Nissan - Altima :: Check Engine Light Came On / Knock Sensor Is Bad
last fall, the check engine light came on- Autozone states the knock sensor is bad. At the same time, odometer/cruise would work off and on. Now as months have gone by, the odometer RARELY works. Could all the electrical issues be connected? Is odometer controlled by Speed Sensor on the transmission or somewhere else?
View 2 RepliesHyundai - Accent :: Check Engine Light Came On - Knock Sensor Code
I have a 2012 hyundai accent. The check engine light came on. The code read knock sensor. Before I could get it into a shop, it went off. It didn't come back for 11 months. When it did come back, the same code was read. Again, it went off the following day before it could be looked at and hasn't been seen since. The shop says that even though there is a history code, it would be hard to diagnose since it isn't an active code. I noticed absolutely no difference in performance when the code was active. Both times it went on, the car was idling for several minutes with the ac on, and it came on as i accelerated onto a highway immediately afterwards. However, it has idled like that many other times without the light coming on as well.
View 11 RepliesAvalon 2005-12 :: Check Engine Light On And Code Is P0327 (Knock Sensor)
So, I have my check engine light and the code is p0327 (knock sensor). Clear cose but it returns. Going on for 3 days now. I was suspicious that something else is going on. I also remembered I've been using a little more antifreeze in the reservoir. So, today I needed to watch the coolant. I ran the car for an hr and I found a lot. Red coolant on my belt, the back passenger side of my engine and it was caked on with coolant. I think the water pump is going up.
I was concerned that coolant was also leaking from the intake manifold but it's only the right side, so I'm pretty sure the coolant is being slung around from the belt. I rinsed the engine down and the knock sensor code went away. Temporarily, until more coolant got back there. Do you think I will need to replace the knock sensor along with the water pump or should the sensor work ok after some intense cleaning after the water pump replacement?
GTI 337/20th Anniversary :: CEL For Knock Sensor Bank
Got a code for knock sensor bank one however this is the wiring going to it. Could it be throwing the code simply because the wire is cut or do i need a new sensor maybe too?
View 11 RepliesJetta - Volkswagen :: 2006 - CEL Code P0332 / Knock Sensor 2 In Bank 2 Faulty
I have a 2006 VW Jetta with 92K miles and just a couple of days ago my check engine late came on and when i took to an auto store to check the code, it came as P0332, Knock sensor 2 in bank 2 is faulty. Three things have happened all around the same time and I am not sure if they are related and are just coincidence.1.Check engine light came on.2. I have noticed after that, my car RPM has dropped, idles at about 600-700RPM and when trying to accelerate, it tops at 3000 RPM and feels like the motor cuts off at that point and I have to step off the gas and the car runs ok again, but cant go over 3000.
Had trouble getting on the interstate due to this and thought the car was going to stall, but it didn't. just had to back off the gas and let it run, It did go up to the speed that I wanted, but seems like it wont go past the 3000 RPM point.3. My fuel gauge, drops to empty when it reaches the half way mark on the meter. It stays at the correct level when I start and keep the car in idle, but when I start moving, it drops to empty. When I fill up the tank, it goes all the way to F, and after the car goes the usually of about 190-210 miles, when It reaches the half full level, the meter drops to zero, so have been using my trip odometer to drive after that.
Lexus GS 2006-11 :: Check Engine / VSC Lights On - P0333 Knock Sensor Code
I just purchased a 2006 GS300 AWD w/115k. Started car on lunch hour to find check engine / check VSC lights on. Ran codes to find P0333 Knock Sensor code. Vehicle seem to run perfectly fine, but now that the light is on, it is definity spark knocking under acceleration. This is my first Lexus / Toyota product, so I am unfamiliar with the common problems or fixes. Are knock sensor replacements common?
View 6 RepliesCamry :: 2009 - Check Engine Light Is On And O2 Sensor Dead
My 2009 Camry check engine light is on. Dealer said the two O2 sensor both are dead and need to replace. After dealer reset the check engine light I have driven two days for 50 miles and the check engine light doesn't come back. If the O2 sensor is bad how long does it take for check engine light on again? Is it possible the check engine report on by mistake since two O2 sensors got bad at the exact same time is really rare.
View 13 RepliesMitsubishi - Mirage :: 1998 - CEL Codes For Fuel Trim Bank / Oxygen Sensor Bank 1 Sensor 2 And Cylinder 1 Misfire
I own a 1998 Mitsubishi Mirage with about 190,000 miles on it. The engine light has started coming on and I get three codes:
P0170 Fuel Trim Bank 1P0136 Oxygen Sensor Bank 1 Sensor 2P0301 Cylinder 1 misfire
Read more: [URL] ....
Subaru - Forester :: 2002 - Check Engine Code For Knock Sensor - Motor Mounts?
2002 Subaru Forester I took my car to the Auto Zone to read a check engine code. It came back as being a "knock sensor". Besides that I needed a battery, and when the guy was putting it in he said my engine was moving too much and that I probably needed motor mounts.
I was looking at a discussion back in 2010 and the Subaru specialist told the person needing motor mounts is rare for a Subaru, is that true? I'm taking it to a mechanic, what should I expect? how many motor mounts does a subaru have?
Toyota - Camry :: Check Engine Light Illuminated / Oxygen Sensor?
I own a 2000 Toyota Camry that was given to me by my father. The check engine light illuminated last year so I brought the car in to my mechanic. He said it was the o2 sensor and changed it. That lasted about a month , and the light went on again. This time it had to do with some valves that get stuck open (or closed) but also had to do with the amount of oxygen that goes into the carburetor . I asked my Dad if he had this problem, and he told me that the engine light was illuminated often, that he had brought the car in about 6 times, but nothing was found. Previously I owned a 1998 Camry, and had the same problem; the check engine light illuminates, the diagnosis is the oxygen sensor, that gets changed, the light goes on again, this valve thing gets changed but the light goes on again in a month. I can't get the car inspected with the engine light illuminated. The light always goes back on but nothing else is found wrong with the vehicle. I really know nothing about cars.
View 4 RepliesCamry :: 2005 - Check Engine Light Is On / Code P0138 (Rear O2 Sensor)
My 2005 Camry check engine light is on. The trouble code is P0138, bank 1 sensor 2 oxygen sensor. Engine is the 2AF-ZE. Not a California emission car. Car is Japan built. It has two O2 sensors. What is the correct OEM part #? I believe it would be a Denso?
View 2 RepliesCamry :: 2006 - Check Engine Light Came On - Code P0032 For Upstream O2 Sensor
This issue pertains to a 2006 Camry LE 4-cyl.
My check engine light came on - code P0032 (upstream O2 sensor). I bought a new sensor from O'Reilly Auto Parts. After installing the new sensor, the car would jerk while accelerating. This continued to happen until roughly 30 miles or so when the engine light came back on and the jerking stopped! I re-scanned the car and it showed the same error - P0032. I then erased the code, and the jerking issue resumed.
I assumed this was caused by a faulty O2 sensor. I returned and got another one. Same issue.
Is this the result of not getting an OEM sensor from the dealer? Or is there something else I should be worried about?
Toyota - Camry :: Heated O2 Sensor Bank 1 Sensor 2 Is Failing
I just had an OBD code pulled on my 2010 Camry and it turns out that my Heated O2 sensor for Bank 1 Sensor 2 is failing. I'd rather do this myself if I can but I can't figure out where this thing is. Is this something I can access myself and swap out? Or does this need to be fixed by a mechanic?
View 9 RepliesMaintenance / Repairs :: Check Engine Light On / Misfire On Bank 1 And 2
Change out the penlum gasket and now the check engine light came back on and the codes are 301 and 302 miss fire on the bank 1 and 2. not sure what it is now. mechanic is lost...
View 14 RepliesFord F-150 (2004-2008) :: Missing On And Off - Check Engine Light - Bank 1 / 2 Too Lean
I bought 04 Lariat (5.4 3v around 100k miles, Roush Off Road side exit exhaust, DWV intake mod, SCT 3015 tuner).
The truck has had a miss on and off for around a month I've changed plugs and tested all the coils. Which cured the problem for around a week, the FPDM had some white stuff on back and soft spot but not ate through. The only Check Engine Lights have been bank 1 to lean (which went away as soon as it came. But yesterday and today I've got bank 2 to lean.
Below is a quick data log pull... The misses is about ready to ship her out if she don't straighten up..
Lexus - RX300 :: 2000 - Check Engine Light Code P0171 Bank 1 Too Lean
2000... I have a code P0171 bank 1 too lean. My question is does this exclude anything that will effect both banks? If it was MAF sensor or fuel filter would it set code and say banks 1 and 2 running too lean? In which MAF sensor ohms out correctly. I cannot view fuel trim files. I have looked for a vacuum leak with no luck. I got some cigars to try to smoke it to see if there is any vacuum leaks. Trying to narrowing what i need to checks.
View 19 RepliesChevrolet - Trailblazer :: 2006 - Check Engine Light Code P0171 - Lean Bank 1
I have a 2006 Chevy Trailblazer LS/LT 4.2 liter 2wd. I have been trying to get it smoged, but can't clear the code. P0171 - Lean Bank 1.
I've been having a parts throwing contest with it, but it has been winning and my wallet is losing.
I have changed the air filter, cleaned the MAF sensor, changed both O2 sensors, changed the secondary air valve and relay. I've done the carb cleaner spray test around the intake and vacuum lines, with no spikes in RPM.
Most recent try was a couple bottles of Techron concentrate with premium chevron gas.(still waiting to see if the code hits again)
Next steps are checking the intake bolts(to see if they are torqued) and intake gaskets, check for exhaust leaks at the exhaust manifold, and checking the MAP sensor.
Freeze frame data from the most recent hit on the code is below.
***Fuel system 1 - CL***Fuel system 2 - NA***Calc Load(%) - 30.2***ECT(deg c) - 48***STFT B1(%) - 3.9***LTFT B1(%) - 22.7***MAP(kPa) - 33***Eng RPM - 809***Veh speed(km/h) - 0***Spark Adv (deg) - 10.5***IAT(deg c) - 20***MAF (G/s) - 5.82***TPS(%) - 15.3***Air status - NA.
Ford - F150 :: 1998 - Check Engine Light On And Error Is Bank 2 / System Too Lean
My vehicle is a 98 F150 5.4 ltr Triton. I got a check engine light on and the error is "bank 2, system too lean." I read that this can be caused by a few different things like vacuum leaks or fuel filter and so far I haven't been able to narrow down. It started with occasional shaking at idle and its happening more as time goes. When at idle it often makes a sound like slurping the bottom of a drink with a straw and shakes intermittently. The fuel economy seems to have gone down. Sometimes it seems like it almost dies in idle, but always keeps running. It runs great when I push on the gas.
View 4 RepliesPassat (B5) :: Check Engine Light Came On - Code P0171 / Fuel System For Bank 1 Was Too Lean
We have a 2003 Passat 1.8t. Had the Check engine Light come on. Went down to AutoZone and hookeded up the OBDII reader. Came up with P0171, Fuel System for Bank 1 was too lean. Probable causes:
1. Fuel Pressure of MAF (If Bank 1 & Bank 2 set codes together)
2. O2 Sensor
3. Ignition Misfire
4. Fuel Injector Problem
Car has 60K - has always run well. Wife says she thinks it's running a bit sluggish. I rarely drive the car, but I think she's right. Car is not missing or running rough.
I cleared the code & started the engine; Check Engine Light is off; then looked at the codes and I find a P0171 (Pending). She tells me that the light has been on before & then gone away. So I guess it clears itself, but eventually comes back.