Ford F-150 (2009-2014) :: 2012 - Rubbing / Grinding Sensation While Turning
I've owned this 2012 Lariat 5.0 for about 6 months (has 49,500 miles on it, approx 6000 are mine).
For awhile, I had kinda thought I sensed a slight vibration/grinding when making right-hand turns. But it seems to be getting more noticeable now. It does not happen with every RH turn, but its not all that rare of an occurrence either. (Does NOT happen with LH turns.)
In addition ............ possibly related, sometimes while breaking, I get a somewhat similar grinding sensation, just before coming to a stop. Again, it does not happen every time.
I tend to think both of these could be a brake issue, but wondered if anything in the driveline could be contributing ? (I should note that I'm in 2-High)
Ford F-150 (2009-2014) :: 2010 XLT - Traction Control Engaged - Grinding Noise In The Back?
For some reason, when I go up/down driveways, pull into parking lots with sloped curbs, etc, my traction control will engage and there is a grinding noise in the back on the back brakes. I don't know if this is normal or not. I had all the brakes replaced recently but that didn't stop the issue, so I don't know if this is just normal or what. Is this normal and if not, what it might be?
View 3 RepliesFord F-150 (2009-2014) :: 2010 XLT - Caliper Rubbing Up Against The Rim Of Tire
I recently replaced my pads and rotors. The driver side was no problem, but on the passenger side, when I was finished, the caliper was rubbing up against the rim of the tire. I took both tires off to compare the differences, I noticed that my passenger side caliper is not going down as deep on the pads as the driver side. The caliper on the passenger side depressed with no problems and had no problems fitting over the pads. Whats really confusing is that all of my bolt holes line up.
View 11 RepliesBmw :: Rubbing / Grinding Noise From Rear Right Wheel
I just recently I have been experiencing a rubbing/grinding noise from the rear right wheel, also it has made a clonking noise like a flat tyre but it isn't, I can hear the noise from about 25/30 mph when I go faster or slower i cant hear the noise.
View 2 RepliesFord F-150 (2009-2014) :: 2011 - Rubbing / Growling Noise When Turning
I have a 2011 F-150 4x4 5.0 with about 45k miles. When I drive at slow speeds (ex. 5mph) and turn the wheels left or right there is a rubbing/growling sound coming from sounds like the front end. It does it either in forward or reverse. It's not a squeaking, clicking, or metal on metal sound. It does not do it when the wheels are straight. I rolled underneath and couldn't see anything that stuck out right away. What could be causing this?
View 12 RepliesFord F-150 (2009-2014) :: Rubbing Noise And Vibration Coming From Right Front Wheel
I have noticed recently that I have a "rubbing" noise and vibration coming from the right front wheel on my FX4. It is most noticeable from 5-10 MPH, and more pronounced when turning right. it is not constant. It sounds almost like a brake pad rubbing on a badly warped, wet rotor. It goes away when I apply the brakes. I am thinking bearing or possible CV joint.
The dealer can't get it in until Tuesday, and they say I will have to pay the deductible on the ESP, even if it is related to the steering vibration they could not replicate or fix about a month ago. I am seriously considering going to another dealer for my service. Given, they did absorb the deductible last time, but they didn't fix the problem!
Ford F-150 (2009-2014) :: Grinding Noise At Start Up Only
I have a 2010 XLT, 85K, just started having a horrible grinding noise at start up for about 2-3 seconds, then gone. Going to dealer tmrrw. Multiple people said, possible oil pump hydraulics, ??????. Whatever it is, they say its expensive!!!!!
View 3 RepliesFord F-150 (2009-2014) :: Grinding Noise When Making Turns Only
There is a grinding noise when i make a turn,when i straighten out it's fine,when i bought the truck in 09 i had a shudder problem but that was repaired by greasing the spline in the drive shaft. Truck has 59,000 and is coming up on the 60,000....
View 1 RepliesFord F-150 (2009-2014) :: Grinding Noise While Driving In Reverse?
Recently had a coworker point out that my truck was making funny noises while it was backing up. It is a 2013 f150. It almost sounds like metal grinding to me. It does not do it while going forward either.
Have been underneath and can't notice anything out of place, although I'm not sure I'd notice if there was.
Ford F-150 (2009-2014) :: 2013 XLT - Brake Grinding Noise Before Stop
I have a 2013 XLT Scab that has been in twice now for a low speed to stop brake rubbing or grinding noise. The first visit they turned the front rotors and scuffed the pads, which seemed t fix the problem for about a month. The second visit they repeated the same process on the rear and the problem was good for about two months. Today while driving I noticed the noise, probably worse than I have ever heard. It seems like after about 20 stops the noise gets quieter. I am taking it back for the third time and I am hoping they will fix the problem for real this time. I am tired of burning my gas to get to the dealer and then having to ask my salesman for a loaner car. Other than this issue I love the truck.
View 6 RepliesFord F-150 (2009-2014) :: Grinding / Ratcheting Noise In LH Front Axle When In 2WD
Wife's 2010 F150 4x4 85000 KMs makes grinding / ratcheting noise in LH front axle when in 2 wheel drive. Mostly when turning left some times when traveling straight never when turning right. Never makes the noise when in four wheel drive. I am suspecting the auto hub is the issue but wonder if others have had this trouble ?
View 5 RepliesFord F-150 (2009-2014) :: Grinding Noise From Front Driver Side?
First off I have a 2009 F150 4wd 4.6L truck...we have noticed a grinding noise on the front driver side wheel...we have replaced the auto locking hub acuator and the hub assembly but the noise is still there....it has us puzzled now not sure what it could be. I have read many different threads on this issue an it seems that it might be something to do with the vacuum. The noise is only on the driver side and only in 2wd, when its in 4wd it doesn't make the noise at all. Also while in 2wd the noise seems to go away when we let off the gas.
View 5 RepliesFord F-150 (2009-2014) :: Grinding Noise In Front Passenger Wheel
Just installed new actuator and wheel hub assembly on my 2009 f150,truck still had grinding noise in front passenger wheel , New solenoid and vacuum hose kit installed when test drove noise still there until you put the truck in 4 wheel drive it disappears . The noise returns as soon as you take it out of 4 wheel drive. Also mechanic said steering was tight,installed new shaft same thing, could this be the rack and pinion.
View 5 RepliesFord F-150 (2009-2014) :: Grinding Noise On Highway With Cruise Control Turned On?
This morning (roughly freezing temperature - nothing out of the ordinary after the brutal winter we just had) got onto the highway to head to work and set the cruise control (as normal) at approx 110km/h (65mph) and after several seconds heard a distinct, quite unpleasant grinding noise. It was loud enough to be heard over the heater and radio. Turned the heater and radio off to listen closer and didn't like the sound of it - sounded like metal on metal.
There was no different feel in the floor, pedals or steering wheel. As soon as I turned cruise control off, the noise disappeared! Turned cruise control back on, and the noise returned approx 5 seconds later. If I continued driving along normally and sustained a certain speed, the noise would appear after 5 seconds again and only go away once I lifted off the gas or coasted down a hill... Very bizarre. Once I got to work and poked my head underneath didn't immediately notice anything out of the ordinary - no funny smells or anything...
Background info: 2011 FX4 ecoboost, crew cab. Stock, no modifications. Approx 134,000km (~80,000 miles)...
Ford F-150 (2009-2014) :: 2011 - Loud Grinding Noise From Front End Of The Truck
Today I was out getting lunch in my Ecoboost When it started making an extremely loud grinding noise from the front end of the truck. My first thought was I blew a turbo. After holding the break and building boost I discovered it was not the source of the noise. Also the truck runs perfect and there is no smoke. I then took it to my friends auto shop and pulled both front tires off to check and see if anything break related came loose. We found nothing. The noise only happens upon acceleration or cruising throttle, as soon as you let off the sound goes away. So after I found nothing I took it to ford and what would cause that, but they assured me that they would have my truck for a long time while they figure out the issue.
View 14 RepliesFord F-150 (2009-2014) :: 2011 - Grinding Noise / High Pitched Squeal On Front End?
This evening, my F150 with 2,600 miles developed a high pitched squeal, much like you might experience on an older vehicle with failing front brakes. Yes, that same squeal/grind the brakes make...metal on metal. It came in instantly while at highway speeds. It was VERY loud. The pitch didn't really change with speed...it was pretty consistant going slow or fast. There was no vibration, chatter or growl as I would expect with a failing bearing.
It was definately in the driveline/brakes. I was 10 miles away from a friends house, so I turned around and took it back to his place. Shortly after turning around, it quieted, only sounding when I would turn ( like a wheel bearing would when being side loaded ). I looked at the brake disks, thinking something was grinding on one of them. The outsides of the disks looked fine. Due to the shields on the inside, I couldn't see.
Later in the evening, I had to drive it back home, about 50 miles. Again, it was quiet unless turning fairly hard. By the time I got home, the squeal had turned into an intermitant growl/thump, as if a warped rotor was banging on the caliper. The noise was 1 to 1 with the rotation of the driveline. But still no vibration. Brakes work perfectly and the noise doesn't change with brake use. Backing up and turning hard results in a variety of sounds, including squeaks.
The hubs and CV joints felt cool. The brake disks were not hot as if they were dragging.
It is 4x4 / 3.7l
Ford F-150 (2009-2014) :: Grinding / Rustling Noise Coming From Front Driver Side
2011 F150 Limited 4wd 6.2 liter. I just bought the truck a few weeks ago with 26,000 miles. Late last week I began hearing a mild grind/rustling noise that appears to come from the driver's front. It's not terribly loud (loud enough to hear), but it's annoying. It happens when I slow down (on and off the brake and below 25-30 mph) as well as let off and begin to speed up. It doesn't last but a second after I let off the brake and speed up though. The kicker is it does not happen all of the time. I drove it home from work last night and it did not do it one time, but driving to work this morning it happened every time I did what I described above. I have taken it to our local tire/suspension shop and they claim they could not reproduce the sound which does not surprise me. They did a full inspection and found nothing.
View 14 RepliesFord F-150 (2009-2014) :: 2011 2WD - Grinding Noise From Driver Side Front Tire
I have a 2wd 2011 F150 90K with grinding noise coming from the drivers side front tire. Even though it was happening when coasting I thought it might be pads but they are real good. Turning the hub with no tire on it I can hear a little grinding. So I suspect bearings. I want to remove the hub but can't find out how to pull that off.
Where I would expect to find a spindle nut there is an area where it looks like you put a puller in. Can't find any videos or other information on the "Internets". Maybe I'm the first to have bad bearings? Anyway, how to remove the hub?
Ford Excursion :: Rubbing / Grinding Sound From Rear End When Taking Off From A Turn
I have noticed this rubbing, not quite grinding sound/vibration when I take off and turn. For instance pulling out of a parking lot and turning either left or right. Truck will do it only after it's been driven a while. I originally thought it was just the limited slip ratcheting but recently just changed the rear axle fluid adding Amsoil this time. I did not add any friction modifier because I didn't think the Amsoil needed it. So after going on a 500 mile trip I find it is still doing it. The truck sits at the stock ride height and has stock size wheels and tires on it. What it could be ? It only happens in the turn, not while driving straight. It still sounds like the differential but just want to be sure.
View 7 Replies