Ford F-150 - 1997-2003 :: Vacuum Diagrams For 4 Wheel Drive?
Looking for the vacuum diagrams for the four wheel drive, where I can find them?
View 10 RepliesFord F-150 - 1997-2003 :: 1998 - Stuck In 4 Wheel Drive
Well I was trying out my four wheel drive today and it worked fine until I went to turn off switch, it would not cut off it is a 98 F150 switch is located on dash. It is stuck in four wheel high!
View 3 RepliesFord F-150 - 1997-2003 :: 4 Wheel Drive Is Stuck Engaged
Can't drive the truck. Went through the how to fix 4x4 and no go. How to kick it out of four wheel dive?
View 6 RepliesFord F-150 - 1997-2003 :: 2000 - 4 Wheel Drive Will Not Disengage
I have a 2000 ford f-150 4 wheel drive that will not disengage, I am down here in south fla where and don't put it in 4 wheel drive much, but yesterday I put in 4 wheel drive and I heard the click click and it engaged I put it in drive and drove it about 5-10 miles parked it and turned the switch to 2 wheel high and got out , got back in the truck turn her back on and the 4 by 4 lamp came one went off then came back on and stayed on and it still in 4 wheel drive and wont disengage.
View 4 RepliesFord F-150 - 1997-2003 :: Horrible Grinding Noise When Turn The Wheel Either Direction
I may, or may not have had to jump a curb at 40 mph to avoid rear ending another car. Truck is a 2003 F-150, single cab stx package, 4.2ltr. Long story short, no damage to my passenger side front tire or rim that I can see, but I do have a horrible grinding noise when I turn the wheel either direction. The truck still turns properly, power steering fluid is level. What should I start replacing first?! She's got about 90k miles on it, I'm sure a lot of the suspension parts are due, just need to know where to start!
View 3 RepliesFord F-150 - 1997-2003 :: 2000 - 4 Wheel Drive Isn't Engaging Properly?
I have a 2000 F-150 4x4 and the four wheel drive isn't working properly. It does work,but to get it to engage I had to drive in reverse for a couple feet then it locked it and everything was fine,pretty sure that isn't normal. What could be wrong with it? As soon as I turn the lights up on the dash,but the front tires don't spin.
View 1 RepliesFord F-150 - 1997-2003 :: Wheels Do Not Engage When Shifting Into 4 Wheel Drive
I have a 1998 F-150 and when shifting into 4 wheel drive (manual floor mount shifter) the drive shaft from the transfer case turns but the wheels do not engage.
Looking for a diagram of how the axle works?
Ford F-150 - 1997-2003 :: Selector Switch Does Not Light Up When Engaging Four Wheel Drive
My selector switch does not light up when engaging four wheel drive on my 98 f150,could this be my GEM module gone bad ?
View 6 RepliesFord F-150 - 1997-2003 :: 4 Wheel Drive Not Engaging / Indicator Lights Are Not Flashing
My 4 wheel drive is not engaging on a 2001 F150. The indicator lites on the dash illuminate to suggest that the truck is in 4 wheel drive but sigh...it stays in 2 wheel drive. No gross sounds and the indicator lights are not flashing. Could this be a fuse or a relay issue of some sort. What else should I try?
View 3 RepliesFord Super Duty (1999-2016) :: Grinding Noise Constant In 2 Wheel Drive
I have a 2001 F350 with a7.3 power stroke, 6 speed manual with manual t case and hubs. I have a bad grinding noise when in 2 wheel drive. Similar sound as if you are trying to shift t case into 4 wheel drive too slowly. The grinding is constant in 2 wheel drive, but if I shift it into 4 wheel drive, the noise completely goes away. I have been driving around in 4 wheel drive (T case only, manual hubs not locked) for the past 2 days. If I shift back into 2 wheel drive, a constant terrible grinding noise returns. What could be wrong, and why it goes away in 4 wheel drive?????
View 3 RepliesFord Aerostar :: 1997 - Grinding Noise From Steering Wheel?
'97 Ford Aerostar, 155k miles. Airbag model-
The problem: When I turn the wheel, there is some grabbing and tightness, and a strange grinding noise from the top of the steering column, like, right under the steering wheel. What's more, the wheel will actually pivot up and down on the steering shaft. I have tried pulling on it, and it loosen the grabbing, but it won't pull off in my hands or anything....
I suspect a bearing in the upper steering column has failed or has come loose. I guess I need to pull the bag and look around- Are there any tricks to pulling the airbag?
Santa FE SM (2001-06) :: Brakes Make A Grinding Noise - ABS / ESC And 4 Wheel Drive Lights On
2004 Santa Fe, after starting car the brakes make a grinding noise, the nthe ABS, ESC and 4 wheel drive light come on. After the initial grinding the noise stops and the brakes work fine. Just the lights stay on.
View 4 RepliesFord - Explorer :: 2003 - Grinding Sound Like Wheel Bearing Noise
I have a 2003 Sport Trac 4wd with 299,000 miles. There is what sounds like wheel bearing noise (grinding) that was noticed after returning from a trip where I flat towed it behind my rv. I did not notice the noise the last time I drove it - before towing it about 450 miles. I have towed this vehicle for many years and miles this way - transmission and transfer case in neutral with key in on position to unlock steering. I stated this part about the towing because the noise may have gone unnoticed for many miles. About 20,000 miles ago, I changed front wheel bearings, brake calipers, upper and lower ball joints, shocks and outer tie rod ends. Also rear brake pads.
I put the vehicle on jack stands and in drive mode couldn't hear anything in either 2wd or 4wd. I held one wheel at a time so the other side would spin. After checking for wobbling wheel bearings, I took off the wheels and did a push / pull on everything - all seems good. I changed driver's side wheel bearing anyway because I thought it to be a little rough. I removed the front drive shaft and took it out on the road. Noise was still there. This makes me think front differential but before entering unknown territory (for me) is there something else I can do to narrow down the problem? At this point, I'm not even convinced it is from the front end - maybe the sound is radiating through the truck.
Ford F-150 - 1997-2003 :: ABS Light On - Little Grinding In Front End
2002 F150 XLT Supercrew 4x4 5.4L V-8, non-7700 payload
Was feeling a little grinding in the front end a couple weeks ago. Turned out to be simple, brake pads were low, and the wear indicator was causing the mild vibration (though no noise). Replaced the pads, all was good.
Then in the middle of a 50 mile drive around the area, the ABS light comes on. Found the front right sensor was bad. Replacement. Put it on, ABS light went off, all is good. Drove probably 30 miles over the course of the next day, then light came back on. Tested the same sensor, and get no resistance. So the new one is bad.
Ford F-150 - 1997-2003 :: A/C Compressor Is Rattling And Grinding
My air conditioning compressor is rattling and grinding. I am trying to determine if I need a whole new unit or just a clutch assy. I can say this, when running it's rattling, but when the clutch engages, it clears up.
Would I be right in assessing it's the clutch? 1998 250 5.4 .....
Ford F-150 - 1997-2003 :: Grinding Then Thumping Going Into 4wd - Vacuum Solenoid?
I have 97 4x4 f-150 V6 4.2 litre that in 2wd tries to go into 4wd causing a grinding then a thump. When I put the truck into 4wd there is no grinding or thumping.
I believe one of the vacuum solenoids could be bad. Just was wondering which one would cause it to want to go into 4wd while in 2wd. The left most solenoid looking under the hood is the 4wd and the other with the pink vacuum is the 2wd.
I have no vacuum from the solenoids but from the lines going into them.
Ford F-150 - 1997-2003 :: Grinding And Starter Won't Engage The Flywheel
I just bought a 2000 f150 4x4 ex cab with the 5.4. Once in a while when starting, there is a grinding and the starter won't engage the flywheel. The truck has only had 17000 miles put on it in the past 4 years, and has sat quite a bit. Could the starter gear be gummed up and not engaging all the way, or should the starter be replaced? Or could poor contact on the cables cause this? Or is this a flywheel issue?
View 14 RepliesFord F-150 - 1997-2003 :: Grinding Noise On Passenger Side
I'm trying to find out why my truck has a grinding noise on the passenger side when my truck first starts driving for the first 1/4 mile. It stops after that or when I apply the brakes. Do I have a brake sticking or something more serious?
View 1 RepliesFord F-150 - 1997-2003 :: 1998 4.2L - Grinding When Down Shifting Into 3rd Gear
A few weeks ago I bot this truck to have some fun with. 98 F150 4.2l with a lift and some beefy tires. Well something to get me into trouble. On the test drive i never herd anything, mostly because I wasn't ripping it around. I know very little about transmissions, mostly because I never had a problem before.
I have a grinding noise when down shifting into 3rd for either 4 or 5th. It doesn't happen when I am going from 2-3. It also wont happen if i keep the clutch disengaged for a few seconds. It almost like the transmission need time to slow down for a second before shifting.
It also does this going into reverse.