Ford Super Duty (1999-2016) :: 2006 F350 - No Crank - Engine Sensor Data / Trans Temp Error

I have an '06 F350 dually with a 6.0 diesel. I bought this used about 5 years ago and for the most part have loved it. i would always smile on the inside when i heard people bash the 6.0...i thought i got lucky....until today.

140k miles. recent oil change. all is swell...until this morning. Stick in key and turn it. glow plug indicator comes on...all lights come on for a few second....wrench, abs, dtc etc....wrench shuts off...glow plug light comes on...4 or 5 seconds later wrench light comes back on....turn key and NO CRANK.

All fuses are fine...starter cranks if i jump the solenoid...but it won't start. Miles to empty and everything else is just dashes hit the OBD and it says "engine sensor data error"/ "trans temp error" ...

View 1 Replies

Ford Super Duty (1999-2016) :: 2001 F350 Manual Trans 4x4 - Temp Gauge Not Working

I replaced the sensor on top of the water pump and the gauge still doesn't work. I tested the gauge by unplugging and grounding out the wire and the gauge goes all the way up. What I can try next. I didn't get a Motorcraft sensor so I'm going to go get one of those tomorrow hoping the duralast wasn't correct even though it looked 98 percent identical to the original. 7.3 lite diesel.

View 1 Replies

Ford Super Duty (1999-2016) :: 2001 F350 - 4R100 Not Up Shifting To OD

Bought truck drove it 240 miles on interstate 80 mph no problems---2001 F350 4x4 auto. Next morning backed out drive and trans fluid trail 6 inches wide. Didn't leak in forward gears (at that time) added fluid and drive to town shifted fine.

Next day gonna drive 150 miles to check out leak. (Son was driving it) said it wouldn't go over 40 mph. Revving high. Hauled truck here on trailer and pulled tranny. Rear housing cracked just before 4x4 adapter. (This trans was rebuilt 10k miles ago) ..

Got used 4R100 from friend who replaced only because he built one for his truck. It was shifting fine etc when pulled 6 months ago. Used cracked trans TC and installed. Test drive no 4th or OD. Pulled trans put TC that came with trans in. Still no OD. Put on scanner while driving. Trans is being commanded to shift to OD but not up shifting. 45mph at 2400rpm.

Pulled plug to solenoid pack inside trans ( this should make trans default to OD / limp mode) still no OD and won't go over 45.
Pulled OD button checked wires inside steering column. All looks great. Not even a heavy rub mark.

Should I replace the coil pack in trans? Where do I go from here? Again this trans was known to be good when pulled 6 months ago.

View 4 Replies

Ford Super Duty (1999-2016) :: 2002 F250 - Trans Temp Sensor Location

I have noticed my trans temp gauge needle is dead center of the gauge even on a cold start. I thought my sensor was under the pan so I pulled it and did not see any sensor at all. Is there a external sensor?

View 5 Replies

Ford Super Duty (1999-2016) :: 2008 F350 - Trans Temp Sending Unit Replacement?

The trans temp guage on my '08 F-350. V-10 started acting erratically, and the wrench icon popped up on the display. i crawled under the truck to look for the sending unit and it's lead. i assume that i found the lead. it is encased in a corrugated sleeve, and appears to be a vaccuum type tube and boot connector? the boot still had a small round gray cap plugged into it. it appears that the cap was never glued (go figure) upon assembly. i have tried to reach up on top of the trans to find the sending unit to figure out the best angle of attack. i can barely touch it with the tip of my finger. going with mechanical guages is out of the question at the moment, so i'm wondering can it be driven any distance this way, AND any schmooze tricks developed to get at the sucker without dropping the cross member or exhaust????

View 3 Replies

Ford Super Duty (1999-2016) :: 2001 F350 - Temp Read-out On Mirror

I have a 2001 F350 and the temp read-out on the mirror hasn't worked since I got the truck in 2004. Where the sensor is. I found a connector on the back side the core support on the driver's side that has nothing plugged in. Could this be where it should be?

View 4 Replies

Ford Super Duty (1999-2016) :: 2001 F350 V10 - Temp Gauge Failed

I had a mechanic replace the temp sensor on the top of the intake in my 2001 f350 v10 and since then my temp gauge doesn't work. He replaced the sensor again and still nothing. Is there a different sensor/sender that controls the temp gauge???

View 4 Replies

Ford Super Duty (1999-2016) :: 2001 F350 5.4 - Free Rev Over 2500 RPMs - Engine Or Trans?

Truck: 2001Ford F350 5.4 auto 4x4

Issue: Engine seems to free rev over 2500 RPMs. Barely hits 50 MPH. Revs fine in park, no power in gear. At 1/4 throttle it will move, but sluggish at best. Once you get around 2500 RPMs it stops accelerating and just revs. Does this in every gear, and gets worse the faster you go. feels like its stuck inbetween gears almost. No CEL's

Replaced: MAF, TPS, Trans fluid and filter, fuel filter, cleaned intake system, fuel system treatment, O2 sensors. Trans fluid was dark, but no burnt smell.

I'm about to pull the exhaust and look for a clogged cat.

View 6 Replies

Ford Super Duty (1999-2016) :: Transmission Temperature Sensor Location 4R100

My truck has a bit of an interesting trait. Unless it's just about freezing, my transmission is just about always at operating temperature. If it's 50*F outside and I start the truck, the Trans temp is smack dab in the middle. If it's 30*F outside it starts just a little above cold then is "warmed up" when I drive it down my short street block, which ain't right.

All the rest of the time, it's always reading middle of the bar temperature. My old 5.4L never did this. My 7.3L does. Best I can tell is it's a fault in the temperature sensor for the transmission. I don't have a scan gauge yet to get the readings but will be getting one. Just need to know where the sensor is at so I can have a starting point.

View 3 Replies

Ford Super Duty (1999-2016) :: FIPL Sensor For 4r100 - Downshifting On Acceleration Going Uphill

Having downshifting problems with REbuilt transmission. Is there a FIPL sensor for the 4r100? I was told to check all engine codes first, but i just have a EBPV sensor code, but removed the valve when I installed the GT38R turbo...

Rebuild:
- Tugger kit
- triple disc Billet torque converter
- New clutches and seals,.
- Banks Trans command module

... I also have a 6-pos tuner.. I had a Super chips tuner too and it has ALWAYS had the downshifting on acceleration on up-hill grades!!

View 14 Replies

Ford Super Duty (1999-2016) :: 2003 F250 4R100 Trans Blowing 10a Fuse When Pull Selector Into First Gear

Whenever I manually pull my gear selector into first gear it blows one of the 10a fuses (not sure which number). I lose all gauges and accelerator pedal. It's about the fourth fuse from the right on the bottom row.

View 4 Replies

Ford Super Duty (1999-2016) :: Trans Not Getting Up To Temp

I have noticed that in the past 1-2 months my trans probably has just get to 150*. Even on warm/hot days. Lately its just been 120-140 all day every day.

Can this cause any problems? It used to go up to 150-170 when warm, now it takes a hot day to get there.

I assume its fine, but just checking because I have, admittedly, neglected my trans fluid.

View 10 Replies

Ford Super Duty (1999-2016) :: Trans Filter 4R100 - Safety Clip Used To Hold Filter Up?

On my previous 1992 F-350, when I serviced the E40D 2WD trans I replaced the filter during a trans service. I read about some filters falling down inside pan causing shifting issues. There is an aftermarket clip sold that holds the filter in the up position and prevents it from falling into pan.

Is the clip also used on the 2WD 4R100? is it the same issue of potentially falling down in pan as was the case with the E40D? Preparing to service my 2003 F-350 2WD 4R100 and install a new filter and want to be sure I have all parts/supplies ready to go.

View 13 Replies

Ford Super Duty (1999-2016) :: Trans Seems To Run Hot / Temp Range?

I have a 16 with a 6.2. Truck has less than 1k on it but the tranny seems to run hot. What do these run at?

View 10 Replies

Ford Super Duty (1999-2016) :: 2001 V10 4r100 Won't Shift Out Of Gear?

The other day I was driving i was driving down the road when suddenly my truck wouldn't shift out of first gear, then the truck died and the motor wont turn over either. Acts like it is locked up. Its an 01 with v10 and 4r100.

View 6 Replies

Ford Super Duty (1999-2016) :: Linking Trans Temp To Scangauge 2

I put in the X codes and it doesn't show. The icon is on the screen but no reading for temp shows up. The truck is a 2008 with the 3V V10. Maybe verify the codes for me?

View 6 Replies

Ford Super Duty (1999-2016) :: Trans Temp Upper Parameters

I recently purchased a ScanGuage II and installed it in our '09 F-250 SD 5.4 slush-a-matic with 4.30's and 31 1/2" tires. This unit is primarily used for towing and I wanted to keep an eye on the trans fluid temp. By the way, I really like the ScanGuage II. It gives me real time fuel mileage, coolant temp and accurate trans fluid temp, among many other things.

My question for you guys that pull your trucks hard on a regular basis is this, what is the maximum trans fluid temp that I should allow the slush-a-matic to rise to? I towed our 9000# 5ver 200 miles one way to Indy for the 500 over Memorial Day weekend and the highest TFT was around 180 to 185 max. It was under 180 most of the time.

What are the upper parameters of TFT that his tranny will endure and still live a long trouble free life?

View 11 Replies

Ford Super Duty (1999-2016) :: 2001 F250 - 4R100 Cooler Minimum GVW?

What's an acceptable GVW value when one is looking to replace the air to oil cooler for this transmission?

2001 F250 CC SB PSD 7.3 Edge

View 1 Replies

Ford Super Duty (1999-2016) :: 2012 F350 - Tailgate Step Installation?

We just purchased a new 2012 F 350. Love it, however when shoping forgot about getting one with a step. Have found step and handle available (OEM) but need to know how hard/easy to install it on our current tailgate. I gather from another post the handle part is easy but what about the step itself?

View 2 Replies