Ford Super Duty (1999-2016) :: ABS Light On - Wiring Harness Damaged
I have been tracking down my ABS light and found that the left front wheel speed sensor has had the wiring harness ripped off from behind the front wheel. I have about 2ft of the harness coming off of the actual sensor.
Question is, since I cannot locate any wires that this seems to be able to be connected to, can I simply cut and splice these wires directly into the Tan/Black + Tan/Lt Green wires going straight to my ABS controller?
Ford Super Duty (1999-2016) :: F350 - No Power At Harness
I found these on my buddies truck, its on the frame rail on both sides. I have the connectors and lights to install but there is no power at the harness. Is this something the dealer has to "reflash" in the pcm to make these light up? I assume they should operate while unlocking the doors or opening, ign. on or off.
YouTube.....
Ford Super Duty (1999-2016) :: F550 Trailer Wiring Harness - Getting Shorts Whenever It Rains
I recently purchased a 2011 F550 Super Duty with a flatbed mounted on it. Turns out, the trailer wiring harness is totally screwed up and I am getting tons of shorts whenever it rains. Going through it front to back, we are finding multiple problems like missing fuse box covers, damaged fuses for starters. The Ford dealership in Texas that did my prepurchase inspection for me totally missed all of this, so i am stuck holding the short end.
IN the rear of the truck we detected shorts in several areas. One of them is in this adapter pictured along with this. Is this a Ford part, or does it appear aftermarket? Is it just an adapter or is it more than that? I am just now getting to l know this truck more specifically. given the date of manufacture on the label it would seem to be from Ford??? Part # is 99-004 and 71-012-A...
Ford Super Duty (1999-2016) :: 2015 F250 - Rear Wiring Harness Connectors?
I'm trying to find out what the two connectors in the image are.. I've looked through the manual that I have and searched around on the web and find nothing.
They're on a 2015 F250. "upfitter" switches were installed from the factory.
Ford Super Duty (1999-2016) :: Key Won't Move To Off Position After Cylinder Lock Removal And Installation
I have a problem with an 2000 F250 7.3 6spd. Recently, the "key in the ignition" chime kept dinging even when no key was in the ignition. I read in the forums that a wire can be disconnected to stop the chime. The problem is that after I re-install the cylinder lock, I cannot move the key to the off position to remove the key. I can rotate it to start and run, but it won't move backwards to the off or acc position.
The truck has this little lever that normally needs to be pushed to allow key to be released, but even after pushing that, turning the steering wheel back and forth, and messing with the tilt, I still can't get the key into the off position. I have removed the cylinder and it looks good. It rotates properly and I can remove the key, but only when it isn't installed. I tried replacing the ignition switch, but the lock cylinder still doesn't move.
I have an 04 F250 that I've tried swapping the lock cylinders from the 04 to the 00, but it still doesn't turn. What might be the cause/fix? Also, the 2000 F250 has a intermittent chirping/squeaking sound under the dash that happens even when the batteries are disconnected - might this be a malfunctioning vacuum motor? It happens even though the truck hasn't been driven for a week.
Ford Super Duty (1999-2016) :: 2012 F350 - Tailgate Step Installation?
We just purchased a new 2012 F 350. Love it, however when shoping forgot about getting one with a step. Have found step and handle available (OEM) but need to know how hard/easy to install it on our current tailgate. I gather from another post the handle part is easy but what about the step itself?
View 2 RepliesFord Super Duty (1999-2016) :: 2012 F350 - Hellwig Front Sway Bar Installation?
Installing the Hellwig 1 1/4 inch Front Sway Bar on their 11 and up F250 or F350 SRW Pickup?
My 2012 F350 Super Cab LWB XLT 6.7L seems to have quite a bit of sway in the front end. This is especially true moving slowly such as turning into service stations or other off angle turns. The truck only has the FORD OEM puny Rear Anti Sway Bar but the front seems to accentuate sway. The Truck has Rancho 9000XL Shocks, Timbren Enhanced Suspension System as well as Torklift Quick Release Stable Loads in the rear.
The Truck I have is not overloaded but it does carry an Eagle Cap 950 Camper pretty much full time. True the Campers now days are tall so some sway is expected. I just want to reduce the apparent front end sway and wonder if others have used the Hellwig Sway Bar in the front.
Ford Super Duty (1999-2016) :: 2012 F350 - Road Armor Bumper Installation?
I am installing a set on a '12 F350 for a customer. I already had to go buy an additional hardware in order to get the back bumper on correctly...and now I'm looking at the front bumper and I swear I don't have the parts I need to install it. It appears to be missing some brackets. There were NO instructions with them (apparently a chronic problem with Road Armor) and I can't possibly imagine it bolting to the flimsy brackets that hold the factory bumper (fairing would be a better word for it) in place.
View 6 RepliesFord Super Duty (1999-2016) :: 2001 F350 - Trans Temp Sensor 4r100 Installation?
I have an isspro sensor that I need to install on my 4r100. I have it all installed except for the actual sending unit. My question is where is the best place to put it?
I've watched multiple YouTube videos and it seems a lot of people use the test port on the driver side above the linkage. I found out the hard way that it is a very poor choice of location. A lot of people say that the best way is to drop the pan drill a hole and weld in the bung? I was wondering would it be possible to put it on the "out" line on the transmission oil headed to the cooler? 01 f-350 7.3
Ford Super Duty (1999-2016) :: 2002 F350 Won't Start After Installation Of Positive Cable Set For Dual Battery?
I just installed a new positive cable set for the dual battery's and the starter checks out good.
View 5 RepliesFord Super Duty (1999-2016) :: 2012 F350 XLT - Premium Sound Tweeters Installation On Door Pillar
I have a 2012 SD Reg cab 350XLT, I am installing the premium sound tweeters on the door pillar. Looking for the diagram for the big plug that connects all the door stuff to the truck body? I need to find the tweeter wires, or figure out another way to jump the gap from the door to the body.
View 1 RepliesFord Audio/Video System :: 1999 - Powerstroke Amp Installation - Wiring Harness?
I am no novice at stereo system upgrades but have never done anything to a diesel before so here it goes....99f-250 powerstroke....which battery should i hook the amp power cable to driver side or passenger side or does it matter?
View 3 RepliesFord Super Duty (1999-2016) :: F350 - Wiring Diagram For Taillights?
I am looking for a wiring diagram for that taillights for a 1999 f350 pickup. I am working on a friends truck that doesnt have any taillights and I would like to have a diagram in hand before I get started on it.
View 7 RepliesFord Super Duty (1999-2016) :: 2014 F350 - Reverse Camera Wiring
On one of the trucks in work, the salt has corroded the truck side plug for the reverse camera in the tailgate. Because of this, the camera no longer works.
Is this part of the whole rear wiring harness, or it the tailgate plug a separate pigtail that can be replaced? If it is a separate part, what is the part number so I can order it?
Ford Super Duty (1999-2016) :: 2005 F350 - Radio Wiring Diagram
What is the factory radio wiring colors or know where I can find a diagram?
View 14 RepliesFord Super Duty (1999-2016) :: F350 - 4x4 Manual Lock Out Hubs
I just purchased an F-350 with manual locking hubs. I am unsure if I can keep these locked in for part time four wheel driving or I need to unlock them each time I go back to two wheel drive?
View 6 RepliesFord Super Duty (1999-2016) :: 2007 F350 - Uplifter Switch Wiring Diagram
I just picked up my 2007 F350 as a replacement for my 2003 F350 (still have the 2003). I really like the uplifter switch option on the truck, I can normally figure things out but I am one of those people who is electrically challenged (home and auto)and also am one who does not wish to butcher the new ride (same for the home)to gain an education in the art of wiring. I would like to reinstall my headache rack lights on this truck as they are needed for winter work. I was in my truck manual and the info for wiring is weak and the website did not respond nor did my email to ford. I have found the wire harness but it is not tagged as a pair/color to switch. I have the lights already grounded to the rack, so I am thinking I just need the hot wire from the switch. Looking for the color code for positive and ground for the switches.
View 14 RepliesFord Super Duty (1999-2016) :: 2011 F350 - Anti-lock Brakes Come On When Turning
I have a 2011 F350, with a 4 inch Rancho Suspension lift. Ever since the lift kit was installed, more commonly when turning to the left than right, the anti lock brakes come on and the traction control light comes on/flashes. without even stepping on brake pedal.
It seems to happen when the wheel is at about 80% of max turning, about 15mph. Both wheel hubs and sensors have been replaced. road tested with Ford tech , he watched the speed sensor input while hooked to the computer and all sensor are reading correctly.
Today I went in a constant circle and can make it do it non stop, and when you try to press the brake pedal while the anti-lock (grinding/chattering) noise is happening, it only gets louder.
Ford Super Duty (1999-2016) :: 2000 F350 - Factory Key Fob To Lock And Unlock The Doors While Running?
Ok, it's cold out... is there a way that I can use my factory key fob to lock and unlock the doors with the truck running? 2000 F350.
View 10 Replies