Ford F-150 (2004-2008) :: 2006 - 4x4 Light Not Coming On
just picked up a high mile f-150. (146,000) 4x4 light not coming on. jumpered out the vacuum solenoid first, nothing. Then found out I could try to tap on the actuator motor at transfer case. It worked. Just wondering if i keep exercising the actuator motor, if it will continue to work, sounds like the previous owner did not put it in 4x4 for a long time. also, if needed, where is a good place to purchase the replacement actuator motor? If this truck has heated seats ( it is a lariat) , where is it controlled from? Seems to ride a little rougher than i expected. new tires, but it seems a little harsh. I have an f-350 as well. it seems to ride just about as good.
View 2 RepliesFord F-150 (2004-2008) :: Check Engine Light Is Flashing / Throttle Actuator Control System Forced Idle
I have a 2005 f-150 street boss with 79000 mile, and it is shooting off going down the road, and the check engine light is flashing. The first time I started it back up and it would idle fine, but the throttle wouldn't do any thing. After setting about 15 min. I started it up and it ran good. I checked the codes and it had a p2104 Throttle actuator control system forced idle. It happened again with my wife. This time when I checked the codes it had the p2104 and a p2112 throttle actuator control system stuck closed code. What could be the problem, or a troubleshooting guide I could use to try and diagnose it.
View 6 RepliesFord F-150 (2004-2008) :: 2007 5.4L - Ticking Noise Coming From Somewhere Around The Motor
I have a question about my 2007 F150 4x4 with the 5.4L. It has a ticking noise sound coming from somewhere around the motor, but it's not there till the motor has warmed up. It almost sounds like a exhaust leak, but I'm not sure. What it might be, or what to look for?
View 11 RepliesLexus GX 2004-09 :: Cannot Open Passenger Door After Changing Actuator Motor
I changed the actuator motor on the DS passenger door. Now the door does not open. The electronic lock moves, locks and unlocks but the door does not open from inside or outside.
After a few tries the lock tab chatters but the door still does not open. What could be wrong? As far as i know i put it back together, like i took it out.
How to take the panel off from inside then i can atleast get to the two wires that go to the lock and see if i can open the door to take the actuator out once again.
Ford F-150 (2004-2008) :: 2006 - Replacing Motor Mount?
I need to replace the motor mounts on my truck. Is there any special tools or tricks I will need before I get half way into it and find myself in a bind? Oh yeah it's a 5.4L
View 1 RepliesLexus GX 2004-09 :: Rear Door Lock Actuator Motor Stopped Working?
My left rear door actuator motor has stopped working and I have read about the repair of just the electric motor, BUT has anyone found the replacement of the little electric motor, Lexus wants a fortune because they want to sell you everything, cables, latches, it all comes in one bundle for 250 or so--Jeez. So hoping someone has the part number or place that we can get these little motors and just replace that!
View 3 RepliesFord F-150 (2004-2008) :: 2006 - Whine From Motor Which Gets Louder With Increased RPM
My truck seams to have developed a whine. It gets louder with increased RPM. Sounds like its coming from the motor, specifically the front of the motor, maybe one of the pulleys? Water pump??? Alternator??? Im not sure but Im about to head out on a 2800 mile round trip pulling a heavy load and want my truck to be ready for the trip...? It sounds like its gotten louder in the last couple weeks but I think its just because I had a new manifold installed on one side and the truck is quieter making this seam louder.... But I don't know if I should be worried about it.. I don't want to waste money (right before a big trip) chasing a noise if its not something that is an issue..
View 6 RepliesFord F-150 (2004-2008) :: FWD Not Working - Actuator Is Not Allowed To Engage By Vacuum Pressure
I have a 2004 FX4 4x4 ... Four wheel drive is not working!!!!! Turn the dash switch to 4High or 4Low and the lights come on in my dash gauge cluster. So my 4x4 lights come on as if the 4x4 is working but my front wheels do not turn. What I have done:
Drove the truck forward while I watched the front drive shaft going from the transfer case to the front differential. Did this in 2WD and then in 4WD high. While driving forward in 2WD the front drive shaft did not move. Once put into 4WD high and driven forward the front drive shaft was turning. I guess this tells me that my transfer case and shift motor are working?
I jacked up my driver side front wheel and turned the tire by hand while the truck was running in 2WD. The tire spun freely and the CV axle (half shaft) did not turn. Then turned 4x4 dash switch to 4WD high and turned the tire again by hand and the CV axle turned while turning the tire. I guess this indicates that the IWE actuator was working....I guess???
Repeated the process above for the front passenger side of the truck and the tire would always spin freely regardless if in 2WD or 4WD. I could not get the CV axle to turn while spinning the tire on the passenger side when the truck was running and switched to 4WD
I checked the vacuum solenoid near the battery mounted on the firewall. The vacuum line supplying vacuum to solenoid was working and pulling vacuum. I did a series of test in conjunction with the dashboard 4x4 selector and the Vacuum Solenoid seemed to be working properly.
Crawled under the truck while the engine was running and pulled the vacuum line off the nipples of each IWE Actuators (drive and passenger side) put my finger over the lines and felt decent vacuum at each end of each vacuum line.
So dash switch and 4x4 light works stays on solid and bright does not flicker
Vacuum solenoid and vacuum lines seem to be working
Transfer case and shift motor seem to be working
Driver side IWE actuator seems to work
Front passenger side Actuator does not seem to be working??? Why I am so confused about this is because in HOURS of Internet research it seems that this Actuator is not allowed to engage by vacuum pressure. When I disconnect the vacuum line to the passenger side actuator I expected to hub to lock, but it did not, the tire would turn but the CV axle wouldn't? If I replace the passenger side IWE actuator will this fix my four wheel drive? Or is there something else I am missing??
Ford F-150 (2004-2008) :: Truck Shut Off While Driving / Throttle Actuator Stuck Closed
I am usually on 6.0 site and don't know much about a 5.4 gasser, hope to get some tech info. My buddy was driving to my house yesterday and his 06 F-150 with a 5.4 liter just shut off while driving. He got it restarted on first try, all engine vitals normal. I sent him to Advance Auto Parts and they pulled codes; P-2112 and P-2104 and throttle actuator stuck closed. Engine is running fine and he has driven it about 100 miles since yesterday with no problems. 06 F-150 5.4 liter 58,000 miles.
View 3 RepliesFord F-150 (2004-2008) :: P2107 And P2110 - Throttle Actuator Control Module Processor
Where is the Throttle Actuator Control Module Processor on a 2008 5.4L? Is it built into the throttle body, or integrated into the PCM?
View 4 RepliesFord F-150 (2004-2008) :: 2006 - Outside Air Coming In Cab - Buzzing Noise
On my 06 Mark LT I have a buzzing noise of outside air coming in the cab on the passenger side. I have had the grinding vent door actuator problem fixed in the past so I am not sure if it is related. The buzzing gets louder as I go faster, such as on the highway. Where to look?
View 3 RepliesFord F-150 (2004-2008) :: 2006 - Small Shutter Coming From Rear End Every Now And Then
OK so I noticed the last few weeks that I have just a small shutter coming from my rear end every now and then. It feels like it locks up for just a sec and then is fine. It will normally do this earlier in the day and maybe once or twice. Is this telling me its time to add some more friction modifier into the rear diff or do I have another issue. I don't notice it once the truck is warmed up and been driving around some.
2006 F150 Screw Fx4
Ford F-150 (2004-2008) :: 2006 Truck Making Noise That Is Coming From Engine
My 2006 f150 was making a noise that's coming from the engine. It sound like rocks in the engine. When I'm going 50-60 MPH the engine starts to make a sounds like rocks in the engine. What's happening. When I go about 40 it stops.
View 12 RepliesFord F-150 (2004-2008) :: 2006 Truck Won't Start - Squealing Coming From Under The Hood
I went for a tour with my truck and everything was fine, 5 minutes before getting home I heard a squealing coming from under the hood, I then lost all my gauges inside the truck. The truck didn't shut off so I drove it home. when I shut it off I tried restarting it and it wouldn't even roll over. I tried boosting it and it still won't even crank over.
View 1 RepliesFord F-150 (2004-2008) :: 2006 STX - Oil Leak Coming From Where Transmission Connects To Engine
2006 STX 4.6 .... I recently changed my oil a couple of weeks back. I've noticed spots of oil on the driveway. I thought it may be coming from the oil pan drain plug but i checked it and it seems to be coming from where the transmission connects to the engine. Lotta oil on the bell housing. That's where it looks like it's dripping off of. Could it be the rear main seal?
View 1 RepliesPrius (2004-09) :: 2006 - Removing Brake Actuator Resistor?
The brake actuator on our 2006 Prius (95K miles) was activating (pump turned on) every 20 seconds or so. I used AutoEnginuity (AE) software to monitor the pressure of PACC (accumulator pressure sensor) and the pressure dropped rapidly once the sensor voltage got up to around 3.1 volts; therefore, the pump would activate again and this cycle would keep repeating as long as the Prius was turned on. Therefore I decided to replace the brake accumulator and its associated resistor. I purchased a new brake actuator and its associated resistor from Toyota. The brake accumulator replacement went well but when I tried to locate the resistor to replace it, I was dismayed to see that the old resistor is very hard to access (even though I took most of the dash apart to find it).
In my 2006 Prius, the resistor is on the driver's side near the body and high up under the dash. I think I understand the reason for matching the resistor value with the resistance of the pump windings but I am going to use the old resistor and see how noisy the pump is. BTW I referenced Toyota website (TIS) for how to do the replacement procedure and now I am going to see how good AE software (latest version) is at bleeding the various components. This is FYI when replacing the brake actuator and wanting to know where this resistor is located and how difficult it is to access.
Ford F-150 (2004-2008) :: Brake Light Coming On Intermittently
As the title states, my brake light on the dash keeps on coming on intermittently. I can't figure it out. Fluid level is fine, and I added more just to be sure. Pads and rotors all got replaced within the last 9 months. I don't see any chafed or broken wires to the wheel/abs sensors. I don't know where else to look
Also when the light comes on the pads on the rear passenger side seem to drag a little bit. I can't feel it, but I can hear it just slightly.
Ford F-150 (2004-2008) :: 2007 - Odometer Light Coming On And Off?
Odometer light on my 07 f150 was coming on and off,read the thread here on how to change bulb. Got that done no problem but the odometer is now blank. Read the thread saying it was a common issue and to look for a bad or broken soder. My problem is i can't figure out how to get the circuit board off of the cluster after i pull off all the bulbs and screws. My local ford service dept wants to replace entire cluster at a hefty price.
View 2 RepliesFord F-150 (2004-2008) :: ABS Indicator Light Has Been Coming On Intermittently
'08 Ford F-150 with 53,000 miles. ABS indicator light has been coming on intermittently for a week now. Mechanic said its a left front wheel sensor code. Wants to charge $98 to diagnose. Says it could be bad sensor or broken wire.
I have limited mechanical experience. Is this something I can tackle? Or is this a major job?