Ford Ranger / B-Series :: ABS Engaging When Slow Down To A Stop While Turning Left
I noticed that my ABS was engaging when I would slow down to a stop while turning left. I pulled the fuse for the ABS just to make sure that's what was causing the pulsating brake, and it was. Anyway, if it's an ABS sensor problem, would it be the front passenger side sensor if it's only happening when I turn left? Is there a way to test this. Would a scanner detect it? It hasn't been throwing a code or anything. Just the ABS engaging while braking and turning to the left when it shouldn't be.
View 6 RepliesPrius (2010-12) :: Ticking From Left Front Brake When Turning
I've got a problem that has the dealer stumped. 2010 Prius TWO with 67,000 miles. While gently braking in the final stages (<10mph) and turning, a ticking can be heard from the left front brake. It is a very fast ticking, and is proportional to speed. The frequency of the ticking is very fast, think of holding a pin into the cooling fins of the brake rotor.
I had it at the dealer last week. They had it for 2 days, with the service advisor, manager, and director all driving it and listening. They ended up replacing the wheel bearing. No luck unfortunately. They've had the entire brake assembly on the floor and reassembled, no change. Tightened all suspense links, no change.
The circumstances are:
- mild braking
-anything more than just a slight turn (maybe only to the right?)
-slower speeds (<10mph)
Ford :: Creaking Front End When Accelerating From Stop And Turning Left
My 2005 ford freestyle (fwd) has a creaking noise when accelerating from stop and turning left but not when turning right. It's been there for a while. I had a problem where front left wheel felt loose. Replaced struts no change. Replaced left front wheel ball joint and fixed that awful feeling, but it still creaks.
View 2 RepliesFord F-150 (2004-2008) :: Popping Noise In Front End When Turning Left
Hear a small pop in the cab when I am turning left pulled left wheel everything looks fine. Ball mount maybe, I don't want to tear into it at this point.
View 5 RepliesFord F-150 (2004-2008) :: Clunking Noise From Front Left When Turning Right Only
I have a 2004 2WD supercab. And am hearing a 'clunking' sound when I turn almost full-lock. Below is a summary of what I have experienced so far:
- My truck used to be lowered 2" (below stock) at the front since new. Last month I lifted it (front and rear) and it now sits 2" above stock on new rancho shocks.
- I installed a camber kit and had the front aligned (toe and camber) after the above suspension work.
- The truck drove beautifully for two weeks until one day a 'clunking' sound was heard from the front-left every time I turned left. The alignment also changed as I had to now hold the steering very slightly to the left to drive straight.
- The alignment shop re-did the toe tracking (the camber did not change) and the truck drove great for about a day. Now I can hear the same clunking sound when I turn right and the tracking is again screwed up meaning I need to hold the steering very slightly to the right to drive straight.
What parts are playing up and what may need replacing?
Ford F-150 (2009-2014) :: Vibration During Left Turn
Vehicle has a vibration most prevalent when cold during a left turn especially first thing in the morning. Feels kinda like 4x4 is on, but its not.
Tech test-drove it and tells me it needs "clutch packs".
Has changing clutch packs to address this issue, and did it correct problem?
If I let him change them, am I in danger of screwing anything else up in the process?
& what the fuxa clutch pack anyway?
Ford Super Duty (1999-2016) :: Front End Noise When Turning Left
Last couple drives I have noticed some front end noise on the left side. Back in May I also noticed grease all over behind the rotor. I believe this is the grease inserted via ABS hole into the unit bearing. I do not hear the needle bearing crunching while driving and did not here it in May either. I also attempted to move the unit-bearing up and down thinking the axle seal was toast but it seemed solid at the time.
Today I hear some noise while turning left which lead to the pictures below. Wet side is Driver side, dry side is passenger. Tomorrow morning I should have some time to take a look at this more in depth. Passenger needle bearing was changed last year and no issues since then......
Ford Super Duty (1999-2016) :: Clicking Sound In Front Left When Make Sharp Turns To The Left And Hit Small Bumps
2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
Ford F-150 (2009-2014) :: Truck Not Level Left To Right In Back
I recently bought a 09 F150 Screw short box. I just hooked it up to my camper for the first time and was measuring height on the corners of the truck to check my WD hitch. I noticed that the driver's side was higher than the passenger's side in the back of my truck. I checked again without the camper on some level ground and found the same thing - approximately 1 1/4" difference at the wheel wells and about 3/4" at the frame. I can't believe that this would be normal, so trying to figure out what happened here - maybe it got rear-ended?
View 6 RepliesFord F-150 (2009-2014) :: Left Tire Hard To Rotate
2014 f150 4wd. Jacked front tires off the ground today, right tire rotated easily by hand, left tire VERY difficult to rotate at all. Removed brake caliper and pads, but still difficult to rotate. Started truck up, right tire seemed even easier to rotate, but no change in left tire...
View 4 RepliesFord F-150 (2009-2014) :: Scraping Sound On Hard Left Turn
I'm getting a scraping sound on hard left turns. I've only noticed it on a steep hill where I work going under five mph and making a sharp left turn. I got out today and it doesn't look like the tire is hitting anything. The shield in front of the tire is slightly looser than the right side, but can't see it making the noise unless something is hitting it. I've read some previous posts that indicated traction control possibly coming on. I have about 4,000 miles, 20 inch tires, and everything stock.
View 14 RepliesFord F-150 (2009-2014) :: After Hard Left Turn Clunking Noise And CEL On?
If I'm stopped and turn the wheel for a hard left turn I hear a clunking noise and the check engine light comes on, will be taking in to the dealer on Mon.
View 2 RepliesFord F-150 (2009-2014) :: Left Trailer Tow - Stop / Turn Will Not Work
2010 F-150 owner. Why my left trailer-stop/turn will not work on any of my trailers. This issues has happen to me in the past due to a wire grounding out in one of my trailers, I have fixed the issue in the past by changing the 20amp trailer/tow fuse, this time the fuse looks fine and I am still not having any luck finding the issue. I have went through my manual to see if it could be a different fuse and they all seem to check out ok, I have also messed around with the relays and they seem to be fine too?
View 2 RepliesCamry :: 2009 - Metal Rubbing Sound When Turning Left
I have a 2009 Camry that makes a metal to metal rubbing noise when turning left. t is coming from the Front Right passenger side. I recently changed out the bearing and hub on the front right but I still have the noise when turning left. Also, when driving normally and going straight there seems to be somewhat of a dull click click click noise.
View 3 RepliesPassat (B5) :: Knocking In Front When Wheel Was Turning Either Left Or Right
In July I noticed there was knocking in the front left wheel when that wheel was turning either left or right AND went over slight/heavy bumps..it sounded like some metal knocking....i had my mechanic put the car on the lift to check for any VISUAL problems, and he didnt find anything wrong...said it was probably the bushings inside...so yesterday the knocking got much worse and the ride sucked...so i put the car up again and found out that the left axle needed replacing, which i did..so the harsh ride went away but the left wheel knocking is still there...WHAT COULD THIS BE?? Im thinking that maybe it was this problem that caused my axle to break... [IMG] [URL].....
View 5 RepliesTouareg :: Shock From Front Wheels When Turning Left
When turning left , I felt that there was a shock from front wheels. The service person told me that it was a differential problem and the controller unit is needed to reprogrmmed. Is it true? When my Touareg ran over the bump, I felt that the front suspensions were not adjusted well. Is it normal?
View 2 RepliesFord F-150 (2009-2014) :: Click In Steering On Left Hand Turns At About 1/4 Revolution
I have noticed on our 2009 F-150 there is an audible "click" (and you can feel it in the steering wheel) in left hand turns at about 1/4 revolution. You can also hear/feel the same thing coming out of right hand turns. It doesn't happen EVERY time, but pretty often. My wife had the service guy drive it when it was in for an oil change, and of course he didn't experience the same thing. What it might be or where to start?
View 8 RepliesFord F-150 (2009-2014) :: Driver / Left Side Mirror Started Wiggling
My Driver side/Left side mirror started wiggling, and fell, hanging on by just the wires for the heating element. I snapped it back on twice now, and I noticed 2 small plastic clips broken.
It's a 2013, XLT, heated, drivers side mirror.
Ford - Explorer :: Left Front Brake Caliper Locked Up
My teenage son just bought his first car, a 1991 Ford Explorer XLT 2-wheel drive. I had it checked out by our mechanic before I let him shell out the money, and everything seemed OK. It's the prototypical low-mileage car (127k actual, confirmed by Carfax) owned by a little old man who took good care of it (stack of service records a foot high) and didn't drive it very much.
Earlier this week ... he'd driven it for about two weeks with no issues ... the left front brake caliper locked up on it, to the point where it heated up enormously, the pads and rotors got so hot they were discolored and some transmission fluid got blown out by the strain.
He took it to our regular mechanic, great guy who we've used for years and has worked magic with our cars, he got into it and he diagnosed the problem as ... I hope I'm explaining it right ... a little pin or piston or something in the caliper was upside down. He put it back in the right way, and everything seemed to be OK, although he said my son would probably end up needing a brake job sooner than later because of the way the pad got ground down.
FYI, master cylinder is full of fluid, our mechanic couldn't see any leaks anywhere. Although when we took the car to the mechanic, my son tried to back it up to get a better angle at getting into the service bay, and the pedal went to the floor.
Fast forward two days, and danged if the same thing didn't happen with the right front caliper, seized up although he didn't get it as hot as the other time, parked it a lot quicker. And of course it happens on Friday going into the weekend, when our mechanic isn't working, he won't be able to do anything until Monday, which leaves us scrambling trying to get everyone to work, etc., down one car.
Doing a little online homework ... which we probably should've done before my son made this purchase ... I'm seeing a lot of brake issues with '91 Explorers. I asked my mechanic if he thought there was some ABS-related problem here and he said he didn't think so.
I will say that the car apparently sat undriven for a long time, which I know can unleash a lot of issues. What might be going on here? Do we just need to go ahead and replace the calipers, any hoses, etc., as preventive maintenance?