GTI 337/20th Anniversary :: Clutch Not Working / Grinding Type Noise And Doesn't Go Into Gear
So I picked up a 20th today. The clutch has 30k on it its an oem luk. Drove fine most of the ride home then i went to shift and it wouldn't grab. Got it towed home. trans goes into all gears fine. When you put it in first and try to go it starts to roll but just makes a grinding type noise and doesnt go into gear. I didn't hear any chatter until maybe 10 miles before this happened. I still have pressure in the clutch pedal as well. when the car is in neutral running there isnt any noise which makes me think it isnt the throw out bearing.
View 2 RepliesGTI 337/20th Anniversary :: 2004 - Rubbing Noise When Accelerating Through Hard Left Turns
My 04 gli makes a rubbing noise when accelerating thru hard left turns.. but weird enough i can take the same turn at the same speed in neutral and have no noise at all. I changed both front wheel bearings and cant seem to find the answer. I brought it to vw and they checked the whole suspension struts springs cv's tie rods ect. and they all checked out good they said. the car used to have a exhaust and i just recently put it back to stock, could the exhaust make the noise perhaps?
View 1 RepliesGTI 337/20th Anniversary :: Grinding Noise While Engine Braking On 2004 Jetta GLI V6
2004 Jetta GLI V6 24v 6 speed ... This started a few years ago, but it was happening in 3rd gear only -- therefore I avoided engine braking in 3rd gear all along. The noise was a pretty loud, noticeable grinding/spinning noise. 3rd gear while accelerating or maintaining gas worked and still works perfectly, smooth as can be.
Somewhat recently (6mo-1yr ago) all the other 5 gears started making this grinding noise, some more than others. 1st gear I don't really know because I don't engine brake in 1st. However, 2nd, 3rd, 4th, 5th and 6th (barely noticeable but still there) all make the noise. I now of course avoid all engine braking, however even the transitional steps between gears can be heard sometimes ... unless I perfectly match the RPM etc, but I'm just trying to get to work and back here ...
The car is still quite drivable, but with a major obstacle (pain in the ass) and a new clutch is probably around the corner -- I have 107K on it now. However ... a few years ago when it had 26K on it .. it didn't need a new clutch yet 3rd was still making that noise.
GTI 337/20th Anniversary :: Clutch Grinding When Go Into Second Gear
So I am pretty sure its my clutch that is the problem, here's what happens: When I go into second gear, it doesn't really grind.. but its tough to get it into gear and its only with second gear. sometimes it will go right in and others i have to double clutch. when i double clutch it goes in smooth every time. now I don't think it would be syncros because I am pretty sure if it was that it would do it every time I shift? It only does it while its cold or hasn't been drove in awhile.. but after i drive it around its fine so I am pretty sure its the clutch. Second thing, what is an upgraded clutch that is good for these 6 speed transmissions?
View 2 RepliesGTI 337/20th Anniversary :: No Clutch When Going To Put Car In Gear / Just Grinding
I just put a stage 1 clutch in my 20th anniversary. When i was taking the transmission out, i dropped the hydraulic clutch line and all of the fluid spilled out. I got the whole thing done, and bled the clutch line and topped off the reservoir. I started the car and the clutch pedal had, what felt like the right amount of pressure. More than the stock, but not significantly. When i went to put it in gear, its like there is no clutch, just grinding and it doesn't go in to anywhere. I can cycle through the gears with the car off and like i said, the clutch has the right pressure and everything.
View 10 RepliesGTI 337/20th Anniversary :: 1.8 O2m GLI - Constant Grinding When In Gear And Moving
so I bought my gli about a month ago assuming it needed a clutch (got it for a steal so wasn't worried about it) the kid I bought it from didn't really know much about the issue but it was a constant grinding when in gear and moving but the second you engage the clutch it would stop, and quiet down completely, so I dropped the trans and inspected clutch, throw out bearing, & fly wheel it all looked new.
So than my second guess was it was something internally in the transmission so I sent it out to be inspected and repaired as needed. I got a call from the shop today that said everything was perfect so I am completely stumped as to what my problem is. I have a new clutch, flywheel, throwout bearing, all new linkage, & am changing fluid. I don't know what else it could be and really don't wanna have to drop the trans again once its back together.
GTI 337/20th Anniversary :: Bouncing / Rubbing / Thudding Noise And Feeling From Driver Side Wheel Tire Area
I have 7mm spacers and when I take a hard turn, I get like an almost bouncing, rubbingish, thudding noise and feeling from my driver side wheel/tire area. I have FK coils. Do I need bigger front spacers? I have RC's btw, it gets worse as I go lower, and seems to go away if I really raise it up... how does everyone get away with this?
View 11 RepliesGTI 337/20th Anniversary :: Transmission Grinding Noise When Letting Out The Clutch
Normally I'm pretty good about searching and finding info, but there doesn't seem to be a lot out there for these trannys. In any case, when I hopped in my 20th to move it today, I got this grinding noise when letting out the clutch. The car won't go move in reverse or any of the forward gears. Idles fine, sounds fine when in neutral or when the clutch is depressed. It just grinds when you let the clutch out. Seems like I can select each gear OK. Linkage feels normal.
View 2 RepliesGTI 337/20th Anniversary :: Slight Grinding Noise In Neutral - Clutch Went Out
I was driving down the street and i noticed i couldnt get it in first gear, almost like a wall blocking it. and then i put it into 2nd gear and i started rolling... i turned my car off and when i started it back up, it had a slight grinding noise (in neutral). i put it in first gear, took out the clutch and i wasnt going anywhere... same with 2nd gear...
so i towed my car to the shop, they said my clutch went out and i "lost first and REVERSE gear".... is that possible?!
GTI 337/20th Anniversary :: Clicking / Grinding And Creaking Noise When Turn Wheel
I've just started noticing a "clicking/ grinding/ creaking" when I turn my wheel. It makes the noise if I'm parked, or driving slowly. I can feel it in the steering wheel, and hear it in the cabin, but can't hear anything when I'm under the car.
It sounds like 'two pieces of rubber binding on each other', is the best I can describe it. I THINK its coming from the driver's side. I've considered: strut mounts shifting, CV joints, something in the steering column, Tie rods, power steering pump...
Everything is tight on the wheel when I try to move it by hand (on jacks), and no rips/ tears in any boots.
GTI 337/20th Anniversary :: Grinding / Squealing Noise When Moving Backwards / In Reverse
So I put in new rotors and pads and everytime the car is backing up I get a weird grinding or squealing noise. I've driven the cars for hundreds of miles and this still happens. This only happens when going backwards. Anything to try???
View 4 RepliesGTI 337/20th Anniversary :: Grinding Or Rattling Noise At Start Up That Stops After Few Seconds - Code PO411?
I have the po411 code, not sure which problem it is but when I first start the car it sounds awful like almost a grinding or rattling noise then stops after a few seconds.
View 3 RepliesGTI 337/20th Anniversary :: Rattle Noise Going Into 1st And Low RPM In 2nd Gear?
Sounds like maybe from exhaust, I could be wrong but what that is? Just started today...
View 10 RepliesGTI 337/20th Anniversary :: 2004 - Clutch Won't Go Into Any Gear
My wife was driving home and was exiting the freeway, downshifted and then no response from the clutch or gearbox. It would move left to right but not go into any gear with the car on. No real pressure in the clutch pedal either. With the car off you are able to find all the gears but when you start the car in gear with the clutch down it just jumps forward and dies. No smoke or burning smells either way and the pedal does come up by itself. Pushed the car into the driveway and its goin to the shop tomorrow morning.
With the search button so far: master/ slave cylinder, full clutch problem, air in brake/clutch lines, shifter linkage bracket
I don't think it's the slave cylinder as the pedal is NOT stuck to the floor, but I am not handy with cars, only motorcycles. First thing I checked was the linkage bracket, which seemed to be fine and as I stated, I was able to get in gear while car was off. Brake fluid was almost full but i know that doesnt rule out air in the lines.
Prius (2004-09) :: Beeping And Grinding Noise As If Wheels Are Rubbing
When I drive my prius and make sharp turns or any sort of UTURN, the wheels lock up, automatically brake and there is a grinding noise as if the wheels are rubbing and there is a beeping noise. I took my prius back to the dealer for warranty repairs and the problem persists. is this a normal thing?
View 1 RepliesGTI 337/20th Anniversary :: Rubbing Sound When Wheels Turned
When I turn my wheel, i hear this sound like im rubbing my lip but not as loud.... Is this something I should be worried about... or am I just rubbing my fender lining?
View 4 RepliesGTI 337/20th Anniversary :: Rubbing On Front Passenger Side?
Couple of days ago I notice some rubbing on my front passenger side and I'm pretty sure it's my sway that rubs on the axle. I could understand that if I was slammed but I'm not even all the way down on my vmaxxs. I have about 15 threads left and it still rubs especially while making left turns. When I first got my coilovers I used to drive all the way down with no issues but now it's getting worse and worse and I don't know what to do besides going up couple of threads. The tricky part is that my driver's side front doesn't rub at all. Any ides why would start rubbing all of the sudden when it never rubbed before even when I was lower? Is there anything I could do, maybe adjust the end links or something? I know I can cut the sway out but but I'm pretty sure there is another way to fix it since it started rubbing recently.
View 13 RepliesFord F-150 (2004-2008) :: While Turning Makes Rubbing / Grinding Noise From Front?
I've got a new issue that is happening on the front end of my truck. Whenever I try turning my wheel while driving, I get this rubbing/grinding noise coming from the front of my truck. It only happens when the wheels are in motion. It seems to happen less when I'm driving at higher speeds, but I can notice it make the sound at any speed. I tried driving it slowly in an empty parking lot while turning and it's definitely making the sound every time the tires rotate.
I took it in for an alignment because this was happening every time I drove, whether it be driving straight or making a turn. Now that my alignment has been fixed, it no longer make this noise if I am driving in a straight line, so it only seems to happen when I'm turning. I had the mechanic check to see if they could reproduce the issue. The mechanic was able to hear what I hear, but when he put it on the lift at the shop, he was not able to reproduce the sound.
GTI 337/20th Anniversary :: OEM Shifter Makes Clicking Noise Going Into Gear When Driving
When driving my car, my oem shifter makes a clicking noise going into gear. is there a way to get it to stop, other than getting a short throw?
Looking for 2004 gli all weather floor mats? or ones that would fit?
[IMG][URL] ....