Passat (B6) :: Rear Brake Pads Wearing Too Quickly
My car has about 37k on it; and while the front pads look to be about 50% worn; the rears look like they are closer to 90%. Is this normal? The car is also sluggish while braking especially when the engine is being auto-revved to keep the system voltage up (a known problem). It also seems that the car will step into ABS lock-up mode too soon in a panic stop situation; which might also indicate that the brake system is biasing too much power to the rears; too little to the fronts.
I've never had a car wear the rear brakes more rapidly than the fronts; usually the rears are much more lightly utilized to reduce the tendency to skid. Is there any way to adjust brake bias? I'm getting ready to change rear pads and flush brake fluid.
Golf/GTI VI :: Front Brake Pads Wearing Unevenly
Today as I was adding pressure to my tires I noticed the front brake pads were wearing unevenly. Both outer pads wore the same. More "meat" on the inner section of pads than on the outer, evenly worn, just sort of slanted down as you move out towards the outer rim of the brake disk.
Is this normal? What would cause this? Should I have it looked at? I've never seen anything but even pad wear, perfectly parallel to the brake disk.
Edit for these pictures to clarify.....
Corolla / Matrix 2009-13 :: Rear Brakes Pads Sticking / Wearing Quickly?
At about 25,000 miles I had one of my rear brake pads sticking so had to change the rear brakes. The non-stuck pads on the other side looked decent still, so I'm assuming I'd have gotten quite a few more miles out of them if the one hadn't been sticking. Changed the front pads at about the same time, although they were in pretty good shape still (but it was taken apart already, so did them while it was apart and the chance was there). At about 50,000 miles later the rear pads are again unevenly (and I feel perhaps prematurely?) worn, and the fronts look fine. Is it something with the screw-type e-brake mechanism on the rear disc brake that lends itself to sticking? Or am I just especially unfortunate?
View 10 RepliesPassat (B7) :: Rear Brake Pads And Rotors Went Shot
So my car has 36 or so thousands miles and well the rear brake pads and rotors were SHOT! The rear rotor was falling apart and huge chunks were coming off. The issue stands now that I can't spread the rear caliper for anything, the ebrake is off too. I tried to use the C-Clamp trick but it honestly didn't even budge. I also opened up the bleeder and master cylinders cap just to cross that off the list when trying to compress. This is the hardest caliper I've ever had the misfortune of dealing with and I fear that the passenger side is not going to be any better. Aside from spending more money or renting the "tool" is there anything else to check because the C-Clamp trick has work on mine and my father trucks calipers.
View 3 RepliesFord F-150 - 1997-2003 :: Rear Brake Pads Removal
After removing the tires, I can't figure out how to remove the brake pads to change them. How to do it? Does the caliper have to come off? These are on the rear. 2001 F150 4X4...
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Rear Brake Pads Are Worn Out
Well I had a flat today, but that turned out to be a good thing. I noticed the rear brake pads are worn out. They are not metal to metal, but close. I have been looking at Rockauto, Pepboys and others. The funny thing is they never prompt or list different pads for the SRW vs the dually.
Are they the same including the parking brakes shoes? I was going to go with the OEM material or should I go with a ceramic pad?
Corolla / Matrix 2009-13 :: Right Rear Brake Pad Is Wearing Unevenly
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
Passat (B6) :: 2007 - Rear Brakes Are Wearing Out So Much Faster
I have a 2007 Passat with 47,000 miles on it. The dealer tells me I need new rear brakes now, but the front brakes have 50% life left in them. When I asked why the rear brakes are wearing out so much faster, he said VW rear brakes always seem to wear out twice as fast. Is this true?
View 3 RepliesTouareg :: Rear Brake Pads Low?
Just went to the dealership for 40k miles service and they told me my rear brake pads were low, around 20%. And they quote me $430 for replacement (Parts + labor). Should i go with it? or i better go buy parts from internet store and find some local mechanic install it for me?
View 9 RepliesPassat (B6) :: E-Brake Won't Release When Change Brake Pads?
Having issues with the auto-ebrake? My friend has a 09 passat with the push button ebrake. He was changing his brake pads when his ebrake will not release. He was told by VW to not use a c-clamp to depress them as they would mess up the sensors or something along those lines.
View 14 RepliesAccent RB (2012+) :: Rear Brake Pads Worn Out 30,000 Kms
Just had 30,000 km service done and was told the rear disc brake pads are almost completely worn out. The front ones are hardly worn and I'm not a fierce type driver who jams on the brakes or one who leaves the handbrake on..
I asked the service manager how come the rears are worn yet the fronts aren't - his answer was sometimes this happens.
Lexus SC430 :: 2007 - How To Change Rear Brake Pads
I am wanting to change my rear brake pads and . Looking for step by step instructions or photos.
View 1 RepliesPassat (B5) :: Brake Noise After Swapped New Pads
My independent mechanic just swapped out some PBR Deluxe pads that he put on with new rotors in June with with PBR Deluxe Plus pads. He did this free of charge because the front brakes were making a loud metallic clunk sound on the first brake application when backing up (weird, no?), and they were dusting like crazy. Back in the summer I followed the bedding-in procedure fellow Vortexers recommended. Aside from the clunk, the brakes were silent, though extremely dusty.
Well, after a couple of drives with the Deluxe Plus pads, I can say that they perform very well, just like the Deluxe pads before them. It's too early to tell if the dust issue is better, but the metallic clunk is still there, though far quieter than before (even with the windows open); I'd say its more of little click now.
But here's what I really don't like. I took the car out tonight to bed the brakes, doing 5 or 6 60-to-30 mph runs, followed by 5 minutes of 40-50 mph cruising with little braking and no real dead stops. All was good until I went to get gas afterward: as I slowed to <10 mph, I heard some squeaking from the fronts. Not hugely loud, but enough for me to be upset about.
Did I do something wrong? They were fine until the bedding-in run. Maybe the temperature (20s) played a role? I didn't think I went too nuts on them. I'm hoping I don't hear the squeak tomorrow. What about the persistent click I hear when braking for the first time in reverse? Could this be related the excessive dust with the PBR Deluxes?
Passat (B5) :: After New Brake Pads Rough Ride?
Background: I had new rear brake pads/shoes installed today. The dealership installed them, and let me know that the front wheels still have another 10,000 miles before they'll need new pads. I have 55,000 miles on my Passat. Back in August, I put new Nokian tires on.
So, when I took my car from the dealership, after they installed the brake pads, I went on the highway, and my ride felt different. It was a rumbly roughness, but it was subtle. I am not even sure if I am imagining it, but I don't think I am.
I checked the air pressure of the tires, and it's fine. The invoice from the dealership said "replace rear pads/shoes, service drums/rotors and check wheel cylinders". I do not know how any of that could make my ride have this slight roughness to it.
Ford 6.0L Power Stroke Diesel :: 2007 F250 - Rear Brake Pads Don't Fit
I bought new pads for my truck and the fronts went on with no problem at all, but when I got to the rear the tabs/ears on the pads are about 1/8 inch wider than the notch they are supposed to fit in. I bought part number BR-1067, which is supposed to fit but obviously doesn't. What part number should I have bought? My truck is a 2007 F250 Super Crew Lariat FX4.
View 9 RepliesPassat (B5) :: Rattle Which Sounds Like Brake Pads Came Unglued
My 99 Passat 1.8T eats brake pads and rotors like crazy. After about six months I hear a rattle, which sounds like brake pads came unglued. After a month of rattling, the pads must shift into a new groove on the rotor, and pulse like crazy. I can handle that, but this time the parts store gave me pads without the wire coming out of the pad. I thought the wire was just a brake wear sensor, and I figured I didn't need it, but now my ABS light is on. If that is a wear sensor Can I loop the old wire and bypass the system? I like having ABS. Also, with the two piece caliper, the spring holding the two pieces together broke. Can I get a new spring? Or do I need a new caliper? I appears the brakes function with the damaged spring, but I'm guessing the pads will wear unevenly. Or maybe the abs light is because the pads are seated funny because the caliper isn't sitting right?
View 4 RepliesPassat (B5) :: 1999 - ABS And Brake Light After Replacement Of Pads And Rotors?
OK, I just got back from having pads and rotors install on my '99 Passat. I was expecting this to clear up the brake and abs light problem but it did not. The brakes still feel mushy and the ABS light still comes on.What should I check? In the brake forum people suggested bleading the brakes, is this the next step? Any quick how to?
View 3 RepliesPassat (B6) :: 2006 - Replaced New Pads But Brake Fault Light Came On?
Put new pads on by 2006 Passat tonight. Disconnected the battery removed the calipers and used a 12 volt battery to retract the pbrake then pushed back the pistons. Buttoned everything up but when I started the car had the park brake fault light and car is now in limp mode (3rd gear only with harsh engagements.
Disconnected the battery again and will let it sit.
Passat (B5) :: Changing Pads On Rear Disc Brakes
I am trying to change pads on the rear disc brakes. I got everything apart but can't get the piston to retract to get the new pads in. I am turning the piston clockwise with needle nose plyers and it isn't retracting. What do I need to do?
View 7 Replies