Golf V R32 :: Front Tires Wearing Unevenly
My front tires had previously been wearing out a lot faster on the inside. I was told it was due to the front lower control arms, does this sound right? Is it possible and cost effective to just have the bushings rebuilt (replaced) or will i have to buy new control arms. How can I tell what my car actually needs? I just put 4 new tires on the car and am weary of driving it until i get this fixed.
View 11 RepliesCorolla / Matrix 2009-13 :: Right Rear Brake Pad Is Wearing Unevenly
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
Passat (B6) :: Rear Brake Pads Wearing Too Quickly
My car has about 37k on it; and while the front pads look to be about 50% worn; the rears look like they are closer to 90%. Is this normal? The car is also sluggish while braking especially when the engine is being auto-revved to keep the system voltage up (a known problem). It also seems that the car will step into ABS lock-up mode too soon in a panic stop situation; which might also indicate that the brake system is biasing too much power to the rears; too little to the fronts.
I've never had a car wear the rear brakes more rapidly than the fronts; usually the rears are much more lightly utilized to reduce the tendency to skid. Is there any way to adjust brake bias? I'm getting ready to change rear pads and flush brake fluid.
Passat (B5) :: (2003 1.8T) Rear Brake Pads Wearing Out
What's with the rear brake pads wearing out before the front brake pads. Took my '03 Passat in last week to the dealer for the recall and the service dept. guy said my brake pads were worn out. I took the car to my local mechanic who specializes in VW's. Sure enough, rears were almost gone but fronts still had plenty of meat left on them. Of course I had him replace the rears. But I always thought the fronts wore out first. Could this anomaly be due to ABS?
View 11 RepliesElantra MD (2010-15) :: GLS Aligned - Tires Wearing A Bit Unevenly
I have about 20,000 miles on my elantra gls with the stock 16" wheel.
I was measuring my tire tread and noticed that the outer groove of all 4 tires is down to 3/32 tread depth while all of the middle and inner grooves have about 5/32 to 6/32. My car was aligned about a year ago. Tires rotated every other oil change, i do oil changes at about 3,500 miles.
I drive pretty conservatively, though the street in front of my neighborhood is 50mph and has heavy traffic, so I have to take an aggressive about half the time I pull out of my neighborhood.
Ford 6.7L Power Stroke Diesel :: Rear Tires Wearing Unevenly - Tire Pressure?
I do 98% of my driving unloaded and almost never tow. (Kinda weird for an F350 huh) I know that the truck recommends going with 65psi front and 80psi rear but the rear tires seem to not be wearing evenly across the tread pattern. The edges still have the little rubber stubs sticking out of them even after almost 3000 miles. Should I be running a lower tires pressure in the rear when empty or should I just let tire rotations take care of the uneven wear. If I should air down, what pressure would be recommended? The front tires are wearing normally at 65psi and they have more weight on them then the rear.
View 14 RepliesGolf V R32 :: Front Brake Pads Makes Clacking Noise
The front pads on the R shift from one side of the caliper to the other whenever I move from forward to reverse they make a loud "clack". I thought it might be an O.E. pad issue, but I've changed the pads out to EBC's, but still no bueno. The new pads fit snuggly into the calipers and seemed to have solved the problem at first, but about 5k km's in, they're making the same noise.
I have anti-rattle springs installed, but they're not working. Is there supposed to be a pair of shims between the caliper sliders and the pads grooves that the previous owner removed for some reason? I don't think so, because that car only had 25k km on it when I purchased it; but you never know.
Golf VI R :: Changing Front Brake Replace Rotor And Pads?
Just got out of the dealer they said they recommend front brake change. They quoted me for ~730 just for Rotors/Pads/labor on the front (I am going to shop around).
I tried search Golf R Brakes info prior to posting but alot of the searches are for people buying Golf R brakes for Gti's.
1) Do I need to Replace Both Rotors and Pad at the Same time?
2) Currently Car is still stock and see's no tracks, the most car would see in the next 2 yrs would probably be stg 2+ if that. Would OEM Rotors + OEM pads be sufficient? or should i upgrade pads? Below is listing i found with some different pads options.
[URL]
3) Car is currently a 47.5k miles with oem brakes, should i just replace rears as well? even though dealer did not recommend?
4) SS Brake Lines, should i get them?
Lexus IS 2014+ :: Front Brake Pads Touching The Rotors / E-Brake Engaged And In Park
I noticed the front brake pads were touching the rotors when I was painting the brake calipers. I had my e-brake engaged and in park. I'm assuming the e-brake only brakes the rear wheels because the front rotors were still movable. Although the car still rides fine but I'm not sure if this is normal.
View 1 RepliesCorolla / Matrix 2009-13 :: Rear Brakes Pads Sticking / Wearing Quickly?
At about 25,000 miles I had one of my rear brake pads sticking so had to change the rear brakes. The non-stuck pads on the other side looked decent still, so I'm assuming I'd have gotten quite a few more miles out of them if the one hadn't been sticking. Changed the front pads at about the same time, although they were in pretty good shape still (but it was taken apart already, so did them while it was apart and the chance was there). At about 50,000 miles later the rear pads are again unevenly (and I feel perhaps prematurely?) worn, and the fronts look fine. Is it something with the screw-type e-brake mechanism on the rear disc brake that lends itself to sticking? Or am I just especially unfortunate?
View 10 RepliesGTI 337/20th Anniversary :: Front End Noisy - Brake Pads Rattling
Having trouble with front brake pads rattling? About a month ago, I replaced pads - rotors - caliper pins on my 20th GLI. I know these cars ride a bit stiff but it sounds like my front end is about to fall off. All brake parts were torqued to spec - I've gone through all T25/T30 torx front end screws etc and I just can't find the rattle??? This has only started within the last few days. Any other places to check for obvious loose bolts etc?
View 15 RepliesFord F-150 - 1997-2003 :: Front Brake Pads Replacement
I know on some cars and trucks you need a special tools to push the caliper back in. i just use a large c clamp to do the job. Question do i need any special tools to replace the front brakes pads?
View 7 RepliesCamry :: 2007 SE - Knocking Sound After Changing Front Brake Pads
Scion TC for Camry SE 2007.
I changed the front brake pads and resurfaced the rotors. After putting everything back together, I took the car to test drive it. The stopping power is fine and there is no squeaking or robbing sounds. However, when I apply the brakes at lower speeds moving forward there is knocking sounds the comes with the tire rotations. What is the reason for this sound?
This is my second time changing the pads and rotors, with the first with no issues. I put grease between the shams and the pads, and I sprayed the rotors with brake cleaner before the installation.
Ranger :: 96 Ford - ABS Yellow Light On After Front Brake Pads Replacement
I replace the frond brake pads. Press the piston caliper using a c- clamp. When my brake job is done, start the engine, pump the brake now the yellow light come on.
View 4 RepliesPrius (Gen 3) :: 2010 - VSC / TRAC Warning Comes On After Changing Front Brake Pads
I changed the front brake pads, took all the precautions during the change, did not disconnect the 12 v battery, pumped the brake pedal 12 times, started the car and no warnings. Now the brake pedal is a little spongy, if I press the pedal to the floor the VSC/TRAC light comes on, to reset it I have to press on the pedal again and the brakes do work.
View 11 RepliesPassat (B5) :: Yellow (Front Brake Pads Worn) Light Turning On Then Off
I have about 50,000 miles on my pads, they look 50% gone, but couple days ago I've got short "beep" and light yellow came on(circle with several small parts of larger circle). What and why? Rotors, pads, other?
View 4 RepliesPrius (2004-09) :: Died After Replacing Front Brake Pads / Can't Start Afterwards
I replaced the front brake pads the same method as a traditional car. (Popped out caliper. Pushed piston in. Put new pads in). I did not pump the brakes after installation (forgot to do so).
I drove off to test drive. A block later as I approached a stop sign, I smelled something similar to burning brakes (this might have been some of the oil I spilled when I added oil just before I left). Went to the next stop sign 100 yards away and was able to stop. Made a slow left turn and MFD displayed a warning and ABS (and maybe other ones too) light came on. I pulled over. I don't remember if the car shut itself or if I turned it off.
Now, I can not get the car started. Had car towed home with wheel lift tow truck.
Tried the following:
- Press brake, push Start: Car appears to power up then shuts down immediately. Lights appear on dash, then go out. The squares around P,N,D,R,B are the last ones to go out.
- Press start to go into ACC mode: Radio and clock power up without problems. Pressing start again results in same symptom above.
- Tried to read code with ODBII scanner: all I get is "ERROR". Appears that it's not linking.
Prius (2004-09) :: Brake System Failure After Changing Front Pads
2004 prius. I change the brakes on various cars all the time, and never had this problem. After I changed both sides, I started the car, and saw 4 lights:
- Red brake light
- The yellow exclamation light
- ABS light
- VSC light
The car now stops funny, and reading the service manual, it says that if there's a failure detected, that it will revert back to very basic braking (no abs, only fronts, etc..)... As I was exiting off the fwy, I realized this when one of my front wheels locked up, even and I was not stopping very well. Scared the crap out of me.
In any case, I can't see what I may have done which would cause a failure. The only thing I could think of is to bleed the brakes again, but I did this and think it's ok. Is there anything else I can check or is this something I have to get serviced? I saw another thread where they suspected the actuator, but it is somewhat a coincidence that it would go bad after I replace the pads? I'm not sure how the regenerative brakes works on a prius, and whether there's anything I could visually inspect to see if I bumped something???
Toyota - Camry :: Front Pads Started Making Noise On Brake Application
05 Camry, 2.4L, 47K. Replaced the front brake pads two months ago. I put in Akebono pads and did nothing with the rotors as the original pads were not completely worn out and there is no vibration whatsoever in the pedal.
The pads have recently started making noise on brake application. I'm getting ready to take them back apart and re-lube everything. Should I take some sandpaper to the pads & rotors to knock off any glazing? Do I hit it with a course or fine grit? I have not had this problem happen in the past and was thinking that maybe it is the quality of the pads but I believe these are oem...