Ford F-150 (2004-2008) :: 2007 - Loss Of Power And Ticking Noise
07 f150 screw 5.4 104+ miles, loss of power and ticking noise (sounds like no oil)on passengers side, no engine light, no codes, ford dealer changed coil packs and plugs, inspected valve gear on passengers side and nothing seemed out of spec, no broken springs, followers, lifters, manifolds on both sides have been replaced very recently.
The ticking noise began about a week after an oil change, truck runs fine but no power/sluggish. exhaust is magnaflow side exit and seems to be louder inside the cab than usual or could be just me.
Truck had a miss that i was trying to find prior to oil change and ticking noise. it ran well for a week with the tick before (and miss) the loss of power which started after a 30 min drive under load up hill. it almost felt and sounded as if the muffler was dragging on the road for about 100 feet, ran fine for two miles until it was shutdown. restarted fine but flat when you get into it.
Clogged cat/cats; internal damage to muffler, oil issue even tho the gauge reads fine.
Ford F-150 (2004-2008) :: 2005 5.4 3v - Idle Rough And Knocking / Ticking In Motor
Getting these codes what they mean or need to do ..to get rid of them...p0022, p0171, p0174, p0183, p0340, p0300, p0316, p2006 did timing n plugs fuel filter n gas filter getting very bad gas mileage it runs good but here a ticking in motor at idle and more as u accelerate, running rough....
View 7 RepliesSonata NF (2006-10) :: Ticking Noise Coming From Motor
So i am looking to buy a 2007 Sonata 4 cylinder with 145K miles. There is a ticking noise coming from the motor. Sounds like a lifter tick. You can here it all the time even after its warmed up. I just don't know much about these cars.
View 4 RepliesSonata NF (2006-10) :: Constant Ticking Noise Coming From Motor
I bought my 2006 Sonata with the 2.4L when it had 115,000 and it currently has 130,000 on it now. Ever since I bought it I noticed it had a ticking noise coming from the motor, it makes the noise constantly, it doesn't matter if the motor is hot or cold. I've always been a little worried about the noise. The car does runs like it should though. What it could be?
View 6 RepliesFord F-150 (2004-2008) :: Ticking Sound Coming From Inside The Seat
Started my truck (2007 EB 4x4, 5.4) this morning with my daughter in her car seat behind me, we get about 1/4 mile down the street and all of a sudden I notice myself moving!
My daughter starts freaking out, I pull over and my seat is still moving. I end up COMPLETELY reclined, all the way down and all the way back. The seat pinned my daughter in her seat, she's flipping out...I had to unbuckle her car seat while she's screaming because her legs are pinned and have to slide her car seat out sideways with her in it.
Seat does NOT move at all.
Now, before all of this I had heard a "ticking" sound coming from inside my seat, been doing it for months but since everything worked and not dummy lights came on I just ignored it. Apparently, this was not a good idea because now it is not ticking and the seat is not working....
Ford F-150 (2004-2008) :: 2007 - Ticking Sound At Highway Speeds
I have a 2007 F150 King Ranch Super Crew 5.4 3v and it makes a ticking sound. I have read about the VCT solenoids and the phasers. My issue is that the ticking noise can be heard at Highway speeds. At it seems to be quicker as the engine speed increase. Not sure what to think. No rough idle. What could this be.
View 3 RepliesFord F-150 (2004-2008) :: 2007 - Speed Related Ticking Sound / Wheel Bearing?
The front driver's side wheel of my 2007 Ext. Cab makes a speed-related "ticking" sound. It's usually audible but not always there. I look for rocks in the tread of my BFG All-Terrains and sometimes I find some, sometimes not. The noise seems to be independent although some of the rocks really get up in there. Sometimes its really loud and it sounds like a rock. Bearing? 4WD CV or U-Joints or whatever?
View 6 RepliesFord F-150 (2004-2008) :: 2006 4x4 Light Not Coming On - Actuator Motor Sticking
Just picked up a high mile f-150 (146,000) 4x4 light not coming on. Jumpered out the vacuum solenoid first, nothing. Then found out I could try to tap on the actuator motor at transfer case. it worked,. Just wondering if i keep exercising the actuator motor, if it will continue to work, sounds like the previous owner did not put it in 4x4 for a long time. Also, if needed, where is a good place to purchase the replacement actuator motor? If this truck has heated seats ( it is a lariat), where is it controlled from? .... Seems to ride a little rougher than I expected. New tires, but it seems a little harsh. I have an f-350 as well. It seems to ride just about as good.
View 3 RepliesIS F (2008-2014) :: Engine Noise / Ticking Sound Coming
I noticed my sound a few weeks ago but wasn't as loud as the videos I've seen. Didn't really bother me. I did notice today that the sound was a lot louder . The only thing that has changed is i had my oil changed over the weekend with mobil 1 5w-30 fully synthetic. Now I don't know if that could factor into the sound getting louder.
I am really hoping its just a cat and i can replace my headers and everything is good. i just got the car with 19k miles on it and do not have a warranty.
I have been worrying about "engine noises" for years and at this point if its something i can't fix without dumping thousands of dollars into it, then so be it. I am just going to enjoy the car too the fullest. Plus, once i get full exhaust, it will work with canceling out the ticking sound.
Camry :: 2007 - Clicking / Ticking Noise Coming From Engine
I have an 07 Camry with an I4 engine and there are times when I am driving with the two front windows down and I hear a ticking/clicking noise coming from the engine as if the engine is brittle.
View 12 RepliesLexus LS 2007+ :: Ticking / Rattling Noise Coming From Underneath The Car
Experienced a noise that is evident when the side window is down which seems to coming from underneath the car. It is difficult to describe but it is a ticking / light metallic sound. Possibly coming from the exhaust system area. It is particularly annoying at a drive through window where the sound reflects off the building.
View 7 RepliesFord F-150 (2004-2008) :: 2007 - Motor Start Running Rough At Low RPM
I have 07 sscrew with 5.4. 93,000 miles. At start up truck runs perfect. After 20-30 minutes of running motor will start to start running rough at low rpm. Diesel sound. I can rev up and motor clears up and idles fine. Should I replace VCT solenoids? Or phasers? Or both at one time??
View 14 RepliesFord F-150 (2004-2008) :: Rattling And Ticking Noise While Idle
I have a 2004 ford f150 5.4l v8 triton lariat and while at idle it has a ticking noise like this video
YouTube...
However I also have a rattling noise when decelerating at around 2000 rpms that sounds like a loose chain in a box. Not sure if its VCT sensor or cam phasers ...
Ford F-150 (2004-2008) :: Ticking Noise From Front While Driving
I have a 2005 F 150 5.4L and i just changed the front rotors, pads, and calipers. Because the passengers side caliper had locked and the rims was really hot and i knew it was the caliper so i changed both the driver and passenger side calipers and hoses. A month before this i had changed the pad and rotors but after the caliper locked it put grooves in the rotor and damaged the pad but the pads and rotors i bought have a lifetime warranty so i got a brand new set and changed them while replacing the calipers.
After installing everything i bleed the front brakes. But did not bleed the rear and i am wondering since i did not do the rear even though i did not touch them it is causing the front to make a ticking sound the whole time i am driving and it is starting to annoy me even though it has only been 4 days since i did the front brake job. I put Duralast rotors and Duralast Gold Cmax Premium Ceramics Pads. What is causing this ticking.
Ford F-150 (2004-2008) :: Slight Ticking Noise - Code P0022
Getting code P0022, which is over retarded cam position, drivers side bank. My 2004 F150 has the 5.8 triton. I have replaced all cam phasers and tensioner a as well as the timing chains. I have also replaced both VCT solenoids. Before I was getting codes for both banks, now just the code mentioned above with a slight ticking as well. My question is this... What am I not seeing? What could be causing this?? Would it be beneficial t get the lockout kit for the phasers to always keep them open?? Seems to stall a little at very low RPM like when you are off-road.
View 1 RepliesFord F-150 (2004-2008) :: Ticking Noise On Passenger Side During Idle
I recently got Gibson Performance Headers on my 2006 Ford F150. And when you cold start it or just start it period it has a odd ticking noise on the passenger side.
View 3 RepliesFord F-150 (2004-2008) :: Running Rough / Ticking Noise / Low Mileage?
the F150 of my brother has the follow diseases:rough running ticking noises, low mileage per gallone, blue smoke out of exhaust after start, i have ordered the cam phaser, hope, that will be the reason. But today, my brother means, i have to do a test drive, because the truck has no power. and really, feels like missing of one or two cylinders. Very bad performance. Is it possible, that the reason are the phasers?
View 4 RepliesSanta Fe (CM - 2007-12) :: Grinding / Ticking Noise Coming From Directly Under Center Console
My 2007 Santa Fe Limited 3.3L with 102,000 miles started making a grinding/ticking noise yesterday. It's hard to tell but it sounds like its coming from directly under the center console. The noise is directly proportional to the speed and if I put my hand on the shift selector, I can feel the tick vibrations. It drives and shifts fine. What it could be? I'm hoping it's not a transmission issue. I'm thinking something with the AWD connection to the rear wheels.
View 1 RepliesFord F-150 (2004-2008) :: 2005 - Ticking Noise Left Bank Cylinder 3 And 4
Once winter arrived I started having problems with my truck running like crap after warm up. However, I noted that during initial start up and lasting till the engine got to its Normal Operating Temp, it would run like a BAOH! Once the engine reached Normal Temp, it would fall flat on its face if I got into it down the road. I wasn't getting any codes, so knowing about the EPU and timing; I opted to change out the O2 sensors. Bought all 4 sensors, Bosh, installed them and within a day got a P0420, P0303; known as Cat system efficiency below threshold and a #3 misfire. (side not all plugs, timing chains, COP's, Phasers, cam positioning sensors have been replaced within the past 18 months) So I decided to take the COP off of the #3 cyl and swapped it with the #5 cylinder; still getting a misfire on #3.
Didn't pull the plugs, knowing they have less than 50,000 miles on them. The problem lasted about a week, off and on with heavy acceleration. Then last Saturday I was driving around town, came to a stop light and the engine shook hard while stopped, missing for a few seconds but not sending a code. Upon acceleration I noticed a loud ticking coming from the right (passenger) bank. The truck practically fell on its face through 3,000 rpm's. No power, and still no codes. I got home, pulled out my steth and listened. I got a loud ticking on the cover at the #3 and #4 Cyl. I know ya'll acclaim ticking to the phasers but it's a totally different sound. Its not coming from the front of the cover as it did when my phasers went out. This is strictly confined to #3 and #4. Took it to FMC., for diagnostic fee and a day later they said, symptoms of lash adjusters. I told them I'd pick up my truck.
Got in it, and drove it home and that noise is loud, echoing through the right exhaust. Seems to be running very rich, still no power what so ever and now I pull up in my driveway and instantly get these codes. P0316 (misfire on startup), P0420 Cat efficiency below threshold, and p1000 (due to resetting my computer back to stock before taking it to FMC) I thought about doing the job myself, but working 120 hours a week I don't see how, and I'll need to buy the valve spring compressor and timing chain wedge (260.00 set) So I started calling around to mechanics, 10 to be exact, none of which, will even look at the truck.