Ford Super Duty (1999-2016) :: 2012 F350 - Tailgate Step Installation?
We just purchased a new 2012 F 350. Love it, however when shoping forgot about getting one with a step. Have found step and handle available (OEM) but need to know how hard/easy to install it on our current tailgate. I gather from another post the handle part is easy but what about the step itself?
View 2 RepliesFord Super Duty (1999-2016) :: 2012 F350 - Hellwig Front Sway Bar Installation?
Installing the Hellwig 1 1/4 inch Front Sway Bar on their 11 and up F250 or F350 SRW Pickup?
My 2012 F350 Super Cab LWB XLT 6.7L seems to have quite a bit of sway in the front end. This is especially true moving slowly such as turning into service stations or other off angle turns. The truck only has the FORD OEM puny Rear Anti Sway Bar but the front seems to accentuate sway. The Truck has Rancho 9000XL Shocks, Timbren Enhanced Suspension System as well as Torklift Quick Release Stable Loads in the rear.
The Truck I have is not overloaded but it does carry an Eagle Cap 950 Camper pretty much full time. True the Campers now days are tall so some sway is expected. I just want to reduce the apparent front end sway and wonder if others have used the Hellwig Sway Bar in the front.
Ford Super Duty (1999-2016) :: 2012 F350 XLT - Premium Sound Tweeters Installation On Door Pillar
I have a 2012 SD Reg cab 350XLT, I am installing the premium sound tweeters on the door pillar. Looking for the diagram for the big plug that connects all the door stuff to the truck body? I need to find the tweeter wires, or figure out another way to jump the gap from the door to the body.
View 1 RepliesFord Super Duty (1999-2016) :: 2008 Bumper Fit A 2006 F350?
Will a bumper off a 2008 F350 fit on my 2006 F350?
View 7 RepliesFord Super Duty (1999-2016) :: 2014 Front Bumper Fit On 2001 F350?
Do a 2014 f350 front bumper will fit on a 2001 f350? Wanting to know if the bolt holes and body lines will match up? I put a 2014 rear bumper on and it bolted right up.
View 8 RepliesFord Super Duty (1999-2016) :: F350 - CC Pop N Lock Installation - Wiring Harness?
Installing a Pop N Lock on a 2016? What were the wire colors you tapped into?
View 3 RepliesFord Super Duty (1999-2016) :: 2001 F350 - Trans Temp Sensor 4r100 Installation?
I have an isspro sensor that I need to install on my 4r100. I have it all installed except for the actual sending unit. My question is where is the best place to put it?
I've watched multiple YouTube videos and it seems a lot of people use the test port on the driver side above the linkage. I found out the hard way that it is a very poor choice of location. A lot of people say that the best way is to drop the pan drill a hole and weld in the bung? I was wondering would it be possible to put it on the "out" line on the transmission oil headed to the cooler? 01 f-350 7.3
Ford Super Duty (1999-2016) :: 2003 F350 - Wire Color For Reverse Lights At Rear Bumper
Installing a back up camera and need to locate reverse lights on driver's side at rear bumper. What color wire is for the reverse lights on a 2003 F-350 (truck in my sig)?
View 4 RepliesFord Super Duty (1999-2016) :: 2002 F350 Won't Start After Installation Of Positive Cable Set For Dual Battery?
I just installed a new positive cable set for the dual battery's and the starter checks out good.
View 5 RepliesFord Super Duty (1999-2016) :: 2002 F350 TPS - Low Crawling / Throttle Is Very Jerky Off Road
My truck is a 2002 F350 CC dually longbox 4x4 7.3 auto that I bought last fall. On the street it is very well behaved although I suspect it is not giving me as much power as it should be, as compared to my previous 95 powerstroke.
Off road, slow crawling, the throttle is very jerky. Under acceleration it is smooth, but if I try holding a low throttle position, the rpm rises and falls. I am certain this is a bad TPS, and may also be contributing to my perceived low power on the street.
I have googled my brains out and it seems there is a cheap replacement TPS for earlier trucks but the 2002 has the 5 wire combined TPS and IVS, which reportedly is not replaceable without replacing the whole pedal assembly. To complicate matters I have the adjustable pedal assembly
So are there any options other than buying a complete pedal assembly from ford? Can I save some bux and retrofit a non-adjustable pedal assembly? I saw a youtube video where a guy put a newer 6.0 pedal assembly in but he was short on specifics about what exactly he gained doing this.
Ford Super Duty (1999-2016) :: 2000 F350 Front End Vibration When Hit A Little Bump On The Road?
2000 F350. 4x4, V10. 153,xxx miles. Here's the story. Whenever I hit a little bump in the road, I get a vibration directly under my feet and in the gas pedal, NOT in the steering. It will go away pretty quick or when I hit another bump. It only happens when the front driveshaft is not spinning. Hubs locked in in 2WD, it doesn't vibrate. Hubs unlocked and in 4x4 High it doesn't vibrate.
View 8 RepliesFord Super Duty (1999-2016) :: 1997 F350 - Engine Stalls Going Down The Road With No Warning
I have a 1997 f-350 crew cab 4x4 w/ off road package and 7.5 fuel muncher power package. My engine stalls going down the road w/ no warning. Sometimes it will start back up immediately, and other times not until i cycle the ignition 6 times or so.it seems to be getting worse as time goes by. Since it started i replaced tps, cap, rotor, plugs and wires. I also replaced fuel tank and pump and filter about 1.5 years ago. Some other issues to clear up, but concerned w/ current problem.
View 2 RepliesFord Super Duty (1999-2016) :: F350 - Rear Suspension Clunk Over Bumps / Heaves In The Road
I have a 2005 king ranch and have a clunk coming from the back over bumps/heaves in the road. It doesn't happen all the time but often enough. I just replaced the shocks, that worked a little but didn't solve the problem. Now thinking rear sway bar end links? Anything I can check/inspect?
View 1 RepliesFord Super Duty (1999-2016) :: F350 4x4 Death Wobble Felling Even Around Slight Bends In The Road
I put new ball joints on a few months ago and now the truck is starting the death wobbles felling even around slight bends in the road.I jacked it up and the passenger side tire will move 1" side to side scarey.Not sure what I need to replace.
View 9 RepliesFord Super Duty (1999-2016) :: 2006 F350 - Low Side Oil Pressure After Driving Down The Road A Couple Miles
Have a 06 f350 just rebuilt the engine. Started up ran it down the road a couple miles and lost low side oil pressure. Got back to the house and will not start again so put a gauge on and it only has 3 lbs after cranking for 10-15 sec. Pulled the balancer and lpop cover and front cover had some deeper scoring then before. No noticeable stuff in the pan or filter. Changed out the front cover and lpop. Still has only about 5 psi.
View 3 RepliesFord Super Duty (1999-2016) :: 2012 F350 - Air Only Comes Out Of Vent?
I recently purchased a 2012 f350 power stroke. Love the truck but went out this morning and the air would only come out of the vents. I couldn't get anything out of the defrost or the floor vents? Truck is out of basic warranty so want to see if I can figure this out myself or if it needs to go in the shop.I've looked for a fuse but didn't see anything that ran an actuator door.
View 5 RepliesFord Super Duty (1999-2016) :: 2012 F350 Truck Won't Start
I have a 2012 Ford F350 I've been looking to install a compressor on. I've poked a hole in the gasket that runs wires through the firewall and cut the tips off of a couple of the accessory wires. Went to go get some more parts and now the truck won't start! The lights and radio turn on when the car is turned on but the starter doesn't even click when I try to start it. What should I look at?
View 7 RepliesFord Super Duty (1999-2016) :: 2012 F350 - How To Disable DRLs
How do I disable the day time running lights on 2012 f350?
View 4 RepliesFord Super Duty (1999-2016) :: 2012 F350 6.7l - EGR System Torque Specs
Replacing EGR cooler/ EGR valve. Are there torque specs going back together with the EGR system? or is there a forum that has all the torque specs id need to complete the job.
View 4 Replies