Ford F-150 - 1997-2003 :: 2001 4x4 - Front Wheels Will Not Engage When Turn The Switch On
When I turn the switch on the front wheels don't engage. I replaced the two vacuum solenoids on the firewall no change. I replaced the actuator motor on the transfer case and everything worked....once. Tried to go around the back of the house thought I was in 4x4 but front wheels not engaging again. buried in mud. I let it set there overnight. Went out earlier started it and put it in 4x4 and it started puling out front wheels engaged. As soon as I gave it a little gas the front wheels became disengaged and it wouldn't go anywhere. I made several more attempts and no luck. I did the vacuum test where you turn the heater on panel and if there's a vacuum leak somewhere the heater blower will default to defrost. It passed this test so I'm assuming there is no leak anywhere. Why it worked right after I replaced the transfer case motor and again only after I got stuck and it set in the mud overnight?
View 2 RepliesFord F-150 - 1997-2003 :: 4 Lo Sometimes Will Not Engage Or Shifting Rough
I have 1999, F150 5.4L with electric 4wd shift. I put it in 4high just fine and smooth. Now 4lo on other hand rough shift if it goes in 4lo, sometimes won't engage but 4 high works fine. What's the cause
View 2 RepliesFord - Explorer :: 2003 - Push Button For 4 Wheel Drive Won't Engage
So my Push Button 4 wheel drive wont engage. The light on the dash wont light up and it doesn't shift into 4x4. Where to start? I would like to check the simple stuff first. O and my heat only gets hot when im giving the vehicle gas. This is all on a 2003 Ford Explorer.
View 2 RepliesFord F-150 - 1997-2003 :: 2000 - Front Axle Won't Engage While Shifting Into 4x4?
I have a 2000 F-150 XLT Supercab 5.4 4x4 with the dash shifter. My front axle won't engage when shifting into 4x4. A few months ago the vacuum solenoids were replaced and they sound as though they are functioning properly. The diaphragm isn't moving the lever thing and i can't get the lever to move with a screwdriver either.
I know it has worked the past two weekends. Two weeks ago it was in a significant amount of mud and possibly submerged at times. I power washed everything pretty good immediately afterwords though and it has worked in between then and now. What could be going on?
Ford Super Duty (1999-2016) :: 2003 - Locking Hubs When Trying To Engage To Shift Into 4 Wheel Drive
I recently purchased a 2003 F350 FX4 Dually with the 7.3L Diesel. It has locking hubs and electric shift in the cab.
I have had locking hubs before that you had to engage to shift into 4 wheel drive and I have had trucks without locking hubs.
My truck didn't come with a manual, so I am looking for instructions for the proper use of this system.
Ford F-150 - 1997-2003 :: 1998 2WD V6 - Delayed Shifting Into Drive
I have a 1998 F-150 XLT, 2WD, 4.2L, V6, just over 103,000 miles. My transmission shifts fine into reverse but when I put it into drive it is very slow to engage, sometimes it doesn't. I have to put it in drive, hold down the brakes, give it some gas and then it will engage and lurch forward. I have check the fluid level and quality. Both are fine. This just started to happen two days ago with no fore warning. No previous problems with transmission.
View 4 RepliesS-10 :: 2003 4 Wheel Drive With Automatic Transmission - Front Axle Will Not Engage
Its a automatic transmission with a v6 4.3 vortec. The front axle will not engage, it is not the acuator (I replaced it and the cable) you can pull the cable and the axle will engage. There is a low buzzing noise(coming from the drivers side) until you give it gas. This noise stops when the front axle is engaged. The transfer case will go from hi to low without any problems.
View 1 RepliesFord F-150 - 1997-2003 :: Grinding When In 4 Wheel Drive
I have a 1997 f150 4x4. When I put to 4 wheel drive on all I hear is grinding, but I'm pretty sure it works...
View 4 RepliesFord F-150 - 1997-2003 :: Vacuum Diagrams For 4 Wheel Drive?
Looking for the vacuum diagrams for the four wheel drive, where I can find them?
View 10 RepliesFord F-150 - 1997-2003 :: 1998 - Stuck In 4 Wheel Drive
Well I was trying out my four wheel drive today and it worked fine until I went to turn off switch, it would not cut off it is a 98 F150 switch is located on dash. It is stuck in four wheel high!
View 3 RepliesFord F-150 - 1997-2003 :: 4 Wheel Drive Is Stuck Engaged
Can't drive the truck. Went through the how to fix 4x4 and no go. How to kick it out of four wheel dive?
View 6 RepliesFord F-150 - 1997-2003 :: 2000 - 4 Wheel Drive Will Not Disengage
I have a 2000 ford f-150 4 wheel drive that will not disengage, I am down here in south fla where and don't put it in 4 wheel drive much, but yesterday I put in 4 wheel drive and I heard the click click and it engaged I put it in drive and drove it about 5-10 miles parked it and turned the switch to 2 wheel high and got out , got back in the truck turn her back on and the 4 by 4 lamp came one went off then came back on and stayed on and it still in 4 wheel drive and wont disengage.
View 4 RepliesFord F-150 - 1997-2003 :: 2000 - 4 Wheel Drive Isn't Engaging Properly?
I have a 2000 F-150 4x4 and the four wheel drive isn't working properly. It does work,but to get it to engage I had to drive in reverse for a couple feet then it locked it and everything was fine,pretty sure that isn't normal. What could be wrong with it? As soon as I turn the lights up on the dash,but the front tires don't spin.
View 1 RepliesFord F-150 - 1997-2003 :: Wheel Bearing Play / Clunking Or Sounds Like Something Mechanical Shifting
I have a 2002 Extended Cab F150 2WD 5.4L 3.55 Open. I have recently begun to notice a clunking or "sounds like something mechanical shifting" when I come to a stop or take my foot off the brake before accelerating (as in, when the light turns green.) The shocks are shot, so, some of the noise when I stop is likely due to bounce back, but the noise when I take my foot off the brake is clearly not related to suspension relaxation.
I jacked up the front, passenger corner and checked the wheel play. I immediately noticed wheel play in both 12/6 and 9/3 hand positions. First thought was obviously ball joints, but when I looked more closely I found that the steering knuckle itself was not moving at all. (I only had one corner jacked up, so, the torsion bar might have been stabilizing the steering knuckle to some degree, but...nonetheless, the wheel play is still there.)
So, the wheel play is between the wheel/rotor, and the steering knuckle. To me this suggests wheel bearings. But, I'm not sure how much play is allowable between the wheel and the spindle. Should the rotor/wheel move at all with respect to the spindle/steering knuckle? How much is okay? Does movement suggest I need to replace the wheel bearings? (I installed the rotor and wheel bearings myself last year.)
Ford F-150 - 1997-2003 :: Selector Switch Does Not Light Up When Engaging Four Wheel Drive
My selector switch does not light up when engaging four wheel drive on my 98 f150,could this be my GEM module gone bad ?
View 6 RepliesFord F-150 - 1997-2003 :: 4 Wheel Drive Not Engaging / Indicator Lights Are Not Flashing
My 4 wheel drive is not engaging on a 2001 F150. The indicator lites on the dash illuminate to suggest that the truck is in 4 wheel drive but sigh...it stays in 2 wheel drive. No gross sounds and the indicator lights are not flashing. Could this be a fuse or a relay issue of some sort. What else should I try?
View 3 RepliesFord Ranger / B-Series :: 1999 - Four Wheel Drive Will Not Engage
I bought a 99 ranger few months ago cant the 4x4 has not worked in the truck for about 4 years. Bought it off my dad. He hasn't figured it out the t case locks in the drive shaft spins but hubs will not lock in. Has new hubs in it and still not working. Trying to get it fixed so I can park the diesel for the winter and run the ranger.
View 3 RepliesFord Super Duty (1999-2016) :: 2015 - How To Engage 4 Wheel Drive Correctly
I have just switched from GM to Ford and have a new F250 4x4 XLT. I am wondering how to engage 4 wheel drive correctly. I have the manual shifter and the manual lock hubs. However during my test drive I shifted the lever into 4H and 4L and it seemed to engage just fine. Do I need to lock my hubs as well? Or if im just in a wet spot can i just shift into 4h without locking my hubs? I know if I am in anything serious I need to lock the hubs. I just want to be sure before I get into a tricky situation. My 02 GM all i had to do was push a button and it shifted automatically.
View 7 RepliesFord - Explorer :: 1997 - Trans Won't Engage While In Drive - Reverse Lost?
I got myself a 1997 explorer Australian model when I got it (here's the problem) if you put it in drive it will not engage but if put in first will drive normal then shift into second all good now u have push O.D then shift into drive all good (unless u slow down to almost a stop) ? New problem is, it has gone and lost reverse, put it in reverse and it engages with a small clank (normal) but just slips with any revs. I have read posts here talking about upper and lower valve body gaskets and transgo shiftkit which I have ordered but do there maybe more parts needed? Cause it's going to cost me lot just to put transmission fluid back in.
View 4 Replies