Ford Ranger / B-Series :: 2000 - Pulls To Left Real Hard?
My 2000 ranger in 4x4 high never did this. And in 2wd it doesn't pull at all...
When in 4x4 high it pulls hard to the left ?????? is left not working? It has automatic hubs ...
Ford Ranger / B-Series :: 1986 - Power Steering Shaking Then Spinning On Itself To Hard Left?
My 40 Ford pickup is on an 86 Ranger chassis and uses the stock Ranger steering gear. My question is about the connections on the steering box. I'm using a GM power steering pump and several steering gear vendors have told me that outside of needing to adjust the pressure for the correct feel, the combo works. I fired the truck for the first time tonight but the steering wheel went crazy, shaking around and finally spinning on it's own to a hard left.
Some quick research leads me to believe that I have the lines reversed but it would be great to know for sure. I did manage to find on e diagram of a Ford PS box on Google and it shows the lines reversed of what I have set up on my truck and I can't for the life of me remember how I figured out what the plumbing should be when I installed it. Which port on the box is the inlet and which is the return?
Ford Ranger / B-Series :: Bronco II A/C Cuts Off While Driving
The panel goes off and the fan quits blowing. Sometimes it works, cools great, then just cuts off...
1989 Bronco II 2.9 4x4 auto 164k miles... I have been on TRS, BroncoII Corral, and even FSB searching.
This is the first attempt at reaching out because i have found that here at FTE the folks that chime in know their stuff, or know where i can find out for myself.
Ford Ranger / B-Series :: 2004 - Hard To Turn - No Power Steering?
My Daughters 2004 Ranger has about 195K the power steering reservoir is full it turns to the left as it should (assisted power steering) turning to right there is no power steering (manual Rack) I am thinking the issue is most likely in the steering rack..
View 2 RepliesFord - Bronco :: 1988 - Keeps Turning Over When Tried Shutting Car Off
I have a 1988 FORD BRONCO, full size, that has a peculiar problem. I tried starting the car and it turned over, but when I tried shutting it off it kept turning over. I had to disconnect the battery to stop it. I replaced the solenoid being careful to route the wiring connections the same way. I tried starting it and it shut off using the key switch the first time, but when I tried starting it again it wouldn't shut off so I had to disconnect the battery. What might be the problem? The ignition switch??
View 3 RepliesFord - Ranger :: 1995 - Pulls Hard To The Right
I've got a 1995 Ford Ranger that pulls hard to the right. It has always pulled to the right a little, but recently it has been worse. About a year and a half ago I replaced all four shocks, the two front tires, and had all four wheels aligned, but this did not stop the slight pull to the right. I get it back from the mechanic yesterday, and he tells me that there is a little bit of wire showing on the inside or the front drivers side tire.Is there some kind of joint or something in the steering that may be worn out that needs to be replaced? If so, how much does something like this cost to replace?I've been slowly replacing everything on my truck that needs to be replaced as I get the money, but it seems that lately it's just got way more expensive. I know that it's not a cheap fix for something like this, but I just wish it wouldn't happen all at once
View 2 RepliesFord Bronco :: 1988 - Motor Keeps Turning Over Even When Turn The Key Off
I have a 1988 full size Ford Bronco that when I start it the motor keeps turning over even when I turn the key off. I installed a new solenoid thinking that would do the trick and it worked correctly the first time, but the second time it kept turning over until I unhooked the battery. What is the problem? Is it the ignition key?
View 12 RepliesFord Brakes/Suspension :: Truck Badly Pulls Left When Braking Hard
Just replaced break pads and rotors. Inner pad on left side was gone leading me to believe slides were not working properly. Pulled apart, cleaned and greased everything, and replaced pads and rotors. Calipers seem to be working fine. Now when I break hard, the truck pulls badly to the left. When I break softly, it seeks normal. My front end is a bit out of whack and veers just a bit to the left. Do you think this is my issue with the breaking ? I'm getting new tires and an alignment soon but was just curious.
View 3 RepliesFord Ranger / B-Series :: 1992 - No AC And Power Steering / Poor Clutch Disengagement Resulting Hard Shifting
1992 Ford Ranger 4x2 with 2.3L engine and 5 speed manual transmission. 135,000 miles, no AC and no power steering. I am having poor clutch disengagement and resulting hard shifting. The shop added a little fluid to the reservoir last oil change and it is still looking full. I always park on concrete and never see any leaking. I don't know what may have been done before as I haven't had the pickup all that long. Where should I start? Is there probably internal bypass leaking in the hydraulic clutch as there seems to be no external leaking?
View 4 RepliesNissan - Maxima :: Car Pulls To The Left And Right When Brake Hard Over 40
OK so when I'm driving on freeways or highways and I have to break hard for some reason my steering wheel always pulls in some direction I don't want it to go. forcing me to hold it straight I've lived with this problem for a while but I'm doing 500 miles trips this weekend in the car and am concerned about if I had to brake at higher speeds etc., what might cause my steering wheel to pull left and right... 2003 nissan maxima ...
View 7 RepliesFord Ranger / B-Series :: 1988 - Headlights Won't Turn On At All?
I have a 1988 ford ranger and my headlights won't turn on all my fuses are fine but no headlights! All the other lights work fine blinkers, parking, brake ,and tail lights! What do I need to look for????
View 14 RepliesFord Ranger / B-Series :: 1988 - Overheats While Idling?
My 88 2.9 ranger keeps heating up badly while idling. Was waiting in the drive-thru at Wendy's and it was taking them longer than usual, the temp guage started climbing closer and closer to 'H'.. I revved it up a bit to a fast idle (1500-2000rpm) and it did not work much... figured the gauge was being screwy. But when i finally got my food and started moving the truck was pinging..it really was hot..
But as soon as I got her moving at a steady 40mph, engine cooled back down to normal temp as if nothing ever happened..i put an extra wide two row aluminum radiator from a 4.0 explorer in it, fan clutch is not very old, no coolant leaks that i can see.. can't figure out why it heats up so much so fast at idle. Not enough air or coolant flow?
Ford Ranger / B-Series :: 1988 - Won't Start - No Spark
Any way to tell if the ECU is faulty? I hooked my analyzer up to my friends 1988 Ford ranger 2.3L and it wouldn't even detect that the ignition switch was on. He was driving it the other day and is shut off on him while he was making a turn and it wouldn't start back up. We have rebuilt the distributor by replacing the pick-up, rotor button and cap, and we had the ignition module tested and found it was good. We have also replaced the coil. When the ignition is turned to the on position, the fuel pump comes on and never cycles off.
View 8 RepliesFord Ranger / B-Series :: 1988 - Won't Idle - Starts Right Away Then Die?
88 ranger. 2.9L manual. Just bought this truck. It ran great when I bought it. After a day or 2 it would idle rough. Almost die but it wouldn't. No check engine light. It seemed to do this intermittently. Some times I'd start it and it be fine. Other times I'd start it and I'd expect it to die at each stop light.
Now for the last couple days it dies on every start up. It won't idle. It'll start right away and then die. I can keep it going by keeping the engine rev'd but the check engine light is one. If I keep it running and start driving down the road it'll drive with the check engine light on for about 5 minutes. Then the light goes out and it runs like normal, even at idle, until I shut it off. Then it's the same story at next start whether it's right after I shut it off or hours later.
It doesn't seem to matter whether the engine is hot or cold. When the check engine light is out, it runs great the rest of the time whether at speed or at idle. To me it sounds like a sensor is on it way out. I figure if it was vacuum, it happen at every idle, and if it was fuel it happen all the time or at least every idle. Tried to get a code at parts store but the reader wouldn't work. It couldn't tell it was plugged in the the truck for some reason.
Ford Ranger / B-Series :: 1988 XLT V6 Won't Start Just Crank
I have tried about everything i know about cars on this truck!! It ran great when I got it until a head gasket got blown so I tore into it and replaced them both torqued heads to specs. Made sure valves wasn't to tight. Distributor is in correct spot timing is correct had ignition module tested good!!! Coil tested good replaced both fuel pumps and put new tank and sending unit in the truck b/c it needed it new fuel filter replaced return line firing order is correct 1 4 2 5 3 6 it is getting fire it will crank and crank sometimes act like it is going to start then not also I can get it to run for about 3 sec on 3 or 2 cylinders it seems to have plenty of compression as well!! only thing really I can think of that could be wrong is computer? Also one last detail tried pull starting it as well still wouldn't go.... V6 2.9L...
View 9 RepliesFord Ranger / B-Series :: 1988 - How To Tightened The Valve
It's an 88 2.9 and sounds like a little diesel! The fellow I purchased it from said the valves need tightened, I thought perhaps a timing chain, but figured valves would be an easier place to start. Yet, I'm not sure where to begin? Or how tight the valves need to be, are there torque specks?
View 2 RepliesFord Excursion :: 2001 - Acceleration Pulls Left / Deceleration Pulls Right
2001 Ex 7.3 4x4 with 4" lift (6" with 37" Pro Comp tires)
All new front end steering components.
All new Shocks (bilstein)
All tires properly inflated to same PSI
All new brake rotors, calipers, caliper mounts, and pads.
When under hard acceleration the vehicle pulls to the left and I have to compensate by steering to the right. Under deceleration the vehicle pulls to the right and I have to compensate by steering to the left.
I am about to change all four brake lines to Braided Stainless Steel lines, replace all leaf spring bushings with polyurethane, and install a rear anti-sway bar. I'm going through this methodically enough or am I just building a brand new truck one part at a time?
IS F (2008-2014) :: 2012 - Car Pulls To The Left On Hard Acceleration?
So, I picked up my new car today, a 2012 obsidian ISF with 53,000. I'm driving it back from Texas to Georgia in the morning but after driving it for the first 100 miles I notice a pull to the left under hard acceleration and to the right when I let off. I've never driven an F before and I'm coming out of an IS350. I haven't had a chance to check tire pressures yet but I notice the right rear tire is a Dunlop and all other 3 are Bridgestones. Could this be the cause?
View 12 RepliesFord Ranger / B-Series :: 1988 - Turn Signals Not Working
I have an 88 ranger with the 2.9l. The headlights work and the markers do to. The brights don't though. and also none of the turn signals work, the brake lights work though but i don't think the reverse do, I can't see them. Do the turn signals and brights share a fuse on there own? How to diagnose it or what it may be?
View 9 Replies