Santa FE SM (2001-06) :: Grinding Noise When Turning Wheel To The Left
I am hearing a grinding noise when I turn the wheel to the left.. and when I straighten it again the noise goes away.. no noise at all when turning the wheel to the right. what could it be? 2006 Hyundai Santa Fe / 205,000 km's
View 4 RepliesAccent LC (2000-05) :: Brake System - Front Right Wheel Started To Make Grinding Noise
I own a 2005 Hyundai Accent 1.3 SOHC and a while ago the front right wheel started to make a grinding noise, problem was related to the brake system..
So far I've tried replacing the rotor (disc), repaired the caliper (using a rebuild kit), replaced hoses (both), and event the master cylinder.... and the problem persists, it actually came to the point that after driving a while the front wheels will get stuck.
I've followed all the directions from the service manual and it still got the problem...
Elantra XD (2001-06) :: ABS / TCS Lights Came On And Brakes Occasionally Grinding
Ok, i have a 2006 elantra with traction control steering (TCS). Brake master cylinder went bad so i replaced that. Now the brakes occasionally start grinding when i'm driving slowly and turning (usually happens when turning into a parking spot). When I jam the brakes down they usually catch. Sometimes the ABS and TCS lights will come on after this happens.
Another problem i've had is that is not connected to the braking is that the ABS and TCS lights will come on and the car will not shift and this is going like 55 - 60 mph. I've found that if i throw the car in neutral, cut it off and back on that everything is fine. This is my first hyundai and first car with TCS. I bout this car used with 75000 miles and have only had it about 3 months.
Ford Super Duty (1999-2016) :: Grinding Noise Constant In 2 Wheel Drive
I have a 2001 F350 with a7.3 power stroke, 6 speed manual with manual t case and hubs. I have a bad grinding noise when in 2 wheel drive. Similar sound as if you are trying to shift t case into 4 wheel drive too slowly. The grinding is constant in 2 wheel drive, but if I shift it into 4 wheel drive, the noise completely goes away. I have been driving around in 4 wheel drive (T case only, manual hubs not locked) for the past 2 days. If I shift back into 2 wheel drive, a constant terrible grinding noise returns. What could be wrong, and why it goes away in 4 wheel drive?????
View 3 RepliesSanta Fe (CM - 2007-12) :: Grinding Noise Come From Front Right Wheel
I have a 2010 Santa fe ( since new) 28k miles - I'm getting a grinding noise that seems to come from the front right wheel - noticeable only when doing a right hand turn or going around a roundabout.
So, Is this likely (from my terrible description) to be a wheel bearing problem....
Hyundai - Elantra :: 2007 - Brakes Make A Grinding Sound When Tried To Stop In Icy Conditions
The brakes on my 2007 Hyundai Elantra make a grinding sound (almost like finger nails on wood) when I have tried to stop in icy conditions. It's also hard to get the car to stop and I end up pumping the brake. A Hyundai dealer replaced the front brakes over a year ago and Adirondack tire replaced back brake pads in the summer. Is the noise part of the anti-lock feature or does it sound like a problem?
View 10 RepliesFord Brakes/Suspension :: Faint Grinding Noise When Turning The Steering Wheel At Low Speeds
One my F350 with 175,000 miles on it, at low speeds when turning the steering wheel it seems as if it has two places during use that it rubs or has an oblong spot in it. I have 285 tires on it and have for years.
Kind of like if you were turning a shaft in a seal and it rubbed or was rough. It makes a faint, muffled, barely audible grinding noise or feel. I have a lift and level of about 4" and 285s for years. This just started in the last 5 months or so.
Santa FE SM (2001-06) :: 2007 - When Tap The Brakes Lights Go Dim Then Come Back On
I have a 2007 Santa Fe, I have been having issues with the power. I tap the brakes and the lights go dim and come back on. Then when the truck is turned off then back on I have nothing like the truck is dead. I replaced the battery and still same issue. I then replaced the alternator and I thought it was good. Just today I decided the use the keyless remote to lock the truck and it locked but not horn sound. I tried to unlock the truck with the remote and nothing. I opened the door and no lights. Turn the key and nothing. The battery still has power to hit. What it could be?
View 6 RepliesSanta FE SM (2001-06) :: Grinding Noise When Driving
What could it be? Replace front brakes. Then they said it was front axels, replaced them. Making same noise... grinding and feels like you are hitting brakes when you are not. Sounds like metal on metal. What else can it be? 01 sante fe 180,000 miles v6 awd. It was doing it in reverse but after all of this now just in drive at slow speeds.
View 3 RepliesSanta FE SM (2001-06) :: 2004 3.5LD Warning Lights Came On / Slight Shudder In Drive Line
I own a 2004 Santa Fe 3.5L AWD and recently when ever I drive at a highway speed 65mph or greater the ABS and Traction lights come on as well as the AWD indicator which lights up green and blinks. When this happens I feel a slight shudder in the drive line and I no longer have AWD, ABS or Traction control functioning. This condition continues until I stop and turn off and re-start the truck at which time everything is back to normal. It does not happen around town and I have had my local garage check for stored codes in the computer and there are none listed. We have also inspected the drive line on a lift and everything looks dry and fine. Other than that this truck runs and drives great.
View 3 RepliesFord Transmission :: 2001 F250 - Vibration And Grinding Noise When Drive Over A Slight Dip In The Road
2001 F250 7.3L 280k miles. Truck is new to me in the last 6 weeks. Was driving out to Glenwood Springs last night and I got a weird rear end vibration between 79 and 81 mph - couldn't say if it's a new vibration as haven't had the truck long enough. It's sort of still there over 81 but less obvious than bang on 80. Whilst the vibration was there I caught a slight dip in the road that caused a grinding noise to accompany the vibration - I'm guessing because something's was getting extra loading on the upside of the dip.
I'm away from home until Monday so my options are a bit limited, however while crawling around in the dark last night pushing and shoving stuff to see if anything was loose I noticed a couple of things:
Minor leak from pinion seal - but it has flung some spots of oil. Drive shaft 'center bearing'(? U shaped attachment on drive shaft to chassis with rubber bearing?) has play I can push the drive shaft at least a 1/4" with my hand and it seems a little sloppy but I'm no mechanic.
I'm going to check transmission fluid level today and top up if required and check the magnets, such that I can limp home as necessary avoiding 80 and get the diff checked and pinion seal replaced. Does the drive shaft bearing need changing or should it have that much play? I'm assuming it's LSD on the rear?
Santa FE SM (2001-06) :: 2004 V6 - Light Grinding Noise At About 1.9k RPM
I own a 2.7 L v6 Santa Fe, 2004 with almost 50k miles on it.
When I accelerate and hit approximately 1.9k RPM I can hear a light grinding noise underneath the car. This happens both in 2nd and 3rd gear. So as it's accelerating up I can hear it, and when the car shifts up and the RPMs drop it will make the noise again as it passes through the same RPM range.
The noise is always there at 1.9k to approx 2.1k RPMs.
Also of note is that the sound is either gone or significantly reduced after driving around for a while. I don't notice it after freeway driving, for example.
Santa FE SM (2001-06) :: Grinding Noise In All Gears At 3500 RPMs
Codes currently on ecm: P0134, P2125, P1174, P0735 My 2003 Santa Fe 2wd 3.5l with 160,000 miles was driving fine, then all the sudden whenever I reach about 3500 rpms there's a grinding noise that sounds like its coming from near or in the automatic transmission. As for the codes: P0134- I just replaced the o2 sensor with an oem part from autozone, so not sure why that's popping up. The connections look fine. P2125 and P1174- I'm trying to figure out whether the accelerator position sensor or throttle position sensor needs to be replaced. I have a multimeter but don't know if that will be able to tell me which one is out. The P0735 gear 5 incorrect ratio and grinding noise at 3500 rpms is what I am mostly worried about though. Could a transmission flush work with that?
View 2 RepliesSanta FE SM (2001-06) :: Loud Grinding Noise Seems To Be Coming From Behind Glove Box
I have a 2002 Hyundai Santa Fe v6. I've had problems with the air conditioning in that it blows hot. Paid around 900 bucks to have a new compressor installed because the mechanic said that would fix it but it didn't. That was about 8 months ago. Still blowing strong but no cold air. About two weeks ago I took the car to a different mechanic who told me it needs a new compressor which would be 900 bucks. I declined that but had the guy do a little work on the breaks. He put new rotors and pads on the front brakes two weeks ago. Now within the past couple days when I start the car up it makes an extremely loud nasty grinding type of sound for a couple seconds then stops. Oil is fine and new. It happened this morning long enough for me to look under the hood and see the fans looked like they were fine, and the loud grinding noise seems to be coming from behind the glove box. It hasn't broke down on me yet, it's just really obnoxious and embarrassing with all the noise every morning.
View 8 RepliesFord Super Duty (1999-2016) :: 2001 F350 - Grinding Noise When Drive Slow And Especially Turn To The Right
Have an f350 4x4 diesel that when I drive slow and especially turn to the right it makes a grinding noise. It seems to either go away or just gets muffled by road noise when cruising. The ball joints were bad so I replaced them and I figured with this especially when I turn right it had to be a wheel bearing so I replaced both of them and still same thing. Don't want to throw money at it hoping to fix the issue. Also front duff is full of oil.
View 5 RepliesSanta FE SM (2001-06) :: 2005 - Grinding Noise But Driving And Shifting Fine
I have a 2005 Santa Fe 2.7L engine. Right now it seems to be making a funny grinding noise in the passenger side. It's driving and shifting fine. Wheels seem to be ok. Once it cooled down the noise seemed to go away.
View 4 RepliesSanta FE SM (2001-06) :: Grumbling Noise When First Started And Put Into Drive Or Reverse
My 2003 Santa Fe makes a grumbling noise when first started, and put into drive or reverse. The noise seems to be coming from the passenger side of the engine compartment. The noise disappears when the drive train has warmed up.
View 4 RepliesSanta FE SM (2001-06) :: 2002 - Loud Noise From Engine When In Drive
2002 hyundai santa fe GL2 4 Cyl Automatic ... I noticed that there is a super heavy motorcycle-ish loud noise from my engine when I put it in drive. When it's idle or in reverse or neutral the problem does not occur. but then when I switch it to drive, uber loud noise...which gets louder when I step on the gas.
What has been done so far - replaced spark plugs, ignition coils and plug wires so far...also changed the oil, no fix.
No check engine light at all.....however the battery did die due to someone leaving a light on for days So I am unable to get any code readings.
Santa FE SM (2001-06) :: 2004 - Clunking Noise In Drive Or Reverse
2004 Santa Fe, clunking noise in drive or reverse. checked brakes and cv joints, replaced drivers front and still making the noise. Transfer case was a little low on fluid but not much. Put up on stands and turn wheels with no noise. Put in drive or reverse while in the air and rear wheels sit still. It is a 4wd so I would think that all 4 tires would be turning. While in the air the front both turn and no noise is made.
View 18 Replies