Ford Ranger / B-Series :: 2000 - Grinding Noise Only When Turn Left And At Any Speed
When I make a left turn I have a horrible grinding noise. Only when I turn left and at any speed.
View 2 RepliesFord Super Duty (1999-2016) :: Rubbing / Grinding Noise When Turning Left Or Right
My dually has started to make a rubbing or grinding noise just about every time I make a turn, left or right. What this could be, truck has 8500 miles on it.
SD Dually
Ford - Explorer :: 2013 - Grinding / Rubbing Noise In The Middle Of The Turn
My new 2013 Ford Explorer Limited (5000 miles) recently started making a grinding/rubbing noise with a slight to significant braking action in the middle of turns (typically left turns, at moderate to slow speed, e.g., at stoplights) when my foot is on the accelerator, not the brake. Lasts about 1 second, happens once a day or so, typically when the car is cold. The dealer was flummoxed, tried replacing the steering gear, but the same thing happened as soon as I drove out of the lot. Apparently no codes showing on brakes or ABS.
View 2 RepliesGolf IV R32 :: Rubbing Noise When Going Straight Or Turn Left
So, I put my RCs with Eagle F1 DSG3s back on and now I have noise. I thought there was some rubbing, so I spaced them out tonight, but the noise is still there. I thought it could be my alignment, so I got an alignment, still noise.
It happens when I'm going straight and when I turn left, but not at all when I turn right, things get quiet. It sounds like a a rubber rubbing noise but i took the wheel off and I couldn't see any wear... Could it just be tire noise??
Ford Ranger / B-Series :: 1989 - Grinding Noise When Let Off Gas
I have a 89 Ranger, 2.3, 2wd, Mazda 5 spd. Last year, 10,000 miles ago, I replaced the clutch, pressure plate, slave cyl, and pilot bearing. Today, it started making a terrible grinding sound/vibration when you let off the gas. The noise is coming from the clutch/transmission area. It is so bad that any amount of "engine braking" sounds terrible and I have to press the clutch in and the noise immediately stops. What to check for?
The only thing I can think of off the cuff is
1) bad pilot bearing,
2) low/no tranny oil. I replaced the oil and put silicone on the known leaky spots while I had the tranny out,
3) Input shaft had some "wobble" in it when I had the tranny out to replace clutch 10,000 miles ago.
This could be it but why would it start 10k miles later?
Ford Ranger / B-Series :: 2002 - Vibration And Grinding Noise?
Bought a 02 Ranger, 4.0 4x4 super cab 122,000 miles. etc Picked it up for 500 bucks because someone scrapped it along the side of a guardrail this last winter. Replaced rack and Pinion (cracked), Tie rods, Shocks, driver side knuckle and wheel bearing, and some body issues (bed is still shot so if any black short bed sitting around let me know). I've been kind of putting around all day in it, letting it used to working again. Starts right up, turns easily, I string aligned it so it goes where I want.
But as I get up to speed start at about 10MPG there is a vibration based noise coming from the front, can't pin down if its left or right. If Im going straight then turn it gets slightly more intense as I even start turning the steering wheel. The noise increases with vehicle speed. And I don't know if its separate or related, but any turn over 5-10* to the left results in a grinding sound but then I turn to about 10-15 and it gets less intense. No noise turning right.
I'm thinking a bad CV, TWO bad CVs, or a bad differential. Before I start ripping into those things, thought I'd get opinions, or hopefully experience in this area. I'm really hoping its something small and stupid. (like not getting a professional alignment)
Ford Ranger / B-Series :: 1999 - Grinding Noise When Let The Clutch Up Off Floor
1999 ranger 3.0, 5 speed stick. I was backing out of my driveway but there was a car coming so i pushed in the clutch and waited for the car to pass, when I let clutch pedal up off floor i heard a grinding noise, a little while latter did the same thing in first. Is this a first and reverse gear scyronizer or something else. What causes this and how to fix it ?
View 10 RepliesFord Ranger / B-Series :: 1994 - Grinding Noise While Clutching Down - U Joint?
I have a 1994 ford ranger 4 cylinder manuel transmission regular cab. I am hearing a grinding noise when I push and hold my clutch down. It doesn't make any noise when my foot is off the clutch. It makes the noise off and on when i stop at a light or stop signs. I have also noticed a vibration at certain speeds around 30 and then again around 70. What is the cause of these noises? Could it be my U joint?
View 5 RepliesFord Ranger / B-Series :: 2010 - Grinding Noise From Manual Transmission
A friend has a 2010 ranger with the 2.3L with the manual transmission. He said that when he drives and the rpms are up he said he gets a grinding noise it doesn't matter what gear 1rst or 5th. He think throw out bearing but no noises at all until the rpms are up there. I was think internal like shift fork but don't know.
View 4 RepliesLexus RX 2010-15 :: Rubbing Noise Coming From Wheel Base On Hard Left Turn
Just got my 2013 RX 350 CPO and been driving it for 2 weeks without any problem. But today when I was trying to steer my wheel all the way to the left (car was parked) and I heard rubbing noise coming from wheel base. It only happens when making hard left steering not right.
I read online and seems like it's a common problem for wheel bearing for Lexus cars.
Ford Ranger / B-Series :: 2003 - Grinding Noise While Shifting - Use Pressure Bleeder On Clutch System?
Just picked up a 2003 Ranger XL 2.3L and notice that I get a little grinding every now and then when shifting into 1st gear. The clutch was replaced 3 years ago according to the PO but had no clue as to how long it's been since the clutch was bled.
I've used my Motive pressure bleeder numerous times in the past on brakes with much success but I've never used it on the clutch. I've used vacuum bleeders as well but it's always a 50/50 success rate with that. The pressure bleeder just works much better for me.
Using a pressure bleeder on a clutch and if so any tips like still needing to tip the master cylinder end up to release any potentially trapped air bubbles?
Camry :: 2009 LE Grinding Noise On Sharp Left Turn?
I have 35k on my 2009 camry, (past warranty). All of a sudden in the last few days when I make a sharp left turn (like into a parking spot) I hear a grinding noise from my car. Not really a full on grinding, but like a quiet fart can muffler noise. No issues with alignment, driving straight, or sharp right turns.
View 5 RepliesGolf IV R32 :: Grinding Noise While Making A Left Hand Turn
The other day I hit a good size bump at speed, slightly bent a wheel which I didn't even notice at first. The car drove straight and had no other symptoms, thought everything was okay. A couple days later I heard a weird grinding noise while making a left hand turn, it was so faint I honestly thought it was the fender liner. After the noises continued and further examination I noticed that the carrier is rubbing the rotor on the lower drivers side corner.
View 1 RepliesFord Excursion :: Rubbing / Grinding Sound From Rear End When Taking Off From A Turn
I have noticed this rubbing, not quite grinding sound/vibration when I take off and turn. For instance pulling out of a parking lot and turning either left or right. Truck will do it only after it's been driven a while. I originally thought it was just the limited slip ratcheting but recently just changed the rear axle fluid adding Amsoil this time. I did not add any friction modifier because I didn't think the Amsoil needed it. So after going on a 500 mile trip I find it is still doing it. The truck sits at the stock ride height and has stock size wheels and tires on it. What it could be ? It only happens in the turn, not while driving straight. It still sounds like the differential but just want to be sure.
View 7 RepliesCamry :: 2007 - Steering Wheel Grinding Noise On Left Turn
Lately my 2007 Camry (2.4 L, Auto) has developed a bit strange problem. When I'm driving on highway, even slight left turn results in a grinding noise and sort of resistant steering wheel. It happens only when I turn left. As soon as steering wheel gets back to straight, the noise and steering wheel resistance/hardness goes away. I don't really feel much when I'm driving slow on the city streets. Although some time when I am little bit fast, I feel slight grinding noise and steering hardness. No problem in turning right at all.
View 5 RepliesFord Ranger / B-Series :: Noise From The Front Whenever Turn The Truck Slightly To Right?
My 99 ranger has just hit 111,000 miles. I'm getting a weird sound from the front right whenever I turn the truck slightly to the right. I don't hear it if it's leaning left. Is this likely the wheel bearing? I've heard these rangers are not best known for the quality of the wheel bearings.
View 14 RepliesFord Ranger / B-Series :: 1994 - Truck Won't Turn Over Just Making Noise Like It Wants To Start
The truck just won't turn over makes a rrrgh rrrgh noice like it wants to start, I push the gas peddle to the floor and I should smell a lot of gas but don't!!! I added oil when it died at the store last night and it started up but the oil stick indicates oil is fine??? Pulled the diode out this morning put it back in the truck would not start just made that noise but turned it off and reseated the diode and it started??? These things may or may not have anything to do with the problem. Could it be electrical or oil pressure gauge sticking or something else that I could tell my mechanic and he could fix so I don't get stuck????
View 14 RepliesFord F-150 (2009-2014) :: 2010 - Rubbing / Grinding Noise From Rear End
Just got a 2010 lariat supercrew...I put 1900 miles on it so far. When slowly letting off the accelerator (doing between 20-30 mph and between 1000-1500 rpm) there is a distinct rubbing sound for about 1-2 seconds...it is now sounding more like grinding now...took it to the shop today...(they couldn't duplicate (because service rep documented 60 mph instead of the 20-30 mph...went back at the end of the day to ride with the tech, and i was able to duplicate so now they have something to work with....also the noise happens mostly when the path of travel is either level road or slight to great incline..it has not happened on a down slope....
View 14 RepliesFord Super Duty (1999-2016) :: Sounds Like Tire Is Rubbing Inner Fender When Make A Slight Turn To Left
Have a problem When i make a slight turn to the left sounds like the tire is rubbing the inner fender. Don't do it all the time. The tire is not rubbing.
View 4 Replies