Golf V R32 :: Bulb Out Fault After Installing Rear Fog
Just installed a set of euro tails with rear fog (non-LED). I also have front fogs on my car. I used the following VDCS changes in Central Electronics to activate the rear fog:
Byte 3 - Bit 1 set to 1 (1 rear fog light)
Byte 3 - Bit 2 set to 1 (1 reverse driving light)
Byte 4 - Bit 6 set to 0 (Rear fog deactivated)
Byte 18 - Bit 3 set to 1 (Cold diagnose rear fog lights active)
All lights work correctly, but I still get bulb out warnings for all four fog/reverse lights, i.e.
Front Left Fog
Front Right Fog
Rear Left Fog
Rear Right Reverse
I have cleared all CECM errors and the warning light disappears, but as soon as the fog lights are used, it comes back.
Golf/GTI VI :: Getting Bulb Out Error?
I had HID's installed in my fogs (before haters jump in, it doesn't look remotely bad, and they're aimed down, so no glare), and I'm getting a bulb out error. I have a VAG, but I'm not seeing any long coding to disable error checking for the fogs. I have the error cancelling add on, but we forgot to install. Just curious if there's a VAG trick to disable that error before I rip the fogs out again.
View 1 RepliesGolf/GTI VI :: Random Bulb Out Error
I have been getting random bulb out errors, usually its the front side lights and today with out turning on the lights I had rear parking light...thing is I get out of the car to check and they are lit? Faulty bulbs? stock tails and side markers but do have a bi xenon retro in the headlights using the usp hid kit in the projectors.
View 3 RepliesGolf/GTI VI :: 2012 - How To Get Rid Of Bulb Out Error
I got black side markers for my car and put on the bulbs the side markers came with... I like the look but I got the bulb out error.. Wanna keep these bulbs but the error code annoys me .. Need to know the vag-com code to get rid of this? I searched but I can't find it.. I have a 2012 GTI .
View 11 RepliesPrius (Gen 2) :: 2004 - Red Warning And Check Engine Lights With Error Message
As far as the owner can tell, the car is running fine. He hasn't driven it aside from getting home after the light came on. It seems to give a very informative error message. What it's saying?
View 4 RepliesGolf/GTI VI :: License Plate Bulb Out Error With Stock Bulbs?
I have an intermittent error that comes on most of the time I have my headlights on, but sometimes goes off and comes back while I am driving. It shows me the bulb out light, and says on the screen "Number plate Check license plate lighting!" I have never touched the oem factory bulbs on the license plates, and if i get out and look at the plate, both lights are on over the plate.
The only change I have made was about a year ago, I installed an LED bulb in the trunk, and ran a second OEM trunk light in the left side and installed an LED bulb in that too, tee'd off the factory trunk light housing. But like I said, that was 1 year and 30,000 miles ago, and my bulb our error for the license plate has only just started, so I doubt they are related.
Golf/GTI VI :: Check Medium Error Message In MDI
I recently performed the MDI update, and now whenever I connect something to the USB, I get a "Check Medium" error message.
View 10 RepliesGolf IV R32 :: Alternator Workshop Error Message Appeared
Don't know know the cause of this message. From what I've been able to find, it sounds like a serpentine belt.
View 13 RepliesGolf/GTI VII :: Airbag Error Message Come On When Started 2016 CSG
I picked up a 2016 CSG GTI S 4-door with DSG on Dec 31st. I had an Airbag Error! message come on when I started it this weekend. I went through several cycles of restarts and it didn't go away. I did a quick Internet search and didn't hit on any common problem with airbags, seatbelt pre-tensioners, etc. I called that Saturday and was given a Monday appointment. I was dreading them having to take out interior dash, seats, trim, etc. to troubleshoot. I just got the call that the problem turned out to be with an airbag sensor connection in the front bumper and it is ready to go. Can't wait to get back to driving!
View 5 RepliesGolf VI R :: Error Message Displaying - Brakes Service Now
For the last 3 months I've been bringing in my vehicle in and out of the VW dealership trying to find out why once in a while when I turn off my my vehicle the accessory part turns back on by its self and error message displaying "Error: Brakes service now!" In the middle of the cluster & then the car turns off completely. The first time I brought it to the VW dealership they called corporate and they said to change the cluster so they did. Two days after I pick up my car the error message came back on. Took it for the 2nd time and they said that it was the gateway .
And one day later after picking up my car the error message came back on again. I'm getting tired bringing in my Golf R and not fixing this issue. What it could be? Just an FYI, It is a push start. Here's a quick video link so you can see what I'm talking about [URL] ....
Golf IV / Jetta IV :: Installing Fog Lights
So i have been looking to get some new headlights with the projector housing but noticed that most of them have a fog light which my car does not have. I know in order to get them to work properly i would need the euro switch, but would i need to run additional wires through the firewall?
View 8 RepliesGolf IV / Jetta IV :: 2002 - Replace Throttle Body And Coil In Cylinder 2 But Again Error Message P0638?
I have got a 5 door 2002 Golf 1.6l petrol, manual transmission with 190k kilometers on the clock. It has been playing up recently and the authorized VW garage is clueless, but still happy to charge for a miserable job...
The "symptoms" are always the same: I can start the car no problem. Plenty of water coming out of the exhaust and EPC light comes on, no power transmission (or very little). In this state, the engine runs irregular. Before all this happens, you can tell there will be a problem (this is not super obvious), as the car does not run smoothly in neutral, especially when it is at a a hill You might get away with another 50k but that's it.
Breakdown 1: Called out road side assistance and got it towed. Volkswagen dealer retrieved the error code P1564 and they replaced the throttle and some of the contacts of the throttle. (Costs 800 GBP)
Breakdown 2: However, 300 km later, same problem as before road side assistance retrieved error code P0638. The memory was reset and it did run perfectly fine for a short while (2000 km).
Breakdown 3: As before, error message P1564 was read. This time they thought there was a problem with the coil in cylinder 2 and replaced it (250 GBP) - also the one in cylinder 1 as "old". Picked up the car and it was not running smoothly in neutral and it eventually broke down after only 90 km.
What to get changed next? What is the real root of the problem here?
Golf/GTI VI :: City Lights Seems Dimmed After Installing LED Taillights
I had oem LED taillights installed to my car. Dealer coded the car to avoid error lights on dash. The problem is now the city lights under xenons look dimmed. Not as bright as before. I asked him why did it happen and he said that it's normal as it needs to balance the current flow to supply enough power to the LED taillights. I'm not satisfied with this answer though.
View 3 RepliesGolf/GTI VI :: 2011 - Installing Missing Footwell Lights
I just took delivery of a new 2011 golf and noticed the footwell lights were absent, presumably because Canadians always seem to get shafted. I would like to hear from other Canadian golf owners before going to the dealer.
If absent footwell lights are indeed standard for Canadian golfs, I'm thinking about installing them myself. I found a link on another site that details the install on an MKV : [URL]...
Golf V R32 :: Tail Lights Bulb Out Warning
So, I'm not entirely sure if this has been covered, but I dealt with the bulb out warning with the LED tail lights. I am not running the fourth wire. I had tried searching for a while but found no answers. Most conversation about this issue are buried in old threads.
The usual DIY disclaimer applies. In the Central Electrics module (09), access Coding, then Long Coding. You will need to make sure that Byte 19, Bit 3 is checked (Diagnosis Rear Parking Lights Active).
Here is my current coding:
E68D8B6700041500470A0000F000000000918095C000100000 000000000
I have verified all operations (parking lights, brake lights, turn signals [amber]) and no flickering as well.
Golf IV R32 :: Front Parking Lights Won't Work After Installing Euroswitch
Installed the euroswitch yesterday because I want the parking lights to work in the front. All the lights work except for the front parking! In the second click I have the rear but no front. Am I missing something or do I have a bad euroswitch?
View 12 RepliesGolf V R32 :: Turn Signal Bulb Lights Up When Braking
When I brake, my turn signal bulb lights up. Is that how it's supposed to be? Which bit I need to change in the vag?
View 5 RepliesTiguan :: 2009 - Bi-xenon Bulb Went Out / Error Codes
My driver side bi-xenon bulb was out, so I go to replace the bulb and it still doesn't turn on. I scanned my car with my vagcom, and I get this error.
Address 09: Cent. Elect. Labels: 3C0-937-049-30-H.lbl
Part No SW: 3C8 937 049 E HW: 3C8 937 049 E
Component: Bordnetz-SG H54 2602
Revision: 00H54000 Serial number: 00000008706034
Coding: E78C8FA300041C004719000014000000002AF7475C40012539 0000000000
[Code] .....
Passat (B6) :: 2006 - Airbag Fault Error After Installing New Head Unit
After installing the new head unit in my 06 Passat 2.0T, the "Airbag Fault" error appears on the MFD upon startup and the airbag light on the gauge stays on.
View 5 Replies