly Broke?
My wife called me on her way to work this morning and said her car(2.0T auto) was not running right and her engine light was on. We had it towed to the dealer and they said that the air cleaner assembly broke and was creating a false air run. The car has 33k miles and he said it was not covered under warrantee because it looks like somebody broke the part based on it being cracked in several areas. Well I haven't touched it and the last one to even open the hood on the car was them, when they had to replace the valve body 3k miles ago. How would that thing even break unless they did it? It was idling at a light, then started shaking and running poorly. I'm going back in tomorrow morning to talk to them about it, but I'm not sure what to say here...what do you think?
View 1 RepliesPassat (B5) :: On Remote Hook That Holds Spare Keys Broke Off?
here is my problem on a 02 passat. on the remote, the little siver hook that holds your spare keys broke off. i had a new spare remote that had never been programed. so what i did was to simply remove the blank key and replace it with the cut key. also i took out the computer chip (i guess that is what it is called) and put it in the new remote. so i have the same key with the same chip that has always worked only in a different fob. BUT when i start the car it will only run for a sec. or two then it will shut off and i will get 'imoblizer disabled' ???? everything else on the remote workes. this makes NO since to me at all and is driving me crazy.
View 3 RepliesPassat (B6) :: Tire Pressure Sensor Broke Off At The Valve Stem
We have a 2007 Passat. The tire pressure sensor broke off at the valve stem. In checking with the dealer, I was told the tire pressure sensor and valve stem are all one unit. My question is if you can use a regular valve stem and attach the sensor to it, or do you have to get the entire unit with the valve stem and sensor together.
View 2 RepliesPassat (B5) :: Plastic Or Oil Smell From Vents?
I am getting a plastic or oil smell from the vents. I read about this on hear a while ago but I didnt record the problem. What that is. Oil leak from engine seal? I don't know...
View 4 RepliesPassat (B5) :: Dull Headlights Plastic Covers
My 2000 GTI and 2001 Passat have dull headlights plastic covers. I did try a kit from autozone with sand papers and a liquid polish without good results - It was a great workout.
View 1 RepliesPassat (B7) :: None Of The Plastic Storage Areas Are Lined
One of the things that kind of annoys me about the B7 is that none of the plastic storage areas are lined. Hence, whenever you put something in them it rattles around when you drive. I was searching the web for a solution and ran across this product: [URL]...............
It is a flocking kit.
Passat (B7) :: Clunking Around The Plastic Inside Of Trunk Lid
I noticed something clunking around in the plastic piece that is on the trunk lid itself - the piece that covers the brake lights. When the trunk goes up or down, there is a distinct noise that is something rolling around in there.
I pulled off the access panel to get to the lights, but is does the rest of it just snap off if I pull at it or use a pry tool?
Passat (B5) :: Plastic Housing On Headlights Fogging Up / Yellowing?
The plastic housing on the headlights for my 2001 Passat wagon is really fogging up and yellowing pretty badly. Is there a way to fix the yellowing/fogging? If not, what are good replacement headlights that won't cost me an arm and a leg? I'll need the entire assembly, not just the bulb.
View 2 Replies