Golf V R32 :: Should Remove Taillight To Replace Bulb?
Got the light bulb symbol in the tach this afternoon. After checking it out, the LR inner bulb seems to be out. Am I correct in assuming I have to pull back the carpet, then remove 2 nuts/washers, and then remove the taillight lens/housing to replace the bulb? Any recommendations on bulb or just stay with OEM? My R32 has 88K+ miles and this is the first bulb to go...
View 5 RepliesPassat (B5) :: Moisture In Taillight - Removing Assembly Part
I need to replace my passenger side tailight assembly due to moisture inside of it. Is it hard to take the assembly apart? If it is not hard than how do i do it. I already know that i have to go into the compartment in the back of my 02 1.8 wagon, but from there what do i need to do?
View 4 RepliesPhaeton :: Steps To Remove Left Vent Assembly?
What are the steps to remove the left side vent assembly? The hinge is broken on my wooden cover and poking around I can't seem to get the whole vent assembly out.
View 2 RepliesPassat (B5) :: 2000 - How To Remove The Viscous Fan Assembly
I'm doing an install on my son's 2000 passat V6 30 valve.
I have the front rad pulled out and there is plenty of room to work. How do I get off the viscous fan assembly. I removed the fan's 3-4 allen bolts, I now need to get the assembly out. I also removed one of the long allen bolts in the actual assembly. I have the fan ribbed pulley secured with an old serp belt and grip wrench. I am trying to losen the large nut behind he fan assembly. I have attached a photo to point of reference. I may have a manual next week yhat may explain all this.
Passat (B5) :: How To Replace Passenger Side Turn Light Assembly
I was driving the other day and the lens on the turnlight assembly apparently fell off. I've ordered a replacement assembly and I'm planning on trying to replace it tonight. How to get the assembly out and how to install the new one.
1998 Passat GLS 1.8T ....
Phaeton :: How To Remove Taillight From Trunk
I've having difficulty removing the taillights from the trunk. I'm sure it is simple but there must be a trick to do this properly. I've removed the nuts but I can't bulge the "lockwashers" per the instructions. The threaded stud is a special design and has some type of spring mechanism. I tried removing one of these a few years ago and I broke the stud. How is this done? Below are the Bentley instructions which are not useful.
Volkswagen > Phaeton > 2004-2006
Electrical Equipment
94 - Taillamps Tail light assembly in luggage compartment lid, removing and installing
Removing:
-Switch off ignition, switch off all electrical components and remove ignition key.
-Remove trim for rear lid Body Interior - Repair Group 70 .
-Release the latching mechanism - arrow - and separate the connector.
-Remove bolts - arrows - .
-Remove the lock washers and the tail light housing.
Installing: Install in reverse order of removal, noting the following:
-If a new taillight is being installed, remove the protective foil from the gasket.
-Connect the connector.
-Insert the taillight into the body opening.
Note: When installing the taillight housing, pay attention to the gap dimensions.
-Gap dimensions of tail lamp assemblies .
-Move the taillight by hand into the correct position in the body, hold the position and then tighten the nuts.
-Tighten the nuts using 4 Nm torque.
-Coding or adaptation of the taillight is not required after installation.
-Check the rear light function, Rear light function, checking .
Golf VI R :: How To Remove LED Taillight Turn Signal
Was wondering how to remove the turn signal bulbs in the OEM LED taillights.. Ordered Some new bulbs and decided to see how hard it was to change out. Removed taillight and located socket the contained the bulb. Looks like it should twist to unlock but only turns a little. looks like it wants to turn counter clockwise.
View 2 RepliesPassat (B5) :: 2003 - How To Remove And Replace A Busted Lock Cylinder
How to remove and replace a busted lock cylinder. My wife's car got broken into and used something that punched in the driver's door lock cylinder. VW wants top replace a new lock cylinder. I've been able to remove the drivers door panel but I wasn't able to figure out the final steps.
View 1 RepliesPassat (B5) :: 2002 - Front Side Marker Lights - How To Remove / Replace
My 2002 B5.5 Variant received some "tough love" in a parking lot recently, with the result that one of the front marker lights (in the fender ahead of the front wheel, on the side) was broken. I see that I can push on the light housing and it'll move in a bit, but how can I remove the cover (the colored plastic bit) entirely to replace it with a new, not-busted one?
View 1 RepliesPassat (B5) :: How To Remove Front Turn Signal Socket To Replace Bulb
I have a 2003 W8 wagon and my front turn signal bulb went out. I need to replace it, but am having some problems. I removed the high beam cover to get to the turn signal socket, but I am having problem removing the socket. I was able to turn the socket slightly and was hoping I could just pull it back, unfortunately it doesn't seem to want to move. Is there a trick to remove the turn signal socket so I can remove the bulb? I don't want to force anything in fear of breaking something. there has to be a way.
View 1 RepliesKia - Forte :: 2010 - Left Rear Taillight Was Out / Fuse Blows Repeatedly
I have a 2010 Kia Forte, which I purchased in late 2011. I had not had the car for very long when I noticed that the left, rear taillight was out. My husband replaced the bulb and it still did not work. This led me to the fuse panel. The fuse was blown so not only the taillight was out, but also the front, left, parking light. I replaced the fuse and the lights came back on. However, within days, the lights were out again. I have replaced the fuse two or three times since then, but each time it blows again within days, so mostly, I am driving around without a tail light. What could be causing the fuse to blow repeatedly?
View 8 RepliesTouareg :: How To Remove Headlight Assembly
I can see where there is a 1/4 inch post that if turned will push the assembly out, but i can only get it to come out about 1 inch. Is there something else that has to be released ?
View 2 RepliesPrius (2004-09) :: Brake Light Out / Replace Whole Assembly?
My dealer wants to completely replace the whole tail light assembly because the rear passenger break light is out. Is this really necessary just to replace a light bulb? (2004 Prius)
View 10 RepliesCamry 2012+ :: How To Remove Map Light Assembly
I have a 2016 Camry SE.
How do I pull out the map light assembly? The whole thing not just the bulb covers.
I tried pulling from the rear but it won't budge and created a crease in my headliner.
Is there a certain way to pull it down? I don't want to damage the headliner anymore since it's not even a week old yet.
Passat (B5) :: Repairing Rear Window - Remove Inside Left Gate Panel?
I have to repair or replace my rear window wiper/washer unit.
How do I remove the trim inside the lift gate? I saw two screws and removed them, but it's still being held in place. Is it near the indented handes? There seems to be little square plastic screw covers in there. I couldn't remove them (I was on the road) and didn't want to hack them if they weren't.
Touareg :: How To Remove Rear Turn Indicator Assembly
How do you remove rear turn indicator assembly so bulb can be changed?. Specifically is there another screw besides the two on the end of the assembly. Once the two are removed the assembly is loose but something is still holding the assembly.
View 2 RepliesSubaru - Legacy :: Replace Transmission Valve Body Assembly Code
I started my Subbie and all the lights just start going crazy on my dash. So I pulled of the road and started freaking out, Never had a hint of a problem. So I pulled in AutoZone and they ran the codes and now I'm being told I have to replace the brain to my transmission WTH? I don't own a DODGE!!! Had 3 different dodges and the tranny went on all. So I wont own one because of transmission problems. Now my Subaru has been parked since it can only get worse. Is this normal? All the error codes are...
P0700 Transaxle Control System (MIL Request)
P2762 Torque Converter Clutch Pressure Control Solenoid Control Circuit Range/Performance
Tiguan :: 2011 - Tail Lights Lens Broken / Replace Whole Assembly?
Last night I broke the tail light at the grocery store... I came out and there was a line of carts behind my car that a parking lot attendant was collecting. I added my cart to the end and went to shove them all out of the way, and he yells to me, "I got it! I got it!" so I leave them, get into my car, see him go past with a bunch of carts & back up. What this will run? Can I just replace the lens or do I have to replace the whole assembly? And is this something I can easily enough swap out myself?
View 2 RepliesLexus SC430 :: How To Remove / Reinstall Just The Lens In Rear Light Assembly
How do you remove and reinstall just the lens in the rear light assembly in 2002 SC430 ? I can see that it probably just snaps out using a screwdriver as a pry tool but want to be sure !
View 5 Replies