Ford F-150 - 1997-2003 :: Blower Motor Resistor Location
I'm looking for information and possible photo location for the blower motor resistor. My truck has climate control. I've looked under the dash on the passenger side and behind the glove box door and I've been unable to spot the location. Do I have to remove the plastic panel behind the glove box?
View 6 RepliesFord F-150 - 1997-2003 :: Blower Motor / Blinkers Not Working
My 99 f150 blower motor and blinkers slowly but surely went out on me. The hazards still work. I changed the flasher relay and the relay for the blower motor, and nothing. I've checked all the fuses, and checked for wire issues and nothing.
View 4 RepliesFord F-150 - 1997-2003 :: 1998 - Power Mirror Switch Removal
How to remove power mirror switch 1998 f150, and where to buy if can't be cleaned up to work?
View 1 RepliesSonata NF (2006-10) :: Blower Motor Not Working - Switch Is Not Getting Power?
I have a problem with my 09 Sonata. Blower motor does not work at all, on any setting. I thinks it's not getting any power. When I turn the blower on, on the dash, little red light does not come on on the switch. I think the switch itself that controls the speed and power to the blower is not getting any power.
I checked fuses that control the blower and they are fine (I looked up fuse location online).
Ford Aerostar :: 1997 - Location Of Blower Fan Motor Relay?
I'm having some trouble with the front blower fan on my 97 Aerostar 3.0, it will only intermittently work, one time we had it running, lifted up the hood on the van, checked the connection to the motor, looked good, dropped the hood and the fan immediately started working again, I'm wonder if the relay might be starting to go bad, the fan in the back works, so I'm not sure. Where the relay is for the blower motor, or what might be wrong?
View 6 RepliesFord Ranger / B-Series :: 1997 - Blower Motor Doesn't Work
I've got a new to me 97 Ranger that the blower has never worked in and I can't get it going. I've checked the fuse. That's good. Tested the relay. That's good. Did an ohm test on the power switch for the blower. It's open in the "OFF" position and closed in the other positions. I've got continuity through the speed selector switch. New resistor and pigtail because the other one was nasty looking. What seems odd to me is that I've only got power to the blower motor relay at one terminal with the switch on (number 30 I believe). In addition, when I test the plug for the motor itself with my test light, one of the wires (org/blk I think) has power only when the switch is off. And I ran power straight to the fan from the battery and it spun right up. What am I missing?
View 8 RepliesFord Aerostar :: 1997 XLT - Front Blower Motor Does Not Blow Occasionally
My 1997 XLT 4.0 AWD w/Rear A/C has been having a Blower Motor issue for many months. Occasionally the front blower does not blow. Banging on the Blower Motor, either from under the hood, or even from inside the van underneath the glove box, will start it up again. Once running, it continued running okay until at least the next shutdown. This has gone on throughout the summer. Sometimes a good bump in the road would start it.
Now that the winter is here, heat and defrost are more critical, so it has become a bigger problem. Furthermore, is is now almost constant, where it rarely works without a bang. So it is time to actually fix it now.
From other posts, I think it is either the Blower Motor itself, or the Control Module / Resistor. But since the control module is not located on the motor itself, where I bang, it is probably the motor. Question:
1 - What is the problem, and can I fix it with grease (elbow or actual) etc... or is replacement the proper option?
2 - Should I replace the wheel too, which is not available on RockAuto - but is on the junkyard options on eBay. Unfortunately those are often just as broken as mine. Generic Wheels are available in Auto Zone.
Ford Ranger / B-Series :: 1997 - Blend Door Motor Removal?
My actuator/motor doesn't have the screws that hold it on. It's just clipped down. Can I just pry it up & off with out it breaking the clips that hold it down? It's a 97 Ranger.
View 2 RepliesFord Ranger / B-Series :: 1997 - Heater Blower Motor Resistor Rusted
I am not great with electrical but can manage. Here's the deal, Ihave a 1997 ford ranger 2wd 2.3L 5spd with a/c 233,000 miles i just replaced the heater blower motor resistor as the old one was rusted bad as was the pig tail going to it bad that one of the terminals broke off and was rusted in the harness so i replaced the plug as well problem is i still have no fan if i jump it it works but have no power at the plug for resistor or motor and no power at the switch inside the truck I do have power to one terminal where the relay plugs in, where to look next?
View 14 RepliesFord A/C :: 2003 F150 - Blower Motor Stopped Working All Of A Sudden
I've read quite a few threads on this subject and came across the resistor, fuses, and relays. I have some fundamental testing procedure questions.
1. To test the resistor, it says to back probe the brown/orange wire to check for voltage. So I'm assuming I would hook up my positive lead, here?
Do I really need to hook up the black lead all the way to the negative terminal on the battery? Just with a long extension? Or is there somewhere else I can hook the black lead to? (I know, how dumb!)
2. I downloaded owners manual, but I can't seem to find a fuse or relay specifically for the blower, so what fuse and what relay is it?
3. In the Haynes manual, it says locate the blower motor relay, in the relay box under the center dash panel, where the hell is that?
4. Do I need to remove the glove box to access the resistor and blower hosting.
5. Anything else I should know?
Ford A/C :: 2003 E350 - Front Heater / AC Blower Motor Isn't Working
Recently bought a 2003 E350. The front heater/ac blower motor isn't working. I found the control switch melted and bought a new switch. Before installing it, I need to do some diagnostics. I checked the blower with a couple of jumpers ant it turns and blows. I think that leaves the blower motor resistor. Where it is on a 2003 E350? I also need to check the relay. I have a power distribution box at the front left under the hood. Is the relay there? The box is not labeled like my GM products. Which is the blower motor relay? Finally, which fuse controls the blower motor? I read it might be a 40 amp fuse. If so, that might narrow it down.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Blower Motor Only Works On High?
I don't know if its a coincidence but it rained hard all weekend and went to work this morning to find out the blower motor only on 4(high). I checked the plug going into blower motor and it looks dry and clean. is there a common occurrence with this? What to look for?
View 14 RepliesFord Super Duty (1999-2016) :: 2003 - Second Position Of Blower Switch Does Not Work
I have an '03 F250 and the second position of the blower switch doesn't work. The first, third, and fourth are all fine.
I bought a Motorcraft YH-1670 blower switch, but can't figure out where it's located?
I looked behind the glove box, but didn't see it there. I did not remove the screws to the cover behind the glove box because I wanted to first confirm where the switch is located.
Ford Super Duty (1999-2016) :: 2003 - Blower Motor Loud Rumble Noise?
I have a 2003 super duty V10 4WD super cab long bed.
loud deep rumble noise when turn on the blower. both heat and a/c. removed the blower and seemed to turn ok. blew out all vents. removed heater radiator cover, checked most flaps to see if working. doesn't seem to be obstruction invent. the flap behind blower clear and functioning ok.
When on second speed, almost sounds like blower motor is out of balance. if run on high for 1 minute, smell electrical burning! Think to replace motor will work? will post another issue with radio and power windows
Ford F-150 - 1997-2003 :: 4.2 2WD - Oil Pan Removal?
Is it possible to remove the oil pan from a 1997 F150 with a 4.2, 2WD, without removing the engine? I seem to be reading that's it is possible (but difficult) for 4wd, but it can't be done for 2WD - is that correct?
View 4 RepliesYaris/Scion & Vitz :: 2003 Toyota - How To Change Echo Blower Motor
How to change a 2003 toyota echo blower motor.... Looking for a step by step directions ....
View 2 RepliesCivic - Honda :: 2003 - Fan / Blower Motor Not Working After Rotor Replacement And Oil Change
Our 03 Civic recently went into the shop for a rotor replacement and the shop did an oil change for us while they were at it. My wife got the car back and she immediately noticed that the "AC" wasn't working. After asking a few additional questions (I'm not in the same city this week), it isn't the AC that isn't working, the fan/blower isn't turning on at all. We had the same shop check it out again and their response was that they weren't anywhere near the blower motor so this just has to be a coincidence. I could accept that but I'm still worried about a scam.
The car was in the shop just to have the rotors put on, not an oil change but they did an oil change for us anyway. (I was going to change the rotors myself but I couldn't get the caliper hangers off and it was 100+ degrees outside so I decided to have the shop mess with it), Would it be easy to sabotage the blower motor on this car?
Chevrolet - Tahoe :: 2003 - HVAC Blower Switch Only Works When Put It On Highest Setting
My HVAC blower switch only works when I put it on 5 (the highest setting). What needs to be replaced (besides the whole truck)?
View 4 RepliesFord F-150 - 1997-2003 :: Rusty Torsion Bar Removal
99 F-150 4x4. Any tips to get these rusty things separated from their homes? I've got the torsion keys unloaded and loose and the cross member loose. They will not budge. Aside from getting a bigger hammer and abusing the cross member till something gives. I don't like using the torch on heat treated components....
View 14 Replies