Ford F-150 (2004-2008) :: Popping Noise In Front End When Turning Left
Hear a small pop in the cab when I am turning left pulled left wheel everything looks fine. Ball mount maybe, I don't want to tear into it at this point.
View 5 RepliesFord F-150 (2004-2008) :: Clunking Noise In Front End
I've got a clunk in the front end....replaced all the ball joints......checked the sway bar......checked the tie rods......can't find anything wrong...... Shocks go bad and clunk???
View 14 RepliesFord F-150 (2004-2008) :: 2005 - Grinding Noise When Turning Left
First I will start off by stating that my truck is a 2005 Ford F150 2WD Regular Cab 6.5 Bed, with the V6.
My problem is, when making a left turn at low speeds, I have a grinding noise that corrects itself upon straightening out the truck. This seems to happen on turns in the parking lots etc. It almost sounds like the tires are rubbing but the tires are the same BFG's that have been on the truck for 40,000 miles and have never rubbed. I am thinking it might be the power steering pump but am unsure. I do not have access to a lift right now but I have done the shake test on all of the suspension components and nothing seems out of place or loose.
Ford F-150 (2004-2008) :: Roaring Noise Coming From Right Front While Turning - Front Wheel Bearings?
I gotta a roaring noise coming from my right front while turning. Planning on replacing just the wheel bearings tomorrow & not the whole hub assembly(2008 2wd). Is there a thread that lays out the steps and other parts I may need? I've seen alot different stories on the net on how to do it. Everthing from I can press new bearings to I have to do 4x4 hub conversion. Seems to be some confusion.
View 2 RepliesFord Excursion :: Clunking Noise From The Left Front Going Over Bumps
I need to replace the rubber axle bumper guards. I have a clunking noise from the left front going over bumps. Troubleshooting I found the left front axle bumper guard is missing, right side is missing chunks and dry rotted. I had a question about how they attach. The one that is missing looks like a rusted bolt snapped off. Is it safe to assume a bolt goes right thru the center of the bumper guard into the frame? Couldn't tell on the right side it is in bad shape. Right front bolt may have sheared off on the bottom and just held in on the top by what is left.
View 5 RepliesFord F-150 (2004-2008) :: Whining Noise From The Front End When Turning To Right Or Going Straight
'05 F150 5.4 Sounds like a whining noise from the front end when turning to the right or going straight. Goes away on left turns. Thought it was tire whine but put originals back on and got same thing. 13.5x35 verses 275 Truck has a Fabtech 6" lift. Right CV axle seems tight, rotor assembly replace 2k miles ago. Any other option before going into front diff?
View 2 RepliesCorolla / Matrix 2009-13 :: Clunking / Popping Noise When Turning And Accelerating Left
Have a 2010 Corolla, 42k miles, from a dead stop, turn left under power with wheel about 90% of one full turn, get a clunking popping clicking noise from the front end -- I cannot tell if from the left or right side -- I've been in the back seat too, and cannot determine if the noise is coming from the left or right side up front. I've had the car since 34k miles, has been making this sound ever since, not sure if its gotten worse, if it has, maybe just a little.
No noise if turning while NOT under power (coasting). No noise if turning to the right. No noise while driving in a straight line or veering left at a higher speed. Also, I tried to recreate this noise from a dead stop, turning going in reverse, both left and right, and no noise ever.
If in a parking lot, from a dead start, turn wheel left almost one full turn, accelerating slowly I can get the car to make this sound continuously (until I start going too fast beyond my comfort zone).
Have looked under car jacked up several times, nothing obvious. CV axles have minimal play and the boots are in great shape. Suspension parts appear ok.
My gut tells me could be a CV axle, but not certain, and I don't know which side..... something else that could cause this ?
Ford F-150 (2004-2008) :: While Turning Makes Rubbing / Grinding Noise From Front?
I've got a new issue that is happening on the front end of my truck. Whenever I try turning my wheel while driving, I get this rubbing/grinding noise coming from the front of my truck. It only happens when the wheels are in motion. It seems to happen less when I'm driving at higher speeds, but I can notice it make the sound at any speed. I tried driving it slowly in an empty parking lot while turning and it's definitely making the sound every time the tires rotate.
I took it in for an alignment because this was happening every time I drove, whether it be driving straight or making a turn. Now that my alignment has been fixed, it no longer make this noise if I am driving in a straight line, so it only seems to happen when I'm turning. I had the mechanic check to see if they could reproduce the issue. The mechanic was able to hear what I hear, but when he put it on the lift at the shop, he was not able to reproduce the sound.
Ford F-150 (2004-2008) :: Clunking Sound While Turning Slightly
Recently when I leave my driveway which only has a slight grade to it my truck makes a clunking sound when I hit the gutter and while turning slightly. Also my front drive line from transfer case to front axle has some play in it. I can rotate the front drive line about 3/4" to an 1" while parked in the driveway. Changing u joints. I figured this would be a good starting point. 2005 XLT 4x4 5.4L F150.
View 8 RepliesSedan :: Clunking Noise In Front Suspension Only Sometimes When Turning
So I got a steering problem and it's got me going crazy. I have a 06 g35 sedan lowered about an 1.5 inches. It's been about 5 months since I lowered it, lately I've been herring clunking noise in front suspension, not all the time but only sometimes when I turn. The other day my steering got really stiff and when I turn the steering won't return to the center. My Power steering isn't making any noise and I'm good on fluid. A lot of people say my ball joints but don't they usually make a lot of noise when they go bad ?
View 18 RepliesFord F-150 (2004-2008) :: Clunking / Knocking In The Front End
I got a horrible clunking/knocking in the front end of my pickup this morning, jerking the steering wheel like a flat tire, and after a couple miles it stopped..... bearing ???
View 7 RepliesFord Super Duty (1999-2016) :: Front End Noise When Turning Left
Last couple drives I have noticed some front end noise on the left side. Back in May I also noticed grease all over behind the rotor. I believe this is the grease inserted via ABS hole into the unit bearing. I do not hear the needle bearing crunching while driving and did not here it in May either. I also attempted to move the unit-bearing up and down thinking the axle seal was toast but it seemed solid at the time.
Today I hear some noise while turning left which lead to the pictures below. Wet side is Driver side, dry side is passenger. Tomorrow morning I should have some time to take a look at this more in depth. Passenger needle bearing was changed last year and no issues since then......
Ford F-150 (2004-2008) :: 2005 - Clunking Around Turns In The Front And Rear End
My 05 f150 is lift with a 6" skyjacker lift I've only had it a week from the dealership when it stopped firing on cylinder 8 which is a lil problem easy to fix,but then it started clunking around turns in the front and rear end. So I took it the dealer and 3 days later they give it back. It's running good but its still clunking in the front they said they changed the cv joints and tie rod ends but after I got home. I inspected it they changed one damn tie rod and that was it. Is it the tie rod end that's still making the noise?
View 1 RepliesSubaru - Brakes - Steering - Outback :: 2008 - Whining Noise In Engine / Clunking While Turning?
My outback has 57k miles on it and already needs the front struts and rack replaced (diagnosed today at the Subaru dealership). The car has been making a whining noise in the engine and has been clunking when making turns for the past week. I have also noticed it hasn't been taking bumps as smoothly. They told me that both ends of the rack are leaking and both front struts are leaking. My husband did admit to hitting the curb on the driver side front tire pretty hard while making a u-turn about a month ago, but all other driving is pretty standard. Yes, we drive on dirt roads in the mountains a few times a year for hiking, but don't drive in a manner that I consider wrong. Did the u-turn incident cause this? (hard to believe that would affect both sides of the rack and struts).
View 2 RepliesHonda - Accord :: Hard Knocking / Clunking Noise At Front Center After Left Turn - Subframe Rusted Out
I've got a 2000 Accord. I recently started hearing and feeling a hard knocking/clunking noise at the front-center of the car during the correct after a left turn. My trustworthy mechanic told me the subframe is rusted out on the right side and that it isn't safe to drive until the subframe is replaced (he also said he's seen several of these this last year). He suggested that the cause is that the hose leading away or down from the air conditioner is too short, and leaks directly onto the subframe. There is no recall on this problem currently. I've done some Internet research and there is some buzz about this, but not as much as I was hoping for.
View 17 RepliesFord Super Duty (1999-2016) :: 2008 F350 4WD - Clicking Noise Only When Turning Hard Left
'08 F350 6.4l 4wd, I had the truck come in with a exploded transfer case. (See pics). Ive read all about this happening to many others. The truck still drove, hubs not locked, plenty of fluid in the TC, pretty sure it was the double Cardan that did it. Anyways I replaced thwith TC, replaced the front driveshaft, filled the TC with recommended fluid. Test drove and drives great, shifts fine. Only until I turned left.
At slow speeds turning hard or 15-20 taking a turn, it sounds like a ratchet clicking from somewhere on the left side, right around the drivers door, from what I can hear from the cab. Does it in 2wd, 4wd hi/low, hubs locked or not. I changed the vacuum pump, no leaks, changed the IWE solenoid, pulled out both locking mechanisms, tightened crossmember, checked everything from the hours of research I did on the internet. I cannot find the problem. I don't know what else to check. Front axles free spin and lock when they are supposed to. I'm at the end...
Ford F-150 (2009-2014) :: Left Front Brake Is Engaging Randomly When Turning Left
2010 F-150 King Ranch. Randomly when turning left, it feels like the left front brake is engaging and it sounds like your anti-lock brakes when you come to a stop on slush or snow. The truck slows with your foot still on the gas, Saturday it came to a complete stop before it released.
I have had it to 2 Ford dealerships, the first could not get the symptom to occur on a test drive and told me there was nothing they could do because they did not now what to look at.
The dealer I bought it from got it to act up, replaced the IWE 2 weeks ago and 3 days later was still doing same thing. My wife dropped the truck at the dealer again Weds.morning, she told them it did it on the way there. I called at 4:30 to check and they said they drove it 2 times and it did not act up.
Elantra XD (2001-06) :: Scraping Noise In Front End When Turning Left
Scraping noise in front end when turning left. Have changed brake pads, calipers, and rotors on both front wheels. There was no scraping noise before changing.
View 2 RepliesFord F-150 (2004-2008) :: Popping / Clunking Noise When In 4WD
I've read alot of info about the 4WD system on the F150's, and I'm having trouble diagnosing what might be going on with mine.
When I put my truck in 4HI (or 4LO), I get a popping sound that seems to come from the front middle/front drivers side when going at speeds around 20-25 and over. I don't experience any loss in traction (that I can tell) or power, but the popping is very loud and noticeable (passengers can hear it clearly).
My problem is a little different than most, as their issues with popping seem to happen when they are not in 4WD, where mine is only when in 4WD. I replaced the IWE solenoid today (wanted to anyway to get the updated casing/shroud) and the problem stayed. I also disconnected the vacuum lines at the solenoid and drove - no noise. I then kicked in 4WD on the switch, and the noise started, which leads me to think it is not vacuum related.
I am kind of lost as to what may be going on. I would think something where teeth broke, etc. would make noise all the time in 4WD, not intermittently or at certain speeds. The noise sounds almost like popcorn popping. I went up the same hill about a dozen times today, and it happened maybe 5-6 times. I don't hear it often (if at all) with speeds below 20 MPH. I can switch in and out of 2WD, 4HI, and 4LO all day with no issues, as well.
The only modifications to the front end have been a 2.5 inch leveling kit, and the only other issues I notice in the front end is a shaking when on the highway, that seems to go away after a while of driving at the same speed. I recently had a front end alignment, and the only thing the tech mentioned was that I will need ball joints in the next 6-8 months (but he said they weren't bad).