Golf IV R32 :: Shifter Moving Slightly Side-to-side While In Gear - Shifter Cables Need Adjustment?
I recently changed the bushings and installed SS kit. I don't know if this was the case before, but now while in any gear, i can still move it approx half inch to the right and half inch to the left.
I checked everything and all screws are tight. Could it be that the shifter cables need adjustment?
Golf IV / Jetta IV :: Quick Shifter Linkage Adjustment (O2M Transmission)
So I just got 42dd shifter bushings and im having some issues!
Installation was no problem but once you complete the install you are supposed to re-adjust the linkage. First you have to lock the shifter in place, both in the cabin and in the engine bay (as shown in this Diesel Geek video: [URL] .... )
The only trouble I'm having is that i cannot locate the locking pin as shown in this integrated engineering picture: [URL] .....
Golf IV / Jetta IV :: Shifter Adjustment - Cannot Get Transmission Into Home Mode
When going to adjust my DG shifter since it wouldn't go into first I noticed that my L-shaped lever (02J-301-358C) on the tranny was more out then usually and could be pulled straight out with no resistance. I am guessing the piece at the end is also broken and will need to be pulled out, but how will I put the transmission into home mode after?
View 8 Replies1992 GTZ V6 - Throttle Valve Cable Adjustment?
I'm attempting to adjust the TV cable on my 92 gtz V6 3sp auto as it is shifting late...I have found the following instructions (which seem simple enough):
Step 1 Stop engine.
Step 2 TBI equipped models, Remove air cleaner assembly.
Step 3 Push and hold down the metal readjusting tab at the engine end of the cable.
Step 4 While holding the tab down, move the slider until it stops against the fitting.
Step 5 Release adjustment tab.
Step 6 Rotate the throttle lever to the wide-open position, cable will come back and automatically readjust itself.
However, I don't know what I'm doing or better yet, looking at when I am trying to do this..I see the throttle, the cable, can move the throttle to wide open but what I'm not seeing/recognizing on the throttle mechanism is:
1. The metal adjusting tab at the engine end of the cable
2. The slider
3. The fitting the slider is supposed to butt up against
how to properly adjust the cable and have come up blank.
Ford Ranger / B-Series :: 2001 - Copper Cable Doesn't Move When The Shifter Does
After taking apart my instrument panel to change the bulbs, I went to reconnect everything, but now the gear shift indicator isn't working. I can change gears fine, and everything else on the instrument panel works just fine.
The copper cable that connects to the shifter doesn't move when the shifter does. Is there a way to fix this problem, or do I need to find a replacement cable?
Ford Super Duty (1999-2016) :: 2006 - ZF6 Shifter Adjustment - Bent To Right?
I've put about 500 miles on my new to me 06 F250 4x4, CC, SB, V-10. One thing that is slightly annoying is the shifter position in R, L, 1 and 2. Shifter is against my knee in those positions. Re bent the shifter to place the more to the right? I have buckets with a console so I don't need to worry about a center passenger's legs. I have plenty of benders and metal working tools at my disposal, just asking for some guidance.
View 2 RepliesFord Excursion :: Reverse Lights And Back Up Alarm Will Not Engage - Gear Shifter Adjustment?
My reverse lights and back up alarm will not engage unless i hold up on the shifter while in reverse the only thing i found was a adjuster for the indicator....
View 14 RepliesGolf/GTI VII :: Headlights Aimed Wrong?
So Ive had my GTi with LP for a week now, and every nite on my way into work the guy in front of me or the middle lane (if I'm in the left) Gets behind me and throws on his high-beams....as if I have my high beams on and they are trying to get even....It sometimes happens 3-4 times on a 30 mile trip. I know they are dynamic and adjust themselves left/right/up/down but I was wondering if they were possibly aimed wrong from the factory?
View 24 RepliesGolf/GTI VI :: 2008 - Steering Wheel Wrong Top View Angle
I have a weird question about the nice gti steering wheel. I noticed it some times ago on my old 2008 rabbit too and didnt really cared much when I saw that on the steering wheel of the 2010 gti. Did you noticed that the SW angle isnt good from a top view, I means, when u look at it carefully, did you noticed that the SW is more prononced to the right side, it easier to notice it when u look from a top perspective view of the SW. When u use 2-hands on the SW, u can notice that your left-hand is closer of you that the right-hand. Why Volks designed it like that way?
View 3 RepliesGolf IV / Jetta IV :: On Cold Start - Weird Noise - Using Wrong Coolant?
not sure if this is normal or not. usually ONLY comes when I turn my car on for the first time of the day. (cold start obviously, keep in mind its cold where i live at this time of year), there is a weird whistling like sound. goes away when the rpm gauge hits 10/ after 1 minute of the engine running. at odd times it will come on again after leaving the car off for a few hours, after work for example. I was told it because I'm using the wrong coolant??
View 4 RepliesGolf IV / Jetta IV :: R32 Cluster Swap - Reads Wrong Fuel Level
The cluster works fine in the car. MFA works. The immobiler does activate but my ecu has an immobilizer defeat so it doesn't kill the car. I'm not having any of the usual issues with cluster swaps. I'll get the immobilizer issue recoded later. My issue is with the fuel level indicator. I have half a tank of fuel and it is reading full. I've researched and found out the r32 has 2 fuel sending units and this may be where the problem is. If so is it a matter of re-adapting the cluster or is it slightly more complicated than that?
View 3 RepliesFord 6.7L Power Stroke Diesel :: Steering Box Adjustment Same As Gear Box Adjustment?
I've searched and can only find instructions/details on 6.4L and older Super Duty trucks. The process is the same to adjust the gear box for a 6.7L?
View 5 RepliesGolf V R32 :: Heavier Gauge Pos Bat Cable
Replacing the factory pos cable from the alt to the bat in the rear yet? if you have what is the path and was it a pain to do? I have not had the chance to get the car on a lift yet to check and don't know even if it needs to be on a lift to do.
View 8 RepliesGolf IV R32 :: Removing Battery Cable
Removing the negative battery cable piece that connects the cable to the terminal. Where I can get the screw that tightens the connector around the terminal.
View 4 RepliesGolf V R32 :: Rerouting Aux In Cable To Center Console
My R is an earlier model with the Aux-in in the glovebox. I cannot think of a more inconvenient place to put an aux in cable which is why they change it I am sure. I would like to reroute the existing one or at least add an extender cable from the glove box to one of the unused buttons near the ash tray.
View 2 RepliesGolf VI R :: Cable Hanging Loose In A Loop Under The Car
After driving in heavy snow I noticed a cable hanging loose in a loop under the car in the mid section. What could this be ?
View 24 RepliesGolf V R32 :: Can't Close The Door Due To Thick Auxiliary Cable
My R has the aux input in the glove box. Connecting to my iPod works, but the cable I have is too fat/thick to let me close the door. Any nice, thin/flat audio connector that would work so I can close the glove box and leave the iPod out where I can control it? If I can find one I'd get a portable nav and connect it via its headphone jack for Bluetooth phone use.
View 9 RepliesGolf VI R :: Longer MDI IPhone Cable - Part Number?
The MDI cable that came with my car is way too short.. What is the part number or where I can get a longer version of this cable?
View 4 RepliesGolf IV R32 :: AUX Cable For Connecting IPhone / IPod - How To Install
I have iPhone, how to connect to the stereo with AUX. Plus, I don't know where and what kind of AUX cable I should buy?
View 10 Replies