Ford F-150 (2004-2008) :: Check Engine Light Is Flashing / Throttle Actuator Control System Forced Idle
I have a 2005 f-150 street boss with 79000 mile, and it is shooting off going down the road, and the check engine light is flashing. The first time I started it back up and it would idle fine, but the throttle wouldn't do any thing. After setting about 15 min. I started it up and it ran good. I checked the codes and it had a p2104 Throttle actuator control system forced idle. It happened again with my wife. This time when I checked the codes it had the p2104 and a p2112 throttle actuator control system stuck closed code. What could be the problem, or a troubleshooting guide I could use to try and diagnose it.
View 6 RepliesFord F-150 (2004-2008) :: Truck Shut Off While Driving / Throttle Actuator Stuck Closed
I am usually on 6.0 site and don't know much about a 5.4 gasser, hope to get some tech info. My buddy was driving to my house yesterday and his 06 F-150 with a 5.4 liter just shut off while driving. He got it restarted on first try, all engine vitals normal. I sent him to Advance Auto Parts and they pulled codes; P-2112 and P-2104 and throttle actuator stuck closed. Engine is running fine and he has driven it about 100 miles since yesterday with no problems. 06 F-150 5.4 liter 58,000 miles.
View 3 RepliesFord F-150 (2004-2008) :: Engine Code P0607 - Control Module Performance?
What could cause code P0607 - Control Module Performance?
Truck seems to be driving fine (except it just recently developed what I think is either the cam phaser tick or an exhaust manifold leak on the passenger side).
I haven't tried clearing the code to see if it comes back. This is on a 2006 F150 FX4 with the 5.4L...
Ford F-150 (2004-2008) :: 2006 - CEL Came On - Idles A Couple Of Minutes And Shuts Off - Codes P0607 / P2107
My 06 was parked about 2 months and when I first started the truck, the CEL light came on. It idles a couple of minutes and shuts off. It was running very well before it was parked. I put a code reader and the codes are P0607 and P2107.
View 1 RepliesFord F-150 (2004-2008) :: Airbag Light Flashing - Control Restraint Module Replacement
2004 f150 - Airbag light was flashing. Received recall letter. Dealer replaced a wiring harness. Dealer did not confirm functionality of airbag prior to leaving shop. Light continues to flash. New diagnostics from dealer says error code 1885 - the control restraint module needs replacing in P&L. Does the code match the fix? Can a novice mechanic replace the module?
View 2 RepliesSanta Fe (DM - 2013+) :: CEL Code P2118 - Throttle Actuator Control Motor Current
I just got a check engine light today too! I wasn't sure if I should start a new thread but I found this one first so I'll see if I get any responses. Anyway, the diagnostic tool showed P2118: throttle actuator control.
I'm not sure myself if I should be worried especially since my wife and little one year old will be driving the SF long distance this week.
Ford F-150 (2004-2008) :: Electronic Throttle Control Light On
I took it to a mechanic, he just told me to sprayed some carb cleaner on the throttle body and butterfly valve, and to wipe it with a rag. He did not hook a computer to it, to diagnose. and he said if the light comes on again to buy a new throttle body... I am thinking of getting throttle body sprayer taking off the throttle body replace the gasket, and hope this fixes my problem. I forgot to change my air filter btw.
View 1 RepliesFord F-150 (2004-2008) :: 2005 - Electronic Throttle Control / Wrench Light
2005 Ford F-150 FX4 5.4 V8
So my battery died the other day when I was working on the radio and I ended up having to jump start the vehicle. After the jump start the Wrench light came on the truck or the ETC light. (After doing research I have discovered you are not supposed to jump start a vehicle with ETC)
I have taken the car to the auto parts store and it does not seem the code readers they have can read codes for the ETC light.
I have also disconnected the battery cable to try and reset the light, but it still always comes on about 10 seconds after starting the car.
I have had no issues with the vehicle despite the light. No rough idle, no starting issues, or acceleration issues at any speed. What I can do to resolve this light or what part I fried when I jump started the car?
Sierra :: 2008 - Location Of Brake Control Module
Where is the brake control module located on a 2008 Sierra, Crew Cab, Z71, 5.3L.
View 3 RepliesPassat (B6) :: 2008 - Steering Wheel Control Module Blown?
I have the below multi-function steering wheel installed on my 2008 Passat. The steering wheel came out of a 2010 CC and the buttons do not currently work.
Which steering wheel control module would I need and what is the price on that?
Besides the steering wheel control module and programming via VCDS/VAGCOM, do I need anything else for this to work?
Ford F-150 (2004-2008) :: 2006 4x4 Light Not Coming On - Actuator Motor Sticking
Just picked up a high mile f-150 (146,000) 4x4 light not coming on. Jumpered out the vacuum solenoid first, nothing. Then found out I could try to tap on the actuator motor at transfer case. it worked,. Just wondering if i keep exercising the actuator motor, if it will continue to work, sounds like the previous owner did not put it in 4x4 for a long time. Also, if needed, where is a good place to purchase the replacement actuator motor? If this truck has heated seats ( it is a lariat), where is it controlled from? .... Seems to ride a little rougher than I expected. New tires, but it seems a little harsh. I have an f-350 as well. It seems to ride just about as good.
View 3 RepliesFord F-150 (2004-2008) :: FWD Not Working - Actuator Is Not Allowed To Engage By Vacuum Pressure
I have a 2004 FX4 4x4 ... Four wheel drive is not working!!!!! Turn the dash switch to 4High or 4Low and the lights come on in my dash gauge cluster. So my 4x4 lights come on as if the 4x4 is working but my front wheels do not turn. What I have done:
Drove the truck forward while I watched the front drive shaft going from the transfer case to the front differential. Did this in 2WD and then in 4WD high. While driving forward in 2WD the front drive shaft did not move. Once put into 4WD high and driven forward the front drive shaft was turning. I guess this tells me that my transfer case and shift motor are working?
I jacked up my driver side front wheel and turned the tire by hand while the truck was running in 2WD. The tire spun freely and the CV axle (half shaft) did not turn. Then turned 4x4 dash switch to 4WD high and turned the tire again by hand and the CV axle turned while turning the tire. I guess this indicates that the IWE actuator was working....I guess???
Repeated the process above for the front passenger side of the truck and the tire would always spin freely regardless if in 2WD or 4WD. I could not get the CV axle to turn while spinning the tire on the passenger side when the truck was running and switched to 4WD
I checked the vacuum solenoid near the battery mounted on the firewall. The vacuum line supplying vacuum to solenoid was working and pulling vacuum. I did a series of test in conjunction with the dashboard 4x4 selector and the Vacuum Solenoid seemed to be working properly.
Crawled under the truck while the engine was running and pulled the vacuum line off the nipples of each IWE Actuators (drive and passenger side) put my finger over the lines and felt decent vacuum at each end of each vacuum line.
So dash switch and 4x4 light works stays on solid and bright does not flicker
Vacuum solenoid and vacuum lines seem to be working
Transfer case and shift motor seem to be working
Driver side IWE actuator seems to work
Front passenger side Actuator does not seem to be working??? Why I am so confused about this is because in HOURS of Internet research it seems that this Actuator is not allowed to engage by vacuum pressure. When I disconnect the vacuum line to the passenger side actuator I expected to hub to lock, but it did not, the tire would turn but the CV axle wouldn't? If I replace the passenger side IWE actuator will this fix my four wheel drive? Or is there something else I am missing??
Sonata NF (2006-10) :: 2008 GLS 2.4 Liter Won't Start - Throwing Codes P2110 / P2118 And P2119
My 08 2.4l sonata gls won't start. I started it this morning to warm it up while I cleared off all the snow, it was running for about ten minutes. I turned it off and about twenty minute later went to start it and it will not catch. All the electronics are running and the engine turns over but it won't start. I replaced the battery in December, the oil was changed last week as well as the air filter. It has 93k miles on it. What could be the problem? I did go borrow a diagnostic scanner and it is throwing a P2110 P2118 and P2119 code.
View 4 RepliesFord F-150 (2004-2008) :: 2006 - 4wd Module Not Working
I have a 2006 F-150 Supercab King Ranch 4wd. The 4wd is not working. Took it to the dealer and they tell me the 4wd module is not communicating with the PCM. It is my understanding that this problem is rare...like 1 in a million. Ford wants to replace the entire PCM. In the past, I have had electrical problems with this vehicle due to corroded wires.
View 9 RepliesFord F-150 (2004-2008) :: Keyless Entry Module?
Does my truck have a keyless entry module? If so where is it?
View 9 RepliesFord 6.0L Power Stroke Diesel :: FICM And Throttle Position Actuator Faults
Been starting get some faults that seems unrelated other than (I think is the) harness. Intermittent low voltage to the FICM and Throttle position actuator faults (I have a 04). All voltages and battery power is solid as a rock. Watching the throttle during key on and it too will do it's self test intermittently. Looking at the cable and noticed that it seemed to be repaired with black tape in the chaffing areas. Knowing that it went threw the recall of that cable, I was under the impression that it was replaced not repaired. Anyway I would like to know how hard it is to change it and any part numbers would be useful.
View 14 RepliesFord F-150 (2004-2008) :: Fuel Pump Driver Module
I have broken alum housing it looks bad , but still works. I can get two after market from rock auto for one 50.00 and anther for 60.00, the dealer is getting 160.00 what do I do?
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Code P0670 - GPCM Glow Plug Control Module Control Line Failure
How to fix SES P0670?? I understand there's a whole procedure on checking fault.
P0670:GPCM Glow plug control module control line failure. Open/grounded circuit, open/shorted GPCM, failed PCM
But how did you resolve problem? replaced GPCM, found open circuit, short --if so where?-- or replaced with updated harness.
(4C3Z-12B568-AA connector upgrade kit as in picture)???
Ford F-150 (2004-2008) :: Fuel Pump Module Falling Apart / Replacement?
So the fuel pump module on my truck is falling apart, and I figured I might as well replace it....
View 10 Replies