Ford F-150 - 1997-2003 :: Rusty Torsion Bar Removal
99 F-150 4x4. Any tips to get these rusty things separated from their homes? I've got the torsion keys unloaded and loose and the cross member loose. They will not budge. Aside from getting a bigger hammer and abusing the cross member till something gives. I don't like using the torch on heat treated components....
View 14 RepliesFord F-150 - 1997-2003 :: Rear Main Seal Removal?
We have a 97 f150 4x4, I have pulled the transmission for repair. The rear main seal is not leaking however I have always replaced them when I pulled a tranny. This is a 5.4l and after removing the flywheel I noticed there is another cover around the crankshaft held on by 8mm bolts around the side and 2 oil pan bolts on the bottom. Does this cover come off to fully access the seal? Is there a gasket available for this cover or is silicone the standard?
View 1 RepliesFord F-150 - 1997-2003 :: Blower Motor Switch Removal?
How to remove the blower motor switch on my 99 F150 without breaking anything.
View 1 RepliesFord F-150 - 1997-2003 :: Torque Converter Removal / Replacement
I have a 97 F-150 Supercab XLT, 4X4, 4.6L W, 4r70W with electronic Overdrive, manual shift transfer case. I need to remove and replace the Torque Converter. My question is: Would it be easier to drop the transmission and transfer case or pull the engine loose and move it forward to get at the torque converter?
It is shifting in and out of overdrive to third, and then back into OD, and back into third erratically and for no apparent reason. It is also slipping intermittently in first from a dead stop and locking all at once, shifts hard then. When I first drive it the OD light does not flash and the OD off switch works, once it warms up good it starts shifting erratically and the OD off switch starts flashing, then the off switch does not work.
I did not get any codes returned on autozones little scanner and am taking it to the ford dealer for a full scan today to see if there might be any other damage or cause for this problem. The problems started when I blew a hose to the trans cooler in the radiator and lost fluid. I didn't notice the blown hose until it started slipping and pulled over, replaced the hose and fluid. Had problems ever since. I have cleaned the MAF sensor and replaced the ABS sensor in the differential so far.
Ford F-150 - 1997-2003 :: Keyless Entry System Removal?
What would be involved with removing the keyless entry system on my '02 F150 XLT so that I can install it into my '97 Explorer that I am fixing up. Is it integrated into the main computer or is it a totally separate system? If so where is it located?
The Expo already has power locks just not keyless (or at least I never received the key fob for it when I bought it) I have shaved the door lock cylinders and am fabricating handles to be hidden in the window moldings.
Ford F-150 - 1997-2003 :: Rear Brake Pads Removal
After removing the tires, I can't figure out how to remove the brake pads to change them. How to do it? Does the caliper have to come off? These are on the rear. 2001 F150 4X4...
View 1 RepliesFord F-150 - 1997-2003 :: Broken Exhaust Manifold Bolt Removal
I have a 1999 ford f150 4.6 engine and it has an exhaust leak but wondering what is the procedure to remove a broken bolt and the rest of the bolts on the manifold
View 2 RepliesFord F-150 - 1997-2003 :: 2000 XLT - Parking Brake Cable Removal
I'm having a hard time trying to figure out to detach the cable from the pedal assembly. The place where the cable attaches is so hidden by various plates, pawls and springs that there is no access. Also the whole assembly is put together with rivets so there's no easy way of taking it apart. Is there some trick to getting the cable out?
Also, I need to find out exactly where the cable goes through the floor pan. I'm in the process of fixing the rust on this. My 2000 XLT 4x4 and the floor pan and rockers were so rusted that there was no evidence of where the cable went through the floor pan! I assume it's supposed to go through the channel right next to the inner rocker but where exactly? A simple measurement from the back edge of the A-pillar is all I need.
Ford F-150 - 1997-2003 :: 2000 - Front Differential Cover Removal?
As I was laying under my truck today I noticed a drip under the front differential, it looks like the cover is leaking by the factory RTV gasket. This is the 00' F150. How hard is it to remove these things? It looks like the front cover mount makes it difficult....
View 3 RepliesFord F-150 - 1997-2003 :: 1998 - Power Mirror Switch Removal
How to remove power mirror switch 1998 f150, and where to buy if can't be cleaned up to work?
View 1 RepliesFord F-150 - 1997-2003 :: 2002 - Stock Head Unit Removal / Replacement?
I have an 02 f150 xl, I'm taking the stock head unit out and replacing it with a Pioneer 1900. I didn't buy a connector I'm just splicing the wires together, I know I shouldn't do it that way but it's to late now, what my problem is, there are three ground wires coming from the truck and the new head unit only has one ground, I just looked wiring diagrams up for both head units and that got pretty much everything done, just there are two speaker ground wires that are black and green, and then a regular black ground wire, I'm not sure if I should connect them all together or cap them separately, because I connected everything up and the head unit wouldn't turn on...
View 2 RepliesFord F-150 - 1997-2003 :: 2001 F350 - Air Intake Removal - Alternator Starts Up To 12?
I have a 2001 f350 7.3 diesel, I am looking at switching out the air intake? Also, I have an issue with the code for a dual upper and lower generator fault.. I checked and only have one generator not a dual system.. The alternator is running strong at 14.1.. But I have noticed when I start it up it is down to 12..
View 1 RepliesFord F-150 - 1997-2003 :: 1999 - Automatic Transmission Removal / Mounting Bolts To Engine?
How does one get to the top mounting bolts to engine? Are special tools required? Is there an access plate?
View 6 RepliesFord - F150 :: 1997 - O2 Sensor Removal?
1997 F150, V6, 4.2L. Replacing the O2 sensor, driver's side before the converter. I've tried using the O2 sensor socket (I have a full set) and it keeps slipping off. Afraid I'll "round" the sensor even more. I've tried heating it up, penetrating oil and it's not budging at all.
View 8 RepliesFord Ranger / B-Series :: 1997 - Blend Door Motor Removal?
My actuator/motor doesn't have the screws that hold it on. It's just clipped down. Can I just pry it up & off with out it breaking the clips that hold it down? It's a 97 Ranger.
View 2 RepliesFord Ranger / B-Series :: 1997 - Removal Of Speed Control From Steering Wheel
My speed control has not worked in years and I do not use them any more any way. I want to remove the control area on each side of the steering wheel, the covers are all messed up so I would like to make it look like it came without them. Can I do this and if so how?
View 1 RepliesFord - Explorer :: 2003 - Power Steering Pump Removal / Replacement
I have a 2003 Ford Explorer with Power Steering problems. I have read and tried all the solutions I found here, except replacing the pump. Seems like it is the pump. Oil was burnt, I flushed twice. I checked the rack and lubed as identified in another post, same jumpy hard to steer issue. Anyway, now I am trying to remove the Pump. I have removed the reservoir and am trying to remove the pump. I have the top two bolts out, but cannot get to the bottom tow bolts. How do you access them? Do I need to remove the lower radiator hose, and / or the oil filter?
View 10 RepliesFord 7.3L Power Stroke (1999-2003) :: Overhead Console Removal
A while ago (1 yr) I read and did the pull the wire thing to keep the lie o meter bright all the time. It worked fine, but all of a sudden it seems dim. I can barely read it in the day time. Fine at night. Could it be that the LED's are starting to fail, or some other weirdness? How to remove the overhead console?
View 12 RepliesFord 7.3L Power Stroke (1999-2003) :: Removal Entire Dash?
I want to remove my whole dash to paint it but i cant figure out what is holding it in,i removed all the black screws from one side to the other the screws under the tabs by the windshield and it still feels like its being held in somewhere underneath?
View 14 Replies