Santa FE SM (2001-06) :: Rear Brakes Keep Wearing Out
My rear brakes keep wearing out extremely prematurely (2,000-7,000 mile intervals) and have been for 60,000+ miles. (No joke my mechanic has warrantied the rotors and pads over and over literally like 10 times) its the insides pads of the back that wear down while the outsides and front are fine...is the proportioning valve causing this problem or is it something else? We've changed the calipers and brake hosed
View 17 RepliesCorolla / Matrix 2009-13 :: Rear Brakes Pads Sticking / Wearing Quickly?
At about 25,000 miles I had one of my rear brake pads sticking so had to change the rear brakes. The non-stuck pads on the other side looked decent still, so I'm assuming I'd have gotten quite a few more miles out of them if the one hadn't been sticking. Changed the front pads at about the same time, although they were in pretty good shape still (but it was taken apart already, so did them while it was apart and the chance was there). At about 50,000 miles later the rear pads are again unevenly (and I feel perhaps prematurely?) worn, and the fronts look fine. Is it something with the screw-type e-brake mechanism on the rear disc brake that lends itself to sticking? Or am I just especially unfortunate?
View 10 RepliesLexus GS 2006-11 :: Tire Side Walls Wearing Faster Than Middle?
I have a GS350 AWD and it seems that my hankook ventus V2 concepts side walls are fading alot quicker than the middle... the middle has A LOT more too go but i cant figure out why its doing this... I have the PSI set to 33psi as the side of the door suggested... should i try putting PSI that the tire recommends?
View 14 RepliesPassat (B6) :: Rear Brake Pads Wearing Too Quickly
My car has about 37k on it; and while the front pads look to be about 50% worn; the rears look like they are closer to 90%. Is this normal? The car is also sluggish while braking especially when the engine is being auto-revved to keep the system voltage up (a known problem). It also seems that the car will step into ABS lock-up mode too soon in a panic stop situation; which might also indicate that the brake system is biasing too much power to the rears; too little to the fronts.
I've never had a car wear the rear brakes more rapidly than the fronts; usually the rears are much more lightly utilized to reduce the tendency to skid. Is there any way to adjust brake bias? I'm getting ready to change rear pads and flush brake fluid.
Passat (B5) :: (2003 1.8T) Rear Brake Pads Wearing Out
What's with the rear brake pads wearing out before the front brake pads. Took my '03 Passat in last week to the dealer for the recall and the service dept. guy said my brake pads were worn out. I took the car to my local mechanic who specializes in VW's. Sure enough, rears were almost gone but fronts still had plenty of meat left on them. Of course I had him replace the rears. But I always thought the fronts wore out first. Could this anomaly be due to ABS?
View 11 RepliesPrius (2010-12) :: Front Brakes Wearing Abnormally Quickly?
Took my Prius to the local dealer for 50,000 mile service and got a call that both of my front brake pads were worn below the limit and needed replacing. This surprised me as I have read here and elsewhere that some go 100,00+ miles before needed replacement. So I had them replaced and when I went to pick it up, asked them how much was left on the front brakes the last time I was in, which was for my 45,000 service. After looking it up, guy told me they measured 8mm in February, meaning I went from 8mm down to needing to be replaced in the span of like 9 months after driving 5,000 miles. Even the guy at the dealership seemed surprised when we looked it up. Could there be some underlying issue causing abnormally fast break wear? I vaguely remember getting the brakes adjusted related to some TSB in the spring.
View 19 RepliesFord Brakes/Suspension :: Front Left Steer Is Making A Lot Of Noise And Wearing On Tire Inside Edge
I bought a 2002 F250, 2 months ago love the truck drives great for 130000 miles, but the front left steer is making a lot of noise and wearing on the inside edge and like its skipping every couple inches so very noisy thought maybe ball joints but a buddy say tire is out of balance truck does not pull left or right and drives straight...
View 3 RepliesGolf IV / Jetta IV :: Rear Tires Wearing Fast
I'm trying to figure out why I am having problems with my read tires wearing fast. I knew my car was out of alignment and took it to a shop and they told me I have -1.05 negative toe and bad camber.
Can some shims fix my issue or would I be better with a whole new rear beam. As far as I know the car has never been lowered, but how would I be able to tell?
Golf VI R :: Rear Tires Wearing Prematurely On Inner Edges?
About a week ago I had my car on a hoist getting new exhaust tips installed. At that time I noticed the rear tires are wearing prematurely on the inner edges. So are the fronts but not nearly as bad as the rears. I asked around and was told that this is normal for the factory Pirellis because of the negative camber built in to our cars. This being the reason the car corners so well. I understand the physics of this and I really like the way the car corners. My question is this---Can the negative camber be taken out of the car thusly reducing wear on the inner edges of the tires?? And how much will this be noticed while driving the car normally, and during spirited driving?? I have noticed that some fellows will purposely mod their cars with increased negative camber on the rear wheels, I'm assuming this is to achieve a certain "look".
View 5 RepliesCamry 2012+ :: Car Feels Like Brakes Are Pressed When Coasting / Decelerates Faster Than Normal
My 2012 camry recently had an issue with the acceleration that I took to the dealer and they drain and filled the transmission fluid 3 times and it fixed that.
There is still one issue which I'm not sure is normal or not - when I let the car coast by letting off the gas the car feels like the brakes are being pressed and it decelerates faster than normal. Also, my e-brake seems less tight than before so it doesn't really stop the car from going back when I park it unless I push it really hard.
Corolla / Matrix 2009-13 :: Right Rear Brake Pad Is Wearing Unevenly
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
Santa FE SM (2001-06) :: Rubber Bushing At The Top Of Rear Shocks Wearing Away
The rubber bushing (is it a bushing) at the top of the right rear shock on my 2002 Santa Fe is wearing away. Can I replace just that? Or do I have to do the whole shock? The shock itself seems fine.
View 2 RepliesPrius (2001-03) :: Driver Side Brakes Wearing Twice As Fast As Passengers Side
I have a 02 Prius and the driver's side brakes are wearing twice as fast as the passengers side. Some times if I have to stop quickly the brakes pads continue to apply pressure on the rotor when the brakes are released. After a little drive they seem to go back to normal. Is this a sign of a bad caliper or master cyl.? I know before I purchased the car the front brakes and rotors were done, but they used after market parts
View 5 RepliesPrius (2004-09) :: Front And Rear Driver Side Tires Wearing On Outside Edge
The front and rear driver's side tires are wearing on the outside edge. Searching about, I find that camber problems are indicated with outside edge wear -- but....
View 19 RepliesLexus LS 2007+ :: 2008 LS460 - New Control Arms / Bearings Are Wearing Out
Dealer told me needed new control arms as the bearings are wearing out. Was quoted a little over $3k. Doesn't really bother me bc it only makes a clicking noise when I apply brakes hard but concerned about safety issue. Surprised a car like this would need new control arms with only 70k miles on it.
View 14 RepliesFord 6.7L Power Stroke Diesel :: Rear Tires Wearing Unevenly - Tire Pressure?
I do 98% of my driving unloaded and almost never tow. (Kinda weird for an F350 huh) I know that the truck recommends going with 65psi front and 80psi rear but the rear tires seem to not be wearing evenly across the tread pattern. The edges still have the little rubber stubs sticking out of them even after almost 3000 miles. Should I be running a lower tires pressure in the rear when empty or should I just let tire rotations take care of the uneven wear. If I should air down, what pressure would be recommended? The front tires are wearing normally at 65psi and they have more weight on them then the rear.
View 14 RepliesFord Super Duty (1999-2016) :: Passenger Rear Tire Is Wearing Out On Inside Edge
My passenger rear tire is wearing out on the inside edge. Thoughts as to cause and possible fix?
View 14 RepliesPassat (B6) :: Rear Brakes Squeal Only In Reverse
My rear brakes started to squeal at 15k miles, only in reverse. Needless to say, the squealing got worse and now it sounds like metal on metal. It's at 21k now. I was suprised that the brakes would go out that soon, especially the rears first! I called the dealer and they said, "wow, I'm surprised they lasted that long, they usually only last about 15k". What about the rears going out first, "oh, VW's are designed that way, the rears go first, the pad material is really soft".
View 13 RepliesPassat (B5) :: Rear Brakes Squeak When Applied
Yesterday I had my snow tires installed at Costco. Immediately afterward I noticed that the rear brakes squeak when I apply the brakes. I took the car back to Costco and asked them if they applied the proper torque or if anything unusual appeared during the change-over. They said no.... I loosened and retorqued the wheels and no change......they still squeak when I apply the brakes.
Questions: I assume there are wear indicators on the rear pads, could this be causing the squeeling? If so, aren't they supposed to squeel all the time when they reach their limit? I haven't inspected the wear yet...... What the tolerance is for the amount of lining on the pad. Could this be a rotor problem? I"m not feeling any pedal vibration.