GTI 337/20th Anniversary :: Transmission Grinding Noise When Letting Out The Clutch
Normally I'm pretty good about searching and finding info, but there doesn't seem to be a lot out there for these trannys. In any case, when I hopped in my 20th to move it today, I got this grinding noise when letting out the clutch. The car won't go move in reverse or any of the forward gears. Idles fine, sounds fine when in neutral or when the clutch is depressed. It just grinds when you let the clutch out. Seems like I can select each gear OK. Linkage feels normal.
View 2 RepliesGTI 337/20th Anniversary :: Clutch Not Working / Grinding Type Noise And Doesn't Go Into Gear
So I picked up a 20th today. The clutch has 30k on it its an oem luk. Drove fine most of the ride home then i went to shift and it wouldn't grab. Got it towed home. trans goes into all gears fine. When you put it in first and try to go it starts to roll but just makes a grinding type noise and doesnt go into gear. I didn't hear any chatter until maybe 10 miles before this happened. I still have pressure in the clutch pedal as well. when the car is in neutral running there isnt any noise which makes me think it isnt the throw out bearing.
View 2 RepliesGTI 337/20th Anniversary :: Clutch Grinding When Go Into Second Gear
So I am pretty sure its my clutch that is the problem, here's what happens: When I go into second gear, it doesn't really grind.. but its tough to get it into gear and its only with second gear. sometimes it will go right in and others i have to double clutch. when i double clutch it goes in smooth every time. now I don't think it would be syncros because I am pretty sure if it was that it would do it every time I shift? It only does it while its cold or hasn't been drove in awhile.. but after i drive it around its fine so I am pretty sure its the clutch. Second thing, what is an upgraded clutch that is good for these 6 speed transmissions?
View 2 RepliesGTI 337/20th Anniversary :: No Clutch When Going To Put Car In Gear / Just Grinding
I just put a stage 1 clutch in my 20th anniversary. When i was taking the transmission out, i dropped the hydraulic clutch line and all of the fluid spilled out. I got the whole thing done, and bled the clutch line and topped off the reservoir. I started the car and the clutch pedal had, what felt like the right amount of pressure. More than the stock, but not significantly. When i went to put it in gear, its like there is no clutch, just grinding and it doesn't go in to anywhere. I can cycle through the gears with the car off and like i said, the clutch has the right pressure and everything.
View 10 RepliesNissan - Versa :: 2007 - Clutch Feels Loose And Slight Grinding Sound When Shifting Only From Neutral To First Gear
Still chugging along!!
So, I haven't been the kindest car owner to my poor little hatchback. I do my best to get regular oil changes, but other than replacing the brakes last year, I have not kept up with most of the manufacturer's suggested regularly scheduled maintenance. The car has about 130,000 miles. Manual Transmission. My clutch feels a little loose, and I have been noticing a slight grinding sound when shifting (only from neutral to first gear).
GTI 337/20th Anniversary :: Slight FW Chatter On Stock Clutch Setup
Getting a slight FW chatter on stock clutch setup (02M)? I've noticed it for a while...most of the time I don't notice it, but other times I will be sitting in the drive-through and it will chatter. Goes away when the clutch is depressed.
View 17 RepliesGTI 337/20th Anniversary :: 2004 - Grinding / Rubbing Noise When In 3rd Gear
Just recently bought a 04 gli. When I shift in to 3rd and let off the gas there is a weird grinding rubbing like noise. It only makes the noise when it's in 3rd gear...
View 3 RepliesGTI 337/20th Anniversary :: Loud Clunking Noise When Release The Clutch
Car was great this weekend, then on saturday, every time I shift my car clunks right near the tranny when I release the clutch. Its a loud noise. Clutch was done around 2500 miles ago. South Bend stg 1 with a LWFW (I know, wish I stayed with a DM). And if I drive in first and second and come off the gas without shifting, it also knocks once really loud. It isn't a back fire or anything it almost feels like the dogbone mount is bad? Also, over 4000 rpm my car sounds deeper sounding than before.
View 7 RepliesGTI 337/20th Anniversary :: Grinding Noise While Engine Braking On 2004 Jetta GLI V6
2004 Jetta GLI V6 24v 6 speed ... This started a few years ago, but it was happening in 3rd gear only -- therefore I avoided engine braking in 3rd gear all along. The noise was a pretty loud, noticeable grinding/spinning noise. 3rd gear while accelerating or maintaining gas worked and still works perfectly, smooth as can be.
Somewhat recently (6mo-1yr ago) all the other 5 gears started making this grinding noise, some more than others. 1st gear I don't really know because I don't engine brake in 1st. However, 2nd, 3rd, 4th, 5th and 6th (barely noticeable but still there) all make the noise. I now of course avoid all engine braking, however even the transitional steps between gears can be heard sometimes ... unless I perfectly match the RPM etc, but I'm just trying to get to work and back here ...
The car is still quite drivable, but with a major obstacle (pain in the ass) and a new clutch is probably around the corner -- I have 107K on it now. However ... a few years ago when it had 26K on it .. it didn't need a new clutch yet 3rd was still making that noise.
GTI 337/20th Anniversary :: Clicking / Grinding And Creaking Noise When Turn Wheel
I've just started noticing a "clicking/ grinding/ creaking" when I turn my wheel. It makes the noise if I'm parked, or driving slowly. I can feel it in the steering wheel, and hear it in the cabin, but can't hear anything when I'm under the car.
It sounds like 'two pieces of rubber binding on each other', is the best I can describe it. I THINK its coming from the driver's side. I've considered: strut mounts shifting, CV joints, something in the steering column, Tie rods, power steering pump...
Everything is tight on the wheel when I try to move it by hand (on jacks), and no rips/ tears in any boots.
GTI 337/20th Anniversary :: Grinding / Squealing Noise When Moving Backwards / In Reverse
So I put in new rotors and pads and everytime the car is backing up I get a weird grinding or squealing noise. I've driven the cars for hundreds of miles and this still happens. This only happens when going backwards. Anything to try???
View 4 RepliesGTI 337/20th Anniversary :: Slight Whirring Noise When Gently Feathered Gas To Maintain Highway Speed
Middle of May, I went to Boston. On the way there, I started to notice a slight whirring noise that was only present when I gently feathered the gas to maintain highway speed. If I were to apply any more throttle, the noise would go away, and if I were to pull my foot away and allow engine braking, it would also disappear.
So I did my best to finish the trip to and from Boston adjusting my driving to avoid the noise. Once I came home, I researched and thought the noise might have been my wheel bearings (I had just replaced lower control arms, lower ball joints, inner and outer tie rods prior to leaving for Boston). I also had a shop install my upper strut mount bearings and bushings simultaneously with the wheel bearings.
Since then, the problem still continues. It has grown louder, but still occurs under the same situations. I've focused more on it and here are the conditions under which it occurs:
1. Car must be warmed up. Starting it up cold and allowing SAI to run then driving, car is fine, no sounds. Usually takes 20-25 mins of driving to get it to start making noise.
2. Car still only makes the noise when the gas is being feathered (ie barely pressing it enough to give it any sort of throttle. It does also make the noise between shifts when reengaging the gear and applying gas, as the throttle pedal passes the point of throttle off to throttle on.
3. I'm hearing more noise now during engine braking than I had been previously. Could be related?
GTI 337/20th Anniversary :: Grinding Or Rattling Noise At Start Up That Stops After Few Seconds - Code PO411?
I have the po411 code, not sure which problem it is but when I first start the car it sounds awful like almost a grinding or rattling noise then stops after a few seconds.
View 3 RepliesGTI 337/20th Anniversary :: Clutch Pedal Operates Properly But Squeaking Noise Coming Within Cabin
So your clutch pedal operates properly, the clutch engages with no issues, but this annoying squeak, snap, crackle, and pop noise keeps coming from the clutch pedal within the cabin.
Could it be your clutch master cylinder? CMC is not leaking in the engine bay and the driver footwell. Not the CMC.
Could it be your clutch switch that's used to control revs and cruise control? Removed it and clutch pedal still made noises when pressing and releasing the pedal. Not the CS.
Could it be the over-center spring that sits behind the clutch pedal assembly? How could it be? It's just a spring. Springs that compress in that orientation don't make snap, crackle, and pop noises.
What most people fail to realize is the noise is coming from the pedal assembly, but it's not the pedal structure or the pedal. It's the pivot point where it mates with the clutch pedal mounting bracket. At the pivot point are two bushings (one on each side of the pedal structure) that wears out over time creating these noises.
Please look up the part number for these bushings. They look like the following at this link but these are aftermarket upgrades for BMW's.[URL] ....
GTI 337/20th Anniversary :: Gears Rev Up, Seems If The Car Is In Neutral
Purchased my first VW. I bought a 2003 IY 20th AE with 83k mi.
Two days ago, i'm picking up a friend at their house and as i go to take off from a complete stop- 1st gear revs up as if the car were in neutral, same thing with 2nd gear. 3rd-6th work normally and so does reverse. I called the dealership and they guy says that since the car was bought 'As Is' he can do nothing for me, but try and get me his price on the repair (which i think is complete BS).
I've had a couple people try and tell me a few things that could be causing the problem, like throw out bearing, or maybe the shift fork. i would say that i know a little bit about cars, but i've mainly worked on honda's or other japanese cars so i feel a little lost under the hood of a vw still.
GTI 337/20th Anniversary :: 1st And 2nd Gear Do Not Work / Act Like Neutral
The shift lever goes into the gates fine, if a bit easier. No weird noises. 1st and 2nd gear don't work - they act like neutral.
3rd-6th and reverse work fine. Clutch hadn't been slipping. It's the original clutch.
Local mechanic found no issues between the shift lever and the transmission itself. 3 weeks ago replaced timing belt and water pump and the car has been running well.
Yesterday I was driving home from work in light stop-and-go traffic. At one point I put the car in first and it acted like it was in neutral. Engine revved but there was no engagement of the drivetrain. 2nd gear was the same story. After experimenting, 3rd-6th and reverse worked and I was able to get the car limping off to a parking lot by starting in 3rd.
I got it towed to a local mechanic who services my car who said he doesn't crack open transmissions but would look to see if there was something obvious wrong between the transmission and the shift lever. He didn't find anything.
GTI 337/20th Anniversary :: Lost 1st And 2nd Gear / Feels Like In Neutral
I was driving fine, pulled into 7-11 to get some drinks and came out went in reverse to get outta the parking spot and put it in first and didn't go anywhere....
When i put it in first or second it feels like its in neutral and the car doesn't stall. 3 through 6 gears are fine.....
GTI 337/20th Anniversary :: Exhaust Odor From Vents When Car Is In Neutral Or At A Stop
So I recently swapped out my cabin air filter, no other major changes or issues... but ever since I noticed that when I'm in neutral or at a stop, I can start to smell the faint odor of exhaust fumes. No CELs and it's not coming from the gas tank area like I know some have experienced - only from the vents. It's noticeable to me, but nothing unbearable by any means. I definitely never had this before - and my old filter was really dirty so not sure why a new one would give me any issues of have anything but BETTER air quality. I notice that I can curb the smell by pushing the circulate air button, effectively shutting off any outside air from coming in.
View 4 RepliesGTI 337/20th Anniversary :: Shift Fork Stuck In 3rd / No Neutral Or Reverse
Well, like the title says, The trans is stuck in third gear, with no other gears, or neutral or reverse. The car is slightly modified 02 GTI 337. APR Chip, Forge TIP, Full 3" exhaust, Greddy FMIC. I definitely drive the car, and had been beating up on it on the highway for a little on my way in to work, then on the way home, down shifted to pass someone, dropped it third, passed them, went to shift to fourth, Shifter moved, felt like it engaged "a gear" and then then i let off the clutch and it was still in third.
I also noticed that unless, I press the clutch in the, the car stays in this gear, even when the shifter is in neutral. I looked at the linkage, and it appears to be functioning. I did some reading around the Vortex and it seems like this might be a shift fork problem. Also, if the trans will be apart, what items should be upgraded?