Ford Super Duty (1999-2016) :: 2015 - Addition Of Programmer / Tuner?
I just bought an 2015 F250 4x4 6.2L (gas) I am thinking about buying a programmer/tuner for it. I am planning on taking the truck pulling a 28' camper to Florida this summer. My goal is to get the most gas mileage I can out of the truck.
View 7 RepliesFord Super Duty (1999-2016) :: F250 - Header Gasket Leak / Passenger Side Only
1999 f250 with some mild upgrades. Trucks got 189,000 miles. Stole it from an older guy for 4k. In fantastic shape. As the weather got colder I noticed an exhaust leak. Took it to a muffler shop only to find that it's got an aftermarket header on the passenger side only. Is that common to replace only one side?. the gasket has gone bad and needs replacement. I wanna replace both headers?
View 8 RepliesFord Super Duty (1999-2016) :: 2000 - Torque Settings For Lug Nut?
What torque setting I should use for lug nuts on a 2000 F-350 dually?
View 7 RepliesFord Super Duty (1999-2016) :: Occasional Misfire With Low RPM - High Torque
On my '99's 5.4l with 55k, I've got a slight misfire occasionally with lower rpms and higher torque - basically going up a grade that's not quite steep enough for the truck to downshift, but clears up right away the instant it downshifts and gets some rpm. It generally seems like weak spark, or perhaps an injector spray pattern such that it doesn't always get fired off.
To give some history, the truck had more or less sat in a farm garage for ~5 years driven maybe once a quarter before I picked it up ~2 years ago. When I first picked it up, it misfired all over the place. I didn't think much of it, considered it gummy fuel, and dumped a couple cans of SeaFoam in the tank, replaced all 8 plugs (pretty sure with motocraft plugs though I don't explicitly remember), checked my air filter, etc and the misfires cleared right up and it purred nice and smooth like a happy little motor. That was at ~45k, or 10,000 miles ago.
Now it's starting to hiccup again and I'm not entirely sure why. The plugs should be nowhere near burned up yet and there are no lights on the dash. It's never come close to overheating and the only oil leak I know of is that famous small drip on the inside-rear of the passenger side bank drips on the exhaust header just enough to stink every so often when I come to a stop. I don't believe I'm burning any oil and certainly not near enough oil to foul a plug. Including that drip, I go about 3,000 miles before needing to add a quart. I've dumped 2 bottles of Berryman's in the fuel tank and it seems to work, but it's definitely not gone, so I'm thinking it's probably not oil related and more fuel/spark.
I'd had it in the back of my head to replace the fuel filter as well, but I hadn't gotten around it yet as it seems to be getting fuel at high rpm's just fine. I went ahead and bought the filter the other day and plan to install it shortly. It doesn't really make sense that that's what it would be, but I figure I'm due and it's worth a shot. If they were old plugs, I'd just replace them out, but they seem to new to be causing any issues.
Ford Super Duty (1999-2016) :: 2014 - Need Torque In Foot Pound?
What torque value is in foot pounds that Ford recommends for the 10mm bolts that attach the overload spring bumper brackets to the frame on a 2014 F250?
View 5 RepliesFord Super Duty (1999-2016) :: Torque For Differential Cover Bolts
Torque on the differential cover bolts, 2016 F250?
View 6 RepliesFord Super Duty (1999-2016) :: Torque Shift Temperature Limit?
I finally got around to installing a transmission temp sensor in our '06 F250, and I have noticed today that it seems to be at 180 degrees regularly driving around town unloaded. It has been around 80-85 degrees outside today. We just got this truck about a month ago, so I'm still getting used to its little quirks. On our old 7.3 with a 4R100, it wasn't at all unusual to see 180 on a day like today around town. Is this normal on a TorqShift?
View 13 RepliesFord Super Duty (1999-2016) :: 2012 F350 6.7l - EGR System Torque Specs
Replacing EGR cooler/ EGR valve. Are there torque specs going back together with the EGR system? or is there a forum that has all the torque specs id need to complete the job.
View 4 RepliesFord Super Duty (1999-2016) :: Substantial Vibration When Torque Converter Locks
I have a bone stock (other than exhaust) F-250 SD, 6.0 auto, 185k miles. I have a substantial vibration when the torque converter locks - about 50-55 mph. Once the transmission warms up (i.e. 4-5 miles from a cold start) the vibration goes away and the transmission performs flawlessly. Backing out of the throttle and allowing the TC to unlock makes the vibration go away, as does shifting into neutral. There is no noise, just a vibration that will shake the whole truck. Transmission fluid looks good, and showing full. Have had the truck about 4 months, and have not flushed or replaced the filters on transmission.
I've seen a couple of similar threads on vibrations, but not one where the vibration will completely go away. I'm thinking replace the torque converter but wanted to get more information from the experienced experts that know these 5R110s better.
2007 F-250 King Ranch 6.0 PSD, 5R110W, 4" Turbo Back, Otherwise bone stock, 185k.
Ford Super Duty (1999-2016) :: Noticeable Torque Converter Lockup In 5th Gear
When running up through the gears under normal acceleration I can feel almost a double shift in 5th gear. It doesn't occur using tow/haul so I assume it is the TC locking up. Everything else seems fine. Truck has 9k miles, mostly towing. 2016 6.2 ....
View 6 RepliesFord Super Duty (1999-2016) :: 2007 - Won't Shift If Does Then Slams Into Gear - Torque Converter?
I have an issue to where every once in a while my truck will not shift and when it does shift it slams into gear, and my overdrive light flashes and then I'll turn the truck off let it sit and crank it back up and it drives fine and the overdrive light is off. It shifts normal and smooth other than when this happens. Not sure if it is my torque converter or maybe a solenoid or what. My truck is an 07 f250 6.0 with 192,000.
View 5 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Torque Converter Clutch Solenoid
I recently purchased this truck so I don't have any history on it. It's the V10 motor, automatic, 4 wheel drive, with a crew cab. I took it to Advance Auto to have them read codes and it came back with torque converter solenoid fault and 2 other codes related to that part. I didn't get to see the actual code numbers.
I've talked to 2 transmission shops and they said they could throw a solenoid pack into it, but that it might not even fix it. The truck drives fine, shifts fine, the tranny oil looks and smells fine, so I'm tempted to not worry about it until something else happens.
The truck has 217,000 miles on it...
Ford Super Duty (1999-2016) :: 2002 - Torque Converter Slip / Stall - No Lock Up
I have a 2002 7.3 with the 4r100 173k miles. If your nice to it she drives fine, but if you get on it the torque converter will slip/stall kinda revs up like 300 rpm then slams really hard between 1st and 2nd. Other gears work fine. I've only had it not happen like 10 times since I've owned the truck ..... I don't really beat on it except for towing which I'm starting to do a lot of. Wondering if putting a new stock torque converter in it is worth it.? Not gona blow the bank on a TC unless I'm putting a brand new trans in the truck. Which I don't think it needs in the near future.
View 14 RepliesFord Super Duty (1999-2016) :: Vibration On Takeoff And Other High Torque Situations - Unbalanced Driveshaft
We've gone through pretty much every other option as to the vibration on take off and other high torque situations and have pretty much settled on the the driveshaft as the issue. I added traction bars recently thinking that the old leaf springs just aren't up to the job anymore. That seems to have worked some but it's still there. We've gone through the rear diff also and that's good. I'm looking at options for replacement of the shaft. What are the current thoughts on one piece shafts? Is aluminum the better option?
View 14 RepliesFord Super Duty (1999-2016) :: F250 - Noise Like Fan Blades Hitting Coming From The Torque Converter
Switch out a 5.4 in a F-250 4X4 4 my neighbor now I have a noise like fan blades hitting coming from the torque converter it goes and comes and hits good in reverse...
View 9 RepliesFord Super Duty (1999-2016) :: 2005 - Torque Specs For Crankshaft / Cylinder Heads And Camshafts?
What are the torque specs for the crankshaft,cylinder heads and camshafts for a 2005 f550 v10 6.8?
View 2 RepliesFord Super Duty (1999-2016) :: 2009 F250 - AC Turned On But No Fan / Air
I just bought an 09 f-250 lariat 6.4 . It has 100k on it. Was driving it AC was working fine. Next time I got in it went to turn the AC Auto on and nothing..the display works fine..lights work..looks like it is working, but nothing. No fan no anything.
Also, the check engine light will come on too. Then next day everything works fine again. Check engine light is out..everything looks perfect. Then this morning the same thing happened..check engine light and no AC.
Ford Super Duty (1999-2016) :: 2009 - While Filling Fuel It Keeps Clicking Off?
When I go to put fuel in my truck. It keeps clicking off? I have to slightly hold the trigger to put gas in it? I have tried to get the vent hose to the tank filler off, but what is the trick to getting the hose off there??
View 5 RepliesFord Super Duty (1999-2016) :: 2009 F250 5.4L - 2 Misfiring Cylinders
I have a 2009 f250 with 5.4l 3v. have had the truck only about 6 months. it started missing about a month after I got it. I replaced all 8 cops and all 8 sp. The truck ran excellent until 11/29, then I got a cel and the truck started running really bad. Found 3 misfiring cylinders. Changed all 3 cops again and that did nothing. Pulled the injectors and found 2 of them were clogged, replaced those also. Still no change was told by someone that the ecm/cpu may need to be reset, did that also. Still no change. There are no codes present but still has the multiple misfires.
View 9 Replies