Golf IV / Jetta IV :: Slight Vibration - Knock Sensor 2 (G66) Signal Too Low (code P0332)
I got my car in November and I just did a scan and got this code. I don't have a CEL on. I do feel a slight vibration from time to time. It's very light.
Should I clear all DTCs and then run a scan a couple of days later to see what codes I truly have? Or should I address this code?
If yes, what should I do about this code? Do I need to buy a new knock sensor or should I check the wiring first with a voltmeter?
Golf IV / Jetta IV :: 5 Engine Fault Codes - Cam Position Sensor / Knock Sensor / Secondary Injection Pump And Mass Air Flow
I recently picked up a 2000 jetta vr6 for a very good price its a glx I have owned a vr6 before and done timing chains myself on it this one is a glx , I am having 5 fault engine codes on my vagcom they are cam position sensor , knock sensor, secondary injection pump, and mass air flow it ran fine 100 miles yesterday this morning the epc came on then went off and ran bad can these codes all be related or do I have to replace each sensor individually..
View 9 RepliesGolf IV R32 :: Intake Air Temperature Sender Signal Too High / Air Mass Meter Signal Too Low
I drove to the mall and left the car there, when I was done and tried starting, it fired up but the rpms started to fall and CEL came on. CEL are:
-16497 P0113 050 Intake air temperature sender-G42 Signal too high
-16486 P0102 050 Air mass meter-G70 signal too low
And after it died it cranks but never fires up. I called the dealership trying to find out where the IAT sensor is but they said it's in the manifold and not sure where. Where is IAT sensor?
Golf IV / Jetta IV :: Replaced Knock Sensor Still Sputtering And CEL On?
I replaced the knock sensor because I was getting the p0327 for the front knock sensor. Drove it again and still sputtering and CEL came back. What are other causes of this? N75 solenoid? Low fuel pressure?? It has a spectre air filter kit on it. Didn't know if this would do it. I cleaned maf. Just put new plugs in it too.
View 5 RepliesGolf/GTI VI :: 2010 - Faint High Pitched Whirling Noise While Cruising
I drive a 2010 Golf Wagon/JSW, and when I'm going at speeds around +60 mph/90 kmph and lift off the accelerator a faint high pitched whirling noise comes on. As soon as I tap the gas pedal it goes away. What this could be?
It's been a week now since I've noticed this, I guess I've never noticed it before or it's getting louder..i don't know?
GTI 337/20th Anniversary :: CEL For Knock Sensor Bank
Got a code for knock sensor bank one however this is the wiring going to it. Could it be throwing the code simply because the wire is cut or do i need a new sensor maybe too?
View 11 RepliesAccent MC (2006-11) :: Location Of Knock Sensor
I need to change the knock sensor of 2011 Accent, don't know where it is.
View 7 RepliesAccent RB (2012+) :: Knock Sensor Location
I cannot find the location of the knock sensor in my 2012 Accent. I just replaced the radiator and had everything off up front unobstructed and couldn't find it. Looked in back, sides, but am completely stumped. I have found information on earlier models but not 2012+.
View 37 RepliesLexus GX 2010+ :: 2013 - High Pitch Sound When Cruising Above 70 Mph
My 2013 GX makes this noise when I step on the gas padel when the speed is 70 mph or higher. It is not very loud but noticeable, even with the radio on. I noticed this these past two days on highway. There is no such sound during local drive or speed below 70. It sounds like it came from the engine compartment, but I am not 100% sure. Is this normal? Could it be from the wheels or chassis? My truck only got 1800 miles after 2 months driving.
View 14 RepliesAurora :: Location Of Knock Sensor On 1997 Vehicle
Where the knock sensor is located on my 1997 Aurora. what does it do?
View 2 RepliesCamry :: 2004 Will Not Shift Into Overdrive - Knock Sensor
I have a 2004 Camry 4 cylinder. Will not shift into overdrive. Diagnostics indicates knock sensor. I ordered one. Where is it located and what do I need to do to replace it?
View 2 RepliesSonata NF (2006-10) :: 2009 2.4l - Location Of Knock Sensor?
Replacing the knock sensor on a 2009-2010 Sonata with a 2.4l? Where exactly is it located and what has to be removed?
View 2 RepliesSonata NF (2006-10) :: Can Oil Temp Sensor Knock Out Airbags?
I went to Jiffy Lube and got an oil change, fuel system cleaning and cabin air filter replacement & sanitizing. I drive an '09 Sonata with 112K miles. When the car came out, I pulled away and noticed that the airbag symbol on my dashboard was lit and the center console was flashing that my passenger did not buckle their seat belt (I didn't have a passenger or anything on the seat). I went back in and after they looked at it, they said they couldn't find anything that could've happened at anytime and was a "horrible coincidence."
Hyundai ran a diagnostic tests and one of the 4 things that came back was B1389 (in addition to B1516, B1324 and B1515). B1389 signifies "Oil Temperature Sensor Circuit Failure." If the guy changing the oil damaged this (does this even get touched on an oil change), could that have offset the sensors for the airbags?
I just don't see how they done the above listed work and coincidentally my airbags are all deactivated afterwards. I'm reading a lot of bad reviews online, including quite a few for NOT putting oil back in the engine after the change.
Accent MC (2006-11) :: 2009 - Location Of Knock Sensor
I'm looking for the location of the knock sensor I can't find it?
View 4 RepliesSanta FE SM (2001-06) :: Code P0325 Knock Sensor
What is the possible, or most likely, cause of a Knock Sensor No 1 Circuit Malfunction reading??
View 1 RepliesLexus SC430 :: Got P0330 And P0325 Knock Sensor?
I noticed my engine light and vsc lights came on two days ago and then after a restart went away.
It's been two days and today the lights came on again and I noticed a hesitation in acceleration.. got the codes scanned I believe they were p0330 and p0325 for bank 1 sensor 1 knock sensor. They wiped the code so I'm going to drive it to see if it comes back on? Where is this sensor located?
Ford Excursion :: Transmission Goes Into High Pressure When Reached Cruising Speed
I've got a 03 x with the 6.8 2wd 4r100. It was flaring pretty bad for a while going into lock up, about 2 months ago the flare went away now NO lockup. Its taking more pedal to get moving and alot more slip, once you reach cruising speed tranny goes into high pressure. Told to replace the selonoid pack, got one use from a tranny shop from a tranny that lost reverse, got it home took mine out and found out the new one is not PWM and mine is, I tested my selonoid by putting 12v to pin 1 and 4 and nothing (on the pwm pack) did it to the new pack and it works. My question is what will happen if I put the non pwm in my tranny that originally had pwm pack in it?
View 2 RepliesCamry :: Check Engine Light Is On For Bad Knock Sensor In Bank 1
Wife has a 08 solara 2.4 auto. Check engine light is on for bad knock sensor in bank 1. Now car is not pulling itself, it takes off fine then shifts and falls on its face, I think its missing 2nd and going to 3rd. It is also not shifting into 5th so its staying in 4th and using a lot of gas. I tried manually shifting but it still goes to 3rd and will not go to 5th. I have been told this knock sensor could be causing it all. Cant clear code, I hit clear but nothing happens. We don't have a lot of money to pay the Toyota dealer to fix it and I can do all the work but they wont even show me where the knock sensor is.
View 5 RepliesAccent RB (2012+) :: Code PO326 - Faulty Knock Sensor
2012 Hyundai Accent. I am getting a po326 code. Wondering if it may be a faulty knock sensor. And po463 fuel level sensor code when I fill up with gas.
View 2 Replies